浙江建德块状硫化物矿床地球化学特征及其成因意义

浙江建德块状硫化物矿床，以Cu＞Zn＞Ph为特征。鉴于Cu、Ph和Zn三元素的地球化学行为和海底喷流作用的固有特性，它们在横向上和纵向上均具独特的分带性，显示出旋回结构。对黄铁矿中特征元素元素比值、成矿温度以及铅同位素组成等方面的研究表明，该矿床乃同生沉积作用的产物，而非岩浆热液成矿。     

Numerical modeling of radionuclide migration in porous media with nonequilibrium sorption

Ｎｕｍｅｒｉｃａｌｍｏｄｅｌｉｎｇｏｆｒａｄｉｏｎｕｃｌｉｄｅｍｉｇｒａｔｉｏｎｉｎｐｏｒｏｕｓｍｅｄｉａｗｉｔｈｎｏｎｅｑｕｉｌｉｂｒｉｕｍｓｏｒｐｔｉｏｎ￥ＣｈｅｎＪｉａｊｕｎ；ＤａｉＪｉｅ（ＤｅｐａｒｔｍｅｎｔｏｆＥｎｖｉｒｏｎｍｅｎｔａｌＥｎ...     

计及风速与风机故障相关性的概率潮流计算

针对计及风速与风机故障不确定性及相关性的风电并网电力系统概率潮流计算问题,基于Nataf变换建立了能够同时考虑风速、风机故障不确定性和相关性的风电场出力模型,提出一种可灵活处理风速与风机故障相关性的MonteCarlo概率潮流计算方法,并引入“拉丁超立方抽样”技术提高抽样效率,降低计算复杂度。仿真结果表明:该方法能反映风电场出力的实际情况,合理评估风电并网对电力系统概率潮流的影响,有助于风电场的选址及电网规划。     

BiOCl/SiO2/Fe3O4复合材料可见光催化去除水中亚甲基蓝

以FeCl_3·6H_2O、FeCl_2·4H_2O、(C_2H_5)_4SiO_4、Bi(NO_3)_3·5H_2O、KCl为主要原料,采用化学共沉淀法和水热法制备了BiOCl/SiO_2/Fe_3O_4光催化剂,并对其进行EDS、TEM、XRD、FT-IR、UV-Vis表征,最后通过亚甲基蓝降解实验,研究了催化剂在合成过程中pH及催化剂投加量对其光催化性能的影响.结果表明,在pH=6、催化剂初始投加量为0.5 g·L~(-1)时,对亚甲基蓝的可见光催化效果最佳,光照120 min后对10 mg·L~(-1)的亚甲基蓝溶液的脱色率达到93.2%.BiOCl/SiO_2/Fe_3O_4经过简单的无水乙醇和水洗后,可高效重复利用4次.综合表明,BiOCl/SiO_2/Fe_3O_4是一种在处理染料废水中具有应用前景的磁性光催化剂.     

CO气体激光检测仪中基于FPGA的信号源设计

在激光检测仪的系统设计中,要求信号源四路波形同步异频发生,且有移相、倍频、波形叠加等要求。利用FPGA技术完成满足以上要求的直接数字频率合成器(DDS)的设计。在实现中选用Altera公司的FPGA芯片EP2C8Q208C8为主芯片进行设计,充分利用了该芯片的超大集成性和快速性。在改进的DDS算法结构的基础上,系统的复杂度降低,更趋于模块化,产生的波形频率更准确。     

Source attribution for mercury deposition with an updated atmospheric mercury emission inventory in the Pearl River Delta Region,China

Estimated anthropogenic Hg emission was 11.9 tons in Pearl River Delta for 2014. Quantifying contributions of emission sources helps to provide control strategies. More attentions should be paid to Hg deposition around the large point sources. Power plant, industrial source and waste incinerator were priorities for control. A coordinated regional Hg emission control was important for controlling pollution. We used CMAQ-Hg to simulate mercury pollution and identify main sources in the Pearl River Delta (PRD) with updated local emission inventory and latest regional and global emissions. The total anthropogenic mercury emissions in the PRD for 2014 were 11,939.6 kg. Power plants and industrial boilers were dominant sectors, responsible for 29.4 and 22.7%. We first compared model predictions and observations and the results showed a good performance. Then five scenarios with power plants (PP), municipal solid waste incineration (MSWI), industrial point sources (IP), natural sources (NAT), and boundary conditions (BCs) zeroed out separately were simulated and compared with the base case. BCs was responsible for over 30% of annual average mercury concentration and total deposition while NAT contributed around 15%. Among the anthropogenic sources, IP (22.9%) was dominant with a contribution over 20.0% and PP (18.9%) and MSWI (11.2%) ranked second and third. Results also showed that power plants were the most important emission sources in the central PRD, where the ultra-low emission for thermal power units need to be strengthened. In the northern and western PRD, cement and metal productions were priorities for mercury control. The fast growth of municipal solid waste incineration were also a key factor in the core areas. In addition, a coordinated regional mercury emission control was important for effectively controlling pollution. In the future, mercury emissions will decrease as control measures are strengthened, more attention should be paid to mercury deposition around the large point sources as high levels of pollution are observed.     

冷冻分离法去除水中污染物的对比研究

分别以含Ca2＋、Mg2＋、Na＋等无机离子水样和含有溴氨酸（1-氨基-4-溴-蒽醌-2-磺酸钠）的水溶液、UIImann缩合反应产生废水为研究对象,采用静态渐进冷冻法分别在人工条件下进行实验,分析并对比了冷冻法对水体中污染物的去除效果和规律。结果表明：冷冻法可以有效去除水体中各种污染物,由于污染物自身结构不同,冷冻法对污染物分离有选择性,对有机物的去除高于无机离子,对单一污染物去除高于复杂废水。     

非饱和土壤轻油污染多相流研究进展

轻油泄漏到地下后 ,在非饱和土壤中水、气、油三相相互作用、相互影响 ,共同构成多相流体系统。在简要分析轻油污染问题的产生、危害以及轻油泄漏在地表以下运移方式的基础上 ,介绍并总结了近些年来国内外土壤轻油污染有关的多相流研究方面的进展 ,包括国外的模型研究成果、国内外试验研究方法和研究成果 ,并指出目前研究中存在的问题和需要进一步探讨的方向     

Understanding and addressing the environmental risk of microplastics

Over the past decades, the plastic production has been dramatically increased. Indeed, a category of small plastic particles mainly with the shapes of fragments, fibers, or spheres, called microplastics (particles smaller than 5 mm) and nanoplastics (particles smaller than 1 μm) have attracted particular attention. Because of its wide distribution in the environment and potential adverse effects to animal and human, microplastic pollution has been reported as a serious environment problem receiving increased attention in recent years. As one of the commonly detected emerging contaminants in the environment, recent evidence indicates that the concentration of microplastics show an increasing trend, for the reason that up to 12.7 million metric tons of plastic litter is released into aquatic environment from land-based sources each year. Furthermore, microplastic exposure levels of model organisms in laboratory studies are usually several orders of magnitude higher than those found in environment, and the microplastics exposure conditions are also different with those observed in the environment. Additionally, the detection of microplastics in feces indicates that they can be excreted out of the bodies of animal and human. Hence, great uncertainties might exist in microplastics exposure and health risk assessment based on current studies, which might be exaggerated. Policies reduce microplastic emission sources and hence minimize their environmental risks are determined. To promote the above policies, we must first overcome the technical obstacles of detecting microplastics in various samples.     

Enhanced nitrogen removal upon the addition of volatile fatty acids from activated sludge by combining calcium peroxide and low-thermal pretreatments

This study investigated a combined low-thermal and CaO₂ pretreatment to enhance the volatile fatty acid (VFA) production from waste activated sludge (WAS). The fermentative product was added to a sequencing batch reactor (SBR) as an external carbon source to enhance nitrogen removal. The results showed that the combined pretreatment improved WAS solubilization, releasing more biodegradable substrates, such as proteins and polysaccharides, from TB-EPS to LB-EPS and S-EPS. The maximum VFA production of 3529 ± 188 mg COD/L was obtained in the combined pretreatment (0.2 g CaO₂/g VS + 70 °C for 60 min), which was 2.1 and 1.4-fold of that obtained from the sole low-thermal pretreatment and the control test, respectively. Consequently, when the fermentative liquid was added as an external denitrification carbon source, the effluent total nitrogen decreased to Class A of the discharge standard for pollutants in rural wastewater treatment plants in most areas of China.