Two thresholds determine climatic control of forest fire size in Europe and northern Africa

Fire weather indices predict fire extent from meteorological conditions assuming a monotonic function; this approach is frequently used to predict future fire patterns under climate change scenarios using linear extrapolation. However, the relationship between weather and fire extent may potentially depend on the existence of fuel moisture content thresholds above which this relationship changes dramatically, challenging this statistical approach. Here, we combine the continuous and the threshold approaches to analyze satellite-detected fires in Europe during 2001–2010 in relation to meteorological conditions, showing that fire size response to decreasing fuel moisture content follows a ramp function, i.e., with two plateaus separated by a phase of monotonic increase. This study confirms that at continental and high-resolution temporal scales, large fires are very unlikely to occur under moist conditions, but it also reveals that fire size stops to be controlled by fuel moisture content above a given threshold of dryness. Thus, fuel moisture content control only applies when fire is not limited by other factors such as fuel load, as large fires were virtually absent during the considered period in dry regions with less than 500 mm of average annual precipitation, i.e., low-productive areas where fuel amount would be scarce and discontinuous. In regions with sufficient fuel, other factors such as fire suppression or fuel discontinuity can impede large fires even under very dry weather conditions. These findings are relevant under current climatic trends in which the fire season length, in terms of number of days with drought code values above the observed thresholds (break points), is increasing in many parts of the Mediterranean, while it is decreasing in eastern Europe and remains unchanged in central Europe.     

Waterborne agrichemicals compromise the anti-predatory behavior of zebrafish

Environmental Science and Pollution Research - Due to human activities, there is an increasing presence of agrochemicals residues in water bodies, which could be attributed to an increased use of...     

Investigations on mechanical biological treatment of waste in South America: towards more sustainable MSW management strategies

This work presents an analysis on the suitability of mechanical biological treatment of municipal solid waste in South America, based on two previous experimental investigations carried out in two different countries. The first experiment was performed for determining the mass and volume reduction of MSW in the province of Concepción (Chile). The implemented bench-scale process consisted of a manual classification and separation stage, followed by an in-vessel biological degradation process. The second experiment consisted of a full-scale experiment performed in the city of Estrela (Brazil), where the existing municipal waste management facility was adapted to enhance the materials sorting and separation. Expressed in wet weight composition, 85.5% of the material input in the first experiment was separated for biological degradation. After 27 days of processing, 60% of the initial mass was reduced through degradation and water evaporation. The final fraction destined for landfilling equals 59% of the total input mass, corresponding to about 50% of the initial volume. In the second experiment, the fraction destined to landfill reaches 46.6% of the total input waste mass, whilst also significantly reducing the total volume to be disposed. These results, and the possible recovery of material streams suitable for recycling or for preparing solid recovered fuels, are the main advantages of the studied process.     

Persistent organic pollutants in atmospheric deposition and biomonitoring with Tillandsia usneoides (L.) in an industrialized area in Rio de Janeiro state, southeast Brazil--Part II: PCB and PAH

Monitoring of immission of persistent organic pollutants in the industrialized area of Volta Redonda (V.R.) and in the National Park of Itatiaia (PNI) in southeast Brazil was performed using an endemic bromeliad species as biomonitor and measuring bulk deposition rates of polychlorinated biphenyls (PCB) and polycyclic aromatic hydrocarbons (PAH). For the sum of PCB, overall deposition rates were between 17 and 314 ng/(m2 day) in winter and between 43 and 81 ng/(m2 day) in summer, respectively. Deposition rates of dioxin-like PCBs ranged from 0.14 to 2.8 pg WHO-TEQ/(m2 day) in winter and from 0.90 to 4.3 pg WHO-TEQ/(m2 day) in summer. PCB deposition rates (total PCB and WHO-TEQ) were in the same range in winter in V.R. and PNI. In summer, contamination levels in V.R. were 6-10-folds higher than in PNI. PCB concentrations in biomonitor samples from V.R. and PNI were in the same range in summer and in winter. Concentrations of total PCB ranged from 14 to 95 microg/kg dry matter (d.m.) in winter and from 18 to 27 microg/kg d.m. in summer, respectively. The TEQ values were between 1.7 and 4.1 ng WHO-TEQ/kg d.m. in winter and between 1.9 and 2.9 ng WHO-TEQ/kg d.m. in summer. PCB concentrations of di-ortho PCB but not of non-ortho PCB were a factor of 2-4 lower in summer in both areas. PCB congener profiles resembled those from technical formulations. The profiles shifted to the higher chlorinated congeners in summer, probable due to revolatilisation of the lighter components at higher temperatures. PCB profiles in biomonitor resembled those from deposition samples and the shift to the heavier congeners in summer was even more pronounced. PAH deposition rates were in a similar range in both areas (131-2415 ng/(m2 day)). PAH levels in biomonitor samples from V.R. were about one order of magnitude higher than in samples from PNI indicating the impact of local sources. PAH profiles revealed stationary thermal processes as main source of contamination in V.R. whereas in PNI, biomass burning seems to be the main contamination source.     

Advanced oxidation processes for the treatment of olive-oil mills wastewater

In this work, the treatment of an actual industrial waste with three advanced oxidation processes (AOP) has been studied: conductive-diamond electrooxidation (CDEO), ozonation and Fenton oxidation. The wastewater comes from olive-oil mills (OMW) and contains a COD of nearly 3000 mg dm(-3). CDEO allowed achieving the complete mineralization of the waste with high current efficiencies. Likewise, both ozonation and Fenton oxidation were able to treat the wastes, but they obtained very different results in terms of efficiency and mineralization. The accumulation of oxidation-refractory compounds as final products excludes the use of ozonation and Fenton oxidation as a sole treatment technology. This confirms that besides the hydroxyl-radical mediated oxidation, CDEO combines other important oxidation processes such as the direct electro-oxidation on the diamond surface and the oxidation mediated by other electrochemically formed compounds generated on this electrode.     

Use of electrochemical technology to increase the quality of the effluents of bio-oxidation processes. A case studied

In this work, it has been studied the use of conductive-diamond electrochemical oxidation (CDEO) as a refining technology to assure the quality of the effluents of door manufacturing processes (DMP). To do this, the raw effluents of these factories have been treated by a combination of physicochemical, biological and CDEO treatments. CDEO was found to be a feasible alternative to the refinement of a wooden DMP waste. It can successfully decrease the organic load of the effluents of the biological oxidation with low energy requirements. In addition, in case of incidents in the biological process, CDEO can treat successfully the effluents of the coagulation process. The effluents of the biological treatment have also been treated by CDEO in order to check the possible use of electrochemical technology to increase the biodegradability of the effluents and their possible recycle to the biological treatment. Unfortunately, electrochemical technology was found to be not adequate to increase the biodegradability of the effluents of a biological treatment. The hard oxidation conditions generated during CDEO do not lead to the accumulation of intermediates but to the almost direct formation of carbon dioxide. Lowering the current density or changing the electrodes can not enhance the biodegradability of the effluents of an electrochemical cell.     

Assessing the ecological effects of human impacts on coral reefs in Bocas del Toro,Panama

Environmental and biological reef monitoring was conducted in Almirante Bay (Bahía Almirante) in Bocas del Toro, Panama, to assess impacts from anthropogenic developments. An integrated monitoring investigated how seasonal temperature stress, turbidity, eutrophication and physical impacts threatened reef health and biodiversity throughout the region. Environmental parameters such as total suspended solids [TSS], carbon isotopes (δ¹³C), C/N ratios, chlorophyll a, irradiance, secchi depth, size fractions of the sediments and isotope composition of dissolved inorganic carbon [DIC] of the water were measured throughout the years 2010 and 2011 and were analysed in order to identify different impact sources. Compared to data from Collin et al. (Smithsonian Contributions to the Marine Sciences 38:324–334, 2009) chlorophyll a has doubled at sites close to the city and the port Almirante (from 0.46–0.49 to 0.78–0.97 μg l^?1) and suspension load increased, visible by a decrease in secchi depth values. Visibility decreased from 9-13 m down to 4 m at the bay inlet Boca del Drago, which is strongly exposed to river run off and dredging for the shipping traffic. Eutrophication and turbidity levels seemed to be the determining factor for the loss of hard coral diversity, most significant at chlorophyll a levels higher than 0.5 μg l^?1 and TSS levels higher than 4.7 mg l^?1. Hard coral cover within the bay has also declined, at some sites down to <10 % with extremely low diversities (7 hard coral species). The hard coral species Porites furcata dominated the reefs in highly impacted areas and showed a strong recovery after bleaching and a higher tolerance to turbidity and eutrophication compared to other hard coral species in the bay. Serious overfishing was detected in the region by a lack of adult and carnivorous fish species, such as grunts, snappers and groupers. Study sites less impacted by anthropogenic activities and/or those with local protection showed a higher hard coral cover and fish abundance; however, an overall loss of hard coral diversity was observed.     

Spectral trend of vegetation with rainfall in events of El Niño-Southern Oscillation for Atlantic Forest biome,Brazil

This study aimed to analyze the spectral trend of vegetation with rainfall in El Niño-Southern Oscillation events (ENSO) in the Atlantic Forest, Brazil. Monthly rainfall data were collected from 85 conventional meteorological stations (EMC), data from the Enhanced Vegetation Index 2 (EVI2) and ENSO events (El Niño, La Niña, and Neutral) in the period from 2001 to 2013. Afterwards, state cluster analysis was performed using the results of non-parametric tests. The Mann-Kendall (MK) non-parametric test did not identify a trend pattern in rainfall distribution in the Atlantic Forest. The results for EVI2 by state and region showed that the trend is decreasing in the Northeast Region, except for the states of Alagoas and Pernambuco. Southeast region showed an increasing trend of EVI2 (except for Rio de Janeiro and São Paulo), while the South region showed a decreasing trend. In the Midwest, the trend was significantly decreasing. In the prognosis elaborated for the future, the regions with significant declines of the vegetation were the Northeast and Midwest. This study shows that the Atlantic Forest in some regions of Brazil has been suffering from the growing urbanization process and there is a trend of soil degradation.     

Protease production by the keratinolytic Bacillus sp. CL18 through feather bioprocessing

Bacillus sp. CL18 was investigated to propose a bioprocess for protease production using feathers as organic substrate. In feather broth (FB), containing feathers as sole organic substrate (1–100 g l^?1), maximal protease production was observed at 30 g l^?1 (FB30) after 6 days of cultivation, whereas increased feather concentrations negatively affected protease production and feather degradation. Protease production peaks were always observed earlier during cultivations than maximal feather degradation. In FB30, 80% of initial feathers mass were degraded after 7 days. Addition of glucose, sucrose, starch, yeast extract (2 g l^?1), CaCl₂, or MgCl₂ (10 mmol l^?1) to FB30 decreased protease production and feather degradation. FB30 supplementation with NH₄Cl (1 g l^?1) resulted in less apparent negative effects on protease production, whereas peptone (2 g l^?1) increased protease yields earlier during cultivations (3 days). Through a central composite design employed to investigate the effects of peptone and NH₄Cl (0.5–4.5 g l^?1) on protease production and feather degradation, FB30 supplementation with peptone and NH₄Cl (0.5–1.1 g l^?1) increased protease production within a shorter cultivation time (5 days) and hastened complete feather degradation (6 days). Feather bioconversion concurs with sustainable production of value-added products.

     

Electrochemical advanced oxidation processes: today and tomorrow. A review

In recent years, new advanced oxidation processes based on the electrochemical technology, the so-called electrochemical advanced oxidation processes (EAOPs), have been developed for the prevention and remediation of environmental pollution, especially focusing on water streams. These methods are based on the electrochemical generation of a very powerful oxidizing agent, such as the hydroxyl radical (^?OH) in solution, which is then able to destroy organics up to their mineralization. EAOPs include heterogeneous processes like anodic oxidation and photoelectrocatalysis methods, in which ^?OH are generated at the anode surface either electrochemically or photochemically, and homogeneous processes like electro-Fenton, photoelectro-Fenton, and sonoelectrolysis, in which ^?OH are produced in the bulk solution. This paper presents a general overview of the application of EAOPs on the removal of aqueous organic pollutants, first reviewing the most recent works and then looking to the future. A global perspective on the fundamentals and experimental setups is offered, and laboratory-scale and pilot-scale experiments are examined and discussed.