Prompting safety-belt use in the context of a belt-use law: the flash-for life revisited

PROBLEM: Safety-belt use reduces motor vehicle crash-related morbidity and mortality, yet an estimated 18% of drivers do not consistently buckle up (NHTSA, 2005). In 1985, Geller and colleagues developed an interpersonal Flash-for-Life prompt that increased belt use among 22% of 1,087 unbuckled drivers (Geller, Bruff, & Nimmer, 1985). METHOD: The Flash-for-Life intervention was re-introduced at a large university with high safety-belt use (i.e., 80%). College students stood at parking-lot entrance/exits and "flashed" signs with the message, "Please Buckle Up, I Care" to unbuckled drivers. RESULTS: Of 427 unbuckled drivers observed, 30% of these complied with the prompt. Male drivers were significantly more likely to comply with prompts delivered by females. DISCUSSION: Compliance was higher than in the 1985 study, indicating a high baseline rate of safety-belt use does not negate potential beneficial influence of a prompting intervention. This intervention is particularly effective with college-aged males, a sub-group of the driving population least likely to buckle-up. IMPACT ON INDUSTRY: A simple behavioral prompt could be used at most industrial complexes to increase safety-belt use among vehicle occupants who are not buckled-up.     

Processing and Morphology Impacts on Mechanical Properties of Fungal Based Biopolymer Composites

Fungal based biopolymer matrix composites with lignocellulosic agricultural waste as the filler are a viable alternative for some applications of synthetic polymers. This research provides insight into the impact of the processing method and composition of agriwaste/fungal biopolymer composites on structure and mechanical properties. The impact of nutrition during inoculation and after a homogenization step on the three-point bend flexural modulus and strength was determined. Increasing supplemental nutrition at inoculation had little effect on the overall composite strength or modulus; however, increasing carbohydrate loading after a homogenization step increased flexural stress at yield and bulk flexural modulus. The contiguity of the network formed was notably higher in the latter scenario, suggesting that the increase in modulus and strength of the final composite after homogenization was the result of contiguous hyphal network formation, which improves the integrity of the matrix and the ability to transfer load to the filler particles.     

Photophysical and photochemical properties of the pharmaceutical compound salbutamol in aqueous solutions

Salbutamol is a potent β₂-adrenergic receptor agonist widely used in the treatment of bronchial asthma and chronic obstructive pulmonary disease. An increasing number of studies have detected salbutamol in natural water systems worldwide. Studies have shown that sunlight degrades salbutamol resulting in the formation of products; some showing higher toxicity to bacteria Vibrio fischeri than the parent compound. In this contribution, steady-state absorption and emission techniques, high-performance liquid chromatography, and transient absorption spectroscopy are used to investigate the photochemistry of salbutamol in aqueous buffer solutions at controlled pH values. Ground- and excited-state calculations that include solvent effects are performed to guide the interpretation of the experimental results. Salbutamol is sensitive to UVB light absorption in the pH range from 3 to 12, forming products that absorb light at longer wavelengths than the parent compound. Quantum yields of degradation reveal that the deprotonated species is 10-fold more photo-active than the protonated species. In line with this result, the fluorescence quantum yield of the protonated species is more than an order of magnitude higher than that of the deprotonated species. Transient absorption spectroscopy shows that population of the triplet state occurs with a rate constant of 7.1 × 10⁸ s⁻¹ in the protonated species, while a rate constant of 1.7 × 10¹⁰ s⁻¹ is measured for the deprotonated species. While degradation of the deprotonated species is not affected by the presence of molecular oxygen, a twofold increase in the photodegradation yield of the protonated species in air-saturated conditions is observed.     

Spatial and temporal characterization of PM2.5 mass concentrations in California, 1980-2007

Systematic measurement of fine particulate matter (aerodynamic diameter less than 2.5 microm [PM2.5]) mass concentrations began nationally with implementation of the Federal Reference Method (FRM) network in 1998 and 1999. In California, additional monitoring of fine particulate matter (PM) occurred via a dichotomous sampler network and several special studies carried out between 1982 and 2002. The authors evaluate the comparability of FRM and non-FRM measurements of PM2.5 mass concentrations and establish conversion factors to standardize fine mass measurements from different methods to FRM-equivalent concentrations. The authors also identify measurements of PM2.5 mass concentrations that do not agree with FRM or other independent PM2.5 mass measurements. The authors show that PM2.5 mass can be reconstructed to a high degree of accuracy (r2 > 0.9; mean absolute error approximately 2 microg m(-3)) from PM with an aerodynamic diameter < or =10 microm (PM10) mass and species concentrations when site-specific and season-specific conversion factors are used and a statewide record of fine PM mass concentrations by combining the FRM PM2.5 measurements, non-FRM PM2.5 measurements, and reconstructions of PM2.5 mass concentrations. Trends and spatial variations are evaluated using the integrated data. The rates of change of annual fine PM mass were negative (downward trends) at all 22 urban and 6 nonurban (Interagency Monitoring of Protected Visual Environments [IMPROVE]) monitoring locations having at least 15 yr of data during the period 1980-2007. The trends at the IMPROVE sites ranged from -0.05 to -0.25 microg m(-3) yr(-1) (median -0.11 microg m(-3) yr(-1)), whereas urban-site trends ranged from -0.13 to -1.29 microg m(-3) yr(-1) (median -0.59 microg m(-3) yr(-1)). The urban concentrations declined by a factor of 2 over the period of record, and these decreases were qualitatively consistent with changes in emissions of primary PM2.5 and gas-phase precursors of secondary PM. Mean PM2.5 mass concentrations ranged from 3.3 to 7.4 microg m(-3) at IMPROVE sites and from 9.3 to 37.1 microg m(-3) at urban sites.     

On the influence of environmental factors on harvest: the French Guiana shrimp fishery paradox

Environmental Economics and Policy Studies - The purpose of this paper is to investigate the environmental nature of the French Guiana shrimp fishery dynamics through an empirical analysis. To do...     

Regional status assessment of stony corals in the US Virgin Islands

States may protect coral reefs using biological water quality standards outlined by the Clean Water Act. This requires biological assessments with indicators sensitive to human disturbance and regional, probability-based survey designs. Stony coral condition was characterized on a regional scale for the first time in the nearshore waters of the US Virgin Islands (USVI). Coral composition, abundance, size, and health were assessed at 66 stations in the St. Croix region in fall 2007 and at 63 stations in the St. Thomas and St. John region in winter 2009. Indicators were chosen for their sensitivity to human disturbance. Both surveys were probability-based (random) designs with station locations preselected from areas covered by hardbottom and coral reef substrate. Taxa richness was as high as 21 species but more than half the area of both regions exhibited taxa richness of <10 species in the 25 m² transect area. Coral density was as high as 5 colonies m^?2 but more than half the area of both regions had <2 colonies m^?2. Both regions showed similar dominant species based on frequency of occurrence and relative abundance. Because of large colony sizes, Montastrea annularis provided more total surface area and live surface area than more abundant species. The surveys establish baseline regional conditions and provide a foundation for long-term regional monitoring envisioned by the USVI Department of Planning and Natural Resources. The probabilistic sampling design assures the data can be used in Clean Water Act reporting.     

Testing the feasibility of a hypothetical whaling‐conservation permit market in Norway

A cap‐and‐trade system for managing whale harvests represents a potentially useful approach to resolve the current gridlock in international whale management. The establishment of whale permit markets, open to both whalers and conservationists, could reveal the strength of conservation demand, about which little is known. This lack of knowledge makes it difficult to predict the outcome of a hypothetical whale permit market. We developed a bioeconomic model to evaluate the influence of economic uncertainty about demand for whale conservation or harvest. We used simulations over a wide range of parameterizations of whaling and conservation demands to examine the potential ecological consequences of the establishment of a whale permit market in Norwegian waters under bounded (but substantial) economic uncertainty. Uncertainty variables were slope of whaling and conservation demand, participation level of conservationists and their willingness to pay for whale conservation, and functional forms of demand, including linear, quadratic, and log‐linear forms. A whale‐conservation market had the potential to yield a wide range of conservation and harvest outcomes, the most likely outcomes were those in which conservationists bought all whale permits.     

Applying chemical oxidation technologies at NAPL‐impacted sites to facilitate risk‐based closure

In situ chemical oxidation (ISCO) has found widespread remedial application at sites that lack nonaqueous‐phase liquid (NAPL) or have a relatively small amount of contaminant mass. Historically, its use has been limited at sites with large amounts of NAPL, primarily because of cost considerations. Proper application of ISCO can expand its use at sites with substantial amounts of NAPL—particularly where it is being used to selectively remediate higher toxicity fractions or reduce the mobility of the NAPL itself through artificial weathering. Alone or in conjunction with conventional technologies, chemical oxidation provides a means for reducing the risk associated with NAPL and potentially closing impacted sites without completely removing NAPL. © 2010 Wiley Periodicals, Inc.     

Biosorption of copper (II) from chemical mechanical planarization wastewaters

Copper Chemical Mechanical Planarization (Cu-CMP) is a critical step in integrated circuit (IC) device manufacturing. CMP and post-CMP cleaning processes are projected to account for 30-40% of the water consumed by IC manufacturers in 2003. CMP wastewater is expected to contain increasing amounts of copper as the industry switches from Al-CMP to Cu-CMP causing some IC manufacturers to run the risk of violating discharge regulations. There are a variety of treatment schemes currently available for the removal of heavy metals from CMP wastewater, however, many introduce additional chemicals to the wastewater, have large space requirements, or are expensive. This work explores the use of microorganisms for waste treatment. A Staphylococcus sp. of bacteria was isolated and studied to determine the feasibility for use in removing copper from Cu-CMP wastewater. A model Cu-CMP wastewater was developed and tested, as well as actual Cu-CMP wastes. Continuous-flow packed column experiments were performed to obtain adsorption data and show copper recovery from the waste. A predictive, empirical model was used to accurately describe Cu removal. Additionally, the immobilized cells were regenerated, allowing for the concentration and potential recovery of copper from the wastewater.