Volatile nanoparticle formation and growth within a diluting diesel car exhaust

A major source of particle number emissions is road traffic. However, scientific knowledge concerning secondary particle formation and growth of ultrafine particles within vehicle exhaust plumes is still very limited. Volatile nanoparticle formation and subsequent growth conditions were analyzed here to gain a better understanding of "real-world" dilution conditions. Coupled computational fluid dynamics and aerosol microphysics models together with measured size distributions within the exhaust plume of a diesel car were used. The impact of soot particles on nucleation, acting as a condensational sink, and the possible role of low-volatile organic components in growth were assessed. A prescribed reduction of soot particle emissions by 2 orders of magnitude (to capture the effect of a diesel particle filter) resulted in concentrations of nucleation-mode particles within the exhaust plume that were approximately 1 order of magnitude larger. Simulations for simplified sulfuric acid-water vapor gas-oil containing nucleation-mode particles show that the largest particle growth is located in a recirculation zone in the wake of the car. Growth of particles within the vehicle exhaust plume up to detectable size depends crucially on the relationship between the mass rate of gaseous precursor emissions and rapid dilution. Chassis dynamometer measurements indicate that emissions of possible hydrocarbon precursors are significantly enhanced under high engine load conditions and high engine speed. On the basis of results obtained for a diesel passenger car, the contributions from light diesel vehicles to the observed abundance of measured nucleation-mode particles near busy roads might be attributable to the impact of two different time scales: (1) a short one within the plume, marked by sufficient precursor emissions and rapid dilution; and (2) a second and comparatively long time scale resulting from the mix of different precursor sources and the impact of atmospheric chemistry.     

Toxic equivalent concentrations (TEQs) for baseline toxicity and specific modes of action as a tool to improve interpretation of ecotoxicity testing of environmental samples

The toxic equivalency concept is a widely applied method to express the toxicity of complex mixtures of compounds that act via receptor-mediated mechanisms such as induction of the arylhydrocarbon or estrogen receptors. Here we propose to extend this concept to baseline toxicity, using the bioluminescence inhibition test with Vibrio fischeri, and an integrative ecotoxicity endpoint, algal growth rate inhibition. Both bioassays were validated by comparison with literature data and quantitative structure-activity relationships (QSARs) for baseline toxicity were developed for all endpoints. The novel combined algae test, with Pseudokirchneriella subcapitata, allows for the simultaneous evaluation of specific inhibition of photosynthesis and growth rate. The contributions of specific inhibition of photosynthesis and non-specific toxicity could be differentiated by comparing the time and endpoint pattern. Photosynthesis efficiency, measured with the saturation pulse method after 2 h of incubation, served as indicator of specific inhibition of photosynthesis by photosystem II inhibitors. Diuron equivalents were defined as toxicity equivalents for this effect. The endpoint of growth rate over 24 h served to derive baseline toxicity equivalent concentrations (baseline-TEQ). By performing binary mixture experiments with reference compounds and complex environmental samples from a sewage treatment plant and a river, the TEQ concept was validated. The proposed method allows for easier interpretation and communication of effect-based water quality monitoring data and provides a basis for comparative analysis with chemical analytical monitoring.     

Monitoring of the ecotoxicological hazard potential by polar organic micropollutants in sewage treatment plants and surface waters using a mode-of-action based test battery

We propose and evaluate a mode-of-action based test battery of low-complexity and in-vitro bioassays that can be used as a routine monitoring tool for sewage treatment efficiency and water quality assessment. The test battery comprises five bioassays covering five different modes of toxic action. The bioluminescence inhibition test with Vibrio fischeri and a growth rate inhibition test with the green algae Pseudokirchneriella subcapitata are measures of non-specific integrative effects. A second endpoint in the algae test, the specific inhibition of the efficiency of photosynthesis, gives an account of the presence of herbicides. An enzymatic assay covers an important aspect of insecticidal activity, the inhibition of the acetylcholine esterase activity. Estrogenic effects are assessed with the yeast estrogen screen (YES) and genotoxicity with the umuC test. Three field studies, each lasting six to seven consecutive days, were undertaken at a sewage treatment plant (STP) in Switzerland. Samples were collected in summer and late autumn, under dry and rainy conditions. None of the bioassays gave positive results with raw water in whole effluent toxicity testing. Therefore, water samples from various sites during wastewater treatment and from surface water were enriched with solid-phase extraction. The focus was on non-volatile compounds of average to moderate hydrophobicity, a range that includes most pesticides, biocides and pharmaceuticals. Various polar solid phases were evaluated for their extraction efficiency, disturbance by matrix components and overall performance. We finally selected a mixture of a polymeric sorbent and a C18-sorbent, Lichrolut EN and RP-18 or, alternatively, Empore SDB-RPS disks. All bioassays gave clear and robust responses with the SPE extracts. With the bioassay data the treatment efficiency of the STP can be assessed with respect to different modes of toxic action and accordingly different groups of micropollutants. Furthermore, the data allowed for a comparison between the effluent and the receiving river. In all bioassays the primary effluent had a strong effect and this effect was reduced after passing the STP. Treatment efficiency was high (typically over 90%) but varied from bioassay to bioassay, which is expected because each bioassay detects different types of micropollutants and therefore we cannot expect a common answer.     

International standardization of water analysis

The efficiency of a water treatment program or a water monitoring program can be checked only if it is accompanied by water analysis procedures allowing meaningful statements on water quality. Meaningful statements do not only include high accuracy, but high precision as well. With high precision values, good repeatability and reproducibility is aimed for. Repeatability and reproducibility may either be monitored by regular inter-laboratory trials, without prescribing a distinct analytical method, or by applying a standardized method which has undergone thorough checks concerning its reliability and efficiency. The article presents the structure of the ISO, CEN and DIN standardization work in water analysis.     

Changes in toxicity and Ah receptor agonist activity of suspended particulate matter during flood events at the rivers Neckar and Rhine — a mass balance approach using in vitro methods and chemical analysis

Background, aim, and scope  

As a consequence of flood events, runoff and remobilized sediments may cause an increase of ecotoxicologically relevant effects from contaminant reservoirs. Aquatic and terrestrial organisms as well as cattle and areas of settlement are exposed to dislocated contaminants during and after flood events. In this study, the impacts of two flood events triggered by intense rain at the rivers Neckar and Rhine (Southern Germany) were studied. Effects in correlation to flood flow were assessed at the river Neckar using samples collected at frequent intervals. River Rhine suspended particulate matter (SPM) was sampled over a longer period at normal flow and during a flood event. Three cell lines (H4L1.1c4, GPC.2D.Luc, RTL-W1) were used to compare Ah receptor agonist activity in different biotest systems. Multilayer fractionation was performed to identify causative compounds, focusing on persistent organic contaminants.     

Hochwasser 2002

In August 2002, highly contaminated areas in the region of Bitterfeld, e.g. the floodplain of the creek Spittelwasser, as well as the adjacent regions of Jeßnitz and Raguhn, were submerged by the river Mulde. An input of mobilized contaminated sediments in residential areas was the matter of concern. The objective of the present study was to estimate the pollutants load on the basis of chemical and biological data and identify the sources of pollutants. Deposited sludge and flood water samples were assessed on the basis of biological and chemical analyses and in comparison with administrative reference values. The pollution of the investigated sites was rather heterogeneous. At several sites, tolerance limits of the German Klärschlammverordnung or the Bundesbodenschutzverordnung were clearly exceeded, e.g. for Pb, As and HCH. Organic extracts exhibited significant effects in several biotests. This may be relevant with respect to direct particle uptake via ingestion or respiration. Pollution patterns for heavy metals as well as for organic pollutants differed significantly from the pattern found in the Spittelwasser flood plain before the inundation, which is in contrast to the initial hypothesis of a possible transport of contaminated Spittelwasser sediments into residential areas. Interestingly, a correlation of chemical load and the overall biological effect could be shown. From the viewpoint of the precautionary principle, the identification of the compounds exerting toxic effects and of the respective pollutant sources would be desirable.     

An empirical perspective for understanding climate change impacts in Switzerland

Regional Environmental Change - Planning for the future requires a detailed understanding of how climate change affects a wide range of systems at spatial scales that are relevant to humans....     

The OECD validation program of the H295R steroidogenesis assay: Phase 3. Final inter-laboratory validation study

Background, goals, and scope

In response to increasing concerns regarding the potential of chemicals to interact with the endocrine system of humans and wildlife, various national and international programs have been initiated with the aim to develop new guidelines for the screening and testing of these chemicals in vertebrates. Here, we report on the validation of an in vitro assay, the H295R steroidogenesis assay, to detect chemicals with the potential to inhibit or induce the production of the sex steroid hormones testosterone (T) and 17??-estradiol (E2) in preparation for the development of an Organization for Economic Cooperation and Development (OECD) test guideline.

Methods

A previously optimized and pre-validated protocol was used to assess the potential of 28 chemicals of diverse structures and properties to validate the H295R steroidogenesis assay. These chemicals are comprised of known endocrine-active chemicals and ??negative?? chemicals that were not expected to have effects on the targeted endpoints, as well as a number of test chemicals with unknown modes of action at the level of the steroidogenic pathway. A total of seven laboratories from seven countries participated in this effort. In addition to effects on hormone production, confounding factors, such as cell viability and possible direct interference of test substances with antibody-based hormone detection assays, were assessed. Prior to and during the conduct of exposure experiments, each laboratory had to demonstrate that they were able to conduct the assay within the margin of predefined performance criteria.

Results

With a few exceptions, all laboratories met the key quality performance parameters, and only 2% and 7% of all experiments for T and E2, respectively, were excluded due to exceedance of these parameters. Of the 28 chemicals analyzed, 13 and 14 tested affected production of T and E2, respectively, while 11 and 8 did not result in significant effects on T and E2 production, respectively. Four and six chemicals produced ambiguous results for effects on T and E2 production, respectively. However, four of these cases each for T and E2 were associated with only one laboratory after a personnel change occurred. Significant interference of test chemicals with some of the antibody-based hormone detection systems occurred for four chemicals. Only one of these chemicals, however, significantly affected the ability of the detection system to categorize the chemical as affecting E2 or T production.

Discussion and conclusions

With one exception, the H295R steroidogenesis assay protocol successfully identified the majority of chemicals with known and unknown modes of interaction as inducers or inhibitors of T and E2 production. Thus it can be considered a reliable screen for chemicals that can alter the production of sex steroid hormones. One of the remaining limitations associated with the H295R steroidogenesis assay protocol is the relatively small basal production of E2 and its effect on quantifying the decreased production of this hormone with regard to the identification of weak inhibitors. An initial comparison of the data produced in this study with those from in vivo studies from the literature demonstrated the potential of the H295R steroidogenesis assay to identify chemicals affecting hormone homeostasis in whole organisms. Particularly promising was the lack of any false negatives during the validation and the very low number of false positives (1 out of 28 chemicals for each T and E2).

Perspectives

Based on the results obtained during this validation study and the accordingly revised test protocols, an OECD draft test guideline was developed and submitted to the OECD working group of the national coordinators of the test guidelines program (WNT) for comments in December 2009.