Design and validation of a practical index for trauma assessment

In the past 20 years a variety of indices have been suggested for measuring the severity of trauma, however none of them meets the requirement of being a simple and objective instrument that can be utilized efficiently by lay persons and providers of health services without previous experience in triaging. A new system has been proposed which meets this requirement and which has been validated with 197 injured persons at the emergency ward of the Valle University Hospital in Call, Colombia. The instrument showed a high level of concordance with the conventional triaging method and classifies victims into four categories: critical with recovery unlikely, critical but recoverable, moderately serious, and ambulatory. There is discussion on the reliability of this instrument and it is recommended that it be validated with victims from larger disasters. Regardless, it has the advantage of being specific and free of the subjectivity that characterizes other indices.     

Suspended particulates and bioaerosols emitted from an agricultural non-point source

Suspended particulate and bioaerosol levels were measured at three sites downwind of an agricultural non-point source during the wheat harvesting season. Suspended particulates were detected at mean values ranging from 10000 to 2420 micrograms m-3 at distances of from 20 to 60 m downwind of the source, respectively. Airborne viable bacterial counts were recorded at mean values ranging between 10(4) and 10(6) colony forming units (cfu) m-3, whereas, Gram negative (Gram -ve) bacteria varied between 10(3) and 10(5) cfu m-3. Fungi levels were detected at mean values varying between 10(5) and 10(6) cfu m-3. However, streptomycetes were found at lower counts than those recorded for viable bacteria and fungi. Total viable bacteria, Gram -ve bacteria, fungi and streptomycetes associated hay fragments were determined at mean values of 1.5 x 10(6), 1.6 x 10(3), 2.2 x 10(4) and 6 x 10(3) cfu g-1 of hay, respectively. Cladosporium, white and red yeasts as well as Alternaria were the predominant airborne fungi, whereas, Alternaria was the dominant species associated with hay fragments. Pseudomonas, Acinetobacter and Enterobacteriaceae were the dominant Gram -ve bacteria. The most common fungal genera, such as Cladosporium and Fusarium (minor short axis), as well as Streptomyces species have an aerodynamic diameter (dae) of less than 5 microns, which can penetrate and deposit in the alveoli. Farmers and nearby residents are exposed to high levels of organic dust and bioaerosols during the wheat harvesting season. This may cause health problems in exposed persons based on toxic or allergic reactions.     

Simultaneous determination of parathion and p-nitrophenol in vegetable tissues by derivative spectrophotometry

A first derivative spectrophotometric method has been developedfor the determination of parathion and p-nitrophenol in vegetabletissues. Ethanol was used as solvent for extracting the compoundsfrom the tissues and subsequently the samples were evaluated against a vegetable tissue blank, directly by derivative spectrophotometry. The simultaneous determination of these compounds can be carried out using the zero-crossing approach for parathion at 253.0 nm and for p-nitrophenol at 273.1 nm. In the samples each analyte was determined in the presence of one another in the ranges between 4.9 to 3883.5 g g^-1 forparathion and 4.9 to 3285.3 g g^-1 for p-nitrophenol.The detection limits (3) were found to be 1.5 and 1.4 g g^-1 for parathion and p-nitrophenol, respectively. The relative standard deviations were in all instances less than1.8%. The proposed method was applied to the determination ofthe analytes in spiked leafs of corn. The results show a goodrecovery and they are in agreement with those obtained bypolarography.     

Indoor and outdoor formaldehyde concentrations in homes in residential areas in Greater Cairo

Indoor and outdoor measurements of formaldehyde were conducted at seven flats located in residential areas in Greater Cairo, during spring and summer seasons 1999. The mean daytime formaldehyde concentrations in kitchens, bedrooms and living rooms were 89, 100 and 100 ppb, respectively, in the seven flats. Significant positive correlations were found between the concentrations of formaldehyde found in these three rooms. On the other hand, no significant differences were found between the mean formaldehyde concentrations in these three rooms. The maximum mean concentration of formaldehyde (147 ppb) was recorded in a new flat, while the minimum concentration (43 ppb) was observed in an old flat. The maximum hourly and daytime concentrations were 350 and 225 ppb, respectively. Air temperature, relative humidity and the age of the flat are factors affecting the emission and concentration of formaldehyde. The maximum indoor and outdoor formaldehyde concentrations were recorded during the summer season. During the spring, 38% of the samples indicated that the concentration of formaldehyde in the seven flats exceeded 0.1 ppm, the American Society of Heating, Refrigerating, and Air Conditioning Engineers' (ASHRAE) standard; in the summer, this figure increased to 53%.     

Evaluation of airborne lead in the welding working environment

Manual and automatic welding machines (which use leaded alloys) are considered to be important sources of the emission of lead fumes into the general air of the working environment. Three workplaces at a television factory were selected for the present study, to determine the control class of the working unit. The concentrations of conventional measurements ("A" sampling points) were lower than the administrative control level (statutory standard of lead, 150 microg m(-3)), whereas the maximum concentration of 264.1 microg m(-3) ("B" sampling point) was higher at one working unit than the administrative control level. However, the control classes varied between class III (bad) and class I (good).     

关于环境监测的抽样检查

关于环境监测的抽样检查ＡｂｏｕｔＥｘａｍｉｎａｔｉｏｎｏｆＥｎｖｉｒｏｎｍｅｎｔａｌＭｏｎｉｔｏｒｉｎｇＳａｍｐｌｉｎｇ楼晓舟（江苏省太仓市环境监测站太仓２１５４００）环境监测抽样检查的目的，一是决定采样频次及测得的数据是否合格，另一是采样及测定过程...     

Utilisation of bubble resonance phenomena to improve gas–liquid contact

 In several branches of science and technology a gaseous phase is dispersed into a liquid in the form of bubbles, a gaseous component then dissolves into the liquid and subsequently undergoes chemical reaction. The overall process performance can be improved substantially when the area of gas–liquid contact is increased. By subjecting the liquid phase to low frequency vibrations, the bubbles are shown to suffer significant breakage, induced by resonance. When the vibration is properly tuned, the interfacial area is found to increase by a factor of 1.8–2.4, depending on the properties of the liquid. Resonance-induced bubble breakage phenomena have a great potential for improving the rates of chemical processes involving fast reactions, with minimal energy input. Received: 7 July 2000 / Accepted in revised form: 28 August 2000     

对当前我国中小城镇污水处理若干问题的思考

本文针对我国目前中小城镇的发展状况，提出了发展中小城镇污水处理事业的一些看法与建议。     

CE-QUAL-W2模型在上海市大型饮用水水库中的应用

通过二维纵向横向平均水动力学和水质模型（CE-QUAL-W2模型）来模拟上海大型饮用水水库的水质状况。模型初步模拟了该水库中不同深度水层的水质状况,使用2011年1月到2011年11月单月（包含一年四季代表性）的数据对模型主要参数进行校正。结果显示,水质状况的模型计算值与实测值比较接近,与实际情况较吻合,AME和RMS值较好,预测该水库的水质是Ⅰ～Ⅱ类。通过本文对该（CE-QUAL-W2模型）的应用得出的结果显示,该模型也适合模拟一些具有湖泊特性的河流,尤其适用于对水体的水质评估。     

Soil amendments, plant age, and intercropping impact p,p'-DDE bioavailability to Cucurbita pepo

Field experiments were conducted to optimize the phytoextraction of weathered p,p'-DDE (p,p'-dichlorodiphenyldichloroethylene) by Cucurbita subspecies. The effects of two soil amendments, mycorrhizae or a biosurfactant, on p,p'-DDE accumulation was determined. Also, p,p'-DDE uptake was assessed during plant growth (12, 26, 38, and 62 d), and cultivars that accumulate weathered p,p'-DDE were intercropped with cultivars known not to have that ability. Cucurbita pepo L. ssp. pepo accumulated large amounts of the contaminant, having stem bioconcentration factors, amounts of p,p'-DDE translocated, and contaminant phytoextraction that were 14, 9.9, and 5.0 times greater than C. pepo L. ssp. ovifera (L.) D.S. Decker, respectively. During 62 d, the stem BCF (bioconcentration factor) for p,p'-DDE in subspecies pepo remained constant and the total amount of contaminant accumulated was correlated with plant biomass (r(2) = 0.86). For subspecies ovifera, the stem BCF was highest at 12 d (1.5) but decreased to 0.39 by 62 d, and p,p'-DDE removal was not correlated with plant biomass. Mycorrhizal inoculation increased p,p'-DDE accumulation by both subspecies by an average 4.4 times. For subspecies pepo, mycorrhizae increased the percentage of contaminant extracted from 0.72 to 2.1%. Biosurfactant amendment also enhanced contaminant accumulation by both subspecies, although treatment reduced subspecies ovifera biomass by 60%. The biosurfactant had no effect on the biomass of subspecies pepo, increased the average contaminant concentration by 3.6-fold, and doubled the overall amount of p,p'-DDE removed from the soil. Soil amendments that enhance the mobility of weathered persistent organic pollutants will significantly increase the amount of contaminant phytoextraction by Cucurbita pepo.