Current status and research on E-waste issues in Asia

Rapid economic growth in Asia and the increasing transboundary movement of secondary resources will increasingly require both 3R endeavors (reduce, reuse, recycle) in each country and appropriate control of international material cycles. Recently, managing electrical and electronic waste (E-waste) has become an important target for domestic and international material cycles from the viewpoints of environmental preservation and resource utilization efficiency. To understand the current status of E-waste issues in the context of international material cycles and to discuss the future tasks related to achieving 3R in the region, we organized the National Institute for Environmental Studies (NIES) E-waste Workshop in December 2004. This article reviews past studies on E-waste and briefly describes the topics presented and discussions held at the workshop. The topics at the workshop included E-waste generation, recycling systems, international trade, and environmental impacts. In addition, we discussed various issues such as terminology, current environmental concerns, and possible solutions. Transboundary shipments of E-waste should be conducted taking into consideration the concept of sustainable development. The direction of future research and possible collaborations are also discussed.     

Comparison of end-of-life vehicle material flows for reuse,material recycling,and energy recovery between Japan and the European Union

Journal of Material Cycles and Waste Management - Japan and the European Union (EU) both have well-established End-of-Life Vehicle (ELV) policies and management systems. However, due to the...     

污泥投配率对污泥中温厌氧消化效果影响的试验研究

试验装置采用半连续流污泥中温厌氧消化反应器,污泥培养接近成熟后开始每天按不同污泥投配率加泥和排泥.结果表明:污泥投配率在3%～10%时,有机物分解率先增大后减小,去除率均在30%以上;污泥投配率在15%和20%时,污泥的有机物去除率非常小;污泥投配率在5%时,有机物分解率最大为41.2%;单位VSS产气量随污泥投配率的增大而呈先急剧上升后逐渐下降的趋势,当污泥投配率为5%时,单位VSS产气量为0.60 L/g,符合美国污水处理厂设计手册标准,其他污泥投配率下该指标均小于0.4 L/g.因此,认为实验用污泥中温消化的最佳污泥投配率为5%,这时污泥的可消化性较好.     

Influence of arsenic stress on synthesis and localization of low-molecular-weight thiols in Pteris vittata

The roles of low-molecular-weight thiols (LMWTs), such as glutathione and phytochelatins, in arsenic (As) tolerance and hyperaccumulation in Pteris vittata an As-hyperaccumulator fern remain to be better understood. This study aimed to thoroughly characterize LMWT synthesis in P. vittata to understand the roles played by LMWTs in As tolerance and hyperaccumulation. LMWT synthesis in P. vittata was induced directly by As, and not by As-mediated oxidative stress. Expression of PvECS2, one of the putative genes of γ-glutamylcysteine synthetase (γECS), increases in P. vittata shoots at 48 h after the onset of As exposure, almost corresponding to the increase in the concentrations of γ-glutamylcysteine and glutathione. Furthermore, localization of As showed similar trends to those of LMWTs in fronds at both whole-frond and cellular levels. This study thus indicates the specific contribution of LMWTs to As tolerance in P. vittata. γECS may be responsible for the As-induced enhancement of LMWT synthesis.     

Municipal solid waste composition and food loss reduction in Kyoto City

For 35 years, Kyoto City has conducted detailed household waste composition surveys under the guidance of Kyoto University by dividing household waste into approximately 400 categories. In addition, the city has conducted detailed composition surveys of commercial waste generated by businesses. These surveys show that food loss accounts for approximately 40% of total waste, of which leftovers and untouched food account for about 40% in both households and business facilities. Consequently, the annual generation of household and commercial food loss is estimated at about 30,000 tons. Various efforts have been made to reduce waste, including food loss, but further reduction in environmental burden is needed. Thus, Kyoto City revised the ordinance for waste reduction, and in March 2015, formulated a new municipal waste management plan. The plan not only includes the 2Rs (reduce, reuse), but also, for the first time in Japan, sets quantitative targets for reducing food loss. Kyoto City must ensure that the necessary waste reduction measures are clearly explained to the residents and business operators. To ensure that this plan is successful, it is important to clarify concrete actions that residents and business operators should implement, along with their effects.     

Japan’s waste management policies for dioxins and polychlorinated biphenyls

We summarize the measures taken by the Japanese government to prevent the emission of dioxins and polychlorinated biphenyls (PCBs) into the environment. Because incineration is the main method of waste management in Japan, reducing the amount of dioxins emitted from waste incinerators is an essential aspect of proper waste treatment. Intensive measures to prevent the formation of dioxins at the source have been implemented, with a focus on waste treatment methods and improving comprehensive management. The efforts have been very successful, with a 95% reduction in the amount of dioxins emitted between 1997 and 2003. The toxicity of PCBs has been monitored with keen interest since the Yusho incident. Unfortunately, treatment facilities for PCB wastes were not built until long after PCBs had been removed from use, and PCB wastes remained in storage in an untreated state. The Japanese government has promoted the construction of facilities for treating PCB wastes, and five such facilities have commenced operations. To more completely eradicate dioxins, a future challenge will be to reduce the amount of PCB-derived dioxins, which are persistent in the environment and have a long exposure pathway from the environment media to the organism and the human body.     

Greenhouse gas emissions from biogenic waste treatment: options and uncertainty

A simplified life cycle assessment was conducted to estimate greenhouse gas (GHG) emissions and energy production from each component of biogenic waste treated in an open dumping site, and by composting, anaerobic digestion, and incineration employed with additional options. The impact of uncertainties and sensitivities of the parameters in the treatment methods were investigated. We conducted a sensitivity analysis to identify the most sensitive parameters, and we discussed the relationship between uncertainty and sensitivity. Our results revealed that the moisture content of food waste and the biomass-derived carbon and methane concentration of the landfill gas of biogenic waste subjected to open dumping are the most sensitive parameters across all the treatment methods. The net GHG emissions from food waste treated in an open dumping site ranged over ten times (0.30 ? 3.67 Gg CO₂ eq/Gg). In addition, by employing additional options for the open dumping site, including soil cover, a landfill gas collection system, shifting to a semi-aerobic condition, and energy conservation by using a gas engine, we found that the net GHG emissions could be reduced by 10, 27.9, 37.4 %, and up to 56.7 %, respectively. Shifting to a semi-aerobic system is the most effective method for reducing GHG emissions, followed by landfill gas collection.     

Levels of polychlorinated dibenzo-p-dioxins and dibenzofurans in China and chemometric analysis of potential emission sources

Aimed to give a preliminary image of dioxin pollution in China, chemometric analysis was performed to determine background dioxin levels during the period 1994-2002 and potential emission sources. Using principal components analysis (PCA), the congener profiles of 71 sediment samples from rivers, lakes, and sea bays around China were compared with the congener profiles of various known or suspected industrial, residential, and municipal dioxin sources to determine whether the dioxin residues typically found in a broad range of potential environmental sources could explain the presence of these chemicals in China. It was found that the background dioxin levels of China were similar to those of lightly polluted samples from other countries during the period 1994-2002. Primary ferrous ore sintering and secondary lead and aluminum smelters were the major sources of dioxin emission in China. Chloranil and wastewater from chemical plants, sodium pentachlorophenate, and pulp bleaching were also important sources of dioxin emission. Open burning of e-waste as well as diesel-fueled and leaded gas-fueled vehicles were additional possible sources of dioxin. In contrast to other countries, in China, flue gases from incineration of municipal waste, hazardous waste, and medical waste might be minor sources of dioxin emission.     

Effect of unburned carbon on lead, zinc, and copper recovery from molten fly ash by chloride-induced volatilization

The present work focuses on investigation of the effective recovery of heavy metals from molten fly ash by applying chloride-induced volatilization. In particular, the effect of unburned carbon on the chloride-induced volatilization of lead, zinc, and copper from model and real molten fly ashes was investigated in the temperature range 873–1173 K under a N₂ atmosphere. As a result, almost 100% of lead and a significant proportion of zinc were volatilized from the real molten fly ash samples at 1173 K. In contrast, for the model fly ash, volatilization ratios of lead and zinc at 1173 K were only 85% and 25%, respectively. Further, the results of X-ray diffraction analysis suggested that PbO in molten fly ash was converted either to Pb₂OCl₂ or Pb by respective chlorination and reduction reactions. Meanwhile ZnO and CuO in the molten fly ash were reduced to Zn and Cu by reaction with unburned carbon. Subsequently, Pb, Zn, and Pb₂OCl₂ were volatilized, but Cu remained in the solid residue. Finally, the volatilization ratio of zinc increased with the addition of carbon, and more than 98% of zinc was volatilized at 1173 K from a fly ash with a carbon content of 20%.     

Material cycles in Asia: especially the recycling loop between Japan and China

In this article, we clarify the current status of Japanese exports and Chinese imports of secondary resources. A total of around 10 million metric tons (t) of secondary resources are exported annually from Japan to China, Hong Kong, and Korea. Hong Kong plays the role of a transshipment point, especially regarding the trade in plastic waste, and China imports much from the USA and Japan, often through Hong Kong. The secondary resources exported from Japan include both byproducts from manufacturing processes and end-of-life products or materials. The great demand in China, and the difference in prices between countries, drive this transboundary shipment, although Japan has enacted various recycling laws that were implicitly intended to promote domestic recycling. In China, the imported secondary resources are recycled, usually by means of primitive and low-cost hand labor. The greatest concern is whether there are still improper (illegal or polluting) recycling activities in China. International material cycles should prevent environmental pollution and ensure efficient resource utilization. To that end, the following measures are needed: cooperative control of the trade of secondary resources between countries, the alignment of domestic laws with the regulations in other countries based on the actual trade activities, and the realization of sound practices for global resources management.