Use of principal component analysis to profile temporal and spatial variations of chlorinated solvent concentration in groundwater

This work aims at evaluating spatial distribution patterns of concentration variations for chlorinated solvents in groundwater, based on principal component analysis and geographic information system (GIS) tools. The study investigates long-time series of chlorinated solvent concentrations in groundwater measured for 18 contaminated industrial sites. The characterization of contaminant plumes and delineation of pollutant sources are essential for choosing appropriate monitoring and remediation strategies, as contaminated groundwaters are characterized by complex patterns of spatial and temporal concentration variability, with wide unpredictable fluctuations over time. The present work describes the results of a new exploratory statistical method called the Variability Index Method (VIM) applied to environmental data to assess the performance of using concentration variations as molecular tracers to reveal aquifer dynamics, industrial impacts, and point sources for contamination plumes. The application of this method provides a useful assessment of controls over contaminant concentration variations as well as support for remediation techniques.     

Innovative applications of subgrade biogeochemical reactors: Three case studies

Subgrade biogeochemical reactors (SBGRs) are an in situ remediation technology shown to be effective in treating contaminant source areas and groundwater hot spots, while being sustainable and economical. This technology has been applied for over a decade to treat chlorinated volatile organic compound source areas where groundwater is shallow (e.g., less than approximately 30 feet below ground surface [ft bgs]). However, this article provides three case studies describing innovative SBGR configurations recently developed and tested that are outside of this norm, which enable use of this technology under more challenging site conditions or for treatment of alternative contaminant classes. The first SBGR case study addresses a site with groundwater deeper than 30 ft bgs and limited space for construction, where an SBGR column configuration reduced the maximum trichloroethene (TCE) groundwater concentration from 9,900 micrograms per liter (μg/L) to <1 μg/L (nondetect) within approximately 15 months. The second SBGR is a recirculating trench configuration that is supporting remediation of a 5.7‐acre TCE plume, which has significant surface footprint constraints due to the presence of endangered species habitat. The third SBGR was constructed with a new amendment mixture and reduced groundwater contaminant concentrations in a petroleum hydrocarbon source area by over 97% within approximately 1 year. Additionally, a summary is provided for new SBGR configurations that are planned for treatment of additional classes of contaminants (e.g., hexavalent chromium, 1,4‐dioxane, dissolved explosives constituents, etc.). A discussion is also provided describing research being conducted to further understand and optimize treatment mechanisms within SBGRs, including a recently developed sampling approach called the aquifer matrix probe.     

Transformation of tetrabromobisphenol A in the presence of different solvents and metals

Solvent-based separation method is presumably an efficient and environmentally beneficial approach for elimination of brominated flame retardants (BFRs) from waste electrical and electronic equipment (WEEE). The overall goal of this study was to evaluate possible effects of organic solvent on the behavior of BFRs during solvent-based processing of WEEE. We initiated a set of batch experiments for examining the rates and possible pathways of transformation of a representative BFR (tetrabromobisphenol A, TBBPA) using acetone, toluene, and methanol as the solvents. Our results showed that toluene and methanol had no effect on the transformation of TBBPA, but approximately 20% of TBBPA (100 mg L⁻¹) was transformed by acetone within 2 h at 50 °C. Analysis of the products with GC-MS showed that two high-molecular-weight products (MW = 586) were major products of the transformation reactions. The role of acetone as a reactant in the transformation of TBBPA was further validated with dueterated acetone. In addition, the effects of co-existing metals in WEEE (i.e., Zn, Cu, and Ni) on the transformation of TBBPA in the solvent systems were investigated. These metals tested were found to greatly enhance the rates of TBBPA transformation. The metal facilitated solvent reactions with TBBPA may lower the extractability of TBBPA by formation of larger and less soluble products, hence potentially increasing the cost for separating the chemical from WEEE.     

农药助剂对蚯蚓(Eisenia foetida)的急性毒性

为评价农药助剂对土壤生物的毒性效应,分别采用滤纸接触法和人工土壤法测定了不同类别农药助剂对赤子爱胜蚓(Eis enia foetida)的急性毒性.结果表明:19种非离子表面活性剂中,烷基酚聚氧乙烯醚与脂肪醇聚氧乙烯醚毒性较高,滤纸法48 h-LC50为7.630 ～ 39.65μg·cm-2,人工土壤法14 d-LC50为876.5 ～2 786.6 mg· kg-1,其它类型非离子表面活性剂毒性较低.5种阴离子表面活性剂中,十二烷基硫酸钠、十二烷基苯磺酸钙毒性高于木质素磺酸钠、木质素磺酸钙、亚甲基双萘磺酸钠,滤纸法48 h-LC50为6575 ～ 41.89 μg· cm-2,人工土壤法14 d-LC50为1 195.0～1 911.7 mg·kg-1.13种溶剂中,二甲苯、乙苯、甲苯、正丁醇、环己酮表现出较高的毒性,滤纸法48 h-LC50为6.587 ～ 57.62 μg ·cm-2,密封人工土壤法48 h-LC50为181.9 ～781.5 mg·kg-1.采用两种方法测得的5种填料高岭土、白炭黑、硅藻土、凹凸棒土和轻质碳酸钙的毒性均较低.采用两种方法测得的毒性系统偏差接近,重现性均较好,并且滤纸接触法测得的毒力高于人工土壤法.     

In situ sequential treatment of a mixed contaminant plume

Groundwater plumes often contain a mixture of contaminants that cannot easily be remediated in situ using a single technology. The purpose of this research was to evaluate an in situ treatment sequence for the control of a mixed organic plume (chlorinated ethenes and petroleum hydrocarbons) within a Funnel-and-Gate. A shallow plume located in the unconfined aquifer at Alameda Point, CA, was found to contain up to 218,000 μg/l of cis-1,2 dichloroethene (cDCE), 16,000 μg/l of vinyl chloride (VC) and <1000 μg/l of 1,1 dichloroethene (1,1 DCE), trans-1,2 dichloroethene (trans-1,2 DCE) and trichloroethene (TCE). Total benzene, toluene, ethylbenzene and xylenes (BTEX) concentrations were <10,000 μg/l. Contaminated groundwater was funneled into a gate, 3.0 m wide, 4.5 m long and 6.0 m deep (keyed into the underlying aquitard) where treatment occurred. The initial gate segment consisted of granular iron, for the reductive dechlorination of the higher chlorinated ethenes. The second segment, the biosparge zone, promoted aerobic biodegradation of petroleum hydrocarbons and any remaining lesser-chlorinated compounds, stimulated by dissolved oxygen (DO) and carbon dioxide (CO₂) additions via an in situ sparge system (CO₂ was used to neutralize the high pH produced from reactions in the iron wall). Groundwater was drawn through the gate by pumping two wells located at the sealed, downgradient, end. Over a 4-month period an estimated 1350 g of cDCE flowed into the treatment gate and the iron wall removed 1230 g, or 91% of the mass. The influent mass of VC was 572 g and the iron wall removed 535 g, corresponding to 94% mass removal. The other chlorinated ethenes had significantly lower influent masses (3 to 108 g) and the iron wall removed the majority of the mass resulting in >96% mass removal for any of the compounds. In spite of these high removal percentages, laboratory column tests indicated that at these levels of chlorinated contaminants, surface saturation of the iron grains likely contributed to lower than expected reaction rates. In the biosparge zone, mass removal of cDCE appeared to occur predominantly by biodegradation (65%) with volatilization (35%) being an important secondary process. The dominant removal process for VC was volatilization (70%) although significant biodegradation was also indicated (30%). Laboratory microcosm results confirmed the potential for aerobic biodegradation of cDCE and VC. When average influent field concentrations for cDCE and VC were 220,000 and 46,000 μg/l, respectively, the sequential treatment unit removed 99.6% of the total mass and when the influent concentrations decreased to 26,000 and 19,000 μg/l for cDCE and VC, respectively, >99.9% removal within the treatment gate was attained. BTEX compounds were found to be significantly retarded in the iron treatment zone. Although they did eventually break through the granular iron, and into the gravel transition zone, none of these compounds was detected in the biosparge zone. No noticeable interferences between the anaerobic (reductive) and aerobic parts of the system occurred during testing. The results of this experiment show that in situ treatment sequences are viable, although further work is needed to optimize performance.     

Determination of alkali-labile phosphoprotein phosphorus from fish plasma using the Tb^3＋-tiron complex as a fluorescence probe

A sensitive method based on the fluorescence quenching effect of the Tb^3＋-Tiron complex is proposed for the determination of alkali-labile phosphoprotein phosphorus （ALP） released from fish plasma. The detection limit was 5.4 ng/ml （S/N=2）, and the relative standard deviation of the quenching effect （6 replicates） was 4.6%. The results obtained by the proposed method were in good agreement with those obtained by the colorimetric assay. The advantages of the present method are its relatively simple detection procedure, the lack of toxic organic solvents, and high sensitivity.     

场地含水层氯代烃污染物自然衰减机制与纳米铁修复技术的研究进展

综述了国际上典型工业场地有机溶剂污染物在地下水中的自然衰减机制及修复技术的研究现状和发展趋势.场地地下水修复技术从抽出-处理发展到治理污染源区和污染羽的纳米铁技术,涌现出-大批较为成熟的联合化学与微生物修复技术,其中潜力较大的有治理污染羽的渗透反应墙、原位化学氧化、原位化学还原、微生物强化降解及基于监测的自然衰减等.文...     

The distribution of the chlorinated solvents dichloromethane,perchloroethylene, and trichloroethylene in the global atmosphere

Dichloromethane, perchloroethylene, and trichloroethylene are commercially important chlorinated solvents whose health and environmental impacts are under scrutiny in the industrial world. Their distributions in the global atmosphere have been computed based on data from the Reactive Chlorine Emissions Inventory (RCEI) project using the Global Balance Environment (GLOBE) model, a 3-D radiative-dynamical-chemical model. Their atmospheric lifetimes, scaled to an observed methyl chloroform lifetime of 4.8 years, are 158 days, 105 days, and 4.3 days, respectively. They have strong interhemispheric gradients, with maximum zonal mean surface concentrations in the winter mid-latitude northern hemisphere of approximately 40 ppt, 9 ppt, and 2.5 ppt, respectively. Their spatial distributions show significant seasonal variability, and are sensitive to vertical mixing by cumulus convection and horizontal mixing by synoptic-scale turbulence. While the model interhemispheric exchange time (1.0 years) and computed atmospheric lifetimes are very sensitive to sub-grid scale diffusion, interhemispheric gradients of the chlorinated solvents are not. The simulated results suggest a greater importance for oceanic emissions of perchloroethylene and trichloroethylene than has previously been assumed.     

The use of ionic liquids based on choline chloride for metal deposition: A green alternative?

Ionic liquids are studied intensively for different applications. They tend to be denoted as “green solvents”, largely because of their low vapour pressure. In recent years toxicity and biotoxicity of ionic liquids have also been investigated, which proved that not all of these are “green”. In this paper the use of ionic liquids based on choline chloride and ethylene glycol in electrochemistry is discussed in the context of their use as green solvents. Due to their low toxicity and ready biodegradability, these deep eutectic solvents are promising for the electrodeposition of metals. The influence of the use of these liquids as metal deposition baths on the waste water is investigated. Drag-out was found to be the most influencing parameter on the environmental impact of the process, as it is three times higher compared to classical solutions due to the higher viscosity of the ionic liquid. There are no major changes needed in the rinsing configuration of classic electroplating plants, and ion exchange to remove the metal out of the waste water was not hindered by the presence of the ionic liquid. The formation of by-products during the deposition of metals has to be further investigated and evaluated in consideration of the environmental impact.