废水中含磷表面活性剂的测定

应用非水电位滴定法测定了废水中各种烷基磷酸酯钾盐及其单、双酯盐。方法的变异系数分别为２．３％和７．８％（ｎ＝１２）。本法可有效地消除非离子表面活性剂的干扰，适用于化纤油剂的质量检验和上油槽中油剂浓度的测定。     

Test for the effects of three surfactants on the penetration ability of the calcium chloride and water glass solutions in dust

１ＩｎｔｒｏｄｕｃｔｉｏｎＣａｌｃｉｕｍｃｈｌｏｒｉｄｅｉｓｏｆｔｅｎｕｓｅｄｉｎｔｈｅｆｉｅｌｄｏｆｓｏｉｌｓｔａｂｉｌｉｚａｔｉｏｎａｎｄｒａｉｓｉｎｇｄｕｓｔｃｏｎｔｒｏｌｂｅｃａｕｓｅｉｔｃａｎｒｅａｃｔｗｉｔｈｗａｔｅｒｇｌａｓ（Ｗｕ，１９...     

Water solubility enhancements of pyrene by single and mixed surfactant solutions

ＩｎｔｒｏｄｕｃｔｉｏｎＳｕｒｆａｃｔａｎｔｓｅｎｈａｎｃｅｔｈｅｒｅｍｅｄｉａｔｉｏｎｏｆＮＡＰＬ ｃｏｎｔａｍｉｎａｔｅｄｓｉｔｅｓｂｙｉｎｃｒｅａｓｉｎｇｔｈｅａｑｕｅｏｕｓ ｐｈａｓｅｃｏｎｃｅｎｔｒａｔｉｏｎｏｆｔｈｅＮＡＰＬｖｉａｍｉｃｅｌｌｅｆｏｒｍａｔｉｏｎ ,ｍｉｃｒｏｅｍｕｌｓｉｆｉｃａｔｉｏｎ ,ｏｒｍｏｂｉｌｉｚｉｎｇｔｈｅＮＡＰＬｐｈａｓｅ (Ｋｉｌｅ ,1989;Ｅｄｗａｒｄｓ,1991;Ｇｕｈａ ,1998ａ ;Ｋｏ ,1998;Ｚｉｍｍｅｒｍａｎ ,1999;Ｂｅｔｔａｈａｒ,1999;Ｗｉｌｌｓｏｎ ,1999;Ｐａ…     

土壤阴离子表面活性剂总量亚甲基蓝法研究

文章通过设计正交试验,针对提取的主要因素提取液配比、提取时间、提取温度和提取剂用量确定最优的前处理方法,建立与国标《水质阴离子表面活性剂亚甲基蓝分光光度法》(GB7494-87)对应的土壤阴离子表而活性剂(LAS)的亚甲基蓝分光光度法.土壤样品烘干后经20 mL乙醇水溶液(70％)提取,水浴恒温振荡仪45℃下振荡2h,...     

亚甲蓝分光光度法测定水体阴离子表面活性剂方法的探讨

LAS是地表水和地下水水质的必测项目,国标（GB7494—87）方法操作复杂,要重复萃取四次后再洗涤,有机溶剂消耗量大,而且相当的耗时,本文通过同步实验对比与分析,得出：一次性加入20mL氯仿萃取加洗涤的方法其测定结果较好,而且极大地减轻了氯仿对分析人员身体的损害程度。测定结果有较好的精密度和准确度。本方法具有可观的经济性、安全性和可操作性。     

胶束强化超滤去除水中双酚A

采用截留分子量(MWCO)为5000 Dalton、1000 Dalton的聚砜超滤膜,MWCO为1 kDa的再生纤维素超滤膜;采用十二烷基苯磺酸钠(SDBS)、曲拉通100(TritonX-100)、吐温80(Tween-80)、烷基多苷(APG)为表面活性剂,用胶团强化超滤工艺去除水中双酚A。研究了不同材质和截留分子量的超滤膜、表面活性剂浓度、膜操作压力、溶液pH和溶液中电解质等因素对该工艺的影响。结果表明,SDBS对双酚A有较好的去除效果,去除率在80%以上。在H+和Na+存在的条件下,双酚A的截留率增加,透过液中SDBS浓度降低。SDBS与非离子表面活性剂的复配可以提高双酚A截留率,降低透过液中SDBS的浓度,复配效果优劣顺序为Tween-80TritonX-100APG。     

表面活性剂改性4A分子筛对Cr(VI)的吸附行为

采用浸渍法对4A分子筛进行表面改性,通过引入阳离子表面活性剂,使4A分子筛表面附着季铵型阳离子,并与反离子Br-形成"阴离子交换膜",从而促使更多的Cr(VI)阴离子通过离子交换吸附到改性4A分子筛上,通过X-射线衍射(XRD)和傅里叶变换红外光谱(FTIR)对样品的物相结构和组成进行表征分析。研究表明,表面活性剂的类型和疏水碳氢链结构会影响4A分子筛的吸附能力,十八烷基三甲基溴化铵(OTAB)碳氢链长,在分子筛表面形成的双分子层密,对Cr(VI)的吸附量最大。采用准一级、准二级、Elovich和Bangham动力学模型对六价铬的吸附数据进行拟合,其中准一级动力学方程最符合十八烷基三甲基溴化铵改性分子筛的吸附行为。同时,分别从Langmuir和Redlich-Peterson等温吸附模型获得六价铬的最大吸附量为13.98 mg/g,且改性分子筛以均一表面吸附为主。     

Ecotoxicity and biodegradability of antielectrostatic dicephalic cationic surfactants

Four series of dicephalic cationic surfactants, considered as new antielectrostatic agents have been investigated in order to establish their toxicity and biodegradability. Among them N,N-bis[3,3′-(dimethylamine)propyl]alkylamides, N,N-bis[3,3′-(dimethylamine)propyl]alkylamide dihydrochlorides, N,N-bis[3,3′-(trimethylammonio)propyl]alkylamide dibromides and N,N-bis[3,3′-(trimethylammonio)propyl]alkylamide dimethylsulphates with different hydrophobic chain length (n-C₉H₁₉ to n-C₁₅H₃₁) and type of counterion (chloride, bromide and methylsulfate) have been studied. The inhibitory effect against microorganisms has been examined using model gram-positive and gram-negative bacteria, and yeasts. None of the tested surfactants have shown antimicrobial activity against gram-negative bacteria (Escherichia coli, Pseudomonas putida) and yeasts (Saccharomyces cerevisiae, Rhodotorula glutinis) at a concentration below 1000 μg mL⁻¹, however some of them were moderately active against gram-positive bacteria (Staphylococcus aureus, Bacillus subtilis). The Microtox® test was successfully applied to measure EC₅₀ values of the studied dicephalic cationic surfactants. Their toxicity to Vibrio fischeri depended upon the alkanoyl chain length with the EC₅₀ values in a range of 2.6-980 mg L⁻¹. N,N-bis[3,3′-(dimethylamine)propyl]alkylamide dihydrochlorides 2a-b and N,N-bis[3,3′-(trimethylammonio)propyl]alkylamide dibromides 3a-b comprising n-decanoyl and n-dodecanoyl hydrophobic tails appeared to be the least toxic. Furthermore, the biodegradability under aerobic conditions of 2a-b, 3a-b was evaluated using OECD Method 301F. According to the obtained results 2a, 3a-3b can be considered as almost readily biodegradable and they are not expected to be persistent in the environment. Additionally, partial biodegradation was observed for 2b, indicating its possible biodegradation in wastewater treatment systems.     

紫外分光光度法在水中阴离子表面活性剂标准样品研制中的应用

研究了阴离子表面活性剂水溶液的紫外吸收特性,并将研究结果用于阴离子表面活性剂水质标样的稳定性,均匀性和定值工作,简化了操作手续,获得了准确的分析结果。     

PM2.5中类腐殖质表面活性测定方法与实例分析

建立了大气细粒子中类腐殖质（HULIS）表面活性的动态表征方法,并以华北平原乡村站点冬季大气PM_2.5样品为例,对PM_2.5中HULIS的表面活性进行表征.HULIS碳质组分（HULIS-C）浓度为2.0~4.6μg C/m³,占水溶性有机碳和总有机碳的比例分别为31%~40%和20%~26%.浓度为88~200mg C/L的HULIS水溶液,其表面张力相对于纯水降低了18%~22%.HULIS-C浓度在低于70mg C/L时表面张力降低显著,在88~320mg C/L之间降低相对缓慢.动态表面张力随着时间变化逐渐降低,在液滴形成后200s以内表面张力下降迅速,之后趋于平缓,说明表面活性分子在液滴中扩散趋于稳定需要一定的时间,该特征时间可能影响表面活性物质在云凝结核活化时的作用.证实了在污染地区的大气PM_2.5中含有一定量的表面活性物质,这些物质可能对颗粒物活化为云滴、雾滴过程产生显著影响;表面活性物质的存在可能在外界湿度变化过程中导致颗粒物发生液-液相分离现象,在颗粒物表面形成有机膜,影响活性分子摄取以及半挥发性物质的气-粒分配过程,从而影响大气非均相反应过程.