北京市发展CNG汽车的条件与前景分析

北京市汽车排放污染物贡献率已达到：HC73.5％，CO63．4％，NOx46％。用CNG代替汽油作汽车燃料，可使CO减少97％、HC减少72％、NOx减少39％、CO2减少24％、SO2减少90％。建立CNG加气站和CNG汽车改装这两个CNG应用关键问题在技术上、经济上都是可行的。北京市CNG燃料来源有保障。北京市车辆都比较适合使用CNG气体燃料。北京有很强的CNG汽车产业科技力量。对北京市当前发展CNG汽车产业提出了一些建议。     

乙醇汽油与普通汽油非常规污染物排放特性对比研究

在一台满足国Ⅴ排放标准的双喷射(气口喷射+缸内直喷)汽油机上开展了燃用E10乙醇汽油(乙醇体积比为10%)对发动机非常规排放特性影响的试验研究.使用傅里叶变换红外分析仪(FTIR)测量了饱和烃、不饱和烃、芳香烃及醇、醛等非常规污染物排放量,对比分析了双喷射模式时各工况下E0和E10两种燃料的非常规排放水平.结果表明,双喷射模式下,加入乙醇有效降低了乙烯、1,3-丁二烯、苯和甲苯的排放量,但会导致乙醛排放升高.双喷射模式下,随着负荷增加,两种燃料下的1,3-丁二烯和甲苯排放呈现先升高后降低的趋势,乙烯、甲醛和苯排放则先降低后升高.乙醇能抑制1,3-丁二烯、乙烯生成,抑制效果为PFI模式优于双喷射模式,GDI模式抑制量最低.PFI和GDI模式下E10的甲醛排放均显著升高,但双喷射模式有效抑制了甲醛排放的增加.     

基于遥感尾气监测的柴油车气态污染物排放因子计算方法研究

采用遥感尾气测试系统实测了柴油车在实际道路工况下的CO、HC和NO排放特征,修正了排放因子的计算方法,并与车载排放测试系统（PEMS）实测结果进行了验证,获得了实测车辆的CO、HC和NO排放因子.测试结果显示,在各种遥感监测的工况下柴油车尾气中均含有较高浓度的氧气,未考虑氧气影响的燃烧方程反演获得的各污染物体积浓度计算值与PEMS实测值的偏差较大,且氧气浓度越大,偏差越大.经过氧气修正的燃烧方程反演计算的尾气浓度与PEMS实测值吻合度大幅提升,适用于实际工况下遥感检测车辆尾气的反演计算.修正算法得到CO、HC和NO的排放因子离散性较小,精确度较高,可以为量化柴油车尾气排放贡献提供科学依据.     

河岸过滤中氨氮的削减及其浓度对细菌与氨氧化微生物的影响

通过小试滤柱模拟河岸过滤,结合荧光定量PCR和高通量测序等手段研究了河岸过滤对氨氮的削减效能和进水氨氮浓度对细菌与氨氧化微生物的影响.结果表明,低浓度（0.2 mg·L^-1）氨氮未被削减,较高浓度（1.0 mg·L^-1和2.0 mg·L^-1）氨氮的削减率可达70%.进水处细菌丰度随氨氮浓度升高而增加,细菌群落组成随氨氮浓度升高发生规律性变化.出水处氨氧化古菌（Ammonia oxidizing archaea,AOA）丰度与氨氮浓度呈负相关,氨氧化细菌（Ammonia oxidizing bacteria,AOB）丰度与氨氮浓度无显著相关关系;进水处AOA-α多样性与氨氮浓度呈正相关,但AOB-α多样性与氨氮浓度呈负相关;进水处AOA群落组成受氨氮浓度影响,而进、出水处AOB群落组成均受氨氮浓度影响.可见,进水氨氮浓度会影响河岸过滤对氨氮的削减效能,还会影响细菌、氨氧化微生物的丰度及群落结构,AOB对氨氮浓度的变化比AOA更敏感.     

DOC+CDPF对国III重型柴油货车实际道路排放的影响

利用便携式车载排放测试系统（PEMS）对2辆加装氧化催化转化器（DOC）和催化型柴油颗粒捕集器（CDPF）与否的国III重型柴油货车进行实际道路排放测试.结果表明,2辆改造重型柴油车的CO、THC、固态颗粒物粒数（SPN）和黑碳（BC）实际道路排放因子分别为（1.31±0.37）g/（kW×h）、（0.20±0.03） g/（kW×h）、（7.13×10¹⁰±5.27×10¹⁰）个/（kW×h）和（0.69±0.06）mg/（kW×h）,相对于原始排放（拆除DOC+CDPF）分别降低52.48%、55.69%、99.91%和99.22%.从低速、中速到高速,CO和THC减排比例呈现上升趋势,然而运行工况对SPN和BC减排比例则无显著影响.加装DOC+CDPF会导致NO₂在NO_x中的占比升高,且从低速、中速到高速涨幅依次增大,但对NO_x无明显减排效益,其排放因子为9.53~9.83g/（kW×h）,远高于实验室排放限值.     

Potential of secondary aerosol formation from Chinese gasoline engine exhaust

Light-duty gasoline vehicles have drawn public attention in China due to their significant primary emissions of particulate matter and volatile organic compounds(VOCs). However,little information on secondary aerosol formation from exhaust for Chinese vehicles and fuel conditions is available. In this study, chamber experiments were conducted to quantify the potential of secondary aerosol formation from the exhaust of a port fuel injection gasoline engine. The engine and fuel used are common in the Chinese market, and the fuel satisfies the China V gasoline fuel standard. Substantial secondary aerosol formation was observed during a 4–5 hr simulation, which was estimated to represent more than 10 days of equivalent atmospheric photo-oxidation in Beijing. As a consequence, the extreme case secondary organic aerosol(SOA) production was 426 ± 85 mg/kg-fuel, with high levels of precursors and OH exposure. The low hygroscopicity of the aerosols formed inside the chamber suggests that SOA was the dominant chemical composition. Fourteen percent of SOA measured in the chamber experiments could be explained through the oxidation of speciated single-ring aromatics. Unspeciated precursors, such as intermediate-volatility organic compounds and semi-volatile organic compounds, might be significant for SOA formation from gasoline VOCs. We concluded that reductions of emissions of aerosol precursor gases from vehicles are essential to mediate pollution in China.     

柴油机尾气中PAH_s的分析

本文概述了柴油机尾气中ＰＡＨｓ的分析方法，着重论述了采样及预处理方法，特别对预处理方法进行了深入的探讨。另外，通过对柴油机两种不同工况下产生的尾气进行分析后发现，柴油机转速越高，其排放尾气中ＰＡＨｓ的含量就越低。     

苏州市机动车尾气中主要污染物特征分析

为了解苏州市机动车尾气中主要污染物浓度特征,运用SPSS19.0时间序列建模器,预测了未来5年(2017—2021年)苏州市机动车保有量,分析和对比了苏州市路边站点和国控站点的主要污染物数据。结果表明,未来5年,苏州市机动车保有量呈现上升趋势,2020年机动车保有量将达到373.1万辆,相比2014年增加约37.5%;路边站点NO2值略高于国控站点,但差异不显著;路边站点CO值明显高于国控站点;路边站点PM10和PM2.5值总体略高于国控站点;路边站点苯系物值高于国控站点。     

Multipoint source method in air pollution modelling of cold start emission

The paper presents a new method of air pollution modelling on a micro scale. For estimation of concentration of car exhaust pollutants, each car is treated as an instantaneous moving emission source. This approach enables us to model time and spatial changes of emission, especially during cold and cool start of an engine. These stages of engine work are a source of significant pollution concentration in urban areas. In this work, two models are proposed: one for the estimation of emission after cold start of the engine and another for the prediction of pollutant concentration. The first model (defined for individual exhaust gas pollutants) enables us to calculate the emission as a function of time after the cold or cool start, ambient temperature and average speed of motion. This model uses the HBEFA database. The second mathematical model is developed in order to calculate the pollutant dispersion and concentrations. The finite volume method is applied to discretise the set of partial differential equations describing wind flow and pollutant dispersion in the domain considered. Models presented in this paper can be called short-term models on a small spatial scale. The results of numerical simulation of pollutant emission and dispersion are also presented.     

城市高架道路建设对机动车尾气污染的影响分析

通过现场观测和对比，分析了城市一般道路上和城市高架道路下机动车排放污染物浓度差异的原因，分析结果表明，扩散条件对城市机动车尾气污染有着重要影响，例举日本对城市高架道路建设的有关规定，提出应重视城市高架道路建设的环境预评估等。