Economic growth and CO<Subscript>2</Subscript> emissions

This article considers a planner’s optimum control exercise with environmental pollution and derives a testable link between the growth rates of consumption and pollution. The link is then empirically estimated for the case of CO₂ emissions for a sample consisting of the union of top 25 countries in terms of CO₂ emissions, population and per capita GNP. The analysis suggests that the interrelationship between the growth rates of CO₂ emission and economic development is mostly significant for countries that have a high level of CO₂ emissions and population.     

Isolation of a novel Pseudomonas sp from soil that can efficiently degrade polyethylene succinate

Purpose

Polyethylene succinate (PES) is a biodegradable synthetic polymer and therefore widely used as a base material in plastic industry to circumvent the environmental problems related with the non-biodegradability of other polymers like polyethylene. Till date only few organisms have been reported to have the ability to degrade PES. Therefore for better management of PES-related environmental waste, the present study is targeted towards isolating mesophilic organism(s) capable of more efficient degradation of PES.

Results

Strain AKS2 was isolated from soil based on survival on a selection plate wherein PES was used as sole carbon source. Ribotyping and biochemical tests revealed that AKS2 is a new strain of Pseudomonas. Scanning electron and atomic force microscopic analysis of the PES films obtained after incubation with AKS2 confirmed PES-degradation ability of AKS2, wherein an alteration in surface topology was observed. The kinetics of PES weight loss showed that AKS2 degrades PES maximally during its logarithmic growth phase at a rate of 1.65?mg/day. This degradation is mediated by esterase activity and may also involve cell-surface hydrophobicity. It has also been observed that AKS2 is able to degrade PES considerably even in the presence of glucose, which is likely to increase the bioremediation potential of this isolate.

Conclusion

A new strain of Pseudomonas has been isolated from soil that is able to adhere to PES and degrade this polymer efficiently. This organism has the potential to be implemented as a useful tool for bioremediation of PES-derived materials.     

A mathematical model for type II profile of concentration distribution in turbulent flows

This paper presents a mathematical model to investigate type II profile of suspension concentration distribution (i.e., the concentration profile where the maximum concentration appears at some distance above the bed surface) in a steady, uniform turbulent flow through open-channels. Starting from the mass and momentum conservation equations of two-phase flow, a theoretical model has been derived. The distribution equation is derived considering the effects of fluid lift force, drag force, particle inertia, particle–particle interactions, particle velocity fluctuations and drift diffusion. The equation is solved numerically and is compared with available experimental data as well as with other models existing in the literature. Good agreement between the observed value and computed result, and minimum error in comparison to other models indicate that the present model can be applied in predicting particle concentration distribution for type II profile for a wide range of flow conditions. The proposed model is also able to show the transition from type I profile to type II profile.     

An ergonomic study on posture-related discomfort among preadolescent agricultural workers of West Bengal, India.

In India, particularly in West Bengal, preadolescents are primarily associated with agricultural work in rural areas. Owing to poor socio-economic conditions, they are compelled to carry out a considerable number of manual, rigorous tasks in agricultural fields. The main aim of this study was to investigate postures adopted by preadolescent agricultural workers during individual agricultural activities and to analyze the causes of discomfort related to those postures. Fifty male and 50 female preadolescent agricultural workers were randomly selected and a detailed posture analysis was performed with the Ovako Working Posture Analysis System (OWAS). It was observed that those workers worked continuously in awkward postures during certain agricultural activities. Consequently they suffered from discomfort in different parts of their body. Even though they were very young, they were likely to suffer from serious musculoskeletal disorders in the future.     

An Ergonomie Study on Posture-Related Discomfort Among Preadolescent Agricultural Workers of West Bengal,India

In India, particularly in West Bengal, preadolescents are primarily associated with agricultural work in rural areas. Owing to poor socio-economic conditions, they are compelled to carry out a considerable number of manual, rigorous tasks in agricultural fields. The main aim of this study was to investigate postures adopted by preadolescent agricultural workers during individual agricultural activities and to analyze the causes of discomfort related to those postures. Fifty male and 50 female preadolescent agricultural workers were randomly selected and a detailed posture analysis was performed with the Ovako Working Posture Analysis System (OWAS). It was observed that those workers worked continuously in awkward postures during certain agricultural activities. Consequently they suffered from discomfort in different parts of their body. Even though they were very young, they were likely to suffer from serious musculoskeletal disorders in the future.     

Comparison of the effects of variable site temperatures and constant incubation temperatures on the biodegradation of petroleum hydrocarbons in pilot-scale experiments with field-aged contaminated soils from a cold regions site

Temporal atmospheric temperature changes during summers at sub-Arctic sites often cause periodic fluctuations in shallow landfarm and surface soil temperatures. However, little information is available on the effect of site-relevant variations on biodegradation performance in cold climates. This study compares the rate and extents of biodegradation of petroleum hydrocarbons at variable site temperatures (1-10 °C) representative of summers at a sub-Arctic site reported previously with those obtained under a constant average temperature of 6 °C. The biodegradation was evaluated in pilot-scale landfarming experiments with field-aged petroleum-contaminated soils shipped from Resolution Island (61°30′N, 65°00′W), Nunavut, Canada. Under the variable site temperature conditions biodegradation rate constants of semi- (F2) and non-volatile (F3) hydrocarbon fractions were enhanced by over a factor of two during the 60-d experiment, compared to the constant temperature mode. The decrease in total petroleum hydrocarbons (TPH) under the variable site temperature mode was 55% compared to only 19% under the constant average temperature mode. The enhanced biodegradation is attributable to the non-linear acceleration of microbial activity between 4.7 and 10 °C and faster growth of indigenous hydrocarbon-degrading microbial populations. The first-order biodegradation rate constants of 0.018, 0.024 and 0.016 d⁻¹ for TPH, F2 and F3 fractions at the variable site temperature were in agreement with those determined by an on-site experiment at the same site.     

Chemical speciation of PM emissions from heavy-duty diesel vehicles equipped with diesel particulate filter (DPF) and selective catalytic reduction (SCR) retrofits

Four heavy-duty diesel vehicles (HDDVs) in six retrofitted configurations (CRT^®, V-SCRT^®, Z-SCRT^®, Horizon, DPX and CCRT^®) and a baseline vehicle operating without after--treatment were tested under cruise (50 mph), transient UDDS and idle driving modes. As a continuation of the work by Biswas et al. [Biswas, S., Hu, S., Verma, V., Herner, J., Robertson, W.J., Ayala, A., Sioutas, C., 2008. Physical properties of particulate matter (PM) from late model heavy-duty diesel vehicles operating with advanced emission control technologies. Atmospheric Environment 42, 5622–5634.] on particle physical parameters, this paper focuses on PM chemical characteristics (Total carbon [TC], Elemental carbon [EC], Organic Carbon [OC], ions and water-soluble organic carbon [WSOC]) for cruise and UDDS cycles only. Size-resolved PM collected by MOUDI–Nano-MOUDI was analyzed for TC, EC and OC and ions (such as sulfate, nitrate, ammonium, potassium, sodium and phosphate), while Teflon coated glass fiber filters from a high volume sampler were extracted to determine WSOC. The introduction of retrofits reduced PM mass emissions over 90% in cruise and 95% in UDDS. Similarly, significant reductions in the emission of major chemical constituents (TC, OC and EC) were achieved. Sulfate dominated PM composition in vehicle configurations (V-SCRT^®-UDDS, Z-SCRT^®-Cruise, CRT^® and DPX) with considerable nucleation mode and TC was predominant for configurations with less (Z-SCRT^®-UDDS) or insignificant (CCRT^®, Horizon) nucleation. The transient operation increases EC emissions, consistent with its higher accumulation PM mode content. In general, solubility of organic carbon is higher (average ～5 times) for retrofitted vehicles than the baseline vehicle. The retrofitted vehicles with catalyzed filters (DPX, CCRT^®) had decreased OC solubility (WSOC/OC: 8–25%) unlike those with uncatalyzed filters (SCRT^®s, Horizon; WSOC/OC ～ 60–100%). Ammonium was present predominantly in the nucleation mode, indicating that ternary nucleation may be the responsible mechanism for formation of these particles.     

Microbial siderophores and their potential applications: a review

Siderophores are small organic molecules produced by microorganisms under iron-limiting conditions which enhance the uptake of iron to the microorganisms. In environment, the ferric form of iron is insoluble and inaccessible at physiological pH (7.35–7.40). Under this condition, microorganisms synthesize siderophores which have high affinity for ferric iron. These ferric iron-siderophore complexes are then transported to cytosol. In cytosol, the ferric iron gets reduced into ferrous iron and becomes accessible to microorganism. In recent times, siderophores have drawn much attention due to its potential roles in different fields. Siderophores have application in microbial ecology to enhance the growth of several unculturable microorganisms and can alter the microbial communities. In the field of agriculture, different types of siderophores promote the growth of several plant species and increase their yield by enhancing the Fe uptake to plants. Siderophores acts as a potential biocontrol agent against harmful phyto-pathogens and holds the ability to substitute hazardous pesticides. Heavy-metal-contaminated samples can be detoxified by applying siderophores, which explicate its role in bioremediation. Siderophores can detect the iron content in different environments, exhibiting its role as a biosensor. In the medical field, siderophore uses the “Trojan horse strategy” to form complexes with antibiotics and helps in the selective delivery of antibiotics to the antibiotic-resistant bacteria. Certain iron overload diseases for example sickle cell anemia can be treated with the help of siderophores. Other medical applications of siderophores include antimalarial activity, removal of transuranic elements from the body, and anticancer activity. The aim of this review is to discuss the important roles and applications of siderophores in different sectors including ecology, agriculture, bioremediation, biosensor, and medicine.     

Assessment of transport of two polyelectrolyte-stabilized zero-valent iron nanoparticles in porous media

This study investigated the breakthrough patterns of carboxymethyl cellulose- and polyacrylic acid-stabilized zero-valent iron (Fe(0)) nanoparticles (NZVI) from packed sand columns under a range of pore water velocities of 0.02, 0.2 and 1 cm min(-1) and NZVI influent concentrations of 0.1, 0.5 and 3 g L(-1). The NZVI effluent relative concentrations of both types of particles decreased with slower flow velocities and increasing particle concentrations. PAA-NZVI exhibited slower elution from the columns than CMC-NZVI under identical experimental conditions, and this is attributed to more rapid aggregation kinetics of PAA-NZVI. The elution patterns of PAA-NZVI showed a stronger trend of gradually increasing effluent concentrations with flushing of additional pore volumes, especially at low flushing velocities and higher influent particle concentrations and this phenomenon too can be attributed to increasing aggregate sizes with time which caused decreases in the values of the single collector efficiency and thus the deposition rate constant. A 7 nm increase in CMC-NZVI aggregate size over 60 min was observed using nanoparticle tracking analysis. The reduction in colloidal stability due to aggregation of CMC- and PAA-NZVI was verified using sedimentation tests, and it was found that PAA-NZVI were less stable than CMC-NZVI. There were also notable inherent differences in the two NZVI particles. The CMC-NZVI were monodisperse with a mean diameter of 5.7 ± 0.9 nm, whereas PAA-NZVI had a bimodal particle size distribution with a small sub-population of particles with mean size of 30 ± 21 nm and a more abundant population of 4.6 ± 0.8 nm diameter particles. Furthermore, PAA-NZVI had a lower surface potential. These characteristics are also responsible for the different elution patterns CMC- and PAA-NZVI.     

Study on the Thermo-Mechanical and Biodegradable Properties of Shellac Films Grafted with Acrylic Monomers by Gamma Radiation

Shellac (SL) films were prepared by casting and were grafted with various acrylic monomers of different functionalities using gamma radiation. Different formulations of shellac with varying concentrations (3, 5 and 7%) of these acrylic monomers such as 2-hydroxyethyl methacrylate (HEMA), 2-ethylhexyl acrylate (EHA) and 1,4-butanediol diacrylate (BDDA) in methanol were prepared. The pure shellac and other treated films were then irradiated under gamma radiation (Co-60) at different doses (0.5–5 kGy) at a dose rate of 3.5 kGy/h where 1 Gy = 1 J/kg = 100 rads. The mechanical properties like tensile strength (TS) and elongation at break (Eb) of the prepared films were studied. The mechanical properties of the irradiated shellac films demonstrated superior values. Among the formulations, shellac grafted with BDDA (SL-g-BDDA) showed the highest TS and Eb values which were 543 and 168% higher than those of raw shellac films, respectively. The water uptake behavior of raw and treated films was also studied. The raw film showed 11% water uptake but HEMA containing film showed 67%. In the soil burial test, HEMA containing shellac film was rapidly degraded than other raw, EHA and BDDA grafted films. Thermal properties indicated that grafting of acrylic monomers decreased the melting temperature of the pure shellac films.