Radium geochemistry in Na-Cl type groundwater in Niigata Prefecture, Japan

Radium isotopes in 23 Na-Cl type groundwater sampled mainly from deep wells in Niigata Prefecture, which is the site of the largest oil- and gas-fields in Japan, were measured along with U isotopes, chemical components and hydrogen and oxygen isotope ratios to elucidate the distribution and behavior of Ra in a brackish environment underground. Also analyzed were U and Th isotopes in 38 rock samples collected from outcrops at 17 locations. Ra-226 concentrations (8.86-1637 mBq kg⁻¹) of groundwater samples roughly correlated with total dissolved solid (TDS) concentrations and other alkaline earth contents. Their ²²⁸Ra/²²⁶Ra activity ratios (0.32-5.2) were similar to or higher than the ²³²Th/²³⁸U activity ratios (0.6-1.7) in the rocks. The most likely transport mechanism of Ra isotopes into groundwater was due to their α-recoil from the solid phase, probably from the water-rock interface where Th isotopes had accumulated, and adsorption/desorption reaction based on the increase in ²²⁶Ra contents with TDS.     

Analysis of running child pedestrians impacted by a vehicle using rigid-body models and optimization techniques

Lack of information from vehicle-to-child pedestrian impacts provides considerable challenges when developing vehicle countermeasures for the pediatric population. Crash reconstructions of real-world incidents provide useful information about the vehicle damage and injury outcome but do not permit definitive and quantitative measures of the impact severity given the high level of uncertainty in the initial conditions of the pedestrian and the vehicle prior the impact. This paper develops an advanced methodology for reconstructing child pedestrian–vehicle impacts that combines the crash data with multi-body simulations and optimization techniques for identifying the pedestrian posture and vehicle speed prior to impact. For the child pedestrian posture, a continuous sequence of the running gait was developed based on the literature data and simulations. Using vehicle damage information from an actual child pedestrian crash, an objective function was developed that minimized the difference between vehicle and pedestrian contact points for the simulated child postures, pedestrian, and vehicle speeds. Simulated annealing and genetic optimization algorithms were used to identify sets of potential solutions for the pedestrian and vehicle initial conditions. Local minimums were observed for several response surfaces of the objective function which shows the non-convex nature of the crash reconstruction optimization problem with the chosen objective function. Based on the results of the real-world reconstruction, this study indicates that numerical simulations coupled with heuristic optimization algorithms can be used to reconstruct child pedestrian and vehicle pre-impact conditions.     

Stable C and N isotope analysis elucidated the importance of zooplankton in a tropical seagrass bed of Santiago Island,Northwestern Philippines

The role of zooplankton in a tropical seagrass ecosystem was investigated in milkfish farms pollution-impacted and -unimpacted seagrass beds in Santiago Island coral reefs, Northwestern Philippines. The aim was to compare between the two sites: (1) abiotic factors and zooplankton community parameters, and (2) the trophic structure using C and N stable isotopes. Low water (98–119?mV) and sediment (–121 to ?138?mV) Oxidation Reduction Potential values indicated a reducing environment in the impacted site. Zooplankton in the impacted site showed the typical community response to eutrophication (low diversity, but high total abundance due to the dominance of the cyclopoid copepod Oithona oculata), generally few elevated δ¹⁵N values, but a significant shift towards depleted ¹³C due to the organic enrichment of fish-farm feeds. Apart from suggesting a highly complex food web with POM and zooplankton as main food sources in the unimpacted site, the Bayesian mixing model simulation generated reduced complexity in feeding interactions between basal sources, zooplankton, and fish including adults of a key fish species, Siganus fuscescens, in the impacted sites. In this study, C and N stable isotope analysis has clarified the importance of zooplankton as fish prey in a seagrass bed food web.     

Research and development of electric vehicles for clean transportation

This article presents the research and development of an electric vehicle (EV) in Dept.of Human-Robotics Saitama Institute of Technology.Electric mobile systems developed in our laboratory include a converted electric automobile,electric wheelchair and personal mobile robot.These mobile systems contribute to realize clean transportation since energy sources and devices from all vehicles,i.e.,batteries and electric motors,does not deteriorate the environment.To drive motors for vehicle traveling,robotic technologies were applied.     

Performance tests of newly developed adsorption/plasma combined system for decomposition of volatile organic compounds under continuous flow condition

The adsorption/plasma decomposition with the combination of adsorption honeycomb-sheets and a plasma element is a new technology for small-sized apparatuses to decompose volatile organic compounds (VOCs) at concentrations lower than about 100 ppm. The feasibility of the prototype adsorption/plasma decomposition apparatus was evaluated with the simulated exhausts containing one VOC component and with real exhausts from a painting booth and an adhesion factory. The apparatus decomposed VOCs e ectively at the painting booth exhaust but not always satisfactorily at the adhesion factory exhaust. The performance test results with real exhausts were discussed with respect to the concentration and discharge pattern of the exhausts and the basic properties of the system such as cooperation of adsorption and plasma reaction and the concentration dependence of the performance.     

Formaldehyde Exposure in a Gross Anatomy Laboratory. Personal Exposure Level Is Higher Than Indoor Concentration (5 pp)

Goal, Scope and Background Cadavers for gross anatomy laboratories are usually prepared by using embalming fluid which contains formaldehyde (FA) as a principal component. During the process of dissection, FA vapors are emitted from the cadavers, resulting in the exposure of medical students and their instructors to elevated levels of FA in the laboratory. The American Conference of Governmental Industrial Hygienists (ACGIH) has set a ceiling limit for FA at 0.3 ppm. In Japan, the Ministry of Health, Labour and Welfare has set an air quality guideline defining two limit values for environmental exposure to FA: 0.08 ppm as an average for general workplaces and 0.25 ppm for specific workplaces such as an FA factory. Although there are many reports on indoor FA concentrations in gross anatomy laboratories, only a few reports have described personal FA exposure levels. The purpose of the present study was to clarify personal exposure levels as well as indoor FA concentrations in our laboratory in order to investigate the relationship between them. Methods The gross anatomy laboratory was evaluated in the 4th, 10th and 18th sessions of 20 laboratory sessions in total over a period of 10 weeks. Air samples were collected using a diffusive sampling device for organic carbonyl compounds. Area samples were taken in the center and four corners of the laboratory during the entire time of each session (4-6 hours). Personal samples were collected from instructors and students using a sampling device pinned on each person's lapel, and they were 1.1 to 6 hours in duration. Analysis was carried out using high performance liquid chromatography. Results and Discussion Room averages of FA concentrations were 0.45, 0.38 and 0.68 ppm for the 4th, 10th and 18th sessions, respectively, ranging from 0.23 to 1.03 ppm. These levels were comparable to or relatively lower than the levels reported previously, but were still higher than the guideline limit for specific workplaces in Japan and the ACGIH ceiling limit. The indoor FA concentrations varied depending on the contents of laboratory sessions and seemed to increase when body cavity or deep structures were being dissected. In all sessions but the 4th, FA levels at the center of the room were higher than those in the corners. This might be related to the arrangement of air supply diffusers and return grills. However, it cannot be ruled out that FA levels in the corners were lowered by leakage of FA through the doors and windows. Average personal exposure levels were 0.80, 0.45 and 0.51 ppm for instructors and 1.02, 1.08 and 0.89 ppm for students for the 4th, 10th and 18th session, respectively. The exposure levels of students were significantly higher than the mean indoor FA concentrations in the 4th and 10th sessions, and the same tendency was also observed in the 18th session. The personal exposure level of instructors was also significantly higher than the indoor FA level in the 4th session, while they were almost the same in the 10th and 18th sessions. Differences in behavior during the sessions might reflect the differential personal exposure levels between students and instructors. Conclusion The present study revealed that, if a person is close to the cadavers during the gross anatomy laboratory, his/her personal exposure level is possibly 2 to 3-fold higher than the mean indoor FA concentration. This should be considered in the risk assessment of FA in gross anatomy laboratories. Recommendation and Outlook If the risk of FA in gross anatomy laboratories is assessed based on the indoor FA levels, the possibility that personal exposure levels are 2 to 3-fold higher than the mean indoor FA level should be taken into account. Otherwise, the risk should be assessed based on the personal exposure levels. However, it is hard to measure everyone's exposure level. Therefore, further studies are necessary to develop a method of personal exposure assessment from the indoor FA concentration.     

Seasonal and spatial variation of atmospheric 210Pb and 7Be deposition: features of the Japan Sea side of Japan

Monthly depositional fluxes of (210)Pb and (7)Be at Tatsunokuchi, Japan which faces the Japan Sea were studied over a 12-year period from 1991 to 2002. The data were compared with the spatial variability of these fluxes at Taejon in Korea and at 11 other sites in Japan from Ishigaki of the southern islands of Okinawa to Wakkanai of the northern end of Hokkaido over a 2-year period from 2000 to 2001. The monthly depositions of both (210)Pb and (7)Be at Tatsunokuchi revealed very similar seasonal variations with a single peak; both depositions were high in winter and low in summer. This phenomenon was found to be not transient but stationary. The deposition of these nuclides was much greater on the Japan Sea side of Japan than on the Pacific Ocean side. The cause for high deposition of (210)Pb and (7)Be in winter might be explained by a combination of a series of the following processes: blowing out of air masses with a high (210)Pb concentration near the surface layer over the continent by strong winter monsoons, additional flow of cold air masses with high (7)Be concentration at high latitude, well-mixing with generation of ascending current and convection clouds over the Japan Sea, and heavy snowfalls accompanying them.     

Plutonium concentration and 240Pu/239Pu atomic ratio in liver of squid collected in the coastal sea areas of Japan

Plutonium isotopes, 239Pu and 240Pu, were measured in liver samples from Surume squid using a sector-field high resolution ICP-MS after radiochemical purification. Surume squid samples were obtained from nine landing ports in Japanese inshore during fishery season from September to December 2002. Concentrations of 239Pu and 240Pu ranged from 1.5 to 28 mBq kg(-1) and 1.1 to 24 mBq kg(-1), respectively. Plutonium (239,240Pu) concentrations in liver were several thousand times higher than levels found in seawater. The concentration factor (CF) compared to seawater for 239,240Pu and 13 other elements ranged from 10(0) to 10(7). The CF values for 239,240Pu, V and Th were 10(2)-10(4). Pu had an intermediate CF between conservative and scavenged elements. 240Pu/239Pu atomic ratios in the squid liver ranged from 0.177 to 0.237 which were slightly higher than 0.178+/-0.014 for global fallout. The variations of 240Pu/239Pu atomic ratios in ocean currents with different source functions are important for interpreting high 240Pu/239Pu atomic ratios in Surume squid liver. It seems likely that Pu with high 240Pu/239Pu atomic ratio is continuously transported through the solubilization and seawater transport from the North Equatorial Current to Kuroshio and its branch, Tsushima Current. By assuming that Pu found in Surume squid liver is a mixture of global fallout Pu (0.178) and close-in fallout Pu with high 240Pu/239Pu atomic ratio (0.30-0.36) around Bikini Atoll, Pu contribution from Bikini close-in fallout Pu accounts for close to 35% of the whole plutonium in Surume squid liver. These results highlight that Surume squid is a useful organism for evaluating environmental Pu levels of larger sea area and facilitate the development of models to understand oceanic transport of close-in fallout Pu from Bikini Atoll.     

Variability and reliability of POP concentrations in multiple breast milk samples collected from the same mothers

Risk assessment of infant using a realistic persistent organic pollutant (POP) exposure through breast milk is essential to devise future regulation of POPs. However, recent investigations have demonstrated that POP levels in breast milk collected from the same mother showed a wide range of variation daily and monthly. To estimate the appropriate sample size of breast milk from the same mother to obtain reliable POP concentrations, breast milk samples were collected from five mothers living in Japan from 2006 to 2012. Milk samples from each mother were collected 3 to 6 times a day through 3 to 7 days consecutively. Food samples as the duplicated method were collected from two mothers during the period of breast milk sample collection. Those were employed for POP (PCBs, DDTs, chlordanes, and HCB) analysis. PCB concentrations detected in breast milk samples showed a wide range of variation which was maximum 63 and 60% of relative standard deviation (RSD) in lipid and wet weight basis, respectively. The time course trend of those variations among the mothers did not show any typical pattern. A larger amount of PCB intake through food seemed to affect 10 h after those concentrations in breast milk in lipid weight basis. Intraclass correlation coefficient (ICC) analyses indicated that the appropriate sample size for good reproducibility of POP concentrations in breast milk required at least two samples for lipid and wet weight basis.