Postnatal nutrition influences male attractiveness and promotes plasticity in male mating preferences

Poor early-life nutrition could reduce adult reproductive success by negatively affecting traits linked to sexual attractiveness such as song complexity. If so, this might favor strategic mate choice, allowing males with less complex songs to tailor their mating tactics to maximize the reproductive benefits. However, this possibility has been ignored in theoretical and empirical studies. By manipulating the micronutrient content of the diet (e.g., low or high) during the postnatal period of male zebra finches, we show for the first time (1) that males reared on a poor (low) micronutrient diet had less complex songs as adults; (2) that these males, in contrast to the high micronutrient diet group, were more selective in their mating strategies, discriminating against those females most likely to reduce their clutch size when paired with males having less complex songs; and (3) that by following different mating strategies, males reared on the contrasting diets obtained similar reproductive benefits. These results suggest that early-life dietary conditions can induce multiple and long-lasting effects on male and female reproductive traits. Moreover, the results seem to reflect a previously unreported case of adaptive plasticity in mate choice in response to a nutritionally mediated reduction in sexual attractiveness.     

Passive sampling: partition coefficients for a silicone rubber reference phase

Silicone rubber sheeting can be used as a passive sampling device for hydrophobic organic contaminants in the environment to determine the available concentrations in water and sediments. Reliable sampler-water partition coefficients are required to determine the sampling rates and the dissolved contaminant concentrations in water and in sediment pore water. Log partition coefficients (logK(sr,w)) for silicone rubber-water have been estimated for 32 polycyclic aromatic hydrocarbons (PAHs), 2 deuterated PAH analogues and 32 chlorobiphenyls (CBs) using the cosolvent method, with methanol as cosolvent. Strong linear relationships were found with literature values for the corresponding log octanol-water partition coefficients (logK(ow)) for both CBs and PAHs, confirming that partitioning into the silicone rubber is strongly determined by the hydrophobicity of the compounds, which suggests logK(ow) is a good predictor of logK(sr,w) and that absorption is the main mechanism for accumulation of analytes into the silicone rubber polymer.     

The distribution and composition of hydrocarbons in sediments from the Fladen Ground, North Sea, an area of oil production

The distribution and composition of hydrocarbons in sediment from the Fladen Ground oilfield in the northern North Sea have been investigated. The total PAH concentrations (2- to 6-ring parent and alkylated PAHs, including the 16 US EPA PAHs) in sediments were relatively low (<100 microg kg(-1) dry weight). The PAH, the Forties crude and diesel oil equivalent concentrations were generally higher in sediment of fine grain size and higher organic carbon concentration. PAH distributions and concentration ratios indicated a predominantly pyrolytic input, being dominated by the heavier, more persistent, 5- and 6-ring compounds, and with a high proportion of parent PAHs. The n-alkane profiles of a number of the sediments contained small, high boiling point, UCMs, indicative of weathered oil arising from a limited petrogenic input. The geochemical biomarker profiles of the sediments that contained UCMs showed a small bisnorhopane peak and a high proportion of norhopane relative to hopane, indicating that there was contamination from both Middle Eastern and North Sea oils. Therefore contamination was not directly as a result of oil exploration activity in the area. The most likely source of petrogenic contamination was from general shipping activity.     

Evaluation of airborne particulate matter and metals data in personal,indoor and outdoor environments using ED-XRF and ICP-MS and co-located duplicate samples

Factors and sources affecting measurement uncertainty associated with monitoring metals in airborne particulate matter (PM) were investigated as part of the Windsor, Ontario Exposure Assessment Study (WOEAS). The assessment was made using co-located duplicate samples and a comparison of two analytical approaches: ED-XRF and ICP-MS. Sampling variability was estimated using relative percent difference (RPD) of co-located duplicate samples. The comparison of ICP-MS and ED-XRF results yields very good correlations (R² ≥ 0.7) for elements present at concentrations that pass both ICP-MS and ED-XRF detection limits (e.g. Fe, Mn, Zn, Pb and Cu). PM concentration ranges (median, sample number) of 24-h indoor PM₁₀ and personal PM₁₀ filters, and outdoor PM_2.5 filters were determined to be 2.2–40.7 (11.0, n = 48) μg m^?3, 8.0–48.3 (11.9, n = 48) μg m^?3, and 17.1–42.3 (21.6, n = 18) μg m^?3, respectively. The gravimetric analytical results reveal that the variations in PM mass measurements for same-day sampling are insignificant compared to temporal or spatial variations: 92%, 100% and 96% of indoor, outdoor and personal duplicate samples, respectively, pass the quality criteria (RPD ≤ 20%). Uncertainties associated with ED-XRF elemental measurements of S, Ca, Mn, Fe and Zn for 24-h filter samples are low: 78%–100% of the duplicate samples passed the quality criteria. In the case of 24-h filter samples using ICP-MS, more elements passed the quality criteria due to the lower detection limits. These were: Li, Na, K, Ca, Si, Al, V, Fe, Mn, Co, Cu, Mo, Ag, Zn, Pb, As, Mg, Sb, Sn, Sr, Th, Ti, Tl, and U. Low air concentrations of metals (near or below instrumental detection limits) and/or inadvertent introduction of metal contamination are the main causes for excluding elements based on the pass/fail criteria. Uncertainty associated with elemental measurements must be assessed on an element-by-element basis.     

Real-Time Measurements of Jet Aircraft Engine Exhaust

Abstract

Particulate-phase exhaust properties from two different types of ground-based jet aircraft engines—high-thrust and turboshaft—were studied with real-time instruments on a portable pallet and additional time-integrated sampling devices. The real-time instruments successfully characterized rapidly changing particulate mass, light absorption, and polycyclic aromatic hydrocarbon (PAH) content. The integrated measurements included particulate-size distributions, PAH, and carbon concentrations for an entire test run (i.e., “run-integrated” measurements). In all cases, the particle-size distributions showed single modes peaking at 20–40nm diameter. Measurements of exhaust from high-thrust F404 engines showed relatively low-light absorption compared with exhaust from a turboshaft engine. Particulate-phase PAH measurements generally varied in phase with both net particulate mass and with light-absorbing particulate concentrations. Unexplained response behavior sometimes occurred with the real-time PAH analyzer, although on average the real-time and integrated PAH methods agreed within the same order of magnitude found in earlier investigations.     

Incineration and human health

After pollutants from an incineration facility disperse into the air, some people close to the facility may be exposed directly through inhalation or indirectly through consumption of food or water contaminated by deposition of the pollutants from air to soil, vegetation, and water. For metals and other pollutants that are very persistent in the environment, the potential effects may extend well beyond the area close to the incinerator. Persistent pollutants can be carried long distances from their emission sources, go through various chemical and physical transformations, and pass numerous times through soil, water, or food.     

Putting affected people at the centre of humanitarian action: an argument for the principle of humanitarian subsidiarity

The humanitarian system has grown organically over the course of a generation to become a complex system bound by a common primary mandate. Its guiding principles provide it with a unique identity and separate humanitarian actors from other aid-related stakeholders. However, all of the evidence suggests that humanitarian actors will extend their reach and engage in new and unprecedented ways with an expanded mandate in years to come. Now, more than ever, they are challenged to retain the moral high ground and to put disaster-affected people at the centre of humanitarian action. Consequently, this paper proposes that the humanitarian system introduce a new principle: humanitarian subsidiarity. It moves the conception of subsidiarity beyond meanings ascribed by the Catholic Church and the European Union and links it instead to the attributes of agency, accountability, and trust to find accommodation with the core humanitarian principles of humanity, impartiality, neutrality, and independence.