Prenatal diagnosis of the fragile X using thymidine induction

Eleven pregnancies in ten patients at risk for the fragile X were monitored by amniocentesis or chorion villus biopsy and induction of the fragile site using thymidine, methotrexate and FUdR. Three female fetuses and one male fetus were found to have the fragile X. The results obtained using thymidine induction were superior to those using methotrexate induction and probably better than those obtained using FUdR induction.     

Applying metabolic fingerprinting to ecology: The use of Fourier-transform infrared spectroscopy for the rapid screening of plant responses to N deposition

The potential for metabolic fingerprinting via Fourier-transform infrared (FT-IR) spectroscopy to provide a novel approach for the detection of plant biochemical responses to N deposition is examined. An example of spectral analysis using shoot samples taken from an open top chamber (OTC) experiment simulating wet ammonium deposition is given. Sample preparation involved oven drying and homogenisation via mill grinding. Slurries of a consistent dilution were then prepared prior to FT-IR analysis. Spectra from control, 8 and 16 kg N ha^–1 yr^–1 treatments were then subjected to cross-validated discriminant function analysis. Ordination diagrams showed clear separation between the three N treatments examined. The potential for using Calluna vulgaris (L.) Hull as a bioindicator of N deposition is further evident from these results. The results also clearly demonstrate the power of FT-IR in discriminating between subtle phenotypic alterations in overall plant biochemistry as affected by ammonium pollution.     

Methane and carbon dioxide emission in a two-phase olive oil mill sludge windrow pile during composting

The aim of this work was to make some preliminary evaluations on CO(2) and CH(4) emissions during composting of two-phase olive oil mill sludge (OOMS). OOMS, olive tree leaves (OTL) and shredded olive tree branches (OTB) were used as feedstock for Pile I and Pile II with a 1:1:1 and 1:1:2v/v ratio, respectively. Each pile was originally 1.2m high, 2.0m wide and approximately 15.0m long. Four 500 ml volume glass funnels were inverted and introduced in each pile, two in the core (buried 50-60 cm from the surface) and two near the surface under a thin 10-15 cm layer of the mixture. Thin (0.5 cm diameter) plastic, 80 cm long tubes were connected to the funnels. A mobile gas analyser (GA2000) was used to measure the composition (by volume) of O2, CO2 and CH4 on a daily basis. The funnels were removed prior to each turning and reinserted afterwards. From each pair of funnels (core and surface) of both piles, one was kept closed between samplings. Two way ANOVA was used to test differences between piles and among the tubes. Post hoc Tukey tests were also used to further investigate these differences. There was a significant difference (at p<0.001) in the two piles for all three gases. The average concentrations of O2, CO2 and CH4 in Pile I, from all four funnels was 16.86%, 3.89% and 0.25%, respectively, where for Pile II the average values were 18.07%, 2.38% and 0.04%, respectively. The presence of OOMS in larger amounts in Pile I (resulting in more intense decomposing phenomena), and the larger particle size of OTB in Pile II (resulting in increasing porosity) are the probable causes of these significant differences. Samples from open funnels presented lower, but not significantly lower, O2 composition (higher for CO2 and CH4) in comparison with closed funnels in both depths and both piles. Not significant were also the different mean gas compositions between core and surface funnels in the same pile.     

等离子气化技术在垃圾处理中的应用

等离子气化技术已经在国外成功应用多年,其用于解决日益增多的垃圾问题,可将废物转化成有用的资源。本文介绍了等离子气化技术的优点、经济性,以及其在垃圾处理中的应用。     

U.S. National PM2.5 Chemical Speciation Monitoring Networks—CSN and IMPROVE: Description of networks

The U.S. Environmental Protection Agency (EPA) initiated the national PM_2.5 Chemical Speciation Monitoring Network (CSN) in 2000 to support evaluation of long-term trends and to better quantify the impact of sources on particulate matter (PM) concentrations in the size range below 2.5 μm aerodynamic diameter (PM_2.5; fine particles). The network peaked at more than 260 sites in 2005. In response to the 1999 Regional Haze Rule and the need to better understand the regional transport of PM, EPA also augmented the long-existing Interagency Monitoring of Protected Visual Environments (IMPROVE) visibility monitoring network in 2000, adding nearly 100 additional IMPROVE sites in rural Class 1 Areas across the country. Both networks measure the major chemical components of PM_2.5 using historically accepted filter-based methods. Components measured by both networks include major anions, carbonaceous material, and a series of trace elements. CSN also measures ammonium and other cations directly, whereas IMPROVE estimates ammonium assuming complete neutralization of the measured sulfate and nitrate. IMPROVE also measures chloride and nitrite. In general, the field and laboratory approaches used in the two networks are similar; however, there are numerous, often subtle differences in sampling and chemical analysis methods, shipping, and quality control practices. These could potentially affect merging the two data sets when used to understand better the impact of sources on PM concentrations and the regional nature and long-range transport of PM_2.5. This paper describes, for the first time in the peer-reviewed literature, these networks as they have existed since 2000, outlines differences in field and laboratory approaches, provides a summary of the analytical parameters that address data uncertainty, and summarizes major network changes since the inception of CSN.

ImplicationsTwo long-term chemical speciation particle monitoring networks have operated simultaneously in the United States since 2001, when the EPA began regular operations of its PM_2.5 Chemical Speciation Monitoring Network (IMPROVE began in 1988). These networks use similar field sampling and analytical methods, but there are numerous, often subtle differences in equipment and methodologies that can affect the results. This paper describes these networks since 2000 (inception of CSN) and their differences, and summarizes the analytical parameters that address data uncertainty, providing researchers and policymakers with background information they may need (e.g., for 2018 PM_2.5 designation and State Implementation Plan process; McCarthy, 2013) to assess results from each network and decide how these data sets can be mutually employed for enhanced analyses. Changes in CSN and IMPROVE that have occurred over the years also are described.     

High-Mileage Study of On-Board Diagnostic Emissions

Abstract

The 1990 Clean Air Act amendments require the U.S. Environmental Protection Agency (EPA) to set guidelines for states to follow in designing and running vehicle inspection and maintenance (I/M) programs. Included in this charge was a requirement to implement an on‐board diagnostic (OBD) test for both basic and enhanced I/M programs. This paper provides the results to date of an ongoing EPA study undertaken to assess the durability of the OBD system as vehicles age and as mileage is accrued. The primary results of this effort indicate the points described below. First, the majority of high‐mileage vehicles tested had emission levels within their certification limits, and their malfunction indicator light (MIL) was not illuminated, indicating that the systems are capable of working throughout the life of a vehicle. Second, OBD provides better air quality benefits than an IM240 test (using the federal test procedure [FTP] as the benchmark comparison). This statement is based on greater emissions reductions from OBD‐directed repairs than reductions associated with IM240‐identified repairs. In general, the benefits of repairing the OBD fails were smaller, but the aggregate benefits were greater, indicating that OBD tests find both the high‐emitting and a number of marginally high‐emitting vehicles without false failures that can occur with any tailpipe test. Third, vehicles that truly had high‐tailpipe emissions as confirmed by laboratory IM240 and FTP testing also had illuminated MILs at a statistically significant level. Last, field data from state programs have demonstrated MIL illumination rates comparable with those seen in this work, suggesting that the vehicles sampled in this study were representative of the larger fleet. Nonetheless, it is important to continue the testing of high‐mileage OBD vehicles into the foreseeable future to ensure that the systems are operating correctly as the fleet ages and as changes in emission certification levels take effect.     

Spatial and seasonal variations in atrazine and metolachlor surface water concentrations in Ontario (Canada) using ELISA

Concerns regarding the impacts of pesticides on aquatic species and drinking water sources have increased demands on water quality monitoring programs; however the costs of sample analysis can be prohibitive. In this study we investigated enzyme-linked immunosorbent assay (ELISA) as a cost-effective, high through-put method for measuring pesticide concentrations in surface waters. Seven hundred and thirty-nine samples from 158 locations throughout Ontario were analysed for atrazine and metolachlor from April to October 2007. Concentrations ranged from <0.1 to 3.91 μg L⁻¹ (median = 0.12 μg L⁻¹) for atrazine and from <0.1 to 1.83 μg L⁻¹ (median = 0.09 μg L⁻¹) for metolachlor. Peak concentrations occurred in late spring/early summer, in rural agricultural locations, and decreased over the remainder of the growing season for both herbicides. About 3% of the samples that had ELISA results occurring above the limit of quantification (0.10 μg L⁻¹) were evaluated against gas chromatography-mass spectrometry (GC-MS). Linear regression analysis revealed a R² value of 0.88 and 0.39, for atrazine and metolachlor, respectively. ELISA tended to overestimate concentrations for atrazine and metolachlor, most likely because the ELISA kits also detect their metabolites. Atrazine data suggest that ELISA may be used complementary with GC-MS analysis to enhance the spatial and temporal resolution of a water quality monitoring study. The commercially available metolachlor ELISA kit requires further investigation. ELISA may be used to detect atrazine and metolachlor in surface water samples, but it is not recommended as a quantitative replacement for traditional analytical methods.     

An assessment of indoor air quality in recent Mexican immigrant housing in Commerce City, Colorado

An indoor air quality assessment was conducted on 100 homes of recent Mexican immigrants in Commerce City, Colorado, an urban industrial community north of Denver. Head of households were administered a family health survey, filled out an activity diary, and participated in a home inspection. Carbon monoxide (CO) and carbon dioxide (CO₂) were measured for 24 h inside the main living area and outside of the homes. Harvard Impactors were used to collect 24-h samples of PM_2.5 at the same locations for gravimetric analysis. Dust samples were collected by vacuuming carpeting and flooring at four locations within the home and analyzed by ELISA for seven allergens. Mean indoor and outdoor PM_2.5 levels were 27.2 and 8.5 μg m⁻³, respectively. Indoor PM_2.5 and CO₂ were elevated in homes for which the number of hours with door/window open was zero compared to homes in which the number of hours was high (>15 h). Indoor PM_2.5 levels did not correlate with outdoor levels and tended to increase with number of inhabitants, and results indicate that the source of indoor particles were occupants and their activities, excluding smoking and cooking. Mean indoor CO₂ and CO levels were 1170 and 2.4 ppm, respectively. Carbon monoxide was higher than the 24-h National Ambient Air Quality Standard in 3 of the homes. The predominant allergens were cat (Fel d 1) and mouse (Mus m 1) allergens, found in 20 and 34 homes, respectively.