Interinstrument comparison of remote-sensing devices and a new method for calculating on-road nitrogen oxides emissions and validation of vehicle-specific power

Emissions of nitrogen oxides (NOx) by vehicles in real driving environments are only partially understood. This has been brought to the attention of the world with recent revelations of the cheating of the type of approval tests exposed in the dieselgate scandal. Remote-sensing devices offer investigators an opportunity to directly measure in situ real driving emissions of tens of thousands of vehicles. Remote-sensing NO₂ measurements are not as widely available as would be desirable. The aim of this study is to improve the ability of investigators to estimate the NO₂ emissions and to improve the confidence of the total NOx results calculated from standard remote-sensing device (RSD) measurements. The accuracy of the RSD speed and acceleration module was also validated using state-of-the-art onboard global positioning system (GPS) tracking. Two RSDs used in roadside vehicle emissions surveys were tested side by side under off-carriageway conditions away from transient pollution sources to ascertain the consistency of their measurements. The speed correlation was consistent across the range of measurements at 95% confidence and the acceleration correlation was consistent at 95% confidence intervals for all but the most extreme acceleration cases. VSP was consistent at 95% confidence across all measurements except for those at VSP ≥ 15 kW t^?1, which show a small underestimate. The controlled distribution gas nitric oxide measurements follow a normal distribution with 2σ equal to 18.9% of the mean, compared to 15% observed during factory calibration indicative of additional error introduced into the system. Systematic errors of +84 ppm were observed but within the tolerance of the control gas. Interinstrument correlation was performed, with the relationship between the FEAT and the RSD4600 being linear with a gradient of 0.93 and an R² of 0.85, indicating good correlation. A new method to calculate NOx emissions using fractional NO₂ combined with NO measurements made by the RSD4600 was constructed, validated, and shown to be more accurate than previous methods.

Implications: Synchronized remote-sensing measurements of NO were taken using two different remote-sensing devices in an off-road study. It was found that the measurements taken by both instruments were well correlated. Fractional NO₂ measurements from a prior study, measurable on only one device, were used to create new NO_x emission factors for the device that could not be measured by the second device. These estimates were validated against direct measurement of total NO_x emission factors and shown to be an improvement on previous methodologies. Validation of vehicle-specific power was performed with good correlation observed.     

Variation in perception of environmental change in nine Solomon Islands communities: implications for securing fairness in community-based adaptation

Community-based approaches are pursued in recognition of the need for place-based responses to environmental change that integrate local understandings of risk and vulnerability. Yet the potential for fair adaptation is intimately linked to how variations in perceptions of environmental change and risk are treated. There is, however, little empirical evidence of the extent and nature of variations in risk perception in and between multiple community settings. Here, we rely on data from 231 semi-structured interviews conducted in nine communities in Western Province, Solomon Islands, to statistically model different perceptions of risk and change within and between communities. Overall, people were found to be less likely to perceive environmental changes in the marine environment than they were for terrestrial systems. The distance to the nearest market town (which may be a proxy for exposure to commercial logging and degree of involvement with the market economy), and gender had the greatest overall statistical effects on perceptions of risk. Yet, we also find that significant environmental change is underreported in communities, while variations in perception are not always easily related to commonly assumed fault lines of vulnerability. The findings suggest that there is an urgent need for methods that engage with the drivers of perceptions as part of community-based approaches. In particular, it is important to explicitly account for place, complexity and diversity of environmental risk perceptions, and we reinforce calls to engage seriously with underlying questions of power, culture, identity and practice that influence adaptive capacity and risk perception.

     

ARSENIC CONSUMPTION AND HEALTH RISK PERCEPTIONS IN A RURAL WESTERN U.S. AREA1

ABSTRACT: Churchill County, Nevada, has approximately 23,000 residents, among whom an estimated 13,500 relied on private wells for water supply in 2002. This study examined exposure to arsenic in water supplies among residents with private domestic wells and factors related to householder choice to consume tap water. It compared opinions and concerns about water quality with consumption habits and observed concentrations from tap water samples. The results from 351 households indicated that a majority (75 percent) of respondents consumed tap water and that a minority (38 percent) applied treatment. Approximately 66 percent of those who consumed tap water were exposed to concentrations of arsenic that exceeded 10 ppb. Water consumption was related to application of treatment. Among 98 respondents who were not at all concerned about the health effects of aqueous arsenic, 59 (60 percent) reported consuming tap water with concentrations of arsenic exceeding 10 ppb. Conversely, among 86 respondents who were highly concerned about arsenic, 33 (37 percent) consumed tap water with concentrations of arsenic exceeding 10 ppb. Results from a national sampling effort showed that 620 of 5,304 private wells sampled (11.7 percent) had arsenic concentrations above 10 ppb. The paradox of awareness of arsenic in water supplies coupled with consumption of aqueous arsenic in concentrations greater than 10 ppb may be common in other parts of the nation. Enhanced educational efforts, especially related to tap water sampling and explanations of efficacy of available treatment, may be useful means of reducing exposure through private water supplies.     

Seasonal fluctuations in sand temperature: effects on the incubation period and mortality of loggerhead sea turtle (<Emphasis Type="Italic">Caretta</Emphasis><Emphasis Type="Italic">caretta</Emphasis>) pre-emergent hatchlings in Minabe,Japan

Incubation period, hatching success, and emergence percentage in loggerhead (Caretta caretta) nests were quantified during the 1993 and 1995 nesting seasons and following incubation seasons in Minabe, Wakayama, Japan. Sand and nest temperatures were also monitored. Over the seasons, daily mean sand temperature at nest depth fluctuated between 18.0°C and 33.3°C, with a steep increase in the second week of July and a peak in late August. Temperatures inside the nest chambers were a few degrees above those of the surrounding sand at the end of incubation. The incubation period ranged from 46 to 82 days. A significant negative correlation was found between mean sand temperature and incubation period. The relationship conformed to the day-degree concept. There was no significant seasonal trend in hatching success, but many pre-emergent hatchlings were found dead in most of the clutches during the warmest part of the season. Emergence percentage was correlated with mean sand temperature calculated for 4 days before emergence, suggesting that mortality may be due to heat. This heat-related mortality is considered to be a common phenomenon at our study site, because the peak in emergences coincides with the peak in high temperatures. These temperature effects on hatchling mortality must be taken into account in estimates of hatchling sex ratios. Because sand temperatures already exceed the optimal thermal range for incubation, this population is vulnerable to even small temperature increases resulting from global warming.     

The role of new technologies in reducing energy demand

Energy efficiency is often stated to be the most cost-effective measure for satisfying our energy demand with minimal environmental damage. However, the potential energy savings attainable in 'the real world' are frequently overestimated, as is shown in an industrial case study of the glass industry. Nevertheless, there are significant energy savings to be realized, and the role of new technologies in this is important. However, the key to the effective use of new technology for improved energy efficiency is good management and. for best effect, it must be integrated into the normal resource management activities of a company.