210m钢筋混凝土烟囱控制爆破拆除数值模拟研究

通过采用LS-DYNA动力学有限元程序,模拟210 m钢筋混凝土烟囱的控制爆破拆除倒塌过程。采用数值模拟方法,不仅可以对控制爆破拆除工程中构筑物倾倒、破坏的重要影响因素进行分析,对有关理论研究结果的正确性和有效性进行验证,还能优化爆破拆除方案、预测实际爆破拆除效果,提高爆破拆除设计与施工的经济性、可靠性和安全性。     

弧焊机器人用数控焊接变位机的研制

依据现有进口弧焊机器人的技术特点和工作要求 ,研制了与之配套的数控焊接变位机。该机工作台可进行旋转和倾斜两个运动 ,可使工件在最佳的位置进行焊接 ,与弧焊机器人一起构成了柔性加工单元。在实际焊接应用中 ,效果良好     

三阶段温度控制堆肥接种法对有机氮变化规律的影响

利用原生生活垃圾,通过三阶段温度控制技术进行堆肥试验,探讨在堆肥过程中有机态氮组分的动态变化规律.结果表明,全氮、酸水解有机态氮、氨基酸态氮均在堆肥的前期呈明显的下降趋势,呈较好的相关性.与CK（对照组）处理相比,在堆肥的后期,三阶段温度控制堆肥酸水解有机态氮、氨基酸态氮、氨基糖态氮及酸解未知态氮含量呈不同程度的上升趋势,增加幅度依次为：10.67%、16.17%、7.17%、22.44%.表明三阶段温度控制技术能减少堆肥中氮素的损失,堆肥产品施入土壤后,可提高土壤的供氮潜力.     

利用铜矿尾砂研制低强度可控性填料

利用铜矿尾砂、粉煤灰、水泥以及加气剂等,混合搅拌成泥浆体,振动成型,制备出低强度可控性填料(CLSM).试验表明:以水泥12.9％、铜矿尾砂(细集料)22.6％、加气剂3.2％、粉煤灰12.9％等工业废弃物,加水48.4％,固液比控制在(14～15):(15～16)之间,制得的CLSM制品,抗压强度0.35～2.00 ...     

碾泥车间主厂房爆破拆除安全技术

介绍了在复杂环境下碾泥车间主厂房定向爆破拆除的成功经验.在对主厂房进行较为充分的预处理基础上,选择了合理的炸高和起爆网路,采用了可行的爆破安全技术,爆破达到了预期效果,可供类似工程参考.     

Topsoil organic carbon mineralization and CO2 evolution of three paddy soils from South China and the temperature dependence

Carbon mineralization and its response to climatic warming have been receiving global attention for the last decade. Although the virtual influence of temperature effect is still in great debate, little is known on the mineralization of organic carbon （SOC） of paddy soils of China under warming. SOC mineralization of three major types of China＇s paddy soils is studied through laboratory incubation for 114 d under soil moisture regime of 70% water holding capacity at 20℃ and 25℃ respectively. The carbon that mineralized as CO2 evolved was measured every day in the first 32 d and every two days in the following days. Carbon mineralized during the 114 d incubation ranged from 3.51 to 9.22 mg CO2-C/gC at 20℃ and from 4.24 to 11.35 mg CO2-C/gC at 25℃ respectively; and a mineralizable C pool in the range of 0.24 to 0.59 gC/kg, varying with different soils. The whole course of C mineralization in the 114 d incubation could be divided into three stages of varying rates, representing the three subpools of the total mineralizable C： very actively mineralized C at 1-23 d, actively tnineralized C at 24--74 d and a slowly mineralized pool with low and more or less stabilized C mineralization rate at 75-114 d. The calculated Q10 values ranged from 1.0 to 2.4, varying with the soil types and N status. Neither the total SOC pool nor the labile C pool could account for the total mineralization potential of the soils studied, despite a well correlation of labile C with the shortly and actively mineralized C, which were shown in sensitive response to soil warming. However, the portion of microbial C pool and the soil C/N ratio controlled the C mineralization and the temperature dependence. Therefore, C sequestration may not result in an increase of C mineralization proportionally. The relative control of C bioavailability and microbial metabolic activity on C mineralization with respect to stabilization of sequestered C in the paddy soils of China is to be further studied.     

The contemporary cement cycle of the United States

A country-level stock and flow model for cement, an important construction material, was developed based on a material flow analysis framework. Using this model, the contemporary cement cycle of the United States was constructed by analyzing production, import, and export data for different stages of the cement cycle. The United States currently supplies approximately 80% of its cement consumption through domestic production and the rest is imported. The average annual net addition of in-use new cement stock over the period 2000–2004 was approximately 83 million metric tons and amounts to 2.3 tons per capita of concrete. Nonfuel carbon dioxide emissions (42 million metric tons per year) from the calcination phase of cement manufacture account for 62% of the total 68 million tons per year of cement production residues. The end-of-life cement discards are estimated to be 33 million metric tons per year, of which between 30% and 80% is recycled. A significant portion of the infrastructure in the United States is reaching the end of its useful life and will need to be replaced or rehabilitated; this could require far more cement than might be expected from economic forecasts of demand for cement.     

Estimation of building-related construction and demolition waste in Shanghai

One methodology is proposed to estimate the quantification and composition of building-related construction and demolition (C&D) waste in a fast developing region like Shanghai, PR China. The varieties of structure types and building waste intensities due to the requirement of progressive building design and structure codes in different decades are considered in this regional C&D waste estimation study. It is concluded that approximately 13.71 million tons of C&D waste was generated in 2012 in Shanghai, of which more than 80% of this C&D waste was concrete, bricks and blocks. Analysis from this study can be applied to facilitate C&D waste governors and researchers the duty of formulating precise policies and specifications. As a matter of fact, at least a half of the enormous amount of C&D waste could be recycled if implementing proper recycling technologies and measures. The appropriate managements would be economically and environmentally beneficial to Shanghai where the per capita per year output of C&D waste has been as high as 842 kg in 2010.     

Development of controlled release formulations of azadirachtin-A employing poly(ethylene glycol) based amphiphilic copolymers

Controlled release (CR) formulations of azadirachtin-A, a bioactive constituent derived from the seed of Azadirachta indica A. Juss (Meliaceae), have been prepared using commercially available polyvinyl chloride, polyethylene glycol (PEG) and laboratory synthesized poly ethylene glycol–based amphiphilic copolymers. Copolymers of polyethylene glycol and various dimethyl esters, which self assemble into nano micellar aggregates in aqueous media, have been synthesized. The kinetics of azadirachtin-A, release in water from the different formulations was studied. Release from the commercial polyethylene glycol (PEG) formulation was faster than the other CR formulations. The rate of release of encapsulated azadirachtin-A from nano micellar aggregates is reduced by increasing the molecular weight of PEG. The diffusion exponent (n value) of azadirachtin-A, in water ranged from 0.47 to 1.18 in the tested formulations. The release was diffusion controlled with a half release time (t_1/2) of 3.05 to 42.80 days in water from different matrices. The results suggest that depending upon the polymer matrix used, the application rate of azadirachtin-A can be optimized to achieve insect control at the desired level and period.     

Emergy analysis of the recycling options for construction and demolition waste

Construction and demolition (C&D) waste is becoming a major contributor to environmental pollution. In Shanghai, China, the quantity of C&D waste is 2.11E+07 t/yr, which accounts for 45% of the total quantity of solid waste. There has been a growing promotion of recycling C&D waste as an effective way to solve this waste problem. However, the evaluation of the efficiency of recycling C&D waste as a potential source of resources is largely based on traditional economic analysis. The economic analysis emphasizes money instead of the harmony between economic benefit and environmental effects. There is a need for a new strategic approach to investigate the efficiency of recycling C&D waste to achieve the integration between economic, social and environmental effects. Emergy theory can be employed to analyze different recycling options for C&D waste. With reference to the Chinese construction industry, this paper demonstrates that the close-loop recycling option is better than the open-loop recycling option for C&D waste in terms of the integration of social, environmental and sustainable aspects. To evaluate different technology solutions for C&D waste recycling, the emergy theory and method is not limited to a cost-benefit balance but can include economic, social, environmental and sustainable effects.