The effects of bisphenol A given in ovo on bursa of Fabricius development and percentage of acid phosphatase positive lymphocyte in chicken

Environmental Science and Pollution Research - Bisphenol A (BPA), one of the endocrine disrupting chemicals, is the object of great concern because of its widespread use throughout the world. In...     

Part based process performance monitoring (PbPPM)

The performances of completed manufacturing processes were evaluated using the surface response to excitation (SuRE) and Lamb wave methods. Both methods used the same piezoelectric elements attached to the surface of the workpiece. The SuRE method and the Lamb wave method were used to identify the structural changes created by welding, drilling, coating, filling a slot with glue, and composite patching. This study indicates that the tested methods are feasible for part based process performance monitoring (PbPPM) which evaluates the quality of the completed process with the sensors attached to the workpiece.     

A numerical study on the effects of EGR and spark timing to combustion characteristics and NOx emission of a GDI engine

EGR is one of the most significant strategies for reducing especially nitrogen oxides (NO_x) emissions from internal combustion engines. The thermal efficiency of spark ignition engines is lower than compression ignition engines because of its lower compression ratio. If the compression ratio is increased to obtain higher thermal efficiency, there may be a knocking tendency in spark ignition engines. EGR can be used in order to reduce NO_x emissions and avoid knocking phenomena at higher compression ratios. In-cylinder temperature at the end of combustion is decreased and heat capacity of fresh charge is increased when EGR applied. Besides EGR, spark timing is another significant parameter for reducing exhaust emissions such as nitrogen oxides, and unburned hydrocarbon (UHC). In this study the effects of EGR and spark timing on spark ignition engine were investigated numerically. KIVA codes were used in order to model combustion process. The combustion process has been modeled for a single cylinder, four stroke and gasoline direct injection (GDI) spark ignition engine. The results showed that in-cylinder pressure and heat release rate decrease as EGR ratio increase. In-cylinder pressure increases with the advancing of spark timing. Advancing spark timing increases the heat release rate and in-cylinder temperature. The simulation results also showed that EGR reduced exhaust gas temperature and NO_x emissions.     

Sorption of alpha and beta hydrophobic endosulfan in a Vertisol from southeast region of Turkey

Endosulfan has been applied to control numerous insects in a variety of food and non-food crops. Limited information is available on dynamics of this pesticide in the soil. The objective of this research was to determine the adsorption–desorption behavior of the alpha (α) and beta (β) endosulfan in a Vertisol from the southeast region of Turkey, where cotton is the main crop in the large irrigated lowlands. The α and β endosulfan were adsorbed considerably and Freundlich adsorption–desorption isotherms fitted the α and β endosulfan data (R² > 0.98). Freundlich adsorption coefficients (K_f) for the α endosulfan ranged between 21.63 and 16.33 while for the β endosulfan they were between 14.01 and 17.98 for the Ap and Bw2 horizons. The difference of K_f values of α and β endosulfan for two horizons were explained with the slight difference in the amount of organic matter and clay, but considerable difference in Fe contents of the two horizons. Alpha and β endosulfan K_fd values were 118.03 and 45.81 for the Ap and 48.08 and 68.71 for the Bw2 horizons. Higher adsorption and desorption behavior of the endosulfan isomers for the same horizon was attributed to poor physical bonding between the endosulfan molecule and the surfaces of fundamental soil particles. This fact is thought to increase the effective use of endosulfan in agriculture with a possibility of its movement to the surface and groundwater in the Vertisol studied.     

Airborne Alternaria and Cladosporium species and relationship with meteorological conditions in Eskisehir City, Turkey

Alternaria and Cladosporium, known as the most allergenic spores were first collected by means of Durham gravimetric sampler from Eskisehir atmosphere from January 1, 2000 to December 31, 2001. The daily, monthly and annual variations in spores/cm(2) of Cladosporium and Alternaria were recorded. During this period, a total of 10.231 spores belonging to Cladosporium and Alternaria genera were recorded. Of these spores, 5,103 were identified in 2000 and 5,128 in 2001. While 63.09% of the total spores were those of Cladosporium, 36.91% were of Alternaria. Relationships between airborne fungal spore presence and meteorological conditions were statistically investigated. A Shapiro-Wilk test revealed that the airborne Cladosporium and Alternaria spores differed from a normal distribution. Thus, a Friedmann test was performed followed by a Pearson Correlation Analysis. The effects of rainfall, temperature and wind speed on Cladosporium and Alternaria numbers were non-significant according to the sites and months (p > 0.05), but the effects of relative humidity on Cladosporium and Alternaria numbers were significant (p < 0.01). Spore concentrations reached to their highest levels in May 2001.     

Nutrient dynamics between sediment and overlying water in the inner part of Izmir Bay, Eastern Aegean

In this article a concept is described in order to predict and map the occurrence of benthic communities within and near the German Exclusive Economic Zone (EEZ) of the North Sea. The approach consists of two work steps: (1) geostatistical analysis of abiotic measurement data and (2) calculation of benthic provinces by means of Classification and Regression Trees (CART) and GIS-techniques. From bottom water measurements on salinity, temperature, silicate and nutrients as well as from punctual data on grain size ranges (0–20, 20–63, 63–2,000 μ) raster maps were calculated by use of geostatistical methods. At first the autocorrelation structure was examined and modelled with help of variogram analysis. The resulting variogram models were then used to calculate raster maps by applying ordinary kriging procedures. After intersecting these raster maps with punctual data on eight benthic communities a decision tree was derived to predict the occurrence of these communities within the study area. Since such a CART tree corresponds to a hierarchically ordered set of decision rules it was applied to the geostatistically estimated raster data to predict benthic habitats within and near the EEZ.     

Cross-border response of mosses to heavy metal atmospheric deposition in Southeastern Bulgaria and European Turkey

First cross-border atmospheric pollution of 11 heavy metals and toxic elements assessed by Hypnum cupressiforme was reported for a part of Southeastern Europe (Southeastern Bulgaria and European Turkey). Moss monitoring technique followed the main requirements of European Moss Survey. Moss samples were collected in April 2006 both in Bulgaria and Turkey. Concentration of Al, As, Cd, Cr, Cu, Fe, Ni, Pb, Sb, V, and Zn were determined by ICP-AES. Interlaboratory parallel calibration (exchanged four moss samples from each country), standard reference moss materials (M2 and M3) results ensured the study. ANOVA showed no differences between measured results in both laboratories at the 99% confidence level. Principle Component Analyze proved two factors: F1 group of Al, As, Cd, Cr, Fe, Ni, and V and F2 of Cu, Pb, and Zn as main atmospheric pollutants. Results obtained showed approximately Cu and Pb high concentrations around Istanbul and Burgas and Zn pollution in Istanbul district. Arsenic cross-border atmospheric pollution in the study area of Southeastern Europe was found.     

Fungal flora in indoor and outdoor air of different residential houses in Tekirdag City (Turkey): Seasonal distribution and relationship with climatic factors

This study was investigated the density and monthly distribution of indoor and outdoor microfungi in six different residential houses in Tekirdag City through the exposure of Petri dishes containing Rose-Bengal Streptomycin Agar media. Samples were collected in 1-month intervals over a period of 12 months between March, 2001, and February, 2002. We used 432 Petri dishes and counted a total of 4,205 microfungi colonies, 1,790 from indoor air and 2,415 from outdoor air. As a result, 42 species belonging to 12 genera were identified. The most frequent fungal genera were Penicillium (28.61%), Cladosporium (16.08%) and Alternaria (15.98%). While Penicillium (40.61%) and Cladosporium (15.92%) were the dominant genera of indoor air, Alternaria (20.62%) and Penicillium (19.71%) were isolated most frequently from outdoor air (Table 3). Alternaria citri (10.15%) and Penicillium brevicompactum (10.15%) were found to be the most frequent among the 42 identified species. While P. brevicompactum (19.55%) and Aspergillus niger (6.37%) were the most frequent indoor species, A. citri (13.37%) and Cladosporium cladosporioides (8.20%) were the most frequent outdoor species. Linear Regression Analysis was applied to determine whether or not there was a relationship between the number of colonies of isolated fungal genera and meteorological factors during the research period. Correlations between the presence of Aspergillus and temperature, relative humidity, duration of sunny periods and agents of air pollution such as SO(2) and PM were statistically significant. No significant correlations, however, were found between other fungal genera and environmental variables.     

Assessment of natural radiation exposure levels and mass attenuation coefficients of lime and gypsum samples used in Turkey

The activity concentrations of ²²⁶Ra, ²³²Th, and ⁴⁰K in lime and gypsum samples used as building materials in Turkey were measured using gamma spectrometry. The mean activity concentrations of ²²⁶Ra, ²³²Th, and ⁴⁰K were found to be 38 ± 16, 20 ± 9, and 156 ± 54 Bq kg^???1 for lime and found to be 17 ± 6, 13 ± 5, and 429 ± 24 Bq kg^???1 for gypsum, respectively. The radiological hazards due to the natural radioactivity in the samples were inferred from calculations of radium equivalent activities (Ra_eq), indoor absorbed dose rate in the air, the annual effective dose, and gamma and alpha indices. These radiological parameters were evaluated and compared with the internationally recommended limits. The experimental mass attenuation coefficients (μ/ρ) of the samples were determined in the energy range 81–1,332 keV. The experimental mass attenuation coefficients were compared with theoretical values obtained using XCOM. It is found that the calculated values and the experimental results are in good agreement.     

Degradation of fipronil under laboratory conditions in a tropical soil from sirinhaém pernambuco, Brazil

The objective of this research was to assess the degradation of fipronil [5-amino-1-(2,6-dichloro-alpha,alpha,alpha -trifluoro-p-tolyl)-4-trifluoromethylsulfinylpyrazole-3-carbonitrile] in soils from sugar cane fields in Northeastern Brazil. Degradation experiments were carried out under laboratory conditions (controlled temperature and in the dark), where sterile and non-sterile soils (Ustoxs) were incubated [under moisture content of 55% of the water holding capacity (WHC)] and analyzed for fipronil disappearance and metabolite formation. Microbial communities present in the soil degrade fipronil. However, biodegradation seems to be dependent on the bioavailability of the fipronil and the half-life according to the zero-order model. Fipronil degradation rate appeared to be biphasic. Degradation fipronil ranged from 83 days (initial concentration = 978 ng g(-1); short-term experiment) to 200 days (initial concentration = 689 ng g(-1); long-term experiment). This an initial slower rate followed by a faster rate after 90 days of incubation may lead to shorter half-life than that calculated with the zero-order model. The sulfone derivative (an oxidation product) was the predominant metabolite, but the sulfide (a reduction product) and amide (a hydrolysis product) derivatives were also formed under non-sterile conditions after 120 days of incubation. The metabolites underwent further biodegradation, particularly the sulfone derivative. Bioavailability appears to affect fipronil degradation in soils with an effective capacity to adsorb fipronil (such as Ustoxs), while redox potential was important for the formation of metabolites. Despite the fine texture, more aerobic sites were present, thus favoring the formation of the sulfone metabolite over that of the sulfide metabolite. Therefore, microaggregation of Ustoxs, with high clay content, played a very important role in determining the types of metabolites formed.