Efficient removal of Cr(VI) by a 3D Z-scheme TiO2-ZnxCd1-xS graphene aerogel via synergy of adsorption and photocatalysis under visible light

Efficient and robust photocatalysts for environmental pollutants removal with outstanding stability have great significance. Herein, we report a kind of three dimensional (3D) photocatalyst presented as Z-scheme heterojunction, which combining TiO 2 and Zn x Cd 1- x S with graphene aerogel to contrast TiO 2 -Zn x Cd 1- x S graphene aerogel (TSGA, x = 0.5) through a moderate hydrothermal process. The as-prepared Z-scheme TSGA was used to remove aqueous Cr(VI) via a synergistic effect of adsorption and visible light photocatalysis. The adsorption equilibrium can be reached about 40 min, then after about 30 min irradiation under visible light (wavelength ( λ) > 420 nm) the removal rate of Cr(VI) almost reached 100%, which is much better than the performance of pristine TiO 2 and Zn 0.5 Cd 0.5 S, as well as TiO 2 graphene aerogel (TGA) and Zn 0.5 Cd 0.5 S graphene aerogel (SGA). The virulent Cr(VI) was reduced to Cr(III) with hypotoxicity after photocatalysis on TSGA, meanwhile the as-synthesized TSGA presented a good stability and reusability. The reduced graphene oxide (rGO) sheets between TiO 2 and Zn 0.5 Cd 0.5 S played a role as charge transfer mediator, promoting the photoinduced electrons transfer and photocatalysis ability of TSGA was enhanced significantly. Hence,such photocatalyst exhibits a potential application on removing heavy metals with high efficiency and stability from polluted aqueous environment.     

Progress and challenges in consolidating the management of Amazonian protected areas and indigenous territories

Effective management refers to the ability of a protected area or indigenous territory to meet its objectives, particularly as they relate to the protection of biodiversity and forest cover. Effective management is achieved through a process of consolidation, which among other things requires legally protecting sites, integrating sites into land‐use planning, developing and implementing management and resource‐use plans, and securing long‐term funding to pay for recurrent costs. Effectively managing all protected areas and indigenous territories in the Amazon may be needed to avoid a deforestation tipping point beyond which regional climatic feedbacks and global climate change interact to catalyze irreversible drying and savannization of large areas. At present, protected areas and indigenous territories cover 45.5% (3.55 million km²) of the Amazon, most of the 60–70% forest cover required to maintain hydrologic and climatic function. Three independent evaluations of a long‐term large‐scale philanthropic initiative in the Amazon yielded insights into the challenges and advances toward achieving effective management of protected areas and indigenous territories. Over the life of the initiative, management of sites has improved considerably, particularly with respect to management planning and capacity building, but few sites are effectively managed and many lack sufficient long‐term financing, adequate governance, support of nongovernmental organizations, and the means to withstand economic pressures. The time and money required to complete consolidation is still poorly understood, but it is clear that philanthropic funding is critical so long as essential funding needs are not met by governments and other sources, which could be on the order of decades. Despite challenges, it is encouraging that legal protection has expanded greatly and management of sites is improving steadily. Management of protected areas in other developing countries could be informed by improvements that have occurred in Amazonian countries.     

Optimal Absorbent Evaluation for the CO2 Separating Process by Absorption Loading,Desorption Efficiency,Cost, and Environmental Tolerance

The CO₂ absorption capacities of potassium glycinate, potassium sarcosinate (choline, proline), mono-ethanolamine (MEA), and tri-ethanolamine were evaluated to find the optimal absorbent for separating CO₂ from gaseous products by a CO₂ purification process. The absorption loading, desorption efficiency, cost, and environmental tolerance were assessed to select the optimal absorbent. MEA was found to be the optimum absorbent for separating the CO₂ and H₂ mixture in gaseous product. The maximum absorption loading rate was 0.77 mol CO₂ per mol MEA at temperature of 20°C and absorbent concentration of 2.5 mol/L, whereas desorption efficiency was 90% by heating for 3 h at 130°C. MEA was found to be an optimal absorbent for the purification process of CO₂ during gaseous production.     

模糊综合评价法在钢铁企业安全投资合理性评价中的应用

为了对钢铁企业安全投资进行模糊综合评价,建立了钢铁企业安全投资的评价体系,确定各因素的权重。得出模糊综合评价矩阵,可对各因素进行评价分析;得出某钢铁企业安全投资现状分数为83.9分,等级为较好,需着重加强安全培训、劳保品、工业卫生等人因素方面的投资;在环境方面的投资较合理。     

Performance assessment system of health,safety and environment based on experts' weights and fuzzy comprehensive evaluation

Performance evaluation of Health, Safety and Environment (HSE) is the measurement of a company's achievement in HSE management. In order to receive a comprehensive and objective evaluation result, it is necessary to consider all evaluation factors and experts at different levels when HSE performance assessment is conducted. To improve conventional HSE performance evaluation, where weighted average method was used, a Fuzzy Comprehensive Evaluation (FCE) method is used in this study by taking experts' weights into account. Further, an HSE operating performance assessment system is designed to simplify manual and complex assessment process and generate charts and analysis reports automatically. Finally, a case of petrochemical enterprise is used to illustrate the effectiveness of the method and system.     

洪涝灾害条件下疏散交通生成预测方法

为有助于有关部门更准确预测洪涝灾害受灾民众的疏散量,结合非集计数据和集计数据的优点,提出分区集计数据的概念,设计了受灾区域分区方法,并通过意向偏好(SP)调查法对我国居民在洪涝条件下疏散交通需求数据进行调查。在此基础上,引入BP神经网络建立基于分区集计数据的疏散交通生成预测模型。利用调查数据进行实证分析发现,所设计方法取得了较好的预测效果,鲁棒性较好,平均相对预测误差仅为1.8%,其预测效果明显优于现有的非集计和整集计模型。     

A hybrid model for human factor analysis in process accidents: FBN-HFACS

Human factors are the largest contributing factors to unsafe operation of the chemical process systems. Conventional methods of human factor assessment are often static, unable to deal with data and model uncertainty, and to consider independencies among failure modes. To overcome the above limitations, this paper presents a hybrid dynamic human factor model considering Human Factor Analysis and Classification System (HFACS), intuitionistic fuzzy set theory, and Bayesian network. The model is tested on accident scenarios which have occurred in a hot tapping operation of a natural gas pipeline. The results demonstrate that poor occupational safety training, failure to implement risk management principles, and ignoring reporting unsafe conditions were the factors that contributed most failures causing accident. The potential risk-based safety measures for preventing similar accidents are discussed. The application of the model confirms its robustness in estimating impact rate (degree) of human factor induced failures, consideration of the conditional dependency, and a dynamic and flexible modelling structure.     

Understanding implications of consumer behavior for wildlife farming and sustainable wildlife trade

Unsustainable wildlife trade affects biodiversity and the livelihoods of communities dependent upon those resources. Wildlife farming has been proposed to promote sustainable trade, but characterizing markets and understanding consumer behavior remain neglected but essential steps in the design and evaluation of such operations. We used sea turtle trade in the Cayman Islands, where turtles have been farm raised for human consumption for almost 50 years, as a case study to explore consumer preferences toward wild‐sourced (illegal) and farmed (legal) products and potential conservation implications. Combining methods innovatively (including indirect questioning and choice experiments), we conducted a nationwide trade assessment through in‐person interviews from September to December 2014. Households were randomly selected using disproportionate stratified sampling, and responses were weighted based on district population size. We approached 597 individuals, of which 37 (6.2%) refused to participate. Although 30% of households had consumed turtle in the previous 12 months, the purchase and consumption of wild products was rare (e.g., 64–742 resident households consumed wild turtle meat [i.e., 0.3–3.5% of households] but represented a large threat to wild turtles in the area due to their reduced populations). Differences among groups of consumers were marked, as identified through choice experiments, and price and source of product played important roles in their decisions. Despite the long‐term practice of farming turtles, 13.5% of consumers showed a strong preference for wild products, which demonstrates the limitations of wildlife farming as a single tool for sustainable wildlife trade. By using a combination of indirect questioning, choice experiments, and sales data to investigate demand for wildlife products, we obtained insights about consumer behavior that can be used to develop conservation‐demand‐focused initiatives. Lack of data from long‐term social–ecological assessments hinders the evaluation of and learning from wildlife farming. This information is key to understanding under which conditions different interventions (e.g., bans, wildlife farming, social marketing) are likely to succeed.     

Toward harmonizing prospective effectiveness assessment for road safety: Comparing tools in standard test case simulations

Abstract

Objective: With the overall goal to harmonize prospective effectiveness assessment of active safety systems, the specific objective of this study is to identify and evaluate sources of variation in virtual precrash simulations and to suggest topics for harmonization resulting in increased comparability and thus trustworthiness of virtual simulation-based prospective effectiveness assessment.

Methods: A round-robin assessment of the effectiveness of advanced driver assistance systems was performed using an array of state-of-the-art virtual simulation tools on a set of standard test cases. The results were analyzed to examine reasons for deviations in order to identify and assess aspects that need to be harmonized and standardized. Deviations between results calculated by independent engineering teams using their own tools should be minimized if the research question is precisely formulated regarding input data, models, and postprocessing steps.

Results: Two groups of sources of variations were identified; one group (mostly related to the implementation of the system under test) can be eliminated by using a more accurately formulated research question, whereas the other group highlights further harmonization needs because it addresses specific differences in simulation tool setups. Time-to-collision calculations, vehicle dynamics, especially braking behavior, and hit-point position specification were found to be the main sources of variation.

Conclusions: The study identified variations that can arise from the use of different simulation setups in assessment of the effectiveness of active safety systems. The research presented is a first of its kind and provides significant input to the overall goal of harmonization by identifying specific items for standardization. Future activities aim at further specification of methods for prospective assessments of the effectiveness of active safety, which will enhance comparability and trustworthiness in this kind of studies and thus contribute to increased traffic safety.     

矿热炉炉壳安装作业危险性分析

为减少事故损失,必须对矿热炉安装施工危险源进行分析。基于此,对矿热炉安装工序中最重要工序炉壳安装应用作业危险性分析进行分析。将炉壳安装作业分成3大部分,用鱼刺图分析方法进行分析,总结出矿热炉炉壳安装中事故发生的主要原因并提出对策措施,以预防和减少事故的发生。