开关电源电磁兼容可靠性设计的一种新方法

首先介绍了开关电源电磁兼容问题产生的原因,研究了提高其可靠性的传统设计方法.提出了一种用以提高电子设备在电磁干扰影响下可靠性的地线加电容法.并对这种方法进行了详细说明,探讨了在实际工程应用中的具体方法,证明了其有助于开关电源以及其它电子产品电磁兼容可靠性设计的改善和提高.     

BUILDUP,WASHOFF, AND EVENT MEAN CONCENTRATIONS1

ABSTRACT: Most watershed water quality simulation models require the user to specify pollutant buildup and washoff rate parameters for pollutants, by land use. Buildup and washoff rates are difficult to measure directly, and only limited guidance and few observed data are available from the literature. Many studies, however, report storm event mean concentrations (EMCs). These EMCs must arise as a result of the buildup and washoff processes, but typically represent the net contribution from a variety of pervious and impervious surfaces. This paper explores the relationship between EMCs and buildup/washoff parameters. An assumption of the mathematical form of the buildup/washoff relationship gives an algebraic expression for the EMC consistent with model assumptions. This yields techniques to separate observed EMCs into contributions from different land uses and from pervious and impervious surfaces. Given this relationship, numerical optimization may be used to estimate site specific values of buildup and washoff parameters from observed storm EMCs for use in modeling. Use of this approach helps ensure that model parameters are consistent with observed data, providing a rational starting point for final model calibration. Several site examples demonstrate use of the method.     

核电设备射频辐射抗扰度试验方法研究

参考美国核管制委员会(NRC)的行业规范RG 1.180,对比研究该规范中涵盖的两大标准体系,并以射频辐射抗扰度试验作为切入点,深入探讨了MIL-STD与IEC标准在干扰信号特性、试验布局、测试方法以及结果评价等关键技术上的差异。举例说明了具体测试中的技术细节以及试验结果的评估和使用方法。最终,形成试验实施的指导建议,为核电设备电磁兼容试验提供技术支持,并最终实现核电站的安全目标。     

长三角典型村域次降雨条件下氮素非点源输出特征

研究长三角典型都市农业村镇不同土地利用下的氮素非点源输出特征,以期为治理该区域的面源污染提供科学依据.通过典型次降雨径流事件中氮形态和输出负荷变化的研究发现:监测点总氮(TN)的事件平均浓度(EMC)为20.01～22.83mg/L,其中溶解态氮(DN)占TN的比例最大;研究区非点源氮流失以溶解态为主,DN又以溶解态有机氮(DON)为主.耦合各形态氮浓度与径流量特征,发现非点源氮素输出呈现2个峰值,且出现在径流峰值之前4～55min;TN、DN和硝态氮(NO3--N)浓度随降雨时间增加呈现减少趋势;氮素负荷受其浓度和径流量的共同作用,基本上呈现与氮素浓度相同的变化特征,但起伏变化较为平缓.氮素污染负荷积累曲线分析表明,村域地表径流各形态氮素均存在初期冲刷效应.     

Estimation of Land Use Specific Runoff and Pollutant Concentration for Tapi River Basin in India

Non-point source (NPS) pollution is the result of various land use practices such as agriculture, sites of construction and waste disposal, urban development and so on. The control of NPS pollution is possible by regular monitoring and assessment on watershed basis to educate people for implementing well-known structural and non-structural measures. Recent trend is to use GIS based modelling tool for assessment of rainfall-runoff and non-point loading. The approach requires generation and analysis of basin wide data on various features of land and estimates of Event Mean Concentrations (EMCs) of pollutants in the runoff. In the present paper, basin wide data in different districts of Tapi basin has been analysed for land use distribution; fertilizer application; low, medium and high-density habitation; and annual rainfall. Coefficients of runoff have been estimated considering pervious and impervious area for different land use types, and compared with the reported values for Indian conditions. The estimated mean annual runoff flow indicated that two districts Jalgaon and Dhule contribute maximum runoff to the Tapi River. Estimates of EMCs for BOD and nutrients (N and P) in the runoff from various districts are useful in GIS-based modelling study for NPS pollution assessment.     

电磁兼容测量结果可追溯性技术探讨

无线电波因其具有较强的方向性和反射性等传播特点,往往会引起电磁兼容测量结果的不稳定甚至有较大的偏差,如果不对测量过程中的测量和试验布置、试品的工况、记录报告等要素进行可追溯性分析和控制,势必会造成测量结果的随意和不确定性.因此在电磁兼容测量实验室,非常有必要对测量过程和测量结果进行可追溯性研究、分析和控制,一是提供准确可再现的测量数据,对客户负责,二是通过可追溯性控制,再现试验和测量过程,验证测量结果,对实验室的风险进行预见和预防.本文主要立求通过实际案例的分析,畅述和分析在电磁兼容测量实验室如何建立可追溯性的控制体系.     

GB4706．2-2007电熨斗新国际非正常测试

本文针对2009年1月1日即将实施的GB4706．2—2007熨斗国家标准,分析了某智能控制电熨斗电路原理,介绍第19章非正常测试,讨论判定条款,常规CE中的EMC与19.11.14条EMC项目的差异。     

一种基于预测法的电磁兼容设计方法

文章以数模混合电路设计实践为基础,介绍了一种基于预测法的电磁兼容设计方法。先以电磁兼容测试理论为基础介绍数模混合电路设计中的电磁兼容方法,在以此方法建立电磁兼容设计模型,并通数模混合电路实践来检验和改进设计模型。     

电器防雷滤波技术探讨

我国是雷电多发地区,在我们日常生活中电器经常会被雷电击坏或不能正常工作。本文就产品设计中我们常采用的一种既防雷又解决滤波的防雷滤波技术讨论,并加以验证。     

血压监护系统的电路分析和印刷电路板设计

本文介绍了血压监护系统的电路设计,其中前端电路的设计采用差分多级放大电路,达到放大的效果。应用PSpice软件对滤波电路进行了仿真,得到了带通滤波器的通带频率,验证了滤波器设计的可行性。同时本文对血压监护系统印刷电路板中电磁兼容问题进行了研究,对血压监护系统电路板的布局布线规则进行了规划和设计。