提高电捕焦油器安全生产运行的措施

简要叙述了电捕焦油器开工以来存在的问题,对电捕捕焦油器不能安全稳定运行的原因进行了分析,并采取改进措施。实践证明,改进工艺技术合理,方法可行,电捕焦油器运行效果达到指标要求。     

初始温度和压力对排污空间甲烷-空气混合物爆燃特性影响的模拟研究

市政排污空间作为城市公共基础设施的重要组成部分，易积聚可燃气体形成爆炸性环境。结合排污空间的特殊环境条件，采用Fluidyn-MP多物理场数值模拟软件，建立了20 L球形爆炸罐分析模型，通过改变初始温度和初始压力，对排污空间甲烷-空气混合物爆燃特性及其变化规律进行模拟研究。结果表明:初始温度升高导致甲烷-空气混合物最大爆炸压力降低，缩短了到达最大爆炸压力的时间；初始压力增加导致最大爆炸压力急剧升高，并延长了到达最大爆炸压力的时间；最大爆炸压力对初始压力的敏感程度远大于初始温度的影响。此外，随着初始温度和初始压力的升高，爆炸火焰平均传播速度增加，而火焰传播速度对初始温度较敏感。     

Impact of floodplain and Stage 0 stream restoration on flood attenuation and floodplain exchange during small frequent storms

River flooding impacts human life and infrastructure, yet provides habitat and ecosystem services. Traditional flood control (e.g., levees, dams) reduces habitat and ecosystem services, and exacerbates flooding elsewhere. Floodplain restoration (i.e., bankfull floodplain reconnection and Stage 0) can also provide flood management, but has not been sufficiently evaluated for small frequent storms. We used 1D unsteady Hydrologic Engineering Center's River Analysis System to simulate small storms in a 5 km-long, second-order generic stream from the Chesapeake Bay watershed, and varied % channel restored (starting at the upstream end), restoration location, restoration bank height (distinguishes bankfull from Stage 0 restoration), and floodplain width/Manning's n. Stream restoration decreased (attenuated) peak flow up to 37% and increased floodplain exchange by up to 46%. Floodplain width and % channel restored had the largest impact on flood attenuation. The incremental effects of new restoration projects on flood attenuation were greatest when little prior restoration had occurred. By contrast, incremental effects on floodplain exchange were greatest in the presence of substantial prior restoration, setting up a tradeoff. A similar tradeoff was revealed between attenuation and exchange for project location, but not bank height or floodplain width. In particular, attenuation and exchange were always greater for Stage 0 than for bankfull floodplain restoration. Stage 0 thus may counteract human impacts such as urbanization.     

COMPARISON OF STOCHASTIC AND DETERMINISTIC DYNAMIC PROGRAMMING FOR RESERVOIR OPERATING RULE GENERATION1

ABSTRACT: Two dynamic programming models — one deterministic and one stochastic — that may be used to generate reservoir operating rules are compared. The deterministic model (DPR) consists of an algorithm that cycles through three components: a dynamic program, a regression analysis, and a simulation. In this model, the correlation between the general operating rules, defined by the regression analysis and evaluated in the simulation, and the optimal deterministic operation defined by the dynamic program is increased through an iterative process. The stochastic dynamic program (SDP) describes streamflows with a discrete lag-one Markov process. To test the usefulness of both models in generating reservoir operating rules, real-time reservoir operation simulation models are constructed for three hydrologically different sites. The rules generated by DPR and SDP are then applied in the operation simulation model and their performance is evaluated. For the test cases, the DPR generated rules are more effective in the operation of medium to very large reservoirs and the SDP generated rules are more effective for the operation of small reservoirs.     

广州轨道交通三号线高速行驶条件下对安全限界的影响研究

给出了轨道交通车辆横向偏移量的计算方法 ,并应用列车 -线路动力耦合模型 ,分析了广州地铁三号线的安全限界变化问题。确定了当前按 80km/h行车速度设计的建筑限界能满足 13 0km/h行车速度的要求 ,限界尺寸不需改动可保证列车运行安全平稳     

基于全过程治理的环境规制减排机制研究——来自长江经济带数据的实证检验

基于2007~2017年长江经济带11个省市的面板数据,利用中介效应模型探究全过程治理视域下政府主导型和市场激励型2类环境规制的减排机制.研究发现,政府主导型环境规制和市场激励型环境规制对SO₂排放均具有显著的抑制作用,其影响系数分别为-0.154和-0.209.其中政府主导型环境规制在源头防控、过程控制和末端治理的全过程都起到显著的减排效应,而市场激励型环境规制只通过末端治理实现减排.因此,尽管市场激励型环境规制具有低成本、高效率的优点,但考虑到源头防控和过程控制在生态环境保护中发挥的根本性作用,对于经济结构和经济发展方式较为落后的地区和行业,仍要重视以政府为主导的环境规制,通过因地制宜、合理科学地运用环境规制工具以实现高效的全过程污染治理.     

Influence of floc dynamic protection layer on alleviating ultrafiltration membrane fouling induced by humic substances

Cake layer formation is inevitable over time for ultrafiltration (UF) membrane-based drinking water treatment. Although the cake layer is always considered to cause membrane fouling, it can also act as a “dynamic protection layer”, as it further adsorbs pollutants and dramatically reduces their chance of getting to the membrane surface. Here, the UF membrane fouling performance was investigated with pre-deposited loose flocs in the presence of humic acid (HA). The results showed that the floc dynamic protection layer played an important role in removing HA. The higher the solution pH, the more negative the floc charge, resulting in lower HA removal efficiency due to the electrostatic repulsion and large pore size of the floc layer. With decreasing solution pH, a positively charged floc dynamic protection layer was formed, and more HA molecules were adsorbed. The potential reasons were ascribed to the smaller floc size, greater positive charge, and higher roughness of the floc layer. However, similar membrane fouling performance was also observed for the negative and positive floc dynamic protection layers due to their strong looseness characteristics. In addition, the molecular weight (MW) distribution of HA also played an important role in UF membrane fouling behavior. For the small MW HA molecules, the chance of forming a loose cake layer was high with a negatively charged floc dynamic protection layer, while for the large MW HA molecules it was high with a positively charged floc dynamic protection layer. As a result, slight UF membrane fouling was induced.     

Coupling mechanism of activated carbon mixed with dust for flue gas desulfurization and denitrification

To clarify the effect of coking dust, sintering dust and fly ash on the activity of activated carbon for various industrial flue gas desulfurization and denitrification, the coupling mechanism of the mixed activated carbon and dust was investigated to provide theoretical reference for the stable operation. The results show that coking dust had 34% desulfurization efficiency and 10% denitrification efficiency; correspondingly, sintering dust and fly ash had no obvious desulfurization and denitrification activities. For the mixture of activated carbon and dust, the coking dust reduced the desulfurization and denitrification efficiencies by blocking the pores of activated carbon, and its inhibiting effect on activated carbon was larger than its own desulfurization and denitrification activity. The sintering dust also reduced the desulfurization efficiency on the activated carbon while enhancing the denitrification efficiency. Fly ash blocked the pores of activated carbon and reduced its reaction activity. The reaction activity of coking dust mainly came from the surface functional groups, similar to that of activated carbon. The reaction activity of sintering dust mainly came from the oxidative property of Fe₂O₃, which oxidized NO to NO₂ and promoted the fast selectively catalytic reduction (SCR) of NO to form N₂. Sintering dust was activated by the joint action of activated carbon, and both had a coupling function. Sintering dust enhanced the adsorption and oxidation of NO, and activated carbon further promoted the reduction of NO_x by NH₃; thus, the denitrification efficiency increased by 5%-7% on the activated carbon.     

驾驶舱空气动力源致振动响应分析研究

目的分析驾驶舱外形上多处凸起对驾驶舱内若干重要部位的振动响应的影响。方法首先采用大涡模拟方法,计算多种飞行工况下分离气流产生的作用于机身前段外表面的非定常脉动压力载荷,然后将所得载荷作用于前机身详细有限元模型上,获得所关心的驾驶舱内部分站位的加速度响应。结果通过对加速度响应结果的分析处理及与试飞测试数据对比,可知驾驶舱外形上多处凸起对驾驶舱内的振动量值影响比较大,气流分离对驾驶舱舱内振动贡献,峰值位置处达到了25%左右。结论相关计算结果可用于驾驶舱工效性评估和驾驶舱外形优化。