太湖梅梁湾水源地示范区水质改善初探

基于改善环境、恢复生态系统的思路,在太湖梅梁湾水源地实施了旨在恢复水生植物的环境改善和生态修复工程。通过2003 年8月开展的本底调查及2003年9月~2004 年11 月的水质监测资料,对太湖梅梁湾水源地水质改善示范区水质的时空变化趋势和质量状况进行了研究与评价。结果表明,工程实施前示范区内各点位的透明度、总氮、氨氮、总磷、叶绿素a等指标均超标,水质为Ⅳ Ⅴ类,表现为富营养化水平;各项工程措施实施后水质有了明显改善,溶解氧明显升高,全年较2003年8月份升高34%,夏季较2003年8月也升高了17%,10个点透明度平均由0.29 m提高到0.35 m,增加了21%,强化净化区较外围区提高0.05 m。但是,上述水质改善仅是生态工程物理效应的结果,由于水生植物尚未恢复,因此,有些指标的改善并不明显,如叶绿素等。但在可以预见的将来,在水生植物得到恢复后,其水质改善的趋势将更加明显。     

曝气和阿科蔓填料对月湖围隔中的水质改善作用

在重富营养化的武汉月湖建立围隔,研究了曝气和投放阿科蔓填料对水质的改善作用。结果表明:建立围隔(5m×5m)后,会使内外水的TP浓度产生明显差异,发生水华的程度和频率增加,进而对透明度(SD)、Chla和COD造成负面影响;水下曝气、放置水花生浮床能够减轻水华发生的频率和程度。经13个月的曝气(每天2~3小时),能够明显降低水中的TN浓度,对TP和COD没有明显影响,在有水华时,能够通过抑制水华而降低Chla,提高SD;在没有水华时,对Chla和SD无明显影响。经11个月的围隔实验,投放阿科蔓(每个围隔2m)2能够能够降低COD和Chla浓度,提高SD,但对TN、TP浓度没有明显影响。     

围网养殖对洪湖水质的影响分析

文章从围网养殖对洪湖水质影响的角度出发,依据1990～2006年在洪湖实测的水质数据分析了洪湖水质的时空变化过程及趋势,并发现水质指标中总氮的超标量变化明显。利用环境污染综合指数法,通过围网内和围网外以及围网前和围网后不同水文期的水质情况对比,对洪湖水质变化进行综合评价。结果表明围网内的环境污染综合指数在枯水期要远大于围网外的,围网养殖对湖泊的局部污染严重;围网前水质基本可以达到Ⅱ类水质标准,开始围网后洪湖水质逐步恶化,且围网养殖面积与水质恶化的程度有着相同的变化趋势,总氮的含量变化尤为明显,随着围网养殖规模面积的扩大急速增加。     

环境实验箱气流组织与围护结构耦合传热研究

目的研究环境实验箱在升、降温过程中气流组织与围护结构的耦合传热行为,为环境实验箱制冷/加热能力的确定提供精确的设计方法。方法首先利用UC240环境实验箱搭建实验平台,测量环境箱送风口速度分布,以及升、降温过程中室内及壁面的温度曲线,然后对环境箱进行建模,以实测的送风速度、温度作为边界条件,利用CFD方法进行仿真,最后对比分析实验值与CFD仿真的结果。结果利用CFD方法计算得到的环境箱升、降温曲线与实测值吻合较好,尤其是壁面温度曲线,误差不超过4℃。送风温度可以根据蒸发器理论或加热功率和回风温度而动态地确定。结论利用CFD方法分析环境实验箱气流组织与围护结构的耦合传热是可行的,FLUENT的UDF功能可根据需要扩展,以协助设计蒸发器和控制策略。     

揭开武汉东湖蓝藻水华消失之谜

水华（亦称湖靛）是湖泊富营养化最恶劣的表征之一。武汉东湖７０年代至１９８４年间每年夏季出现蓝藻水华,１９８５年起突然消失,至今已有１４年没有重现,原因何在？通过三次设在湖里的围隔试验,证明鲢鳙的大量放养,是水华消失的决定性因素。     

穗花狐尾藻和金鱼藻对白洋淀水质影响的原位围隔试验

在白洋淀建成14个原位围隔(9 m2/个),分别按10、20和30株/m2的密度种植穗花狐尾藻、金鱼藻,研究不同密度穗花狐尾藻和金鱼藻在调控水体富营养化方面的效能与稳定性.结果表明:穗花狐尾藻和金鱼藻能有效控制浮游植物的生物量并改善水体SD(透明度),其中密度为10株/m2穗花狐尾藻(平均长度为83 cm,平均湿质量为37.1 g)和密度为20株/m2金鱼藻(平均长度为68 cm,平均湿质量为31.2 g)的围隔控制效果明显,水体中ρ(TN)和ρ(TP)都明显下降,SD增加,浮游植物多样性明显增加,水体营养状态指数(TSIM)明显下降;但高密度沉水植物可能造成水体ρ(Chla)和营养盐含量的反弹.研究证明,种植合理密度的穗花狐尾藻、金鱼藻有利于改善白洋淀水质.      

大型电信枢纽站空调室外机的噪声控制

大型电信枢纽站使用了大量的空调室外机 ,对城市环境造成了严重噪声污染。针对空调室外机的 3种不同布置方式 ,采取了不同噪声治理措施。结合噪声控制 ,合理组织气流 ,不仅有效地降低了噪声 ,而且改善了空调室外机工作环境。利用吸声吊顶 ,设计消声进风口 ,收到了事半功倍的成效     

浑善达克沙地退化草地的封育效果调查

封育保护是促进退化草地自然恢复的有效方法之一,为了研究实施京津风沙源工程措施以来浑善达克沙地沙质草场的围封效果,我们特对浑善达克沙地南缘地段的围封草场进行了调查,并取得了一些结果。     

Effects of significant damage of flame gap surfaces in flameproof electrical apparatus on flame gap efficiency

Electrical apparatus for use in the presence of explosive gas atmospheres has to be specially designed to prevent the apparatus from igniting the gas. Flameproof design is one of several options, and one requirement is then that any holes and slits in the enclosure wall be designed to prevent a possible gas explosion inside the enclosure from being transmitted to an explosive gas cloud outside it. Current standards (IEC) require that joint surfaces have a surface roughness of <6.3 μm. Any damaged joint surface has be restored to this quality. The present investigation has demonstrated that flame gap surfaces in flameproof electrical apparatuses can suffer considerable mechanical and corrosive damage before the flame gaps no longer function satisfactorily. In some cases very significant mechanical surface damage in fact improves the gap performance. This indicates that current high costs of repairing and replacing flameproof electrical apparatus in process plants offshore and onshore can be reduced considerably without any increase of the explosion risk.     

Internal short circuit and accelerated rate calorimetry tests of lithium-ion cells: Considerations for methane-air intrinsic safety and explosion proof/flameproof protection methods

Researchers with the National Institute for Occupational Safety and Health (NIOSH) studied the potential for lithium-ion cell thermal runaway from an internal short circuit in equipment for use in underground coal mines. In this third phase of the study, researchers compared plastic wedge crush-induced internal short circuit tests of selected lithium-ion cells within methane (CH₄)-air mixtures with accelerated rate calorimetry tests of similar cells. Plastic wedge crush test results with metal oxide lithium-ion cells extracted from intrinsically safe evaluated equipment were mixed, with one cell model igniting the chamber atmosphere while another cell model did not. The two cells models exhibited different internal short circuit behaviors. A lithium iron phosphate (LiFePO₄) cell model was tolerant to crush-induced internal short circuits within CH₄-air, tested under manufacturer recommended charging conditions. Accelerating rate calorimetry tests with similar cells within a nitrogen purged 353-mL chamber produced ignitions that exceeded explosion proof and flameproof enclosure minimum internal pressure design criteria. Ignition pressures within a 20-L chamber with 6.5% CH₄-air were relatively low, with much larger head space volume and less adiabatic test conditions. The literature indicates that sizeable lithium thionyl chloride (LiSOCl₂) primary (non rechargeable) cell ignitions can be especially violent and toxic. Because ignition of an explosive atmosphere is expected within explosion proof or flameproof enclosures, there is a need to consider the potential for an internal explosive atmosphere ignition in combination with a lithium or lithium-ion battery thermal runaway process, and the resulting effects on the enclosure.