Association between air pollution and COVID-19 infection: evidence from data at national and municipal levels

Environmental Science and Pollution Research - The impact of high concentrations of air pollution on COVID-19 has been a major air quality and life safety issue in recent studies. This study aimed...     

矿热炉炉壳安装作业危险性分析

为减少事故损失,必须对矿热炉安装施工危险源进行分析。基于此,对矿热炉安装工序中最重要工序炉壳安装应用作业危险性分析进行分析。将炉壳安装作业分成3大部分,用鱼刺图分析方法进行分析,总结出矿热炉炉壳安装中事故发生的主要原因并提出对策措施,以预防和减少事故的发生。     

Exploration of Science Parks

1 DEVELOPMENT OF SCIENCE PARKSThe concept of science park originated in the US. Manyterms are used to describe science parks, such as researchpark, technology park, science centre, research centre,innovation centre, and with various combination of these(MacDonald, 1987). The first science park in the worldis Stanford Industrial Park established in 1951. In 1955,only seven companies were located in the park. By 1980there were ninety companies including Hewlett PackardCompany, whic…     

中国实施生态旅游认证的机遇与挑战

在界定生态旅游认证、分析建立生态旅游认证体系意义的基础上．对绿色环球21、澳大利亚的NEAP、厄瓜多尔的Smart Voyager等目前国际知名的认证体系进行了介绍．重点分析了中国实施生态旅游认证的机遇和面临的挑战，并对我国建立生态旅游认证体系的必要性及相关问题提出了建议。     

北部湾南流江流域土地覆盖及生物多样性模拟

以北部湾独流入海河流南流江流域为研究对象,基于研究区2000年和2015年遥感数据解译的土地利用数据以及社会经济等数据,采用CLUE-S模型对未来2030年生态保护情景、自然增长情景以及粮食安全情景的土地利用格局进行了模拟预测,在此基础上采用InVEST模型对流域过去和未来不同情景的生物多样性进行了评估,探讨了流域生物多样性的生境质量和生境退化程度.结果表明：2000~2015年南流江流域建设用地、园地、水域和未利用地呈现出增加趋势,其中建设用地的增幅最大,而耕地和林地减幅最大.流域土地系统中共存在着34种土地网络转移流关系,上游存在24种,中游20种,下游28种,耕地与建设用地、耕地与林地以及林地与园地之间的转换占到流域总土地利用变化的70.74%.CLUE-S模型模拟未来土地利用的Kappa系数达到0.86,表明模型模拟未来情景的土地利用精度满足要求.2000年、2015年、2030年生态保护情景、2030年自然增长情景以及2030年粮食安全情景流域生境质量总得分和平均得分分别为866630,900357,921055,876231,865370和0.7457,0.7747,0.7925,0.7539,0.7466.2030年3种情景的中上游和下游地区生物多样性都呈现出不同程度的改善趋势,而中游地区则表现出退化趋势.     

Acceleration of floc-water separation and floc reduction with magnetic nanoparticles during demulsification of complex waste cutting emulsions

Waste cutting emulsions are difficult to treat efficiently owing to their complex composition and stable emulsified structure. As an important treatment method for emulsions, chemical demulsification is faced with challenges such as low flocs–water separation rates and high sludge production. Hence, in this study, Fe₃O₄ magnetic nanoparticles (MNPs) were used to enhance chemical demulsification performance for treating waste cutting emulsions under a magnetic field. The addition of MNPs significantly decreased the time required to attain sludge–water separation and sludge compression equilibrium, from 210 to 20 min. In addition, the volume percentage of sludge produced at the equilibrium state was reduced from 45% to 10%. This excellent flocculation–separation performance was stable over a pH range of 3–11. The magnetization of the flocculants and oil droplets to form a flocculant–MNP–oil droplet composite, and the magnetic transfer of the composite were two key processes that enhanced the separation of cutting emulsions. Specifically, the interactions among MNPs, flocculants, and oil droplets were important in the magnetization process, which was controlled by the structures and properties of the three components. Under the magnetic field, the magnetized flocculant–MNP–oil droplet composites were considerably accelerated and separated from water, and the sludge was simultaneously compressed. Thus, this study expands the applicability of magnetic separation techniques in the treatment of complex waste cutting emulsions.     

Development of a static test apparatus for evaluating the performance of three PM2.5 separators commonly used in China

PM_(2.5) separator directly affects the accuracy of PM_(2.5) sampling.The specification testing and evaluation for PM_(2.5) separator is particularly important,especially under China's wide variation of terrain and climate.In this study,first a static test apparatus based on polydisperse aerosol was established and calibrated to evaluate the performance of the PM_(2.5) separators.A uniform mixing chamber was developed to make particles mix completely.The aerosol concentration relative standard deviations of three test points at the same horizontal chamber position were less than 0.57%,and the particle size distribution obeyed logarithmic normal distribution with an R~2 of 0.996.The flow rate deviation between the measurement and the set point flow rate agreed to within ± 1.0% in the range of -40 to 50℃.Secondly,the separation,flow and loading characteristics of three cyclone separators(VSCC-A,SCC-A and SCC112) were evaluated using this system.The results showed that the 50% cutoff sizes(D_(50)) of the three cyclones were 2.48,2.47 and 2.44 μm when worked at the manufacturer's recommended flow rates,respectively.The geometric standard deviation(GSD) of the capture efficiency of VSCCA was 1.23,showed a slightly sharper than SCC-A(GSD = 1.27),while the SCC112 did not meet the relevant indicator(GSD = 1.2 ± 0.1) with a GSD = 1.44.The flow rate and loading test had a great effect on D_(50),while the GSD remained almost the same as before.In addition,the maintenance frequency under different air pollution conditions of the cyclones was summarized according to the loading test.     

Coupling mechanism of activated carbon mixed with dust for flue gas desulfurization and denitrification

To clarify the effect of coking dust, sintering dust and fly ash on the activity of activated carbon for various industrial flue gas desulfurization and denitrification, the coupling mechanism of the mixed activated carbon and dust was investigated to provide theoretical reference for the stable operation. The results show that coking dust had 34% desulfurization efficiency and 10% denitrification efficiency; correspondingly, sintering dust and fly ash had no obvious desulfurization and denitrification activities. For the mixture of activated carbon and dust, the coking dust reduced the desulfurization and denitrification efficiencies by blocking the pores of activated carbon, and its inhibiting effect on activated carbon was larger than its own desulfurization and denitrification activity. The sintering dust also reduced the desulfurization efficiency on the activated carbon while enhancing the denitrification efficiency. Fly ash blocked the pores of activated carbon and reduced its reaction activity. The reaction activity of coking dust mainly came from the surface functional groups, similar to that of activated carbon. The reaction activity of sintering dust mainly came from the oxidative property of Fe₂O₃, which oxidized NO to NO₂ and promoted the fast selectively catalytic reduction (SCR) of NO to form N₂. Sintering dust was activated by the joint action of activated carbon, and both had a coupling function. Sintering dust enhanced the adsorption and oxidation of NO, and activated carbon further promoted the reduction of NO_x by NH₃; thus, the denitrification efficiency increased by 5%-7% on the activated carbon.     

固体样品六价铬的检测比对和验证

采用碱溶液提取/火焰原子吸收法(HJ 687—2014《固体废物六价铬的测定 碱消解/火焰原子吸收分光光度法》和HJ 1082—2019《土壤和沉积物 六价铬的测定 碱溶液提取-火焰原子吸收分光光度法》)测定了固体废物和土壤样品中六价铬含量,比对和验证了2种方法实验流程、分析方法性能及不确定度评定结果。结果表明:HJ 687—2014的方法检出限相对较高,不适合测定浓度较低的土壤;HJ 1082—2019要求按照试样制备的步骤配置工作曲线,考虑了基体干扰的影响。HJ 687—2014的检出限为0.28 mg/kg,相对标准偏差为0.69%~0.93%,样品加标回收率为95.7%~97.2%;HJ 1082—2019的检出限为0.17 mg/kg,相对标准偏差为0.6%~3.0%,样品加标回收率为76.0%~83.1%。对于同一实际样品,2种方法的测定结果相近,HJ 687—2014和HJ 1082—2019的测定结果分别为(48.1±4.2),(46.6±5.4) mg/kg。比对发现,影响HJ 687—2014和HJ 1082—2019不确定度的最主要环节分别为曲线拟合和样品消解。     

白洋淀流域地表水化学特征及控制因素

为探究半干旱区地表水化学特征及物质来源,以白洋淀流域为研究对象,利用Piper三线图和Gibbs水岩模型,对地表水的主要离子组成特征及其来源进行分析。结果表明:白洋淀流域地表水pH为7.56~8.23时,呈弱碱性,且溶解性总固体（TDS,100~650 mg/L）在流域的不同空间区域表现为淀区 > 下游 > 上游。白洋淀流域地表水阳离子以Na+和Ca2+为主,离子总量占比76.60%;阴离子以HCO₃-为主,约占阴离子总量61.52%。地表水的水化学类型为HCO₃-Ca型（上游水体）和HCO₃·SO₄·Cl-Na·Ca型（下游河流和淀区）。白洋淀水文地球化学过程受到人类活动和自然作用的双重控制;自然作用下,白洋淀流域地表水中的离子来源于岩石风化（碳酸盐岩及硅酸盐岩的风化溶解）,同时受到蒸发-结晶作用影响。