Feasibility study of a passive aeration reactor equipped with vertical pipes for compost stabilization of cow manure.

Pilot-scale composting was carried out with cow manure to evaluate the performances of two passive aeration systems: a conventional passive aeration system equipped with horizontal pipes and an unusual passive aeration method based on air delivery by means of vertical pipes. The effects of both types of passive aeration apparatus were investigated in order to determine the degree of composting rate by continuously monitoring temperature, moisture content, organic matter, electrical conductivity, pH and C/N ratio in the piles. Temperatures in the range of thermophily (55-65 degrees C) were reached in all runs within 1-2 days then lasting for about 1 week, a span long enough for pathogen abatement. Results suggest that passive aeration carried out by vertical pipes is more effective for air delivery into compost piles than conventional passive aeration of air adduction with horizontal pipes. The variation in the number of vertical pipes was revealed to be an important parameter for the control of composting rate and temperature. Composting rates estimated from the heat balance equation were substantially in agreement with those computed through the conversion ratio of total organic matter decrement. The conversion ratios and composting rates obtained in this study using passive aeration with vertical pipes were well aligned with those found using forced air delivery systems.     

Multi criteria decision analysis to develop an optimized municipal solid waste management scenario: a case study in Ulaanbaatar,Mongolia

Journal of Material Cycles and Waste Management - Since to 1990, Urbanization has occurred due to an increase in the number of unpredicted citizens and migration from the countryside to...     

Spatial simulation and LCA evaluation on the plastic waste recycling system in Tianjin

With the rapid economic development in China, the amount of plastic waste (PW) generated has greatly increased and much of the waste is currently not treated. To reduce greenhouse gas (GHG) emissions from recycling of PW, we estimated the PW flow and considered methods to improve the household PW recycling system in Tianjin by adjusting processes during transportation and establishing a PW recycling factory in Zi’ya Industrial Park. The goal of the study was to identify reasonable improvements for the recycling system and clarify the environmental load. Geographic information system (GIS) technology was used to simulate transport processes for comparing GHG emissions from the transport processes between the present case and an improved case. Life cycle assessment (LCA) was used to compare GHG emissions between a projected scenario and a baseline scenario. Estimated GHG emissions during transport processes in the improved case were reduced by about 12,197 t CO₂ eq per year compared to the present case, equivalent to about 65.9 % of the total emissions in the present case. GHG emissions in the projected scenario were about 101,738 t CO₂ eq less per year than the baseline scenario, equivalent to about 75.5 % of the total emissions in the baseline scenario.     

Intensification level of rice farming in Myanmar: implication for its sustainable development

This study aims to estimate the intensification of rice farming in Myanmar particularly due to chemical fertilizer application, using farm-level data obtained from field surveys conducted in the 2000s. Relatively high-input rice farming was found in dry season crop in the delta zone and the double crop in well-irrigated lowlands of the central dry zone. The chemical fertilizer used there was about 88–159 kg NPK (nitrogen, N; phosphate, P₂O₅; and potash, K₂O) ha⁻¹ (76–110 kg nitrogen (N) ha⁻¹), and the average paddy yield ranged from 2.8 to 3.5 ton ha⁻¹. On the other hand, nutrient input in survey sites of rain-fed lowland was between 11 and 53 kg NPK ha⁻¹ (5 and 36 kg N ha⁻¹), and the yield ranged from 1.1 to 2.3 ton ha⁻¹. The national average of paddy yield and nutrient input of fertilizer was roughly estimated to be around 2.4 ton ha⁻¹ and 60 kg NPK ha⁻¹, respectively. A gap was observed between these calculated values and the official statistics. A comparison of fertilizer use efficiency for rice production in Myanmar with that in China and Vietnam has shown that the efficiency in Myanmar has not declined to an inappropriate level even in its intensive ones. Rice production in Myanmar has room for increasing the yield by capital intensification. Nevertheless, considering its sustainability as well as productivity, further intensification in rice farming technology in irrigated lowlands of Myanmar may neither be the best nor the only way.     

Debromination of hexabromobenzene by its co-grinding with CaO

A hexabromobenzene (HBB, C6Br6) powder was subjected to co-grinding with excess CaO powder in air using a planetary ball mill to investigate mechanochemical debromination of the HBB sample. The reaction proceeds smoothly with an increase in both grinding time and molar ratio of CaO addition. The co-grinding enables us to debrominate HBB, forming CaBr2, C and CaCO3 besides excess CaO in the product. CaBr2 in the product tends to absorb moisture from the atmosphere to form CaBr2 x nH2O. The reaction yield is quantitatively evaluated by measuring the amount of water-soluble bromide through water washing and the amount of unreacted HBB through toluene washing. It is found that almost 100% of debromination is achieved by 6 h grinding with the molar ratio kept constant at 2:1. Radicals are detected in the ground products, possibly due to rupture in the covalent bonds of C-C and C-Br in HBB.     

Spatial distribution and vertical profile of polybrominated diphenyl ethers and hexabromocyclododecanes in sediment core from Tokyo Bay, Japan

Brominated flame retardants (BFRs), hexabromocyclododecanes (HBCDs) and polybrominated diethyl ethers (PBDEs) were detected in three sediment cores and six surface sediments of Tokyo Bay, Japan. HBCDs were detected for the first time in this region with concentrations ranging from 0.056 to 2.3 ng/g dry wt, implying their widespread contamination, even though their concentrations were lower than summation operatorPBDEs (di- to nona-BDEs) and BDE-209. Levels of these compounds were higher near to the highly populated industrial area of the bay implicating industrial and human activities as sources of these compounds. Summation operatorPBDEs increased in the sediment layer up to the mid-1990s and decreased afterwards, whereas BDE-209 showed an increasing trend until now, following the usage of different commercial BDE mixtures. HBCDs first appeared in the mid-1970s and increased until today. The annual surficial flux of HBCDs (0.62-2.4 ng/cm2/yr) is equal to summation operatorPBDEs (0.95-2.6 ng/cm2/yr) but lower than that of BDE-209 (17-58 ng/cm2/yr).     

Synthesis of Short-chain-length/Medium-chain-length Polyhydroxyalkanoate (PHA) Copolymers in Peroxisome of the Transgenic Arabidopsis Thaliana Harboring the PHA Synthase Gene from Pseudomonas sp. 61-3

In this paper, the photosynthetic production of short-chain-length/medium-chain-length polyhydroxyalkanoate (PHA) copolymers is reported. The wild-type and highly active doubly mutated PHA synthase 1 (S325T/Q481K, abbreviated ST/QK) genes from Pseudomonas sp. 61-3 were introduced into Arabidopsis thaliana. Peroxisome targeting signal 1 (PTS1) was used to target PHA synthases into the peroxisome to synthesize PHA from the intermediates of the β-oxidation pathway. The transgenic Arabidopsis produced PHA copolymers consisting of 40–57 mol% 3-hydroxybutyrate, 21–49 mol% 3-hydroxyvalerate, 8–18 mol% 3-hydroxyhexanoate, and 2–8 mol% 3-hydroxyoctanoate. The maximum PHA contents were 220μ g/g cell dry weight (cdw) in leaves, and 36μ g/g cdw in stems, respectively. The expression of the ST/QK mutated PHA synthase in leaves gene did not lead to significant difference in PHA content and monomer composition of PHAs, compared to the wild-type PHA synthase gene, suggesting that the supply of monomers may be a rate-determining step of PHA biosynthesis in the peroxisome. However, in stems, there were significant differences dependent on whether the wild-type or ST/QK mutated PHA synthase was expressed. These results suggest that tissue-specific monomer availability is important in determining the final mol% composition of PHA copolymers produced by the peroxisome in plants.     

Potential bioremediation of mercury-contaminated substrate using filamentous fungi isolated from forest soil

The use of filamentous fungi in bioremediation of heavy metal contamination has been developed recently. This research aims to observe the capability of filamentous fungi isolated from forest soil for bioremediation of mercury contamination in a substrate. Six fungal strains were selected based on their capability to grow in 25 mg/L Hg2+-contaminated potato dextrose agar plates. Fungal strain KRP1 showed the highest ratio of growth diameter, 0.831, thus was chosen for further observation.Identification based on colony and cell morphology carried out by 18S rRNA analysis gave a 98%match to Aspergillus flavus strain KRP1. The fungal characteristics in mercury(Ⅱ) contamination such as range of optimum pH, optimum temperature and tolerance level were 5.5–7 and 25–35℃ and 100 mg/L respectively. The concentration of mercury in the media affected fungal growth during lag phases. The capability of the fungal strain to remove the mercury(Ⅱ) contaminant was evaluated in 100 mL sterile 10 mg/L Hg2+-contaminated potato dextrose broth media in 250 mL Erlenmeyer flasks inoculated with 108spore/mL fungal spore suspension and incubation at 30℃ for 7 days. The mercury(Ⅱ) utilization was observed for flasks shaken in a 130 r/min orbital shaker(shaken) and nonshaken flasks(static) treatments. Flasks containing contaminated media with no fungal spores were also provided as control. All treatments were done in triplicate. The strain was able to remove 97.50%and 98.73% mercury from shaken and static systems respectively. A. flavus strain KRP1 seems to have potential use in bioremediation of aqueous substrates containing mercury(Ⅱ) through a biosorption mechanism.     

Transmission of ice-nucleating active bacteria from a prey reduces cold hardiness of a predator (Araneae: Theridiidae)

The influence of ice-nucleating active (INA) bacteria on cold hardiness of the house spider, Achaearanea tepidariorum, was determined by measuring the supercooling point (SCP) of hatchlings given either INA-bacteria-fed or bacteria-free prey (Drosophila melanogaster). Spiders that had eaten INA-bacteria-fed flies showed higher SCPs than those fed on bacteria-free flies. Through feeding, INA bacteria in the prey reduce the cold hardiness of spiders. This fact should be taken into account before using INA agents as a means of pest management.     

Degradation of monofluorophenols in water irradiated with gaseous plasma

Decomposition of aqueous monofluorophenols (MFPs) was investigated by contact glow discharge electrolysis (CGDE). During CGDE, both MFPs and the corresponding total organic carbon (TOC) in water were consumed smoothly, suggesting that carbon atoms of benzene nucleus could be eventually mineralized to inorganic carbon (IC). And all the fluorine atoms in the MFPs were equally converted to fluoride ions. Based on the primary intermediates from each starting materials, it showed that aromatic hydroxylation preferentially occurred at the para- or ortho- position to the phenolic OH group of each MFPs. The disappearance of both MFPs and TOC followed the first-order rate law. The apparent rate constants for the decay of MFPs were independent from the pK_a values of MFPs.