论深入广泛推行清洁生产

在全面分析了国内推行清洁生产现状的基础上，根据中国的工业和资源特点，阐述了推行清洁生产的必要必,现时，从技术和管理两方面指出了中国推行清洁生产的巨大潜力，最后，有针对性地提出了深入广泛推行清洁生产的4条措施：（1）加快完善清洁生产政策，（2）深入实施清洁生产审计，（3）加强清洁生产技术的理论研究，（4）积极在中小企业中广泛推广清洁生产。     

Experimental study on static and dynamic mechanical properties of phosphogypsum

Environmental Science and Pollution Research - Phosphogypsum (PG) is a solid waste product of the wet-process phosphoric acid industry that accumulates in large amounts on the ground, forming PG...     

柴油降解菌的筛选、菌群构建及其对柴油和十五烷的降解机理

针对柴油污染土壤生物修复技术效率低的问题,通过构建高效降解菌群修复柴油污染的土壤,采用组合优化和正交实验构建最佳组合与接种比例的菌群,并研究其柴油降解特性。结果表明,通过筛选、鉴定并命名的4株柴油降解菌为Bacillus sp. VOC18-L1、Enterococcus faecalis-L2、Lysinibacillus-L3、Rhodococcus equi-L4;当4株菌接种比例为3∶1∶3∶4,pH = 7.0,30 ℃,转速150 r·min⁻¹时,柴油降解的效果最佳,14 d对7.0 mL·L⁻¹的柴油降解率达到89.0%。通过气相色谱质谱联用仪(GC-MS)检测柴油降解产物,发现该混合菌株能将柴油中的烷烃降解为短链烷烃,最终转化为小分子物质。同时利用KEGG数据库获得代谢丰度图并初步预测每种菌的功能,根据微生物多样性测试结果,进一步证明了混合菌对柴油完全降解的效果优于单种菌种。通过人工构建的微生物菌群可以有效地应用于柴油污染土壤的修复。     

泉州湾表层沉积物中多环芳烃的含量分布特征及污染来源

采用气相色谱-质谱联用(GC-MS)方法,对泉州湾表层沉积物中16种优先控制多环芳烃(PAHs)进行定量分析,采用LMW/HMW、BaA/(BaA+Chr)、InP/(InP+BgP)、Ppi等特定比值对PAHs来源进行分析.结果表明,沉积物中PAHs的总含量在182.8-721.1ng·g-1之间,以3-5环为主;P...     

Experimental study on the mechanism effect of seepage on microstructure of tailings

The deformation of microstructure of tailings caused by seepage is the main factor that leads the tailings dam to be damaged and lose stability. The effect of seepage on microstructure of tailings has been studied by a self-made observation testing apparatus of micro-mechanics and deformation of tailings, and its mechanism also has been explained in mechanics of particulate matter. The results show that the deformation response to microstructure of tailings is fast under load. The settlement of sample increases stepwise. Firstly, the fine particles crumble, then skeleton particles move, so as to noticeable settlement. Because the loose particles migrate taken by seepage water, the upper pores become bigger and lower pores become smaller. The relation of seepage water and settlement changing with time could be divided into two stages. In each stage, the rates of seepage and settlement reduce with time, and between the two stages, the rate of settlement increases significantly and the rate of seepage reduces with time. The seepage has significant effect on the particle size distribution of tailings in different depths, which has a little effect on the coarse tailings; the proportion of fine tailings increases significantly with the depth increasing; the minimum particle size decreases gradually and median diameter reduces stepwise with the depth increasing.     

利用悬浮填料附着生物膜同步去除碳氮磷

采用移动床生物膜反应器（MBBR）处理配制模拟废水,实验结果表明,水力停留时间为6h、悬浮填料填充率为40％时,在不同C／N／P比率条件下,MBBR对COD、NH4＋-N和TN去除性能好且稳定,平均去除率分别达到90％、94．8％和62．39％以上,而TP的去除率受C／N／P值影响较大,当C／N／P的比值为100／10／1．8时,平均去除率达到58．03％。一定的溶解氧（DO）质量浓度能保证反应器中COD、NH4-N高效稳定的去除,同时是TN和TP同时去除的重要影响因素,在MBBR中最佳DO值约为3mg／L。由于附着在悬浮填料生物膜内部存在厌氧、缺氧微环境条件,在反应器中存在少量的反硝化聚磷菌。     

印染废水处理的磁混凝-高梯度磁分离协同作用

混凝过程作为工业废水的预处理技术普遍受到重视,在混凝过程中降低污泥产生量并提高污泥分离速度是该技术发展的方向,基于上述目标,通过将磁粉引入絮体使之磁化并在自行研制的高梯度磁分离装置中实现磁混凝与磁分离的协同作用.以高浊度的印染废水作为试验废水,以色度、COD及SS作为考核指标,重点考察了磁混凝反应及磁分离的影响因素.当印染废水的色度约为900倍、COD约为595 mg/L、SS约为500 mg/L时,在pH=8.5、FeSO4500 mg/L、PAM3.5 mg/L、磁粉400 mg/L的适宜磁混凝反应条件下,相应指标去除率比传统混凝法分别高出17.3%、21.7%及24.2%,此时絮团沉降速度增大了64.3%,污泥体积减少了61%,污泥压缩比为0.39.在电流强度8 A、流速2.5 L/min和介质填充率1%的操作条件下,该磁性絮体流经高梯度磁分离装置时的水力表面负荷达到61.0 m3/m2·h,处理出水达到国家二级排放标准.     

电絮凝-微纳米气泡臭氧氧化工艺处理高盐印染废水的研究

高盐印染废水具有色度大、可生化性差、水质水量不稳定等特点,以致难以通过传统生化方法得到高效处理。将微纳米气泡臭氧（O₃）高级氧化工艺与电絮凝（EC）工艺组合处理高盐印染废水,探究2种工艺的耦合作用,并研究电流密度、盐浓度、pH等因素对组合工艺处理效果的影响。结果表明,单独EC法处理印染废水在一定程度有脱色和去除有机物的效果,但效率低。在相同条件下,EC和O₃同时处理(EC+O₃)150 min与EC处理30 min后再经O₃处理120 min (EC→O₃)过程相比,EC+O₃处理印染废水的效率更高,去除1 mg COD消耗的O₃仅为0.46~1.39 mg。随着电流密度和pH的升高,EC+O₃工艺的色度、UV₂₅₄、COD和TOC去除率增加;盐浓度的增加对色度、UV₂₅₄、COD和TOC去除率影响不大。比较了O₃微纳米气泡工艺、高级氧化法H₂O₂/O₃、EC+O₃ 3种方法对新疆和浙江实际印染废水的处理效果,并进行了经济性分析。3种微纳米气泡处理工艺的单位污染物电能消耗量（EE/O）由低到高为EC+O₃ < H₂O₂/O₃ < O₃。

     

The efficient removal of thallium from sintering flue gas desulfurization wastewater in ferrous metallurgy using emulsion liquid membrane

The removal of thallium ions in flue gas desulfurization wastewater from ferrous metallurgic industry was studied by emulsion liquid membrane (ELM) method using 2-ethylhexyl phosphoric acid-2-ethylhexyl ester (P507) as carrier, aviation kerosene (AK) as organic solvent, polyisobutylene succinimide (T154) as surfactant, polyisobutylene (PIB) as additive, and sulfuric acid as internal reagent. Some important influence parameters such as concentrations of carrier, surfactant and stripping agent, agitation speed, extraction time, volume ratios of feed solution to emulsion phase and internal phase to membrane phase, and their effects on the removal efficiency of Tl in the ELM process were investigated and optimized. Under the optimum operating conditions of 2% of carrier, 5% of surfactant, 0.5 M of stripping agent, 350 rpm of agitation speed, 12.5:1 of volume ratio of feed solution to emulsion phase, and 3:1 volume ratio of membrane to internal phase, the maximum extraction efficiency of thallium reached 99.76% within 15-min reaction time. The ICP-MS analysis indicated that the thallium concentration in treated wastewater was below 5 μg/L and could meet the emission standard demand for industrial wastewater enacted by the local government of Hunan province of China. Meanwhile, the extraction of impurity ions calcium and magnesium in the ELM system was investigated. The result showed that an acidic environment would be in favor of the removal of Tl from calcium and magnesium contained in wastewater.

Open image in new window

Graphical abstract ?

     

促进经济与环境效益协调发展的重要手段--清洁生产

阐述了清洁生产的定义。通过与末端治理的比较，分析了清洁生产的优点：（1）能满足持续发展的要求，（2）可最大限度地利用资源和能源，（3）减少了末端治理的压力和二次污染的可能，（4）改善了劳动条件和工作环境，（5）解决了环境与经济两层皮的矛盾。并以3个具体例子进一步说明清洁生产是促进经济与环境效益协调发展的有效手段，是实现可持续发展战略的一项重要措施。