Fluoride removal and its impact on oral health in Sri Lanka's dry zone: Discussion and recommendation

Fifty percent of the dry zone areas in Sri Lanka have fluoride levels above 1 ppm. This paper discusses the ground conditions and recommends an appropriate range of fluoride in drinking water which can support preventive practices for improving the oral health of children 8-years old and younger. In efforts to address the Chronic Kidney Disease of Unknown etiology (CKDU), water treatment to reduce contaminant level in potable water has been implemented. Such treatment would also remove fluoride and has resulted in potable water with various fluoride levels, depending on concentrations in the raw water. While it is important to reduce fluoride levels, it is important to have appropriate residual levels for prevention of dental caries. It needs, however, to be noted fluoride in excess can cause dental fluorosis. In Sri Lanka's dry zone areas increasing prevalence of dental fluorosis with decreasing prevalence of dental caries has been noted. Consumption of tea and powdered milk could increase total intake of fluoride. Fluoridated toothpaste, when used properly, may, however, result in negligible intake of fluoride. Sri Lanka's hot tropical climate which results in substantial intake of fluids reinforces the need to consider reduction in water fluoride. Consideration of local studies and international standards indicate fluoride levels should be in the range of 0.225–0.500 ppm. In the range of 0.225–0.500 ppm, the prevalence of dental fluorosis and caries was only 14% and 8%, respectively, in an endemic district. When fluoride levels are above 0.500 ppm, the issue of dental fluorosis shall need to be addressed. When levels are below 0.225 ppm, oral health care services shall need to be directed at preventing dental caries.     

ARSENIC CONSUMPTION AND HEALTH RISK PERCEPTIONS IN A RURAL WESTERN U.S. AREA1

ABSTRACT: Churchill County, Nevada, has approximately 23,000 residents, among whom an estimated 13,500 relied on private wells for water supply in 2002. This study examined exposure to arsenic in water supplies among residents with private domestic wells and factors related to householder choice to consume tap water. It compared opinions and concerns about water quality with consumption habits and observed concentrations from tap water samples. The results from 351 households indicated that a majority (75 percent) of respondents consumed tap water and that a minority (38 percent) applied treatment. Approximately 66 percent of those who consumed tap water were exposed to concentrations of arsenic that exceeded 10 ppb. Water consumption was related to application of treatment. Among 98 respondents who were not at all concerned about the health effects of aqueous arsenic, 59 (60 percent) reported consuming tap water with concentrations of arsenic exceeding 10 ppb. Conversely, among 86 respondents who were highly concerned about arsenic, 33 (37 percent) consumed tap water with concentrations of arsenic exceeding 10 ppb. Results from a national sampling effort showed that 620 of 5,304 private wells sampled (11.7 percent) had arsenic concentrations above 10 ppb. The paradox of awareness of arsenic in water supplies coupled with consumption of aqueous arsenic in concentrations greater than 10 ppb may be common in other parts of the nation. Enhanced educational efforts, especially related to tap water sampling and explanations of efficacy of available treatment, may be useful means of reducing exposure through private water supplies.     

Seasonal fluctuations in sand temperature: effects on the incubation period and mortality of loggerhead sea turtle (<Emphasis Type="Italic">Caretta</Emphasis><Emphasis Type="Italic">caretta</Emphasis>) pre-emergent hatchlings in Minabe,Japan

Incubation period, hatching success, and emergence percentage in loggerhead (Caretta caretta) nests were quantified during the 1993 and 1995 nesting seasons and following incubation seasons in Minabe, Wakayama, Japan. Sand and nest temperatures were also monitored. Over the seasons, daily mean sand temperature at nest depth fluctuated between 18.0°C and 33.3°C, with a steep increase in the second week of July and a peak in late August. Temperatures inside the nest chambers were a few degrees above those of the surrounding sand at the end of incubation. The incubation period ranged from 46 to 82 days. A significant negative correlation was found between mean sand temperature and incubation period. The relationship conformed to the day-degree concept. There was no significant seasonal trend in hatching success, but many pre-emergent hatchlings were found dead in most of the clutches during the warmest part of the season. Emergence percentage was correlated with mean sand temperature calculated for 4 days before emergence, suggesting that mortality may be due to heat. This heat-related mortality is considered to be a common phenomenon at our study site, because the peak in emergences coincides with the peak in high temperatures. These temperature effects on hatchling mortality must be taken into account in estimates of hatchling sex ratios. Because sand temperatures already exceed the optimal thermal range for incubation, this population is vulnerable to even small temperature increases resulting from global warming.     

The role of new technologies in reducing energy demand

Energy efficiency is often stated to be the most cost-effective measure for satisfying our energy demand with minimal environmental damage. However, the potential energy savings attainable in 'the real world' are frequently overestimated, as is shown in an industrial case study of the glass industry. Nevertheless, there are significant energy savings to be realized, and the role of new technologies in this is important. However, the key to the effective use of new technology for improved energy efficiency is good management and. for best effect, it must be integrated into the normal resource management activities of a company.