Impacts of converting from leaded to unleaded gasoline on ambient lead concentrations in Jakarta metropolitan area

Total suspended particulate mater （TSP） concentrations were monitored for one year from July 2000 and for one year from April 2003 in Jakarta City. Thirteen elemental TSP components, aluminum （Al）, sodium （Na）, iron （Fe）, lead （Pb）, potassium （K）, zinc （Zn）, titanium （Ti）, manganese （Mn）, bromine （Br）, copper （Cu）, chromium （Cr）, nickel （Ni）, and vanadium （V） were analyzed by a sequential X-ray fluorescence spectrometer. Al, Na, Fe, K, and Pb were major components at most of the sampling locations in 2000. However, only Pb in 2003 dramatically decreased to one tenth. The phase-out of leaded gasoline began on July 1, 2001 in Jakarta City and lead content in gasoline decreased to one tenth, too. The decrease in Pb concentration was a result of the phase-out of leaded gasoline, as lead emissions mainly are exhaust gas from vehicles.     

Sorption-Desorption of Atrazine and Diuron in Soils from Southern Brazil

The objective of this study was to investigate the behavior of sorption and desorption of the herbicides atrazine (6-chloro-N ²-ethyl-N ⁴-isopropyl-1,3,5-triazine-2,4-diamine) and diuron [3-(3,4-dichlorophenyl)-1,1-dimethyleurea] in soil samples from a typical lithosequence located in the municipality of Mamborê (PR), southern Brazil. Five concentrations of ¹⁴C-atrazine and ¹⁴C-diuron were used for both herbicides (0.48, 0.96, 1.92, 3.84, and 7.69 mg L^?1). Sorption of both herbicides correlated positively with the organic carbon and clay content of the soil samples. Sorption isotherms were well described by the Freundlich model. The slope values of the isotherm (N) ranged from 0.84 to 0.90 (atrazine) and from 0.75 to 0.79 (diuron) for the lithosequence samples. Sorption of diuron was high regardless of the soil texture or the concentration added. The desorption isotherms for atrazine and diuron showed good fit to the Freundlich equation (R ² ≥ 0,87). Atrazine slope values for the desorption isotherms were similar for the different concentrations and were much lower than those observed for the sorption isotherms. Significant hysteresis was observed in the herbicide desorption. When the two herbicides were compared, it was found that diuron (N = 0.06–0.22) presented more pronounced hysteresis than atrazine. The results showed that, quantitatively, a greater atrazine fraction applied to these soils remains available to be leached in the soil profile, as compared to diuron.     

Fate of Mutagenicity Produced During Anaerobic Biodegradation of the Herbicide Chlornitrofen (CNP)

The mutagenicity of chlornitrofen (CNP)-containing solutions has been reported to increase during anaerobic biodegradation. In the present study, the fate of this increased mutagenicity under subsequent aerobic and anaerobic incubation conditions was investigated using two Salmonella tester strains, YG1024 (a frameshift-detecting strain) and YG1029 (a base-pair-substitution-detecting strain). Mutagenicity for both YG1024 and YG1029 strains increased during nine-day anaerobic biodegradation. During subsequent anaerobic incubation, the increased mutagenicity decreased gradually for YG1029 but did not change significantly for YG1024. By contrast, the increased mutagenicity decreased rapidly after the conversion to aerobic incubation for both YG1024 and YG1029 strains. The rapid decrease in mutagenicity during aerobic incubation was due to decreases, not only in an identified mutagenic metabolite (CNP-amino) but also in unidentified mutagenic metabolites.     

High-resolution modeling and evaluation of ozone air quality of Osaka using an MM5-CMAQ system

High-resolution modeling approach is increasingly being considered as a necessary step for improving the monitoring and predictions of regional air quality.This is especially true for highly urbanized region with complex terrain and land-use.This study uses Community Multiscale Air Quality (CMAQ) model coupled with MM5 mesoscale model for a comprehensive analysis to assess the suitability of such high-resolution modeling system in predicting ozone air quality in the complex terrains of Osaka,Japan.The 1-km and 3-km grid domains were nested inside a 9-km domain and the domain with 1-km grid covered the Osaka region.High-resolution Grid Point Value-Mesoscale Model μgPV-MSM) data were used after suitable validation.The simulated ozone concentrations were validated and evaluated using statistical metrics using performance criteria set for ozone.Daily maxima of ozone were found better simulated by the 1-km grid domain than the coarser 9-km and 3-km domains,with the maximum improvement in the mean absolute gross error about 3 ppbv.In addition,1-km grid results fared better than other grids at most of the observation stations that showed noticeable differences in gross error as well as correlation.These results amply justify the use of the integrated high-resolution MM5-CMAQ modeling system in the highly urbanized region,such as the Osaka region,which has complex terrain and land-use.     

High-resolution modeling and evaluation of ozone air quality of Osaka using MM5-CMAQ system

High-resolution modeling approach is increasingly being considered as a necessary step for improving the monitoring and predictions of regional air quality. This is especially true for highly urbanized region with complex terrain and land-use. This study uses Community Multiscale Air Quality (CMAQ) model coupled with MM5 mesoscale model for a comprehensive analysis to assess the suitability of such high-resolution modeling system in predicting ozone air quality in the complex terrains of Osaka, Japan. The 1-km and 3-km grid domains were nested inside a 9-km domain and the domain with 1-km grid covered the Osaka region. High-resolution Grid Point Value-Mesoscale Model (GPV-MSM) data were used after suitable validation. The simulated ozone concentrations were validated and evaluated using statistical metrics using performance criteria set for ozone. Daily maxima of ozone were found better simulated by the 1-km grid domain than the coarser 9-km and 3-km domains, with the maximum improvement in the mean absolute gross error about 3 ppbv. In addition, 1-km grid results fared better than other grids at most of the observation stations that showed noticeable di erences in gross error as well as correlation. These results amply justify the use of the integrated high-resolution MM5-CMAQ modeling system in the highly urbanized region, such as the Osaka region, which has complex terrain and land-use.     

Impact of solids on biphasic biodegradation of phenanthrene in the presence of hydroxypropyl- β -cyclodextrin (HPCD)

The consequence of polycyclic aromatic hydrocarbons (PAHs) in the environment is of great concern. The hydrophobic properties of PAHs significantly impact phase distribution causing limited bioavailability. Enhanced biodegradation has been extensively carried out by surfactants and the redeployment effect was recognized. However, the quantitative relationship concerning the impact of solids was rarely reported. A batch of biphasic tests were carried out by introducing Mycobacterium vanbaalenii PYR-1 and hydroxypropyl-β-cyclodextrin (HPCD) into a mixture of phenanthrene solution and various glass beads (GB37-63, GB105-125, and GB350-500). The comparative results demonstrated that HPCD had little effect on microbial growth and was not degradable by bacterium. A model was proposed to describe the biodegradation process. The regression results indicated that the partition coefficient k_d (1.234, 0.726 and 0.448 L·g⁻¹) and the degradation rate k (0 mmol·L⁻¹: 0.055, 0.094, and 0.112; 20 mmol·L⁻¹: 0.126, 0.141, and 0.156; 40 mmol·L⁻¹: 0.141, 0.156 and 0.184 d⁻¹) were positively and negatively correlated with the calculated total surface area (TSA) of solids, respectively. Degradation enhanced in the presence of HPCD, and the enhancing factor f was calculated (20 mmol·L⁻¹: 15.16, 40.01, and 145.5; 40 mmol·L⁻¹: 13.29, 37.97, and 138.4), indicating that the impact of solids was significant for the enhancement of biodegradation.     

Investigation of air pollution concentration in Kathmandu valley during winter season

The monthly concentrations of NO2, NOx, SO2 and O3 measured by a passive sampler from February 2003 to January 2004 showed that the air pollution during the winter season in Kathmandu valley was higher than the summer season. The O3 level was found the highest during April, May and June due to strong radiation. The hourly concentrations of NO2, NOx, O3 and suspended particulate matter（SPM） were also measured by automatic instruments on December 2003. Temperature at the height of 60 m and 400 m at Raniban Mountain in the northwest of Kathmandu valley was measured on February 2001 in the winter season and the average potential temperature gradient was estimated from observed temperature. Wind speed was also measured at the department of hydrology, airport section, from 18 February to 6 March 2001. It was found that the stable layer and the calm condition in the atmosphere strongly affected the appearance of the maximum concentrations of NO2 and SPM in the morning, and that the unstable layer and the windy condition in the atmosphere was considerably relevant to the decrease of air pollution concentrations at daytime. The emission amounts of NOx, HCs and total suspended particle（TSP） from transport sector in 2003 were estimated from the increasing rate of vehicles on the basis of the emission amounts in 1993 to be 3751 t/a, 30570 t/a and 1317 t/a, respectively. The diurnal concentrations in 2003 calculated by the two-layers box model reproduced the characteristics of air pollution in Kathmandu valley such as the maximum value of O3 and its time, the maximum value of NO in the morning, and the decrease of NO and NO2 at daytime. The comparison with the concentrations in 1993 calculated suggested that the main cause of air pollution was the emission from transport sector.