Dry aerial fallout of organochlorine insecticide residues in Delhi, India

Monitoring of airborne dust in Delhi during May to July 1985 revealed residues of DDT varying from 1.3 to 7.14 ng mg(-1) (4.06-22.31 ng m(-2) day(-1)) with an average of 3.32 ng mg(-1) (10.38 ng m(-2) day(-1)), and HCH which ranged from 0.46 to 2.35 ng mg(-1) (1.44-7.34 ng m(-2) day(-1)) with a mean of 1.16 ng mg(-1) (3.63 ng m(-2) day(-1)). The concentration of total DDT was almost 3 times greater than that of HCH.     

Adsorptive removal of Cd2+ ions using dolochar at an industrial-scale process optimization by response surface methodology

Environmental Science and Pollution Research - In this work, performance of laboratory-synthesized dolochar has been investigated for adsorption of Cd2+ ions in a large-scale process with the...     

Assessing Respiratory Morbidity Through Pollution Status and Meteorological Conditions for Delhi

The study focuses on assessing the status of respiratory morbidity in Delhi over a four years period from 2000–2003. An attempt was made to investigate the role of important pollutants (SO₂, NO₂, SPM and RSPM) and various meteorological factors (temperature minimum & maximum, relative humidity at 0830 and 1730 hrs. and wind speed) in being responsible for respiratory admissions on account of COPD, asthma and emphysema. The study showed that winter months had greater exposure risk as pollutants often get trapped in the lower layers of atmosphere resulting in high concentrations. Statistical analysis revealed that two pollutants have significant positive correlation with the number of COPD cases viz., SPM (r = 0.474; p < 0.01) and RSPM (r = 0.353; p < 0.05), while a meteorological factor temperature (minimum) has a significant negative correlation (r = −0.318; p < 0.05) with COPD. Stepwise multiple regression analysis was performed for COPD as dependent variable and R² value of 0.33 was obtained indicating that SPM and RH(1730) were able to explain 33 percent variability in COPD. The partial correlation of SPM and RH(1730) on COPD was higher than any other combination and therefore they can be regarded as important contributing variables on COPD.     

PAHs Contamination in Bank Sediment of the Yamuna River, Delhi, India

This study was performed to elucidate the distribution, concentration trend and possible sources of PAHs in bank sediment of river Yamuna in Delhi, India. The levels of 16 priority polycyclic aromatic hydrocarbons (PAHs) were analyzed during pre-monsoon, monsoon and post-monsoon seasons in the sediment fraction < 53 μm. Reference standards and internal standards were used for identification and quantification of PAHs by HPLC. The sum of 16 PAH compounds ranged from 4.50 to 23.53 μg/g with a mean concentration of 10.15 ± 4.32 μg/g (dry wt.). Among 5 sites studied, the site, Income Tax Office (ITO) was found to be the hotspot attaining highest concentration. Predominance of 2–4 ring PAHs suggests a relatively recent local sources of PAHs in the study area. Moreover, molecular indices based source apportionment also illustrates pyrogenic source fingerprint of PAHs. No significant temporal trend was observed.     

Effect of UV radiation and temperature on mineralization and volatilization of coumaphos in water

This study was undertaken to determine the dissipation and degradation of coumaphos [O-(3-chloro-4-methyl-2-oxo-2H-1-benzopyran-7-yl) O,O-diethyl phosphorothioate] under different sunlight conditions and at different temperatures. The effect of the ultra violet (UV) component of solar radiation was also studied using quartz tubes in addition to other radiation in the visible range using glass tubes and the results were compared with those obtained under the dark light conditions. Water suspensions of coumaphos were incubated at three temperatures viz. 22°C, 37°C and 53°C in closed systems to study the effect of temperature. Volatilization, mineralization and degradation of coumaphos increased with an increase in temperature and exposure to solar radiation, particularly under the UV component of the solar radiation. Major loss of the pesticide occurred through volatilization. The optimum temperature for the degradation of coumaphos was found to be at 37°C. The data obtained from the mineralization and degradation studies indicated that 53°C crosses the biological range for suitable growth of microorganism. UV radiation exposure along with maintaining temperature at 37°C may prove useful in the dissipation and/or degradation of coumaphos prior to its disposal as waste from cattle dipping vats.     

Chromium removal from water by activated carbon developed from waste rubber tires

Because of the continuous production of large amount of waste tires, the disposal of waste tires represents a major environmental issue throughout the world. This paper reports the utilization of waste tires (hard-to-dispose waste) as a precursor in the production of activated carbons (pollution-cleaning adsorbent). In the preparation of activated carbon (AC), waste rubber tire (WRT) was thermally treated and activated. The tire-derived activated carbon was characterized by means of scanning electron microscope, energy-dispersive X-ray spectroscopy, FTIR spectrophotometer, and X-ray diffraction. In the IR spectrum, a number of bands centred at about 3409, 2350, 1710, 1650, and 1300–1000 cm^?1 prove the present of hydroxyl and carboxyl groups on the surface of AC in addition to C═C double bonds. The developed AC was tested and evaluated as potential adsorbent removal of chromium (III). Experimental parameters, such as contact time, initial concentration, adsorbent dosage and pH were optimized. A rapid uptake of chromium ions was observed and the equilibrium is achieved in 1 h. It was also found that the adsorption process is pH dependent. This work adds to the global discussion of the cost-effective utilization of waste rubber tires for waste water treatment.     

Pentachlorophenol dechlorination and simultaneous Cr6+ reduction by Pseudomonas putida SKG-1 MTCC (10510): characterization of PCP dechlorination products, bacterial structure, and functional groups

It is the first report in which a novel psychrotrophic Pseudomonas putida SKG-1 strain was evaluated for simultaneous bioremediation of pentachlorophenol and Cr⁶⁺ under various cultural and nutritional conditions. Pentachlorophenol (PCP) dechlorination products, bacterial structure, and functional groups were characterized by gas chromatography and mass spectrometry (GC–MS), scanning electron microscope and energy dispersive X-ray spectroscopy (SEM–EDS), and Fourier-transform infrared (FTIR) techniques. The strain was extremely tolerant to excessively higher individual concentration of PCP (1,400 mg l^?1) and Cr⁶⁺ (4,300 mg l^?1). Increasing concentration of PCP and Cr⁶⁺ exerted inhibitory effect on bacterial growth and toxicants’ removal. The strain exhibited growth, and concomitantly remediated both the pollutants simultaneously over a broad pH (7.0–9.0) and temperature (28–32 °C) range; maximum growth, PCP dechlorination (87.5 %), and Cr⁶⁺ removal (80.0 %) occurred at optimum pH 8.0 and 30 °C (from initial PCP 100 mg l^?1 and Cr⁶⁺ 500 mg l^?1) under shaking (150 rpm) within 72 h incubation. Optimization of agitation (125 rpm) and aeration (0.4 vvm) in bioreactor further enhanced PCP dechlorination by ~10 % and Cr⁶⁺ removal by 2 %. A direct correlation existed between growth and bioremediation of both the toxicants. Among other heavy metals, mercury exerted maximum and cobalt minimum inhibitory effect on PCP dechlorination and Cr⁶⁺ removal. Chromate reductase activity was mainly associated with the supernatant and cytosolic fraction of bacterial cells. GC–MS analysis revealed the formation of tetrachloro-p-hydroquinone, 2,4,6-trichlorophenol, and 2,6-dichlorophenol as PCP dechlorination products. FTIR spectrometry indicated likely involvement of carbonyl and amide groups in Cr³⁺ adsorption, and SEM–EDS showed the presence of chromium on P. putida surface. Thus, our promising isolate can be ecofriendly employed for biotreatment of various industrial wastes contaminated with high PCP and Cr⁶⁺ concentrations.     

Persistence,degradation and leaching of coumaphos in soil

Abstract

Dissipation, degradation and leaching of fresh ¹⁴C coumaphos, alkylated ¹⁴C coumaphos and aged residues of ¹⁴C coumaphos from vats were studied in alkaline sandy loam soil in soil columns in the field under subtropical conditions in Delhi for a year. Dissipation, degradation and bound residue formation was more in case of alkali treated coumaphos than fresh coumaphos. After 365 days total residues of fresh coumaphos accounted for 33.25% while that of alkali treated coumaphos was 19.12%. Bound residue formation was almost double in case of alkali treated coumaphos (18.95%) than fresh coumaphos (9.53%) after 150 days followed by release of bound residue in both the cases. The proportion of metabolites 4 ‐ methylumbelliferone, chlorferon and potasan collectively was 86.05% in fresh coumaphos extractable residues while the same was 91.74% in alkali treated coumaphos after 365 days. Aged residues from vats containing copper sulphate and buffer were found to be more persistent in soil as total residues remained were 95.58% in comparison with 83.09% total residues of aged residues from vats containing only buffer after 150 days of treatment. Copper sulphate seems to inhibit the degradatiion of coumaphos in soil by microorganisms. Chlorferon was the major metabolite in generally all the samples. Coumaphos did not leach below 10 cm in all the cases.     

Principle and applications of microbubble and nanobubble technology for water treatment

In recent years, microbubble and nanobubble technologies have drawn great attention due to their wide applications in many fields of science and technology, such as water treatment, biomedical engineering, and nanomaterials. In this paper, we discuss the physics, methods of generation of microbubbles (MBs) and nanobubbles (NBs), while production of free radicals from MBs and NBs are reviewed with the focuses on degradation of toxic compounds, water disinfection, and cleaning/defouling of solid surfaces including membrane. Due to their ability to produce free radicals, it can be expected that the future prospects of MBs and NBs will be immense and yet more to be explored.