一般工业固废填埋场建设项目环境监理探析

介绍了一般工业固废填埋场工程的特点和环境监理的现状;结合填埋场项目环境监理工作的实践,分析并总结了填埋场建设项目环境监理要点,即制订切实的监理方案,对工程的关键部位、关键工序做好巡视、旁站监理工作,在实施过程中做好水土保持、生态保护的监理工作。     

城市固体废物好氧生物反应器填埋方式的实验研究

MSW（城市固体废物）生物反应器型填埋是一种较新颖的方法.在系统分析现有填埋方法优缺点的基础上,对其加以改进,将强制通风好氧和渗滤液循环2种方式有机地结合在一起,构建了MSW好氧生物反应器.考察了NH3、CH4、CO2、pH和温度等因素,并监测分析了渗滤液中的COD、BOD5、Zn^2＋、NH4^＋和NO3^-等指标,旨在研究其中垃圾的降解及渗滤液中COD、BOD5、Zn^2＋、NH4^＋和NO3^-的去除情况,探讨该生物反应器对垃圾和渗滤液相关参数的作用机理.结果表明,该反应器对渗滤液中COD、BOD5、NO3^-的去除率分别达到96.34%、94.58%和99.9%,对其中的Zn^2＋也有较好的脱除效果.     

城市生活垃圾渗透系数测试研究

采用常水头测渗实验，对不同压实密度和水力梯度下的新鲜垃圾与陈垃圾的渗透系数进行测试，根据达西定律求得渗透系数值。由于垃圾的不均匀性、小颗粒的运动和大孔隙沟道流的形成和改变，实验初始阶段渗透系数值先增大至峰值，然后缓慢降低直至趋于稳定。实验稳定后，新鲜垃圾压实密度为0．75—0．95t／m^3时，渗透系数值约为1．26E-03～1．43E-03cm／s。陈垃圾在压实密度分别为1．2和1．4t／m^3时，渗透系数为8．29E-04和1．35E-04cm／s。     

Biogeochemistry at a wetland sediment–alluvial aquifer interface in a landfill leachate plume

The biogeochemistry at the interface between sediments in a seasonally ponded wetland (slough) and an alluvial aquifer contaminated with landfill leachate was investigated to evaluate factors that can effect natural attenuation of landfill leachate contaminants in areas of groundwater/surface-water interaction. The biogeochemistry at the wetland-alluvial aquifer interface differed greatly between dry and wet conditions. During dry conditions (low water table), vertically upward discharge was focused at the center of the slough from the fringe of a landfill-derived ammonium plume in the underlying aquifer, resulting in transport of relatively low concentrations of ammonium to the slough sediments with dilution and dispersion as the primary attenuation mechanism. In contrast, during wet conditions (high water table), leachate-contaminated groundwater discharged upward near the upgradient slough bank, where ammonium concentrations in the aquifer where high. Relatively high concentrations of ammonium and other leachate constituents also were transported laterally through the slough porewater to the downgradient bank in wet conditions. Concentrations of the leachate-associated constituents chloride, ammonium, non-volatile dissolved organic carbon, alkalinity, and ferrous iron more than doubled in the slough porewater on the upgradient bank during wet conditions. Chloride, non-volatile dissolved organic carbon (DOC), and bicarbonate acted conservatively during lateral transport in the aquifer and slough porewater, whereas ammonium and potassium were strongly attenuated. Nitrogen isotope variations in ammonium and the distribution of ammonium compared to other cations indicated that sorption was the primary attenuation mechanism for ammonium during lateral transport in the aquifer and the slough porewater. Ammonium attenuation was less efficient, however, in the slough porewater than in the aquifer and possibly occurred by a different sorption mechanism. A stoichiometrically balanced increase in magnesium concentration with decreasing ammonium and potassium concentrations indicated that cation exchange was the sorption mechanism in the slough porewater. Only a partial mass balance could be determined for cations exchanged for ammonium and potassium in the aquifer, indicating that some irreversible sorption may be occurring.Although wetlands commonly are expected to decrease fluxes of contaminants in riparian environments, enhanced attenuation of the leachate contaminants in the slough sediment porewater compared to the aquifer was not observed in this study. The lack of enhanced attenuation can be attributed to the fact that the anoxic plume, comprised largely of recalcitrant DOC and reduced inorganic constituents, interacted with anoxic slough sediments and porewaters, rather than encountering a change in redox conditions that could cause transformation reactions. Nevertheless, the attenuation processes in the narrow zone of groundwater/surface-water interaction were effective in reducing ammonium concentrations by a factor of about 3 during lateral transport across the slough and by a factor of 2 to 10 before release to the surface water. Slough porewater geochemistry also indicated that the slough could be a source of sulfate in dry conditions, potentially providing a terminal electron acceptor for natural attenuation of organic compounds in the leachate plume.     

Ti（Ⅳ）催化臭氧／过氧化氢预处理酸性难降解废水

在Ti（Ⅳ）和过氧化氢存在条件下,考察了臭氧化酸性苯乙酮溶液、硝基苯溶液和垃圾渗滤液（浙江衢州某垃圾填埋场）的预处理效能。结果表明,在pH2．86条件下,单独臭氧化处理对苯乙酮、硝基苯和垃圾渗滤液的COD去除率分别为10．1％、44％和28．6％。BOD,／COD值分别从原来的0．039、0．060和0．085提高到了0．130、0．158和0．174,仍属生化难降解废水。当体系加入Ti（Ⅳ）后,臭氧化苯乙酮和硝基苯的COD去除率分别达到了75．5％和65％,BOD;／COD则提高到了0．679和0．314,可生化性提升明显。对于垃圾渗滤液,只有当体系加入Ti（Ⅳ）和H22后,臭氧化COD的去除率达到66．6％,BOD、／COD提高至0．425。上述结果对酸性难降解废水的处理实际意义非常突出。     

基于航空摄影测量的填埋堆体动态重构精度及影响因素

填埋堆体表面形变监测是填埋场库容管理和堆体失稳等风险分析的核心,其时空高分辨率监测研究近年来引起广泛关注。基于航空摄影的地表测量技术具有采集速度快、时空分辨率高等优点,但在填埋场特殊环境下,面对高频填埋活动、显著的堆体变化以及防雨膜覆盖等干扰时,要同时满足高时空分辨率和耗时短的动态监测要求,无人机的最佳飞行参数设定亟待研究。为此,该研究模拟中等规模危险废物填埋场的规模和日填埋量,利用专业级无人机获取模拟区域图像,空三加密处理生成三维点云数据,利用Arcmap叠加分析多期监测数据,从点位坐标、重构尺度、重构体积、体积差分精度4个角度分析重构误差。结果表明:三维重构的坐标精度可以达到米级;重构尺度误差为2~3 cm,重构体积误差为0.16~0.17 m³,差分体积误差为0.16~0.17 m³;进一步研究发现,高度为25~55 m时,高度越高精度越低,相机倾角为[-53°,-60°]时,精度最高,旁向重叠率大于80%时,误差骤减且基本稳定。考虑到填埋场的填埋作业间隔、无人机续航能力等对飞行时间的约束,为获得最佳精度,建议无人机飞行高度为37 m、相机倾斜角度为[-53°,-60°]、旁向重叠率为80%。     

生活垃圾加载介质层填埋法对初期渗滤液污染抑制效果研究

以传统卫生填埋柱R2为对照,通过往生物反应器填埋柱R1内加载可渗透反应介质层1和2进行模拟试验,主要探讨了填埋柱R1垃圾渗滤液COD、总氮、氨氮及总磷的变化趋势,探索一种新型的加载介质层垃圾填埋处理方法。试验结果表明,填埋20周后, R1柱COD浓度基本维持在40 000～45 000 mg/L间,约为R2柱的20%～30%;第24周,R1柱总氮和氨氮分别为206.5 mg/L和167.3 mg/L,在16～24周内,R1总氮和氨氮分别约为R2的14.5%～17.5%和36.2%～43.6%;18周时,R1柱总磷达最大值1.704 mg/L,至第24周降为0.673 mg/L, 整个实验过程R1柱总磷约为R2的0.15%～0.56%。     

砒霜生产化工厂危险废物处置工程设计

通过对砒霜生产化工厂原场址废渣及污染场地调查的基础上,进行了处置方案比选及技术经济比较,确定了就地安全填埋的处置方案。根据区域性危险废物集中安全填埋场的设计经验,本工程采用先进的HDPE双层防渗的安全填埋方式,并设置了雨水分流系统、渗滤液收集系统、封场处理和填埋气体导排系统,整个场区布置合理,对周围环境的影响小,投资少,取得了良好的社会效益和环境效益,并对危险废物处理处置工程设计中应注意的问题提出了建议。     

渗滤液污染包气带中铁的形态变化

从渗滤液场龄和包气带岩性两方面出发,研究了新、老渗滤液对亚粘土和细砂包气带环境中Fe的含量及存在形态的影响。结果表明：新、老渗滤液分别能使细砂包气带介质中除残渣态以外Fe的含量增加16.68%或降低13.82%。亚粘土比细砂作为包气带介质更能缓冲渗滤液对介质中Fe的影响程度,其受影响范围在包气带0～20 cm深度处。当亚粘土为介质的包气带被新渗滤液污染后,其表层介质中碳酸盐结合态Fe的含量会增加15倍之多,为缓冲渗滤液Fe的污染做出了巨大贡献,但这部分Fe的存在也是潜在的二次污染源,在环境pH急剧变化的情况下,它可能会引起地下水高铁污染。