Study of Pollution of the Plitvice Lakes by Water and Sediment Analyses

The process of eutrophication in form of intense plant growth has been observed in some lakes and water streams at the Plitvice Lakes National Park in central Croatia. Here we investigate whether this phenomenon is a consequence of anthropogenic pollution or due to naturally produced organic matter in the lakes. We applied chemical analysis of water at two springs and four lakes (nutrients, dissolved organic carbon (DOC), trace elements) and measurements of surface lake sediments (mineral and organic fraction analyses, trace elements) in four different lakes/five sites. The chemical composition of water does not indicate recent anthropogenic pollution of water because the concentrations of most trace elements are below detection limits. The concentrations of DOC and nutrients are slightly higher in the area of increased eutrophication-plant growth. Also the content of organic matter in the sediment is at the highest level in areas with highest C/N ratio indicating that the organic fraction of this sediment is mainly of terrestrial origin. There is no significant difference among the trace element concentration in the upper segment of all cores, deposited approximately during last 50 years when higher anthropogenic influence is expected due to development and touristic activity, and the lower part of the cores, corresponding to the period approximately 100–200 years before present. The content of trace elements and organic matter in sediments decreases from the uppermost lake downstream. According to our results there is no indication of recent anthropogenic pollution in water and sediment. Higher concentrations of DOC in water as well as phosphorus and some other elements in the lake sediment can be a consequence of input of natural organic matter to the lake water.     

Used lubricating oil recycling using hydrocarbon solvents

A solvent extraction process using new hydrocarbon solvents was employed to treat used lubricant oil. The solvents used were liquefied petroleum gas (LPG) condensate and stabilized condensate. A demulsifier was used to enhance the treatment process. The extraction process using stabilized condensate demonstrated characteristics that make it competitive with existing used oil treatment technologies. The process is able to reduce the asphaltene content of the treated lubricating oil to 0.106% (w/w), the ash content to 0.108%, and the carbon residue to 0.315% with very low levels of contaminant metals. The overall yield of oil is 79%. The treated used oil can be recycled as base lubricating oil. The major disadvantage of this work is the high temperature of solvent recovery. Experimental work and results are presented in detail.     

Photochemical Degradation of Aqueous Polyvinyl Alcohol in a Continuous UV/H<Subscript>2</Subscript>O<Subscript>2</Subscript> Process: Experimental and Statistical Analysis

Polyvinyl alcohol (PVA), being a dominant contributor of total organic carbon (TOC) in textile wastewater, is not easily degradable by conventional methods of wastewater treatment. This study investigates the degradation of aqueous PVA in a continuous UV/H₂O₂ photoreactor since the feeding strategy of hydrogen peroxide proves to have considerable effects on the process performance. Response surface methodology involving the Box–Behnken method is adopted for the experimental design to study the effects of operating parameters on the process performance. Experimental analysis shows that the TOC removal varies from 16.11 to 42.70 % along with a reduction of the PVA molecular weights from 56.7 to 95.3 %. The TOC removal is significantly lower than the molecular weight reduction due to the generation of the intermediate products during oxidation. Operating the UV/H₂O₂ process in a continuous mode facilitates the degradation of highly concentrated polymeric solutions using a relatively small hydrogen peroxide concentration in the feed with a small residence time ranges from 6.13 to 18.4 min.     

Mitigating the Davos dilemma: towards a global self-sustainability index

The ‘Davos dilemma’ posits a sustainability crisis, provoked by rising human population and intense competitive behaviours, in terms of control and access to depleting natural resources. More broadly understood as an ecological problem, rather than just socio-economic behavioural deficiencies, the call is for better integrated social, natural and business-indexed reporting within planetary boundaries. This poses challenges for nationally governed societies to equitably account for self-sustainability performance, in enabling their successive government agendas to re-orientate policies and industry investments as innovation towards achieving this in the longer term. We propose and test a global self-sustainability index for countries across four metrics: economic, environmental, social and innovation. Our tentative findings from a cross-country analysis of 27 countries during 2007–2010 illustrate the approach for wider systematic analysis and as a basis for future large-scale assessments on self-sustainability within and between countries.     

Application of a Second-Order Kinetic Model to a Complex Melt Polymerization Reaction

A novel copolymer system has been synthesized using methyl hydroquinone diacetate (MHQDA), 1,4 naphthalene dicarboxylic acid (1,4 NDCA), and polybutylene terephthalate (PBT) using the melt polymerization technique. The optimum kinetic parameters pertinent to this system are reported in this study. A simple second-order reaction sequence summarizes catalyzed and uncatalyzed reactions between MHQDA, 1,4 NDCA, and PBT. The kinetic parameters for the copolymerization reaction were determined using a new second-order model. This technique was used to compute the moles of acetic acid generated in the polymerization process. The model was compared to that of the experimentally determined data. Close comparison (percentage error of less than 5%) was obtained between the experimental and theoretical data. The kinetic data support block copolyester formation. The thermal data also supports formation of block polymers.     

Study of environmental isotope distribution in the Aswan High Dam Lake (Egypt) for estimation of evaporation of lake water and its recharge to adjacent groundwater

Oxygen-18 (¹⁸0) and deuterium isotopes were used to estimate the evaporation from the Aswan High Dam Lake and to investigate the inter-relation between the lake water and adjacent groundwater.According to stable isotopic analysis of samples taken in 1988 and 1989, the lake can be divided into two sections. In the first section extending between Abu Simbel and a point between EI-Alaki and Krosko, a remarkable vertical gradient of ¹⁸0 and deuterium isotopic composition was observed. The second northern sector extending to the High Dam is characterised by a lower vertical isotopic gradient. In this sector in general, higher values of ¹⁸O and deuterium contents were found at the top and lower values at the bottom. Also a strong horizontal increase of the heavy isotope content was observed. Thus, in the northern section evaporation is of dominating influence on the isotopic composition of the lake water.With the help of an evaporation pan experiment it was possible to calibrate the evaporative isotope enrichment in the lake and to facilitate a preliminary estimate of evaporative losses of lake water. The evaporation from the lake was estimated to be about 19% of the input water flow rate.The groundwater around the lake was investigated and samples from production wells and piezometers were subjected to isotopic analysis. The results indicate that recent recharge to the groundwater aquifer is limited to wells near to the lake and up to a maximum distance of about 10 km. The contribution of recent Nile water to the groundwater in these wells was estimated to range between 23 and 70%. Beyond this distance, palaeowater was observed with highly depleted deuterium and ¹⁸0 contents, which was also confirmed by 14c dating. The age of palaeo groundwater in this area can reach values of more than 26,000 years.Recommendations are given for efficient water management of the lake water.     

Removal of olive mill waste water phenolics using a crude peroxidase extract from onion by-products

Olive mill waste water (OMWW) originating from a two-phase olive oil-producing plant was treated with a crude peroxidase extract prepared from onion solid by-products. The treatments were based on a 3 × 3 factorial design, employing a series of combinations of pH and H₂O₂, in order to identify optimal operational conditions. The treatment performance was assessed by estimating the removal percentage of total polyphenols. The model established produced a satisfactory fitting of the data (R ² = 0.94, p = 0.0158), while the second-order polynomial equation used to describe the process indicated that peroxidase-catalysed polyphenol removal in diluted OMWW is facilitated at relatively low pH and intermediate H₂O₂ values. A predicted value of 50.7 ± 9.5% removal was calculated under optimal operational conditions (pH 2.76, [H₂O₂] = 3.56 mM). Analysis of an untreated and an optimally treated sample by high performance liquid chromatography revealed that enzyme treatment brought about alteration in the original OMWW polyphenolic profile. The use of peroxidase from onion solid by-products is proposed as an alternative means that could have a prospect in bioremediation applications.     

Identification and Model Predictive Control (MPC) of Aqueous Polyvinyl Alcohol Degradation in UV/H2O2 Photochemical Reactors

Journal of Polymers and the Environment - The performance of two continuous UV/H2O2 photoreactors in series under unsteady-state condition is studied. An input–output dynamic model is...     

Influence of phytase on water-soluble phosphorus in poultry and swine manure

The effect of dietary non-phytin phosphorus (NPP) and phytase (PHY) concentration on total phosphorus (TP) and water-soluble phosphorus (WSP) excretion was determined. Diets tested in broiler experiments were: National Research Council nutrient requirements for non-phytin phosphorus (NRC), NRC + PHY, reduced non-phytin phosphorus (RED), and RED + PHY. Turkey and swine experiment diets included NRC, RED, and RED + PHY. For all experiments, except broiler Experiment 1, excreta were: (i) boiled, antibiotic added, then frozen; (ii) boiled, antibiotic added, incubated (37 degrees C for 72 h), then frozen; and (iii) incubated, boiled, antibiotic added, then frozen. In Experiment 1, excreta were collected and frozen or incubated for 24 or 48 h. In broiler Experiment 1, WSP was not affected by phytase but increased with post-excretion incubation. In a broiler Experiment 2, reducing NPP resulted in reduced excreta TP and WSP (11.3 to 8.3 and 5.3 to 2.7 g kg(-1)). Feeding RED + PHY diets resulted in less TP and WSP (7.6 and 0.6 g kg(-1)) as compared with NRC + PHY (11.2 and 3.9 g kg(-1), Experiment 3). Incubation resulted in increased WSP, irrespective of phytase addition such that WSP as a percent of TP was similar among treatments. Addition of antibiotics before incubation prevented the increase in WSP. Similar results were observed with turkey and swine. Therefore, when phytase is used properly (i.e., with a simultaneous reduction of NPP), WSP or WSP as a percent of TP are not affected. The increase in WSP as a percent of TP post-excretion is a function of excreta microbial activity and not dietary phytase addition.     

Radiometric and environmental impacts of mill tailings at experimental plant processing unit,Allouga, Egypt

Abstract

Uranium mining and ore processing are known to be harmful to the environment and human health if the waste generated is not managed properly. The aim of the present study is to determine the radiological indices in the mill tailings and review the possible attempts to utilize and minimize its hazardous effect. The activity concentrations of natural radionuclides, ²³⁸U, ²³²Th, ²²⁶Ra, and ⁴⁰K have been measured by gamma spectrometry using HP-Ge detector. The average activity concentrations of ²³⁸U, ²³²Th, ²²⁶Ra, and ⁴⁰K in the tailings wastes were 2071.8, 59.92, 6921.262, and 445. 57?Bq/kg respectively which are higher than the international average limit. The ranges of hazard indices such as Radium equivalent activity (Ra_eq), external hazard index (H_ex), internal hazard index (H_in), γ-radiation hazard index I_γ, Dose rate (nGy/h) and annual effective dose equivalent (AED), were estimated. Uraniumm isotopic ratios in the ore –material and mill tailing samples indicate migration out of radionuclides to the surrounding environment causing contamination and many dangerous diseases. Fairly, all investigated tailing waste samples do not satisfy the universal standards, the studied wastes relatively still have high uranium contents and need reprocessing.