The Distribution and Sources of Polycyclic Aromatic Hydrocarbons in Surface Sediments Along the Egyptian Mediterranean Coast

Coastal marine sediment samples were collected from 31 sampling stations along the Egyptian Mediterranean Sea coast. All sediment samples were analyzed to determine aliphatic and polycyclic aromatic hydrocarbons (PAHs) as well as total organic carbon (TOC) contents and grain size analysis. Total concentrations of 16 EPA-PAHs in the sediments were varied from 88 to 6338 ng g⁻¹ with an average value of 154 ng g⁻¹ (dry weight). However, the concentrations of total aliphatic were varied from 1.3 to 69.9 ng g⁻¹ with an average value of 15.6 ng g⁻¹ (dry weight). The highest contents of PAHs were found in the Eastern harbor (6338 ng g⁻¹), Manzala (5206 ng g⁻¹) and El-Jamil East (4895 ng g⁻¹) locations. Good correlations observed between a certain numbers of PAH concentrations allowed to identify its origin. The average total organic carbon (TOC) percent was varied from 0.91 to 4.54%. Higher concentration of total pyrolytic hydrocarbons (∑COMB) than total fossil hydrocarbons (∑PHE) declared that atmospheric fall-out is the significant source of PAHs to marine sediments of the Egyptian Mediterranean coast. The selected marked compounds, a principal component analysis (PCA) and special PAHs compound ratios (phenanthrene/anthracene vs fluoranthene/pyrene; ∑COMB/∑EPA-PAHs) suggest the pyrogenic origins, especially traffic exhausts, are the dominant sources of PAHs in most locations. Interferences of rather petrogenic and pyrolytic PAH contaminations were noticed in the harbors due to petroleum products deliveries and fuel combustion emissions from the ships staying alongside the quays.     

Evaluation of Tire-Derived Fuel for Use in Nitrogen Oxide Reduction by Reburning

ABSTRACT

Tire-derived fuel (TDF) was tested in a small-scale (44 kW or 150,000 Btu/hr) combustor to determine its feasibility as a fuel for use in reburning for control of nitrogen oxide (NO). TDF was gravity-fed into upward flowing combustion gases from a primary natural gas flame doped with ammonia to simulate a high NO combustion process. Emissions of NO, oxygen, carbon dioxide, carbon monoxide, and particulate matter were measured. The tests varied the nominal primary NO level from 600 to 1,200 ppm and the primary stoichiometry from 1.1 to 1.2, and used both natural gas and TDF as reburn fuels. The reburn injection rate was varied to achieve 8–20% of the total heat input from the reburn fuel. NO emissions reductions ranged between 20 and 63% when using TDF, depending upon the rate of TDF injection, primary NO, and primary stoichiometry. NO emission reductions when using natural gas as the reburn fuel were consistently higher than those when using TDF. While additional work remains to optimize the process and evaluate costs, TDF has been shown to have the potential to be a technically viable reburning fuel.     

Application of an indicator based on taxonomic relatedness of ciliated protozoan assemblages for marine environmental assessment

Introduction  

Ciliated protozoa play important roles in aquatic ecosystems especially regarding their functions in micro-food web and have many advantages in environmental assessment compared with most other eukaryotic organisms. The aims of this study were focused on analyzing the application of an indicator based on taxonomic relatedness of ciliated protozoan assemblages for marine environmental assessment.     

Low‐concentration hydrogen peroxide decontamination for Bacillus spore contamination in buildings

Remediation and recovery efforts after a release of Bacillus anthracis (anthrax) spores may be difficult and costly. In addition, response and recovery technologies may be focused on critical resources, leaving the small business or homeowner without remediation options. This study evaluates the efficacy of relatively low levels of hydrogen peroxide vapor (HPV) delivered from off‐the‐shelf equipment for the inactivation of Bacillus spores within an indoor environment. Decontamination evaluations were conducted in a house using both Bacillus atrophaeus var. globigii (Bg; as surrogates for B. anthracis) inoculated on the carpet and galvanized metal as coupons and Geobacillus stearothermophilus (Gs) as biological indicators on steel. The total decontamination time ranged from 4 to 7 days. Using the longer exposure times, low concentrations of HPV (average levels below 20 parts per million) effectively inactivated Bg and Gs spores on the materials tested. The HPV was generated with commercial humidifiers and household‐strength hydrogen peroxide solutions. The presence of home furnishings did not have a significant impact on HPV efficacy. This simple, inexpensive, and effective decontamination method could have significant utility for remediation following a B. anthracis spore release, such as following a terrorist attack.     

Green energy generation by pressure retarded osmosis: State of the art and technical advancement—review

Pressure-retarded osmosis (PRO) is a method for converting salinity gradients to power by allowing water to flow through a semi-permeable membrane against an applied hydraulic pressure. PRO already has a long history, starting from the middle of the last century, and has rapidly improved in recent years. In this paper, we present a historical development of PRO since its inception: the development of this renewable energy process has gone through several stages, depending on technological developments, worldwide energy demands, and environmental concerns. The technological progress of the process is also studied, as well as its cost viability and environmental impact. Finally, some ideas to further develop the PRO process and mitigate its detrimental effects are discussed.     

Can body-size patterns of ciliated zooplankton be used for assessing marine water quality? A case study on bioassessment in Jiaozhou Bay, northern Yellow Sea

Introduction

In order to reveal the potential relationships between body-size patterns of microzooplankton and environmental status, the spatial patterns in body-size spectra of ciliated zooplanktons were studied based on an annual dataset in a bay of the Yellow Sea, northern China.

Materials and methods

A total of 120 samples were collected at a depth of 1?m from each of five sampling sites with a spatial gradient of environmental stress from June 2007 to May 2008. A range of physico-chemical variables were measured synchronously for comparison with biotic parameters.

Results

The spatial body-size patterns of ciliated zooplankton represented significant differences among the five sites, and were significantly correlated with the changes of physico-chemical parameters, especially salinity, dissolved oxygen and nutrients. Two paired indices, the average body-size distinctness (AvBSD) and the variation in body-size distinctness (VarBSD), were proposed based on the trait resemblances among ciliate species in body-size pattern. The paired measures showed a clear decreasing trend of departure from the expected body-size spectra in response to water quality status.

Conclusion

These results suggest that the body-size pattern of ciliated zooplankton might be used as a potential indicator of marine water quality.     

Levels, distribution, and risk assessment of organochlorines in surficial sediments of the Red Sea coast, Egypt

The analyses of environmentally persistent pollutants like polychlorinated biphenyls (PCBs), hexachlorocyclohexane (HCH) isomers, and dichlorodiphenyltrichloroethane (DDT) and its metabolites in surficial sediment samples collected from 17 locations along with the coast of the Red Sea in Egypt were carried out using gas chromatography–mass spectrometry. Several potential organic contaminants from agricultural (e.g., DDT and its breakdown products, lindane, endrin, dieldrin, and endosulfan) and industrial (PCBs) sources were measured. The levels of 20 organochlorine pesticides (OCPs) and ten PCB congeners in sediment collected from 17 stations along ~1,200 km were investigated. Concentrations of PCBs, HCHs, DDTs, and cyclodienes ranged from 0.40 to 6.17, 0.01 to 0.09, n.d. to 0.46, and 0.08 to 0.90 ppb dry weight. Two statistical programs were applied on the data (principal component analysis, PCA, and cluster analysis, CA), and it was concluded that it is impossible to predict the distribution patterns of the OCPs in a contaminated area. Risk assessment of the organochlorines contaminated in the sediments of the studied area was investigated.     

Comparative study of the sensitivity to cadmium of two populations of Gambusia affinis from two different sites

This study aims to demonstrate the influence of animals' origin on their sensitivity toward heavy metals. For this purpose, we compared LC(50) of cadmium in two populations of Gambusia affinis captured in two geographically isolated environments in the east of Tunisia; Oued El Gsil in the city of Monastir (S2) and Oued Chenini in the region of Gabes (S1). Although physicochemical parameters of the water (pH, dissolved oxygen and salinity) are similar in the two studied sites, cadmium concentrations in water, sediments and fish tissues from S1 are significantly higher (P < 0.01) than those from S2, 48-h and 96-h LC(50) of the (S1) population are significantly higher than those from S2. In the same way, the offspring of the polluted site (S1) population exhibit 48-h and 96-h LC(50) values much higher than those of the reference site (S2) population. These results show that the population of the Gabes region is more resistant to cadmium than that of the Monastir region and that this resistance could have a genetic basis. These results indicate the influence of the origin of animals that has to be taken into account not only in laboratory toxicity tests, but also in field ecotoxicological studies.     

Biosorption of Direct Yellow 12 from aqueous solution using green alga Ulva lactuca

The potential of commonly available green alga Ulva lactuca was investigated as viable biomaterials for removal of synthetic azo dye (Direct Yellow 12, DY-12) from aqueous solution. The results obtained from the batch experiments revealed that the ability of the U. lactuca to remove DY-12 from its aqueous solution was dependent on the dye concentration, pH, and algal biomass but less dependent on the particle size of the U. lactuca. The equilibrium conditions and kinetics of adsorption were investigated, and the adsorption kinetic was consistent with the pseudo-second-order model (R²=1). The adsorption isotherm followed only the Freundlich model with a correlation coefficient R²=0.99. This study demonstrated that the U. lactuca could be used as an effective biosorbent for the removal of DY-12 from its aqueous solution.