A climate-change vulnerability and adaptation assessment for Brazil's protected areas

Brazil hosts the largest expanse of tropical ecosystems within protected areas (PAs), which shelter biodiversity and support traditional human populations. We assessed the vulnerability to climate change of 993 terrestrial and coastal-marine Brazilian PAs by combining indicators of climatic-change hazard with indicators of PA resilience (size, native vegetation cover, and probability of climate-driven vegetation transition). This combination of indicators allows the identification of broad climate-change adaptation pathways. Seventeen PAs (20,611 km²) were highly vulnerable and located mainly in the Atlantic Forest (7 PAs), Cerrado (6), and the Amazon (4). Two hundred fifty-eight PAs (756,569 km²), located primarily in Amazonia, had a medium vulnerability. In the Amazon and western Cerrado, the projected severe climatic change and probability of climate-driven vegetation transition drove vulnerability up, despite the generally good conservation status of PAs. Over 80% of PAs of high or moderate vulnerability are managed by indigenous populations. Hence, besides the potential risks to biodiversity, the traditional knowledge and livelihoods of the people inhabiting these PAs may be threatened. In at least 870 PAs, primarily in the Atlantic Forest and Amazon, adaptation could happen with little or no intervention due to low climate-change hazard, high resilience status, or both. At least 20 PAs in the Atlantic Forest, Cerrado, and Amazonia should be targeted for stronger interventions (e.g., improvement of ecological connectivity), given their low resilience status. Despite being a first attempt to link vulnerability and adaptation in Brazilian PAs, we suggest that some of the PAs identified as highly or moderately vulnerable should be prioritized for testing potential adaptation strategies in the near future.     

Seasonal dynamics of phytoplankton in response to environmental variables in contrasting coastal ecosystems

Environmental Science and Pollution Research - Seasonal distribution of phytoplankton community and size structure was assessed in three different tropical ecosystems of the western Bay of Bengal...     

Interinstrument comparison of remote-sensing devices and a new method for calculating on-road nitrogen oxides emissions and validation of vehicle-specific power

Emissions of nitrogen oxides (NOx) by vehicles in real driving environments are only partially understood. This has been brought to the attention of the world with recent revelations of the cheating of the type of approval tests exposed in the dieselgate scandal. Remote-sensing devices offer investigators an opportunity to directly measure in situ real driving emissions of tens of thousands of vehicles. Remote-sensing NO₂ measurements are not as widely available as would be desirable. The aim of this study is to improve the ability of investigators to estimate the NO₂ emissions and to improve the confidence of the total NOx results calculated from standard remote-sensing device (RSD) measurements. The accuracy of the RSD speed and acceleration module was also validated using state-of-the-art onboard global positioning system (GPS) tracking. Two RSDs used in roadside vehicle emissions surveys were tested side by side under off-carriageway conditions away from transient pollution sources to ascertain the consistency of their measurements. The speed correlation was consistent across the range of measurements at 95% confidence and the acceleration correlation was consistent at 95% confidence intervals for all but the most extreme acceleration cases. VSP was consistent at 95% confidence across all measurements except for those at VSP ≥ 15 kW t^?1, which show a small underestimate. The controlled distribution gas nitric oxide measurements follow a normal distribution with 2σ equal to 18.9% of the mean, compared to 15% observed during factory calibration indicative of additional error introduced into the system. Systematic errors of +84 ppm were observed but within the tolerance of the control gas. Interinstrument correlation was performed, with the relationship between the FEAT and the RSD4600 being linear with a gradient of 0.93 and an R² of 0.85, indicating good correlation. A new method to calculate NOx emissions using fractional NO₂ combined with NO measurements made by the RSD4600 was constructed, validated, and shown to be more accurate than previous methods.

Implications: Synchronized remote-sensing measurements of NO were taken using two different remote-sensing devices in an off-road study. It was found that the measurements taken by both instruments were well correlated. Fractional NO₂ measurements from a prior study, measurable on only one device, were used to create new NO_x emission factors for the device that could not be measured by the second device. These estimates were validated against direct measurement of total NO_x emission factors and shown to be an improvement on previous methodologies. Validation of vehicle-specific power was performed with good correlation observed.     

Analysis and optimization on the biodegradable plate making process parameters using RSM-based Box–Behnken Design method

Journal of Material Cycles and Waste Management - The present research work focused on fabricating Biodegradable Plate (BD plate) composed of rice husk ash, bagasse and corn starch which is...     

Stability of a Coal Waste Artificial Reef

The feasibility of using U.K. coal-fired power station waste materials for artificial reef production is being examined. in June, 1989, an experimental artificial reef was constructed in Poole Bay, off the central south coast of the U.K., using three different mixtures of pulverised fuel ash (PFA), flue gas desulphurisation (FGD) gypsum and slurry, stabilized with cement and formed into blocks. Fifty tonnes of 40 × 20 × 20 cm blocks were formed into eight conical reef units replicating three different PFA/gypsum mixtures and one concrete control. the reef structure is 10m below chart datum on a flat sandy sea-bed.

Combustion of coal concentrates the heavy metal content in the resultant ash. the purpose of stabilization of the ash as blocks is twofold: to immobilize heavy metals (or other components) and to provide hard substratum for the attachment of organisms. to examine the effectiveness of this stabilization and hence the environmental compatibility of the block materials, heavy metal (Cd, Cr, Cu, Pb, Mn, Ni, Zn) content of the blocks has been monitored routinely over two years, to determine leaching rates. Sectional profiles indicate partial replacement of calcium content by magnesium. Associated with this there has also been some redistribution of heavy metals. Only in the case of cadmium has there been a detectable loss from the surface of blocks. Chromium and manganese concentrations appear to have increased. the metal content of the reef epibiota (including ascidians, Ascidia mentula; hydroids, Halecium spp.; bryozoans, Bugula spp. and red algae) growing on the ash blocks has been compared to that of epibiota attached to the concrete controls and surrounding sea-bed. to date no evidence of excess bioaccumulation of metals has been detected.

The physical integrity of the ash reef blocks has been maintained. There is evidence that the blocks are increasing in compressive strength.

An indication of the fishery enhancement potential of the experimental structure is given by the presence of eight commercially fished species (crustaceans and molluscs) including lobsters (Homarus gammarus).