Current status and research on E-waste issues in Asia

Rapid economic growth in Asia and the increasing transboundary movement of secondary resources will increasingly require both 3R endeavors (reduce, reuse, recycle) in each country and appropriate control of international material cycles. Recently, managing electrical and electronic waste (E-waste) has become an important target for domestic and international material cycles from the viewpoints of environmental preservation and resource utilization efficiency. To understand the current status of E-waste issues in the context of international material cycles and to discuss the future tasks related to achieving 3R in the region, we organized the National Institute for Environmental Studies (NIES) E-waste Workshop in December 2004. This article reviews past studies on E-waste and briefly describes the topics presented and discussions held at the workshop. The topics at the workshop included E-waste generation, recycling systems, international trade, and environmental impacts. In addition, we discussed various issues such as terminology, current environmental concerns, and possible solutions. Transboundary shipments of E-waste should be conducted taking into consideration the concept of sustainable development. The direction of future research and possible collaborations are also discussed.     

Supercritical water gasification of sewage sludge using bench-scale batch reactor: advantages and drawbacks

Sewage sludge, a byproduct of municipal wastewater treatment, was gasified by supercritical water using a bench-scale batch reactor. Configuration of bench-scale batch reactor and operation procedures are discussed in detail. Experience and challenges that arose during the experiment are also shared. Using the bench-scale reactor under the condition of 600 °C, 23 MPa, and a reaction time of 60 min without catalyst presence, a total gas yield of 9.8 mol/(kg-sewage sludge) was obtained. Furthermore, investigations on operational parameters were conducted. Extension of reaction time up to 60 min increased the gasification, reaching a plateau thereafter. Investigation on pressure indicated the superiority of supercritical pressure. The addition of Ni as a catalyst also promoted gasification, although inorganic salts and char seemed to cover the catalyst surface. With regard to the prospect of future operation at a municipal waste water treatment plant, the effect of operational parameters on heavy metal concentration in the liquid phase is also discussed.     

Quantitative analysis of microbial biomass yield in aerobic bioreactor

We have studied the integrated model of reaction rate equations with thermal energy balance in aerobic bioreactor for food waste decomposition and showed that the integrated model has the capability both of monitoring microbial activity in real time and of analyzing biodegradation kinetics and thermal-hydrodynamic properties. On the other hand, concerning microbial metabolism, it was known that balancing catabolic reactions with anabolic reactions in terms of energy and electron flow provides stoichiometric metabolic reactions and enables the estimation of microbial biomass yield (stoichiometric reaction model). We have studied a method for estimating real-time microbial biomass yield in the bioreactor during food waste decomposition by combining the integrated model with the stoichiometric reaction model. As a result, it was found that the time course of microbial biomass yield in the bioreactor during decomposition can be evaluated using the operational data of the bioreactor (weight of input food waste and bed temperature) by the combined model. The combined model can be applied to manage a food waste decomposition not only for controlling system operation to keep microbial activity stable, but also for producing value–added products such as compost on optimum condition.     

Effects of tributyltin on the energy metabolism of pen shell (Atrina pectinata japonica)

We examined the effects of tributyltin (TBT) on aerobic and anaerobic energy metabolism of pen shell (Atrina pectinata japonica). We exposed pen shells to TBT at nominal concentrations of 0 (control) and 1.0microg/l for 72h under aerobic condition. At the end of the exposure, half of the pen shells in each treatment were wrapped in plastic wrap to simulate exposure to hypoxia and held at 25 degrees C for another 12h. The concentrations of the products of energy metabolism, namely lactate, pyruvate, fumarate and succinate, in adductor muscle were measured. The exposure to TBT under aerobic condition significantly elevated lactate, pyruvate and fumarate concentrations (p<0.001). After subsequent exposure to anaerobic condition, the mean concentration of succinate in the TBT treatment group was 64% of that in the control group, but there were no significant differences. Our results suggest that the energy metabolism of pen shell is disrupted by exposure to TBT.     

Polychlorinated dibenzo-p-dioxins and dibenzofurans in paddy soils and river sediments in Akita, Japan

Paddy soils and sediments from the Yoneshirogawa, Omonogawa, and Koyoshigawa River Basins in Akita were analyzed for polychlorinated dibenzo-p-dioxins (PCDDs) and dibenzofurans (PCDFs). The levels and compositions in those samples including soils from non-agricultural areas (non-agricultural soils) were investigated using isomer-specific analysis to determine characteristic sources. The PCDD/PCDF compositions in the samples were compared with respect to possible sources. The PCDD/PCDF concentrations in paddy soils were much higher than those in the non-agricultural soils and much higher than those found in other parts of Japan. Although PCDD/PCDFs were ubiquitous in sediments from river sources to mouths of the respective river basins, those concentrations were much lower than those from paddy soils and non-agricultural soils, and from other parts of Japan. Comparison of PCDD/PCDF homologues and isomer compositions for samples indicated that compositions of paddy soils and sediments, except for those from river sources, had similar characteristics to PCDD/PCDFs originating from impurities in herbicides, 2,4,6-trichlorophenyl 4-nitrophenyl ether (CNP) and pentachlorophenol (PCP), and that compositions of river-source sediments and non-agricultural soils resembled those of atmospheric depositions. Results of statistical analyses suggest that PCDD/PCDF contamination of paddy soils and sediments is attributable mainly to three sources: CNP, PCP, and atmospheric deposition. Results of this study also demonstrate that CNP and PCP are not only important contaminants of local areas of Japan, but that they exist throughout Akita, in northern Japan. We therefore conclude that PCDD/PCDF pollution caused by those compounds has a widespread influence on paddy soils and river sediments in Japan.     

PCDD/PCDF formation in the chlor-alkali process—laboratory study and comparison with patterns from contaminated sites

Studies on the formation of polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs) during the electrolysis of sodium chloride solution (brine) using graphite or titanium electrodes were carried out at a laboratory scale. High concentrations of PCDFs but no PCDDs were formed in tests using graphite electrodes. With titanium electrodes, PCDFs were only formed when tar pitch was added and mainly originated from the dibenzofuran present in the tar. For the first time, a detailed assessment of the formation of mono- to octachlorinated PCDD/PCDF from tar pitch was investigated. The assessment included of the chlorination steps proved that PCDFs were formed by successive lateral chlorinated from dibenzofuran to MonoCDFs, DiCDFs, and TriCDFs to form the typical known “chlorine pattern” of TetraCDF to OctaCDF with a dominance of 1,2,7,8- and 2,3,7,8-TetraCDFs, 1,2,3,7,8-PentaCDF, and 1,2,3,4,7,8-HexaCDF as marker congeners. The final homologue distributions depended on reaction time and reaction temperature. In addition, electrolysis with non-chlorinated dibenzo-p-dioxins, dibenzofuran, and biphenyl was carried out. As a result, PCDDs, PCDFs, and PCB were formed at comparable yields. Congener patterns in soil samples from a PCDD/F-contaminated site where chlor-alkali electrolysis had been operated for decades in Japan had identical isomer distribution demonstrating the source and contamination potential and risk of these processes. Therefore, sites where in the past 120 years chlor-alkali electrolysis has been operated or where residues from chlor-alkali production or other chlorine using industries have been disposed should be assessed for their pollution level and exposure relevance. The assessment of total organohalogen content revealed that PCDF is only a small fraction of organohalogens in the contaminated soils. For an appropriate risk assessment, also other chlorinated aromatic compounds such as PCBs or PCNs need to be considered.     

Nylon recovery from carpet waste through pyrolysis under the presence of zinc oxide and the roll-milling treatment

Recycling of carpet waste is not extensively carried out because of its complex combination of materials. A representative type of carpet consists of three layers: nylon fibers, adhesives, and backing materials made of poly(vinyl chloride), PVC. Thermal treatment of carpet waste, thus, leads to the emission of hazardous chlorinated compounds. In the present work, we have employed the one-directional thermal treatment of the backing materials under the presence of zinc oxide, which promotes the thermal degradation of PVC. Nylon fibers could be effectively recovered by the consequent milling treatment from the brittle backing materials. The influence of process parameters, such as pyrolysis temperature and reaction time, on the separation efficiency is discussed.     

Wayfinding with a GPS-based mobile navigation system: A comparison with maps and direct experience

This study examined the effectiveness of a Global Positioning System (GPS)-based mobile navigation system in comparison to paper maps and direct experience of routes, by focusing on the user's wayfinding behavior and acquired spatial knowledge. Based on information received from one of these three media, participants walked six routes finding the way to goals. Results showed that GPS users traveled longer distances and made more stops during the walk than map users and direct-experience participants. Also, GPS users traveled more slowly, made larger direction errors, drew sketch maps with poorer topological accuracy, and rated wayfinding tasks as more difficult than direct-experience participants. Characteristics of navigation with these three learning media and possible reasons for the ineffectiveness of the GPS-based navigation system are discussed.