核算间接冷却水污染当量数的研讨

针对间接冷却水的特点和核算其污染当量数过程中存在的问题，阐述了间接冷却水的界定，水源水的采样监测技术，本底值的扣除以及超标排放的判别等环节的技术要求和注意事项，并就与之密切相关的几个问题展开了讨论,为核算间接冷却水当量数提供了一定的参考依据，建议增加水湿排放指标，以切实控制间接冷却水造成的主要污染－热污染。     

Climate hazards: Lessons from recent events in the United States

Three recent cases of climate extremes are studied to identify human impacts and response strategies and to identify common characteristics that may help illuminate the nature of climate hazards. The 1980 heat wave in the central United States, 1981 cold wave in Boston, Massachusetts, and recent flooding and lake level rise in northern Utah, illustrate several important aspects of climate hazards that separate them from the more traditional set of catastrophic events (e.g. tornadoes, hurricanes and earthquakes) usually dealt with by hazards research and management. Among those characteristics are an emphasis on health impacts rather than physical damage, accumulative effects rather than short shocks, a tendency for impacts to accrue to certain socio-economic classes, and relatively slow onset. The management and research implications of these hazard characteristics are explored.     

Kitchen waste valorization through a mild-temperature pretreatment to enhance biogas production and fermentability: Kinetics study in mesophilic and thermophilic regimen

Biowaste valorization through anaerobic digestion is an attractive option to achieve both climate protection goals and renewable energy production. In this paper, a complete set of batch trials was carried out on kitchen waste to investigate the effects of mild thermal pretreatment, temperature regimen and substrate/inoculum ratio. Thermal pretreatment was effective in the solubilisation of macromolecular fractions, particularly carbohydrates. The ability of the theoretical methodologies in estimating hydrogen and methane yields of complex substrates was evaluated by comparing the experimental results with the theoretical values. Despite the single batch configuration, a significant initial hydrogen production was observed, prior to methane yield. Main pretreatment effect was the gain in hydrogen production; the extent was highly variable according to the other parameters values. High hydrogen yields, up to 113 mL H2/g VSfed, were related to the prompt transformation of soluble sugars. Thermophilic regimen resulted, as expected, in faster digestions (up to 78 mL CH₄/gVS/day) and sorted out pH inhibition. The relatively low methane yields (342–398 mL CH₄/g VS_fed) were the result of the consistent lignocellulosic content and low lipid content. Thermal pretreatment proved to be a promising option for the enhancement of hydrogen production in food waste dark fermentation.     

Investigation to meet China II emission legislation for marine diesel engine with diesel methanol compound combustion technology

In order to reduce the pollutant emission and alleviate the pressure of petroleum resources shortage and greenhouse gas emission at the same time, the use of clean and renewable alternative fuel for marine engines is a promising option. In this study, a marine diesel engine, which was modified to run in diesel methanol compound combustion (DMCC) mode, was investigated. After the diesel injection parameters were calibrated, and combined with a sample after-treatment device DOC (diesel oxidation catalyst), the engine could meet the requirements of China II legislation. The overall MSP (methanol substitute percent) reached 54.1%. The value of each pollutant emission was much lower than that in China II emission legislation, and there was almost no methanol and formaldehyde emissions. When methanol was injected into the inlet manifold, the intake air temperature decreased a lot, as well as the exhaust gas temperature, which were beneficial to increase engine thermal efficiency and improve engine room environment. Compared with the engine running in pure diesel mode, when the engine ran in diesel/methanol dual fuel mode, the combustion phase was advanced, and the combustion duration became shorter. Therefore, the engine thermal efficiency increased, and fuel consumption decreased significantly.     

中国“达标排放”政策的实证分析及理论探讨

以固定点源烟尘排放为例,从排放标准和监测标准两方面讨论了中国现阶段“达标排放”的状况,指出当前的大气污染源达标排放实际上是“初步达标排放”,现在的排放标准和监测规范合适考核污染源的初步达标排放,不适合考核污染源的连续达标排放。排放标准的规定形式、监测规范和适用范围需要改革。现在的排放标准指标需要与监测规范和超标率限值结合起来,以促进污染源的连续达标排放。     

冷摆辗模具的材料选择及其热处理

模具寿命是冷摆辗的关键问题之一。选择合理的模具材料以及采用适宜的热处理工艺可以提高冷摆辗模具的强韧性,从而提高模具寿命。基于摆动辗压工艺的基本原理,分析研究了冷摆辗模具的受力情况,并对冷摆辗模具材料的选择及热处理工艺作了探讨。     

煤烟型大气污染解决方法

重点介绍了新型燃煤工艺——水平火焰无烟工业炉及其特点，并提出排烟尾气处理的资源化方案。     

Enhanced cyanogen chloride formation after UV/PS and UV/H2O2 pre-oxidation and chlorination in natural river water

Ultraviolet/persulfate (UV/PS) and Ultraviolet/hydrogen peroxide (UV/H₂O₂) have attracted much attention in recent years as advanced oxidation processes for water treatment. However, it is not all clear how these two methods affect the formation of cyanogen chloride (CNCl) in the subsequent water chlorination process. In this study, it was found that both UV/H₂O₂ and UV/PS pre-oxidation promoted the formation of CNCl in six actual water samples collected from urban rivers. Glycine, uric acid, arginine and histidine were investigated as the model compounds to explore the effects of different methods on the production of CNCl. The results showed that compared with chlorination alone, pre-oxidation by UV/H₂O₂ and UV/PS can reduce the production of CNCl for glycine and uric acid by up to 95% during post-chlorination process. However, they can greatly promote the formation of CNCl for arginine and histidine by up to 120-fold. In a more detailed investigation, pre-oxidation of histidine formed highly reactive intermediates to chlorine, leading to increased CNCl formation and chlorine consumption. The results showed that the precursors of CNCl was altered after pre-oxidation, and need to be re-evaluated.     

聚合氯化铝铁检验方法研究

聚合氯化铝铁是一种新型净水剂,它结合铝系和铁系净水剂的优点,有助于减少水中铅含量。利用《水处理剂聚合氯化铅(GB15892-1995)》和《净化剂聚合氯化铁(GB14591-93)》的方法,对聚合氯化铅铁主要技术指标的检验做了探索。经反复实验,取得了较好的效果。     

从自燃煤矸石中提取聚合铝铁(PAFC)的试验研究

采用盐酸酸浸的方法从自燃煤矸石中提取聚合铝铁，对煤矸石的粉碎粒径、酸浸盐酸的浓度及用量、酸浸的温度等工艺条件进行了试验研究。结果表明，从100g自燃煤矸石中，可提取19．85g固体聚合铝铁，成品的Al2O3含量33％、Fe2O3含量16％、盐基度70％。