铬渣的热解无害化处理

采用热解工艺无害化处理铬渣,探讨了稻秆在铬渣无害化处理中的作用.研究了热解温度、稻秆与铬渣质量比、铬渣粒径及保温时间对铬渣热解无害化处理的影响,并分析了热解前后热解产物中铬元素形态的变化.结果表明,热解工艺能有效地将铬渣中Cr(Ⅵ)还原,稻秆热解过程中产生的气相挥发分对Cr(Ⅵ)的还原起核心作用.较为适宜的热解条件:热解温度为400 ℃,稻秆与铬渣质量比为0.10,铬渣粒径<2 000 μm,保温时间为10 min.在该热解条件处理下,热解产物中的Cr(Ⅵ)质量浓度为121 mg/kg,低于热解前铬渣中的Cr(Ⅵ)(3 400 mg/kg).热解后,可交换态及碳酸盐结合态铬含量降低,大部分铬转化成了稳定的有机结合态和残渣态,极大地降低了铬渣的危害.第一作者:张大磊,男,1982生,博士研究生,研究方向为固体废弃物热处理.     

Pollution characteristics of 23 veterinary antibiotics in livestock manure and manure-amended soils in Jiangsu province,China

The aim of this study was to investigate the pollution characteristics of typical veterinary antibiotics in manure and soil of livestock farms in Jiangsu province. This investigation employed solid-phase extraction (SPE) coupled with ultra-performance liquid chromatography-tandem mass spectrometry (UPLC-MS/MS). A total of 53 manure and 50 amended soil samples from 16 livestock farms in Jiangsu province were collected for analysis. In the manure samples, the highest detected frequencies and concentrations were those of tetracyclines (TCs, 54.1 ± 5775.6 μgkg^?1), followed by fluoroquinolones (FQs, 8.4 ± 435.6 μgkg^?1), sulphonamides (SAs, 3.2 ± 5.2 μgkg^?1) and macrolides (MACs, 0.4 ± 110.5 μgkg^?1). Statistical analysis was used to illuminate the pollution characteristics of 23 veterinary antibiotics for various animal types and different regions in Jiangsu province. The results showed that the pollution level in cow manure was relatively lower compared with pig and chicken manure due to the relative restriction of medication. Furthermore, contamination was serious in amended soil from chicken farms. The pollution level in manure among different regions was higher to the south and north compared with the centre of the region. The same outcome was found for soil. Antibiotic residues in organic fertilizer were also investigated in this study. We found that although the detected concentration was lower in organic fertilizer than in fresh manure, detection frequencies (10–90%) were high, especially for roxithromycin (90%) in MACs (30–90%). This finding suggests attention should be paid to the pollution levels in organic fertilizer. This study is the first extensive investigation of the occurrence and distribution of many kinds of typical veterinary antibiotics in manure and soil from livestock farms of Jiangsu province. This investigation systematically assesses veterinary antibiotics usage and related emissions in southeast China.     

Short-term effects of gaseous pollutants on cause-specific mortality in Wuhan, China

In Asia, limited studies have been published on the association between daily mortality and gaseous pollutants of nitrogen dioxide (NO2), ozone (O3), and sulfur dioxide (SO2). Our previous studies in Wuhan, China, demonstrated long-term air pollution effects. However, no study has been conducted to determine mortality effects of air pollution in this region. This study was to determine the acute mortality effects of the gaseous pollutants in Wuhan, a city with 7.5 million permanent residents during the period from 2000 to 2004. There are approximately 4.5 million residents in Wuhan who live in the city's core area of 201 km2, where air pollution levels are highest, and pollution ranges are wider than the majority of the cities in the published literature. We used the generalized additive model to analyze pollution, mortality, and covariate data. We found consistent NO2 effects on mortality with the strongest effects on the same day. Every 10-microg/m3 increase in NO2 daily concentration on the same day was associated with an increase in nonaccidental (1.43%; 95% confidence interval [CI]: 0.87-1.99%), cardiovascular (1.65%; 95% CI: 0.87-2.45%), stroke (1.49%; 95% CI: 0.56-2.43%), cardiac (1.77%; 95% CI: 0.44-3.12%), respiratory (2.23%; 95% CI: 0.52-3.96%), and cardiopulmonary mortality (1.60%; 95% CI: 0.85-2.35%). These effects were stronger among the elderly than among the young. Formal examination of exposure-response curves suggests no-threshold linear relationships between daily mortality and NO2, where the NO2 concentrations ranged from 19.2 to 127.4 microg/m3. SO2 and O3 were not associated with daily mortality. The exposure-response relationships demonstrated heterogeneity, with some curves showing nonlinear relationships for SO2 and O3. We conclude that there is consistent evidence of acute effects of NO2 on mortality and suggest that a no-threshold linear relationship exists between NO2 and mortality.     

光合细菌及活性污泥法联用工艺处理明胶废水试验

研究了光合细菌(photo-synthetic bacteria,简称PSB)及活性污泥法联用工艺处理明胶生产过程中产生的高浓度有机废水的可行性。经过光合细菌及活性污泥先后次序的变换,得出了最优处理工艺。结果表明:"PSB+活性污泥"工艺、"活性污泥+PSB"工艺COD去除率平均值分别为94.7%和96.0%;"活性污泥+PSB"工艺有较强的去除钙质和耐冲击负荷的能力,该工艺适合处理此种含高钙、高氯、高碱明胶的废水。     

寡糖类农药的研制

葡萄寡糖、半乳糖醛酸寡糖、几丁质寡糖是常见的、能激活植物自卫系统的激活剂,本文综述了这几类寡糖的结构、活性、制备方法、这些寡糖会为无毒、无公害的新农药。     

Cr(Ⅵ)污染土壤的热解还原无害化处理

提出了用热解还原法对含铬土壤进行无害化处理的新技术,研究了热解温度、热解时间及土壤有机质对铬无害化处理的影响,分析了热解前后土壤中铬的元素形态的变化.同时还探讨了热解还原过程中Cr(Ⅵ)的无害化机制.结果表明,土壤中的有机质在热解还原过程中产生的挥发分对Cr(Ⅵ)的无害化起核心作用;在200～600℃范围内,Cr(Ⅵ)的还原量随着热解温度升高而增大,500.0℃最适合于经济有效地实现Cr(Ⅵ)的热解还原处理;Cr(Ⅵ)的热解还原过程较快.铬的形态分析结果表明,热解后可交换态和碳酸盐结合态铬量大大降低,大部分铬转化成了活性低的残渣态,极大地降低了铬的危害.     

光合细菌强化二级流化床工艺处理焦化废水的研究

采用厌氧酸化加二级流化床组合工艺处理焦化废水。一级反应器内光合细菌与兼性厌氧菌处于共生状态,二级反应器内光合细菌与亚硝酸细菌处于共生状态。一级反应器内光合细菌有充分的小分子有机酸可降解并形成二次酸化,在二级反应器内完成进一步降解。结合反应条件：温度,pH,DO和基质浓度等,将二级反应器内硝化反应控制在亚硝化阶段,有效地保证了废水中碳源的利用。稳定运行了60 d,结果显示,出水COD和NH₃-N浓度分别为105～135 mg/L和14～20 mg/L,去除率分别稳定在90.3%～92.5%和92%～95%。TN去除率稳定在83%～86%。酚、氰化物和BOD5的去除率均在95%以上。     

Occurrence and characterization of selected organochlorine contaminants in outdoor dust collected from Xinxiang,a fast developing city in North China

As facile “environmental media”, the outdoor dust may reflect the changes of contaminants in environment more promptly. In the present study, selected organochlorine contaminants (OCs) include hexachlorocyclohexanes (HCHs), dichlorodiphenyltrichloroethanes (DDTs), hexachlorobenzene (HCB), and pentachlorobenzene (PeCB) were detected in 20 outdoor dust samples collected from Xinxiang City. The concentrations of ΣHCHs, ΣDDTs, HCB, and PeCB in dust were in the range of 0.18–5.05 ng/g dry weight, 0.44–13.50 ng/g dry weight, 0.13–51.61 ng/g dry weight and ND-0.74 ng/g dry weight, respectively. Long-range transport, historical use, and recent impact of impure pesticides might be the main sources of OCs in the outdoor dust. The results of this study indicated that impure pesticide application maybe an important source of DDTs and HCB in the environment.     

Chemical compositions and sources of atmospheric PM10 in heating, non-heating and sand periods at a coal-based city in northeastern China

Mass concentrations and chemical components (18 elements, 9 ions, organic carbon [OC] and elemental carbon [EC]) in atmospheric PM(10) were measured at five sites in Fushun during heating, non-heating and sand periods in 2006-2007. PM(10) mass concentrations varied from 62.0 to 226.3 μg m(-3), with 21% of the total samples' mass concentrations exceeding the Chinese national secondary standard value of 150 μg m(-3), mainly concentrated in heating and sand periods. Crustal elements, trace elements, water-soluble ions, OC and EC represented 20-47%, 2-9%, 13-34%, 15-34% and 13-25% of the particulate matter mass concentrations, respectively. OC and crustal elements exhibited the highest mass percentages, at 27-34% and 30-47% during heating and sand period. Local agricultural residuals burning may contribute to EC and ion concentrations, as shown by ion temporal variation and OC and EC correlation analysis. Heavy metals (Cr, Ni, Zn, Cu and Mn) from coal combustion and industrial processes should be paid attention to in heating and sand periods. The anion/cation ratios exhibited their highest values for the background site with the influence of stationary sources on its upper wind direction during the sand period. Secondary organic carbon were 1.6-21.7, 1.5-23.0, 0.4-17.0, 0.2-33.0 and 0.2-21.1 μg m(-3), accounting for 20-77%, 44-88%, 4-77%, 8-69% and 4-73% of OC for the five sampling sites ZQ, DZ, XH, WH and SK, respectively. From the temporal and spatial variation analysis of major species, coal combustion, agricultural residual burning and industrial emission including dust re-suspended from raw material storage piles were important sources for atmospheric PM(10) in Fushun at heating, non-heating and sand periods, respectively. It was confirmed by principal component analysis that coal combustion, vehicle emission, industrial activities, soil dust, cement and construction dust and biomass burning were the main sources for PM(10) in this coal-based city.