Molecular phylogeny and population structure of tideland snails in the genus Cerithidea around Japan

Phylogenetic relationships and genetic population structures were analyzed for tideland gastropods in the genus Cerithidea around Japan on the basis of partial sequence of the mitochondrial COI gene. Large genetic divergence was shown between individuals of Cerithidea cingulata in the southern Ryukyus and those in the central Ryukyus and the Japanese Islands. Haplotypes of C. cingulata from the Japanese Islands were paraphyletic with the exclusion of a monophyletic group from the central Ryukyus. Genetic differentiation of C. cingulata was also detected between Amami-Oshima Island and Okinawajima Island. No genetic divergence was found between Cerithidea rhizophorarum in the Japanese Islands and its subspecies C. rhizophorarum morchii in the Ryukyu Islands. The lack of genetic divergence of Cerithidea largillierti between continental China and Japan suggests relatively recent migration between the Japanese Islands and the Asian continent. For all three Cerithidea species distributed in both the Japanese Islands and the Ryukyu Islands, the Tokara Gap and the Kerama Gap were shown to have acted as barriers to the dispersal.     

Initial ecological risk assessment of eight selected human pharmaceuticals in Japan.

Eight pharmaceuticals were selected on the basis of their domestic consumption in Japan, the excretion ratio of the parent compound and the frequency of detection in the aquatic environment or wastewater treatment plant effluent. Toxicity tests on these pharmaceuticals were conducted using Japanese medaka (Oryzias latipes), daphnia (Daphnia magna), and green algae (Psuedokirchneriella subcapitata). Predicted no effect concentration (PNEC) was calculated using lethal or effect concentration 50 (LC50 or EC50) values and no effect concentration (NOEC) obtained in the toxicity tests for these compounds. Predicted environmental concentration (PEC) was also calculated from annual consumption, the excretion rate of the parent compound, and removal rate in the preliminary batch activated sludge treatment performed in this study. Maximum concentrations found in the aquatic environment or sewage effluent in Japan or foreign countries were also used for another calculation of PEC. Initial risk assessment on the selected pharmaceuticals was performed using the PEC/PNEC ratio. The results of initial risk assessment on the eight selected pharmaceuticals suggest neither urgent nor severe concern for the ecological risk of these compounds, but further study needs to be conducted using chronic toxicity tests, including reproduction inhibition and endocrine disruption assessments.     

Removal of Linear and Branched p-Alkylphenols from Aqueous Solution by Combined Use of melB Tyrosinase and Chitosan Beads

In this study, melB tyrosinase was applied for enzymatic removal of linear and branched p-alkylphenols from aqueous solutions. First, systematic studies were carried out to estimate the effects of the process parameters such as the temperature, pH value, and enzyme dose on quinone conversion of p-cresol as a model phenol compound. A variety of p-alkylphenols were removed from aqueous solutions through the tyrosinase-catalyzed quinone conversion and subsequent nonenzymatic adsorption of quinone derivatives on chitosan beads at pH 6.0 and 30 °C under the optimum conditions determined for p-cresol. The % removal values of 98–100 were obtained for p-n-alkylphenols. Branched p-alkylphenols with a weak estrogenic activity containing 4-tert-butylphenol and 4-tert-pentylphenol, which underwent no quinone conversion by commercially available mushroom tyrosinase in the absence of H₂O₂, were also effectively removed by further increasing either the melB tyrosinase concentration or the amount of added chitosan beads. The present technique is much effective in the fact that a series of reactions rapidly progress under mild conditions and the chitosan beads can be readily separated from the reaction medium after the enzymatic treatment.     

The earliest record of birch mice from the Early Miocene Nei Mongol,China

The earliest species of birch mouse, Sicista primus sp. nov., was recovered from the 17-Ma-old (Early Miocene) Gashunyinadege locality, central Nei Mongol, China. It is ~9 Ma older than the previous first appearance datum of Sicista in Eurasia. This study indicates that North American Macrognathomys is a synonym of Eurasian Sicista, having 12 shared dental characters. As a result, the biogeography of dipodids indicates that Asian Sicista dispersed to North America as opposed to the hypothesis that Sicista originated from the North American clade. Sicista is one of the few extant rodent genera that originated as early as the Early Miocene.     

The effects of mating status and time since mating on female sex pheromone levels in the rice leaf bug,Trigonotylus caelestialium

Although mating status affects future mating opportunities, the biochemical changes that occur in response to mating are not well understood. This study investigated the effects of mating status on the quantities of sex pheromone components found in whole-body extracts and volatile emissions of females of the rice leaf bug, Trigonotylus caelestialium. When sampled at one of four time points within a 4-day postmating period, females that had copulated with a male had greater whole-body quantities of sex pheromone components than those of virgin females sampled at the same times. The quantities of sex pheromone components emitted by virgin females over a 24-h period were initially high but then steadily decreased, whereas 24-h emissions were persistently low among mated females when measured at three time points within the 4 days after mating. As a result, soon after mating, the mated females emitted less sex pheromones than virgin females, but there were no significant differences between mated and virgin females at the end of the experiment. Thus, postmating reduction in the rate of emission of sex pheromones could explain previously observed changes in female attractiveness to male T. caelestialium.     

A novel mechanical plant compression system for biomass fuel and acquisition of squeezed liquid with water-soluble lignin as anti-virus materials

Journal of Material Cycles and Waste Management - Plant biomass could be a viable alternative renewable resource, but the moisture content must be reduced to use it as fuel. Mechanical compression...     

A new condensed toluene mechanism for Carbon Bond: CB05-TU

Toluene is ubiquitous in urban atmospheres and is a precursor to tropospheric ozone and aerosol (smog). An important characteristic of toluene chemistry is the tendency of some degradation products (e.g., cresols and methyl-catechols) to form organic nitro and nitrate compounds that sequester NOx (NO and NO₂) from active participation in smog formation. Explaining the NOx sinks in toluene degradation has made mechanism development more difficult for toluene than for many other organic compounds. Another challenge for toluene is explaining sources of radicals early in the degradation process. This paper describes the development of a new condensed toluene mechanism consisting of 26 reactions, and evaluates the performance of CB05 with this new toluene scheme (Toluene Update, TU) against 38 chamber experiments at 7 different environmental chambers, and provides recommendations for future developments. CB05 with the current toluene mechanism (CB05-Base) under-predicted the maximum O₃ and O₃ production rate for many of these toluene–NOx chamber experiments, especially under low-NOx conditions ([NOx]_t=0 < 100 ppb). CB05 with the new toluene mechanism (CB05-TU) includes changes to the yields and reactions of cresols and ring-opening products, and showed better performance than CB05-Base in predicting the maximum O₃, O₃ formation rate, NOx removal rate and cresol concentration. Additional environmental chamber simulations with xylene–NOx experiments showed that the TU mechanism updates tended to improve mechanism performance for xylene.     

Virtual phosphorus ore requirement of Japanese economy

Phosphorus is indispensable for agricultural production. Hence, the consumption of imported food indirectly implies the import of phosphorus resources. The global consumption of agricultural products depends on a small number of ore-producing countries. For sustainable management of phosphorus resources, the global supply and demand network should be clarified. In this study, we propose the virtual phosphorus ore requirement as a new indicator of the direct and indirect phosphorus requirements for our society. The virtual phosphorus ore requirement indicates the direct and indirect demands for phosphorus ore transformed into agricultural products and fertilizer. In this study, the virtual phosphorus ore requirement was evaluated for the Japanese economy in 2005. Importantly, the results show that our society requires twice as much phosphorus ore as the domestic demand for fertilizer production. The phosphorus contained in “eaten” agricultural products was only 12% of virtual phosphorus ore requirement.     

Evaluation of environmental feasibility of steel pipe sheet pile cutoff wall at coastal landfill sites

An evaluation method that can express the local leakage of leachate from joint sections in steel pipe sheet pile (SPSP) cutoff walls is discussed in this study. In particular, the evaluation of environmental feasibility (containment of leachates containing toxic substances) considering a three-dimensional arrangement and hydraulic conductivity distribution of the joint sections in the SPSP cutoff wall is compared with an evaluation that uses the equivalent hydraulic conductivity. This equivalent hydraulic conductivity assumes that the joint section and the steel pipe are integrated; therefore, the hydraulic conductivity is substituted with a uniform permeable layer. However, in an evaluation that employs the equivalent hydraulic conductivity, it is difficult to consider the local leakage of leachate containing toxic substances from the joint sections in the SPSP cutoff wall. It was established that evaluations of the environmental feasibility of SPSP cutoff walls with joint sections must take into account the local leakage of leachates containing toxic substances from the joint sections. Also, it was clarified that technologies that lower the hydraulic conductivities of joint sections in SPSP cutoff walls and also facilitate the use of sparser joint arrangements contribute significantly to increasing the environmental feasibility of SPSP cutoff walls at landfill sites.