土壤全氮的快速测定

本方法是过硫酸盐氧化消化样品的基础上测定土壤中全氮的光度法.采用碱性过硫酸钾溶液(0.37mol/L K_2S_2O_3,0.375N NaOH)消化土壤样品,然后用百里酚光度法进行测定,具有准确、灵敏、快速、简便等优点,适用于常规和大量样品的分析.     

Effect of leachate recycling and inoculation on the biochemical characteristics of municipal refuse in landfill bioreactors

Activity development of key groups of enzymes involved in municipal refuse decomposition was measured in laboratory landfill bioreactors with and without leachate recycling and inoculation for about 210 days.The results showed that the enzymes(amylase,protease,cellulase,lipase and pectinase)were present in fresh refuse but at low values and positively affected by leachate recycling and refuse inoculation.The total average of cellulase activity in digesters D3 operated with leachate recycling but no inoculation,D4 and D5 operated with leachate recyling and inoculation was much higher than that in digesters D1 and D2 without leachate recycling and inoculation by 88%-127%,117%-162%and 64%-98%.The total average of protease activity was higher in digester D4 than that in digesters D1,D2,D3and D5 by 63%,39%,24%and 24%,respectively,and the positive effect of leachate recycling and inoculation on protease activity of landfilled refuse mainly was at the first two months.The total average of amylase activity was higher in digesters D3,D4 and D5 than that in digesters D1 and D2 by 83%-132%,96%-148%and 81%-129%.During the early phase of incubation,the stimulatory effect of inoculation on lipase activity was measured,but refuse moisture was the main factor affecting lipase activity of landfilled refuse.The inoculation,initial and continuous inoculation of microorganisms existing in leachate,was the mainly stimulatory factor affecting pectinase activity of landfilled refuse.     

Influence of start-up on PCDD/F emission of incinerators

This study aims to evaluate the influence of start-up on polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans (PCDD/Fs) concentration in the stack flue gas of incinerators and its contributing PCDD/F emission. The PCDD/F emission of the first sample among three consecutive stack flue gas samples of five intermittent incinerators, which sampled at a stable combustion condition after start-up, is 2-3 times higher than the mean of the others. For verifying the PCDD/F characteristics of incinerators during start-up, one continuous MSWI was investigated for two years. The elevated PCDD/F emissions of the MSWI during start-up could reach 96.9 ng I-TEQN m(-3) and still maintained a high PCDD/F emission (40 times higher than the Taiwan emission limit) even 18 h after the injection of activated carbon, indicating the memory effect. Taking the MSWI for example, which consists of four incinerators, the estimated annual PCDD/F emission from normal operational conditions was 0.112 g I-TEQ. However, one start-up procedure can generate approximately 60% of the PCDD/F emissions for one whole year of normal operations. And the PCDD/F emission, which is the result of the start-ups of four incinerators, was at least two times larger than that of a whole year's normal operations, without consideration for the PCDD/F emission contributed by the long lasting memory effect.     

Quantification of the interactions between Ca,Hg and extracellular polymeric substances (EPS) of sludge

The interactions between metals (Ca²⁺ and Hg²⁺) and extracellular polymeric substances (EPS) extracted from the aerobic and anaerobic sludge in wastewater treatment reactors were investigated using a combination of zeta potential measurement and 3-dimensional excitation–emission matrix (EEM) fluorescence spectroscopy with parallel factor (PARAFAC) analysis. Results show that Ca²⁺ had no substantial effects on the EEM fluorescence spectra of the EPS, but their zeta potentials increased with the increasing Ca²⁺ dosage. However, Hg²⁺ had a significant effect on the EEM fluorescence spectra of the EPS, while their zeta potentials seemed not to be affected by the dose of Hg²⁺. The interactions between Hg²⁺ and EPS were elucidated using the fluorescence quenching with PARAFAC analysis, while the interactions between Ca²⁺ and EPS were evaluated by the zeta potential technique. The binding constants for Hg²⁺ and EPS were two orders of magnitude higher than those for Ca²⁺ and EPS, suggesting that the binding mechanisms between Ca²⁺ and EPS were different from those between Hg²⁺ and EPS. The results might be useful for understanding the roles of EPS in bacterial self-protection against heavy metals and the aggregate formation mechanisms through ionic bridging interactions.     

Evaluation of the emission characteristics of PCDD/Fs from electric arc furnaces

Distribution of PCDD/F (polychlorinated dibenzo-p-dioxin and polychlorinated dibenzofuran) congeners at two electric arc furnaces (EAFs) in Taiwan is evaluated via intensive stack sampling and analysis. Two kinds of exhaust system in EAFs including stack system and shutter system are selected for measuring dioxin emissions. In addition, dioxin emissions during oxidation and reduction stages at EAF-A were characterized. Results indicate that the PCDD/F concentration of stack gas in EAF-A was 4.39 ng/N m³ while total Toxic Equivalent Quantity (TEQ) concentration was 0.35 ng I-TEQ/N m³. The PCDD/F concentration of stack gas in EAF-B was 2.20 ng/N m³ and the TEQ concentration was 0.14 ng I-TEQ/N m³. 1,2,3,4,6,7,8-H_pCDF, OCDD and OCDF are the major contributors of the dioxin concentrations for two EAFs investigated and the percentage of PCDD/F in particulate phase increases as the chlorination level of the PCDD/F congener increases. The results obtained on gas/particulate partitioning of PCDD/Fs in flue gases prior to the APCD in EAFs indicate that more than 90% exists in particulate phase. In EAF-A, the PCDD/F concentration during oxidation stage is slightly higher than that measured during reduction stage, including the sampling points of CO converter outlet, prior to bag filter and stack. Majority of PCDD/Fs emitted from steel-making processes exists in particulate-phase (about 60–70%) at both EAFs investigated.     

Quasi-dynamic leaching characteristics of polychlorinated dibenzo-p-dioxins and dibenzofurans from raw and solidified waste incineration residues

Quasi-dynamic leaching characteristics of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) from raw and solidified air pollution control (APC) residues were examined via a nine-time multiple leaching test. The effect of injected activated carbon in the APC residues on the PCDD/F leachability was also evaluated. When humic acid solution was used as a leachant, the leaching concentrations of PCDD/Fs fluctuated between the first and the fifth leaching, followed by a gradual increase and then suddenly reached maximum values at the leaching sequences around seventh and eighth. This significant enhancement in PCDD/F leachability was mainly due to an increase in the release of highly chlorinated PCDD/Fs. Leaching of PCDD/Fs with n-hexane was, in contrast, primarily caused by the partitioning of hydrophobic PCDD/Fs between the APC residue surface and the liquid phase of n-hexane. Consequently, the largest leaching concentrations for n-hexane tests achieved at the first leaching, followed by a decrease and reached plateaus. Solidification/stabilization (S/S) decreased the PCDD/F leachability up to the fifth leaching by the use of humic acid solution. However, S/S increased the PCDD/F leaching concentrations and rates with n-hexane. The activated carbon in APC residues significantly inhibited the release of PCDD/F with n-hexane. The inhibiting effect provided by activated carbon was, however, less significant by the use of humic acid solution.     

Life Cycle Assessment of a Wastewater Treatment Plant Focused on Material and Energy Flows

Life cycle assessment (LCA) was applied to analyze a food-processing wastewater treatment plant and investigate the economic and environmental effects of the plant. With the long-term operational data of this plant, an inventory of relative inputs, e.g., flow rate, chemical oxygen demand (COD), and suspended solids, etc., and outputs of the plant, e.g., effluent COD and suspended solids, methane production, etc., was compiled. The potential environmental effects associated with those inputs and outputs were evaluated, and the results of the inventory analysis and impact assessment phases of the plant were interpreted. One feature of this study was the assessment of the treatment plant based on both energy and material flows. Another feature was the establishment of an assessment model with an integration of plant operating parameters, system recognition and grey relation. The analytical results are helpful for the design and operation of wastewater treatment plants.     

Polybrominated diphenyl ethers in various atmospheric environments of Taiwan: their levels, source identification and influence of combustion sources

In this study, ambient air samples from different atmospheric environments were examined for both PBDE and PCDD/F characteristics to verify that combustion is a significant PBDE emission source. The mean ± SD atmospheric PBDE concentrations were 165 ± 65.0 pg Nm⁻³ in the heavy steel complex area and 93.9 ± 24.5 pg Nm⁻³ in the metals complex areas, 4.7 and 2.7 times higher than that (35.3 ± 15.5 pg Nm⁻³) in the urban areas, respectively. The statistically high correlation (r = 0.871, p < 0.001) found between the atmospheric PBDE and PCDD/F concentrations reveals that the combustion sources are the most likely PBDE emission sources. Correspondence analysis shows the atmospheric PBDEs of the heavy steel and metals complex areas are associated with BDE-209, -203, -207, -208, indicative of combustion source contributions. Furthermore, the PBDEs in urban ambient air experience the influence of the evaporative releases of the commercial penta- and octa-BDE mixtures, as well as combustion source emissions. By comparing the PBDE homologues of indoor air, urban ambient air, and stack flue gases of combustion sources, we found that the lighter brominated PBDEs in urban ambient air were contributed by the indoor air, while their highly brominated ones were from the combustion sources, such as vehicles. The developed source identification measure can be used to clarify possible PBDE sources not only for Taiwanese atmosphere but also for other environmental media in other countries associated with various emission sources in the future.     

Characterizing the interactions between polycyclic aromatic hydrocarbons and fulvic acids in water

Polycyclic aromatic hydrocarbons (PAHs) are persistent, bioaccumulative, and toxic chemicals and are listed as priority pollutants by the US EPA. Although they are sparsely soluble in water, their solubility can be increased by binding to dissolved organic matter in natural waters, which will further increase their environmental risk as toxic pollutants. In this study, the interaction between PAHs, exemplified by fluorene and anthracene, and fulvic acid (FA) was studied using fluorescence quenching titration method with fluorescence emission spectra, respectively. The association of FA with the mixture of fluorene and anthracene was also evaluated by excitation–emission matrix (EEM) fluorescence spectrometry combined with parallel factor (PARAFAC) analysis. Results demonstrate that EEM fluorescence spectrometry with PARAFAC analysis was sensitive and reliable to determine the binding properties of PAHs with FA in a mixed aqueous solution. The conditional stability constants and binding capacities show that both PAHs bind to FA tightly.     

PCDD/Fs levels in indoor environments and blood of workers of three municipal waste incinerators in Taiwan

This study monitored ambient air concentrations of polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans (PCDD/Fs) in three municipal waste incineration plants. Blood PCDD/Fs levels of 133 workers randomly selected from these plants were also measured. The associations between workers' blood PCDD/Fs concentrations and occupational exposures to PCDD/Fs were assessed. Means of air PCDD/Fs levels ranged from 0.08 to 3.01 pg/m3 in international toxic equivalents (I-TEQ). The geometric means of blood PCDD/Fs concentrations were 14.6, 15.8, 19.1 pg/g lipid in World Health Organization (WHO) TEQ, respectively, for workers from three plants. Air levels of total I-TEQ and all congeners, except 2,3,7,8-tetrachlorinated dibenzo-p-dioxin (TeCDD) and 1,2,3,4,7,8,9-heptachlorinated dibenzofuran (HpCDF), were significantly higher in plant B. However, blood concentrations of 2,3,7,8-TeCDD, 1,2,3,7,8-PeCDD, 2,3,7,8-TeCDF, 1,2,3,7,8-PeCDF and 1,2,3,4,7,8,9-HpCDF were significantly elevated in plant C workers. Although job contents, duration of employment and time spent in certain location were significantly different among incineration plants, they were not significantly associated with blood concentrations of any congener. Furthermore, results of the multiple regression analysis that assessed important occupational factors simultaneously and adjusted for potential confounders, showed significant associations between four congeners and incineration plant or job contents. However, the results were limited by small R-squares of the regression models. In conclusion, blood concentrations of several PCDD/Fs congeners were significantly different among three incineration plants. The differences were not explained by the discrepancy in job contents, duration of employment, and time activity in these plants.