Chemical states of arsenic contained in sewage sludge incineration ash and insolubilized material

Journal of Material Cycles and Waste Management - The chemical states of arsenic contained in 4 kinds of sewage sludge incineration ash and insolubilized materials are analyzed using a leaching...     

Production of hydrogen by steam gasification of dehydrochlorinated poly(vinyl chloride) or activated carbon in the presence of various alkali compounds

Steam gasification of dehydrochlorinated poly(vinyl chloride) (PVC) or activated carbon was carried out in the presence of various alkali compounds at 3.0 MPa and 560°C–660°C in a batch reactor or in a semi-batch reactor with a flow of nitrogen and steam. Hydrogen and sodium carbonate were the main products, and methane and carbon dioxide were the minor products. Yields of hydrogen were high in the presence of sodium hydroxide and potassium hydroxide. The acceleration effect of the alkali compounds on the gasification reaction was as follows: KOH > NaOH > Ca(OH)₂ > Na₂CO₃. The rate of gasification increased with increasing partial steam pressure and NaOH/C molar ratio. However, the rate became saturated at a molar ratio of NaOH/C greater than 2.0.     

A comparative study on the autoxidation of dimethyl ether (DME) comparison with diethyl ether (DEE) and diisopropyl ether (DIPE)

The Japanese government is planning to introduce DME as a substituted energy for oil and LNG. Introduction of DME could contribute greatly to both the prevention of global warming and the formation of resource-recycling societies. In these circumstances, a safety assessment of DME is very important when DME is used on a large scale. There is a possibility that prolonged exposure in air induces autoxidation to produce explosive organic peroxides during transportation and storage of DME. Therefore, the reactivity of DME with oxygen and the mechanism of the autoxidation were investigated. Accelerating Rate Calorimetry (ARC) was used to evaluate the thermal stability of DME and DIPE, a known peroxide producers, under adiabatic and various atmospheric conditions. In ARC studies of DME under oxygen, exothermic decompositions were detected although its self-heating rate was low in comparison with DIPE. Oven storage tests were carried out and iodimetry was used to measure the concentration of peroxides produced from DME in comparison with DIPE and DEE. However, no products could be found for DME either by GC/MS or by iodimetry, while some evidence of autoxidation of both DEE and DIPE were obtained from these experiments.     

Influence of paint chips on lead concentration in the soil of public playgrounds in Tokyo

Lead concentration in the surface soils from 31 playgrounds in a ward in Tokyo was measured to examine if paint chips, peeled off from playing equipment installed in the playgrounds, contribute to elevated Pb concentration in the soil of public playgrounds. Lead concentration in the paint chips sampled from playgrounds ranged from 0.003 to 8.9%. Lead concentration in the surface soil ranged from 15.2 to 237 mg kg(-1) (average, 55.5 mg kg(-1)) and higher Pb concentration was found in the soil near painted playing equipment indicating that paint chips from playing equipment contributed to increase soil Pb level of playgrounds in Tokyo. The degree of peeling-off of paint on the surface of playing equipment in the public playground (peeling-off index: POI) positively correlated with Pb concentration in the soil (Spearman rank-correlation coefficient, r = 0.366, p = 0.043). The stronger correlation between Pb concentration and isotope ratios (207Pb/206Pb and Pb conc., r = 0.536, p = 0.002, 208Pb/206Pb and Pb conc. r = 0.600, p < 0.001) than that between Pb and POI indicated that gasoline Pb contributed more to the playground-to-playground variation in soil Pb concentration. It was concluded that both gasoline Pb of the past and paint chips contributed to increased Pb concentration in the surface soil of playgrounds in Tokyo, though the contribution of paint chips is smaller than gasoline Pb.     

Comparison of two types of municipal solid waste incinerator fly ashes with different alkaline reagents in washing experiments

In this study, we propose a "washing-calcination-conversion of washed fly ash into cement material with bottom ash" (WCCB) system to reduce the amount of fly ash that must be specially treated so it can be used as raw cement material. Calcium hydroxide (Ca(OH)2) is widely used in air-pollution control devices of incinerators while sodium bicarbonate (NaHCO3) is not. We conducted single-, double-, and triple-washing experiments to compare the washing characteristics of two types of fly ash. Unlike NaHCO3 fly ash, Ca(OH)2 fly ash has almost twice as much washed residue and almost 2.5 times more chlorine after the same washing procedure. After washing once, the washing frequency is also important for NaHCO3 fly ash, while the mixing time and liquid/solid ratio are more critical for Ca(OH)2 fly ash. The use of NaHCO3 is more suitable for the WCCB system.     

Characterization of trace constituents in landfill gas and a comparison of sites in Asia

Because landfill gas (LFG) contains an abundance of methane, the utilization of LFG as a renewable energy source is becoming popular in many countries. LFG, however, contains various trace constituents, some of which may pose problems during utilization. For example, siloxanes and halogenated volatile organic compounds (VOCs) can cause difficulties when present in the fuel of gas engines. In addition, many VOCs and mercury have harmful effects on human health, especially on the health of workers at landfill sites and people living near the landfills. Energy recovery from LFG is expected to make great progress in the near future, particularly in Asia, but we found little information on the trace constituents of LFG in this region. Therefore, we sought to characterize the trace components in LFG generated in two landfill sites in China and one site in Japan, to determine the typical concentrations of these trace components in LFG, and to compare their concentrations among landfill sites in Asia. We concluded that the trace components in LFG at the sites studied were mainly siloxanes generated from sewage sludge and harmful benzene, toluene, ethylbenzene, and xylene compounds from petroleum products.     

Methods and impact of health screening for hospital staff

This study examines: (1) the impact of two methods of giving screening results on health behaviour and beliefs, evaluated in a randomized controlled trial. (2) The association between uptake of screening and health risk behaviours and beliefs. Two methods of feedback of screening results were given: simple informational feedback, and more extensive feedback, including target-setting and a written contract. At six month follow-up, those who received simple informational feedback had lost less weight and had increased their exercise less than those who received more extensive feedback. Attenders believed more strongly in the relationship between lifestyle and health, perceived themselves as less healthy than others and scored higher on the GHQ than staff who did not attend for screening. These results suggest that belief in the effectiveness of lifestyle change in promoting health, and anxiety about health, can influence uptake of screening. Second, the method of presenting screening results can influence the impact of screening on subsequent behaviour change.     

Kinetics on the decomposition of polychlorinated biphenyls with activated carbon-supported iron

The process of destroying polychlorinated biphenyls (PCBs) generates exhaust gases that contain low quantities of PCBs, which cannot be disposed of easily. Activated carbon (AC) can be used to adsorb residual PCBs after disposal of high-level PCBs. We examined the chemical reactivity of AC-supported iron as a catalyst to decompose PCB-153, and varied three decomposition parameters (temperature, time and iron concentration) under an atmosphere of either air or N(2). We measured the Brunauer-Emmett-Teller (BET) surface area and pore volume of AC to assess the adsorption capacity of AC before and after decomposition. At low temperatures the adsorption process was more important than the decomposition process. The decomposition process was completed within 30 and 60 min under air and N(2), respectively. The efficiency of PCB-153 decomposition at 350 degrees C for 120 min was approximately 100.0% and 97.1% under air and N(2), respectively. Analysis of inorganic chloride ions revealed that PCB-153 was effectively destroyed during decomposition. The differences between decomposition under air and N(2) reflected differences in BET surface and pore volume.     

Cognitive skills underlying driving in patients discharged following self-poisoning with central nervous system depressant drugs

Background: Central nervous system-depressant (CNS-Ds) drugs can impair cognitive functions and driving. They are also the most common drugs taken in overdose in hospital-treated episodes of self-poisoning. In Australia most of these patients are discharged within 48?h, while they still have possible subclinical drug effects. We aimed to determine whether patients treated for self-poisoning with CNS-Ds are impaired in the Trail-Making Test (TMT, parts A and B), a neuropsychological test that is known to correlate with driving performance. Methods: This study was a conducted from November 2008 to April 2011 in a referral center for poisonings in New South Wales, Australia. One hundred seven patients discharged from the clinical toxicology unit following treatment for self-poisoning of CNS-Ds (benzodiazepines, atypical antipsychotics, or opioids) and a control group of 68 discharged following self-poisoning of non-CNS-depressant drugs (acetaminophen or nonsedating antidepressants) were tested with the TMT (parts A and B). Due to the known association of impaired TMT with driving impairment and increased risk of traffic accidents, performance less than the 10th percentile for age was defined as significant impairment in each part of the TMT. The odds ratio (OR) for impairment in each part was calculated in multivariate logistic regression (MLR) models adjusted for gender, education, IQ, and the presence of a major psychiatric illness. A secondary MLR analysis was conducted only for those patients (78 CNS-D and 54 control group participants) who were directly discharged home, after excluding those who were transferred for further psychiatric care. Results: The odds of impairment in the CNS-D group was 2.8?times that of the control group on the TMT-A (38 [35.5%] vs. 11 [16.2%]: adjusted OR = 2.76, 95% confidence interval [CI]: 1.28-5.97), and 4.6?times on the TMT-B (67 [62.6%] vs. 22 [32.4%]: adjusted OR = 4.63, 95% CI: 2.06-10.42). The results were similar in the subgroup of patients discharged home, and the odds of impairment in the CNS-D group was 3.3?times that of the control group on the TMT-A (25 [32.1%] vs. 7 [13.0%]: adjusted OR = 3.30, 95% CI: 1.28-8.52), and 3.6?times on the TMT-B (46 [59.0%] vs. 17 [31.5%]: adjusted OR = 3.64, 95% CI: 1.44-9.20). TMT-B impairment in the CNS-D group remained significant even after adjusting for TMT-A performance. Conclusions: Patients with CNS-D overdose may have significant impairment in cognitive skills underlying driving at the time of discharge from hospitals. Clinicians should warn these patients that their driving skills might still be impaired, even if they are considered clinically recovered and advise them not to drive during the first 1 to 2?days following discharge.     

Chlorobenzenes removal from municipal solid waste incineration fly ash by surfactant-assisted column flotation

The organic contaminants in municipal solid waste incineration (MSWI) fly ash, including chlorinated aromatic compounds and polycyclic aromatic hydrocarbons, have high toxicity and a potential negative impact on the environment. An effective and low energy consumption technique to remove the organic contaminants from MSWI fly ash is required urgently. Organic contaminants, such as chlorobenzenes (CBzs), in MSWI fly ash are known to become enriched in the unburnt carbon (UC) fraction. It is proposed that removal of UC from fly ash will result in the effective removal of most organic micropollutants. In this research, we use a technique of surfactant-assisted column flotation to decontaminate MSWI fly ash by removal of the CBzs-enriched UC from MSWI fly ash. We find that 39.8% of CBzs can be removed from fresh MSWI fly ash with 61.7% UC removal efficiency, whereas only 33.2% of CBzs can be removed from weathered MSWI fly ash with a low UC removal efficiency of 33.7%. By adding a mixture of two kinds of surfactants: sorbitan mono-oleate and polyoxyethylene (20) sorbitan mono-oleate to the weathered fly ash, 47.0% of CBzs were removed at the hydrophile lipophile balance value of 13.5, while the UC removal efficiency increased to 49.0%. The results show that surfactants can enhance CBzs and UC removal efficiencies during the column flotation process. Higher CBzs and UC removal efficiencies can be expected by further optimizing the conditions of surfactant-assisted column flotation.