Characterization of titanium oxide optical band gap produced from leachate sludge treatment with titanium tetrachloride

Environmental Science and Pollution Research - This study investigated the coagulation performance of titanium tetrachloride (TiCl4) for leachate treatment and preparation of titanium oxide (TiO2)...     

Spatial distribution and ecological risk assessment of sediment metals in a highly industrialized coastal zone southwestern Taiwan

Spatial variations of Cr, Cu, Hg, Ni, Pb, and Zn in the surface sediments from 34 stations of the Kaohsiung coastal zone southwestern Taiwan were studied to address the current pollution status, sediment quality, and potential ecological risk. The study revealed that the concentrations of sediment metals in Kaohsiung Harbor were alarmingly high compared to the other region of Kaohsiung coast. The concentrations of Cr, Cu, Hg, Ni, Pb, and Zn in the harbor sediments were as high as 351, 247, 1.93, 61.8, 60.9, and 940 mg kg⁻¹, respectively. The current situation of metal pollution was assessed by different pollution indices and results showed moderate to severe enrichment of Cu, Hg, and Zn in the harbor sediments. According to the degree of contamination, pollution load index, and contamination severity index, the sediments from the inner Kaohsiung Harbor show high degree and high severity of metal contamination, while the rest of Kaohsiung coastal areas show uncontaminated or low-level pollution. Results of mean ERM quotient and potential ecological risk index also indicated that the harbor sediments posed a 49% probability of biological toxicity and very high ecological risk. The toxic units indicated that the negative biological effects of the six metals in the harbor sediments were Zn > Cu > Cr > Ni > Hg > Pb. In contrast to Kaohsiung Harbor as a trap where considerable amount of anthropogenic metal loadings accumulated in sediments, low metal concentrations were observed in most Kaohsiung coastal sediments. It probably resulted from the limited fine-grained sediment deposition. In the wave-dominated Kaohsiung coastal zone, fine-grained sediments associated with polluted metals tend to be easily resuspended and transported offshore via waves and wave-induced currents. The results of this study can provide valuable information for river and coastal zone management.

     

Modeling urban solar energy with high spatiotemporal resolution: A case study in Toronto,Canada

This research presents a method to determine the maximum potential for the capturing of solar radiation on the rooftop of buildings in an urban environment. This involves the modeling of solar energy potential and comparison to historical building energy demand profiles through the use of 3-D solar simulation software tools and geographic information systems (GIS). The objective is to accurately identify the amount of surface area that is suitable for solar photovoltaic (PV) installations and to estimate the hourly PV electricity generation potential of existing building rooftops in an urban environment. This study demonstrates a viable approach for modeling urban solar energy and offers valuable information for electricity distributors, policy makers, and urban energy planners to facilitate the substantial design of a green built environment. The developed methodology is comprised of three main sections: (1) determination of suitable rooftop area, (2) determination of the amount of incident solar radiation available per rooftop, and (3) estimation of hourly solar PV electricity generation potential. A case study was performed using this method for Ryerson University, located in Toronto, Canada. It was found that solar PV could supply up to 19% of the study area’s electricity demands during peak consumption hours. The potential benefits of solar PV was also estimated based upon hourly greenhouse gas emission intensity factors as well as Time-of-Use (TOU) savings through the Ontario Feed-in-Tariff (FIT) program, which allows for better representation of the positive impacts of solar technologies.     

The farmer as a landscape steward: Comparing local understandings of landscape stewardship,landscape values,and land management actions

We develop a landscape stewardship classification which distinguishes between farmers’ understanding of landscape stewardship, their landscape values, and land management actions. Forty semi-structured interviews were conducted with small-holder (<5 acres), medium-holders (5–100 acres), and large-holders (>100 acres) in South-West Devon, UK. Thematic analysis revealed four types of stewardship understandings: (1) an environmental frame which emphasized the farmers’ role in conserving or restoring wildlife; (2) a primary production frame which emphasized the farmers’ role in taking care of primary production assets; (3) a holistic frame focusing on farmers’ role as a conservationist, primary producer, and manager of a range of landscape values, and; (4) an instrumental frame focusing on the financial benefits associated with compliance with agri-environmental schemes. We compare the landscape values and land management actions that emerged across stewardship types, and discuss the global implications of the landscape stewardship classification for the engagement of farmers in landscape management.     

Effects of dredging on benthic diatom assemblages in a lowland stream

The objective of this study was to assess the effects of dredging on the structure and composition of diatom assemblages from a lowland stream and to investigate whether the response of diatom assemblages to the dredging is also influenced by different water quality. Three sampling sites were established in Rodríguez Stream (Argentina); physico-chemical variables and benthic diatom assemblages were sampled weekly in spring 2001. Species composition, cell density, diversity and evenness were estimated. Diatom tolerance to organic pollution and eutrophication were also analyzed. Differences in physico-chemical variables and changes in benthic diatom assemblages were compared between the pre- and post-dredging periods using a t-test. Data were analyzed using Principal Components Analysis (PCA), non-metric multidimensional scaling (MDS) ordination and cluster analysis. The effects of dredging in the stream involve two types of disturbances: (i) in the stream bed, by the removal and destabilization of the substrate and (ii) in the water column, by generating chemical changes and an alteration of the light environment of the stream. Suspended solids, soluble reactive phosphorus and dissolved inorganic nitrogen were significantly higher in post-dredging periods. Physical and chemical modifications in the habitat of benthic diatoms produced changes in the assemblage; diversity and species numbers showed an immediate increase after dredging, decreasing at the end of the study period. Changes in the tolerance of the diatom assemblage to organic pollution and eutrophication were also observed as a consequence of dredging; in the post-dredging period sensitive species were replaced by either tolerant or most tolerant species. These changes were particularly noticeable in site 1 (characterized by its lower amount of nutrients and organic matter previous to dredging), which showed an increase in the amount of nutrients and oxygen demand as a consequence of sediment removal. However, these changes were not so conspicuous in sites 2 and 3, which already presented a marked water quality deterioration before the execution of the dredging works.     

Metabolites of the phenylurea herbicides chlorotoluron, diuron, isoproturon and linuron produced by the soil fungus Mortierella sp.

Phenylurea herbicides are used worldwide, and often pollute surface- and groundwater in concentrations exceeding the limit value for drinking water (0.1 μg l⁻¹). Bacteria degrade phenylurea herbicides by successive N-dealkylation to substituted aniline products. Little is known about the corresponding fungal pathways, however. We here report degradation of chlorotoluron, diuron, isoproturon and linuron by the soil fungus Mortierella sp. Gr4. Degradation was fastest with linuron and resulted in successively dealkylated metabolites and 3,4-dichloroaniline. A major new metabolite was detected that has not yet been fully identified. Thin layer chromatography and nuclear magnetic resonance spectroscopy indicate that it is a non-aromatic diol. Degradation of isoproturon, chlorotoluron and diuron involved successive N-demethylation and, in the case of isoproturon and chlorotoluron, additional hydroxylation. A new hydroxylated isoproturon metabolite was detected. The study thus shows that the fungal pathways differ from the bacterial pathways and yield new metabolites of possible environmental concern.     

Sources and seasonal variation of PAHs in the sediments of drinking water reservoirs in Hong Kong and the Dongjiang River (China)

The main objective of this study was to investigate occurrence of polycyclic aromatic hydrocarbons (PAHs) in the sources of the drinking water supply of Hong Kong. The main emphasis was on the Dongjiang River in mainland China which is the major source, supplying 80% of the total consumption in Hong Kong (the remaining 20% is obtained from rain water). Sediments were collected from four sites along the Dongjiang River and four reservoirs in Hong Kong during both the dry and wet weather seasons. The concentrations of total PAHs in the sediments ranged between 36 and 539 microg/kg dry wt. The lower levels were detected at the upstream site on the Dongjiang River and at the reservoirs in Hong Kong (44-85 microg/kg dry wt), while the mid- and downstream sites on the Dongjiang River were more polluted (588-658 microg/kg dry wt). Examination of the PAH profiles revealed that the mid- and downstream sections of the Dongjiang River contained high percentages of 4,5,6-ring PAHs, similar to the amounts of atmospheric particulate matter and road dust collected during the dry weather season from the Pearl River Delta region as reported in the literature. Seasonal changes were revealed in the reservoirs of Hong Kong, with higher PAH levels in the wet weather season than in the dry weather season. For those reservoirs in Hong Kong that store water from the Dongjiang River, a distinct seasonal pattern was also observed, namely, that under dry weather season conditions the PAHs found in the sediments were primarily from petrogenic source, while under wet weather season conditions they were from pyrolytic sources. No such pattern was detected in the reservoirs which stored only rain water.     

Customers as contributors and reliable evaluators of creativity in the service industry

Using hair stylists, we examined the nature of creativity in a service setting and the impact of customers as part of the social context for employee creativity. We also assessed whether customers could serve as reliable evaluators of creativity. To do so, we collected data from multiple sources: service providers, supervisors, and customers. Results demonstrated that customer input and customer affective‐based trust made significant, positive, and independent contributions to service‐related creativity. Moreover, customers in the service industry proved to be reliable raters of employee creativity, compatible with supervisors. Finally, input and trust were associated differently with service‐related and organization‐related creativity. Copyright © 2008 John Wiley & Sons, Ltd.     

Interactive Influence of Biofiber Composition and Elastomer on Physico-Mechanical Properties of PLA Green Composites

The objective of this work was to improve the impact and thermal properties of polylactic acid (PLA)-based biocomposite by appropriate application of cellulosic fiber and a bioelastomer. Biocomposites formulations with fiber contents of up to 20% in combination with a bioelastomer were extrusion-compounded in a twin-screw extruder followed by molding in an injection molding system. Fibers used in the formulations included three types of cellulosic fiber; namely, raw fiber from oat hull biomass (RF), hydrolysis byproduct (ATF) which was the solid fraction obtained from an acid-catalyzed hydrolysis of RF, and delignified fibers (AD30, AD65, AD100) which were the products of delignification of ATF. Formulated biocomposites were characterized for thermal (glass transition and melting temperatures, and enthalpy of melting) and physico-mechanical (tensile and bending strengths, stiffness, impact energy, and water absorption) properties. Among all types of biofibers, RF resulted in poor properties in the biocomposites due to the high hemicellulose content in the structure. On the other hand, the ratio of lignin to cellulose (in the absence of hemicellulose) in the modified fibers did not significantly affect the physico-mechanical and thermal properties of the biocomposites. The elastomer applied in the formulations improved the impact energy, thermal properties, and elongation at break of the composites. However, it adversely affected the strength and water resistance of biocomposites, especially in the presence of hemicellulose. The results indicated that, depending on the application, a wide range of PLA green composites with different physico-mechanical properties can be achieved.     

Performance of IUCN proxies for generation length

One of the criteria used by the International Union for Conservation of Nature (IUCN) to assess threat status is the rate of decline in abundance over 3 generations or 10 years, whichever is longer. The traditional method for calculating generation length (T) uses age‐specific survival and fecundity, but these data are rarely available. Consequently, proxies that require less information are often used, which introduces potential biases. The IUCN recommends 2 proxies based on adult mortality rate, = α + 1/d, and reproductive life span, = α + z^*RL, where α is age at first reproduction, d is adult mortality rate, RL is reproductive life span, and z is a coefficient derived from data for comparable species. We used published life tables for 78 animal and plant populations to evaluate precision and bias of these proxies by comparing and with true generation length. Mean error rates in estimating T were 31% for and 20% for , but error rates for were 16% when we subtracted 1 year ( ), as suggested by theory; also provided largely unbiased estimates regardless of the true generation length. Performance of depends on compilation of detailed data for comparable species, but our results suggest taxonomy is not a reliable indicator of comparability. All 3 proxies depend heavily on a reliable estimate of age at first reproduction, as we illustrated with 2 test species. The relatively large mean errors for all proxies emphasized the importance of collecting the detailed life‐history information necessary to calculate true generation length. Unfortunately, publication of such data is less common than it was decades ago. We identified generic patterns of age‐specific change in vital rates that can be used to predict expected patterns of bias from applying .