Experimental study on explosion inhibition by heptafluoropropane and its synergy with inert gas

The inhibition effect of heptafluoropropane (CF₃CHFCF₃) on methane explosions under different inhibitor concentrations in a closed vessel was studied. A high-speed camera and a pressure sensor were adopted respectively to record flame propagation characteristics and pressure data. Results indicate that the relationship between flame propagation and pressure rising was correlated. As the equivalent ratio (ϕ)≤1, the pressure presented a trend of rising firstly and then decreasing with increasing CF₃CHFCF₃ concentration, and it was found that there existed a critical concentration for pressure decrease. As ϕ > 1, the pressure exhibited a decreasing trend. Although the pressure appeared to seemingly increase, the moment that the pressure began to rise (t_rise) and the moment that the maximum explosion overpressure appeared (t_Pmax) were obviously delayed. The average rate of pressure rise ((dP/dt)_ave) was decreased as the concentration of CF3CHFCF3 increased. It indicates that CF₃CHFCF₃ can effectively reduce the explosion reaction rate. The critical concentration of CF₃CHFCF₃ for complete inhibition was determined. Meanwhile, the synergy of CF₃CHFCF₃-inert gas can improve the inhibition effect. Compared with CF₃CHFCF₃–N₂, the synergy of CF₃CHFCF₃–CO₂ presented a better inhibition effect, and the inhibition effect was increased with increasing inert gas concentration. And the mechanisms of physical and chemical effects on explosion inhibition were analyzed.     

Compostability of Poly(lactide): Degradation in an Inert Solid Medium

Commercial poly(lactide) degradation was studied in an inert solid medium simulating compost conditions, with the aim to achieve a complete carbon balance of the polymer degradation. The mineralisation rate at the end of the test was compared to those obtained for poly(lactide) degradation in compost. It was shown that the mineralisation rate after 45 days of degradation was quite lower in inert solid medium than in compost but the standard deviation of data was enhanced. A protocol for both extraction and quantification of the carbon included in the different degradation by-products was proposed and the carbon balance of the polymer degradation was followed during the test with a satisfactory accuracy. The non-degraded PLA material was recovered during the test, hence the evolution of the glass transition temperature and the molecular weight was followed. A two-step degradation mechanism was highlighted in inert solid medium, showing the fundamental role of abiotic reactions for PLA degradation in compost.     

生物法处理含铬废水的研究进展

随着人类对环境保护的重视和环境法规的日益严格，国内外研究人员纷纷将注意力转向生物法处理含铬废水。文章介绍了惰性生物吸附法和纯种微生物法处理含铬废水近年来的研究进展。     

Application of encapsulation (pH-sensitive polymer and phosphate buffer macrocapsules): a novel approach to remediation of acidic ground water

Macrocapsules, composed of a pH-sensitive polymer and phosphate buffer, offer a novel remediation alternative for acidic ground waters. To test their potential effectiveness, laboratory experiments were carried out followed by a field trial within a coal pile runoff (CPR) acidic contaminant plume. Results of traditional limestone and macrocapsule treatments were compared in both laboratory and field experiments. Macrocapsules were more effective than limestone as a passive treatment for raising pH in well water from 2.5 to 6 in both laboratory and field experiments. The limestone treatments had limited impact on pH, only increasing pH as high as 3.3, and armoring by iron was evident in the field trial. Aluminum, iron and sulfate concentrations remained relatively constant throughout the experiments, but phosphate increased (0.15-32 mg/L), indicating macrocapsule release. This research confirmed that macrocapsules may be an effective alternative to limestone to treat highly acidic ground water.     

The effect of admixed material on the minimum explosible concentration of oil shale

The minimum explosible concentration (MEC) in the air atmosphere at the boundary between an explosion and no explosion in a dust cloud, has been investigated for several particle sizes of oil shale and for mixtures of oil shale and inert powder of different particle size. Limestone, stone dust and coarse particle size of oil shale were used as inert materials. Measurements were made in a standard small vertical tube apparatus. The results obtained indicated that the minimum explosible concentration is dependent on the particle size, i.e., values of MEC decrease with a decrease in the size of the particles. Below 70 μm, values of MEC become almost constant. Admixture of limestone as low as 5% to oil shale is sufficient to reduce the MEC values significantly.     

废水中起始惰性溶解有机物的测定

介绍了4种测定起始惰性溶解有机物的方法．即Ekama和国际水质协会提出的两种直接测定法和排除溶解性残留物干扰的两种间接测定法。通过分析比较，指出了4种方法的优缺点及适用情况。其中直接测定法适用于有机物浓度较低的生活污水．间接测定法适用于有机物浓度较高的工业废水。     

The influence of inert gas on limiting experimental safe gap of fuel-air mixtures at various initial pressures

The Maximum Experimental Safe Gap (MESG) is an important criterion to assess the propagation of flames through small gaps. This safety-related parameter is used to classify the flammable gases and vapors in explosion groups, which are fundamental to constructional explosion protection. It is used both, for the safe design of flameproof encapsulated devices as well as for selecting flame arresters appropriate to the individual application. The MESG of a fuel is determined experimentally according to the standard ISO/IEC 80079-20-1:2017 at normal conditions (20 °C, 1.0 bar) with air as oxidizing gas. The aim of this work is to investigate the effect of inert gas addition on the MESG in order to assess the effectiveness of inertization in constructional explosion protection. The term limiting experimental safe gap (S_G) is used for the result of these measurements. The fuel-air mixtures (fuels: hydrogen, ethylene, propene, methane) used as representatives for the explosion groups in flame arrester testing were chosen and diluted with inert gas (nitrogen, carbon dioxide) before testing. The dependence of the limiting experimental safe gap on the total initial pressure, amount and nature of inert additive is discussed. The initial pressure was varied up to 2.0 bar to include increased pressure conditions used in flame arrester testing. Apart from the well-known reciprocal dependence on the initial pressure, the added inert gas results in an exponential increase of S_G. This effect depends on the inertizing potential of the gas and is therefore different with nitrogen and carbon dioxide. The ranking of the fuels is the same as with MESG. As a result, various mixtures of the same limiting experimental safe gap can now be chosen and tested with an individual flame arrester to prove the concept of a constant and device-related limiting safe gap. The work was funded by BG-RCI in Heidelberg (PTB grant number 37056).     

Effects of initial temperature and pressure on explosion characteristics of propane–diluent–air mixtures

The explosion characteristics of propane–diluent–air mixtures under various temperatures and pressures were investigated using a 20-L apparatus. The explosion limits of propane diluted with nitrogen or carbon dioxide were measured at high temperatures from 25 to 120 °C. The results showed that the upper explosion limit (UEL) increased, and the lower explosion limit (LEL) decreased with the rising temperature. The explosion limits of propane diluted with nitrogen or carbon dioxide were also measured at high pressures from 0.10 to 0.16 MPa. The results showed that the UEL increased, and the LEL almost remainedunchanged along with increased pressure. Under the same initial operating conditions, the concentration of nitrogen required to reach the minimum inerting concentration (MIC) point was higher than the concentration of carbon dioxide. Finally, the study investigated the limiting oxygen concentration (LOC) of propane under various initial temperatures, initial pressures, and inert gases. The LOC of propane decreased approximately linearly with increased temperature or pressure, and the LOC of propane dilution with carbon dioxide was greater than dilution with nitrogen from 25 to 120 °C or from 0.10 to 0.16 MPa, which indicated that the dilution effect of carbon dioxide was better than that of nitrogen.     

微生物制剂在城市湖泊水体生物修复中的作用

利用微生物对富营养化的城市湖泊水体进行生物修复，使水中的污染物降解成H2O、CO2或转化成无害物质。研究表明，该微生物制剂对去除水体中的有机物、叶绿素a、氨氮和提高溶解氧等均有显著效果。为节省运输费用及延长菌液保存期，本试验用惰性粒子流化床对生物制剂进行干燥，固体菌粉末不失活性。