Composition of Floating Debris in Harbours of the United States

As part of a programme to characterize floating anthropogenic debris in the aquatic environment, the US Environmental Protection Agency (EPA) conducted 18 field surveys in the harbours of major metropolitan cities of the east, west, and Gulf coasts of the United States and the Mid-Atlantic Bight. the surveys were designed to provide information on the types, relative amounts, and distributions of aquatic debris in different geographic regions of the United States. Neuston nets (0.33 mm mesh) were used to collect surface debris during outgoing tides on two or three consecutive days in selected areas of each city. After each net tow, the debris, which ranged in size from small resin pellets to large plastic sheeting pieces, was identified, categorized, and counted. the data are being used to qualitatively characterize aquatic debris in coastal metropolitan areas, to examine potential regional variations, and to tentatively identify potential sources.     

深冲钢板塑性变形形为研究

单相塑性材料的强度和塑性基本上是分别研究讨论的。此文以低碳深冲钢板为例,从能量观点出发,讨论了强度和塑性的内在制约关系,唯象地提出了单相塑性材料塑性破坏的判据,并解释了几个实验现象。此文的研究有助于加深对深冲钢塑性变形形为的理解。     

一种硫离子响应杀菌材料的制备及应用研究

目的制备硫离子响应杀菌材料,研究它在不同浓度铜离子条件下的封装效果,以及在不同浓度硫离子条件下的释放行为。方法选择埃洛石纳米管为载体并用透射电镜进行表征、采用真空负载的方式,将甲硝唑和苯骈三氮唑(BTA)分步填充到埃洛石纳米管内部,使用紫外分光光度法测试不同浓度铜离子对纳米管中甲硝唑的封堵效果,以及材料在不同浓度硫离子条件下的释放情况。结果实验中通过调整铜离子浓度发现,铜离子浓度越大对甲硝唑的封堵效果越好,当铜离子浓度达到160 mmol/L时,对甲硝唑的封堵效果最好。杀菌材料在外界硫离子达到0.1mmol/L后,甲硝唑的释放浓度迅速提高,进一步提高硫离子浓度,释放情况改变不明显。结论铜离子浓度达到160 mmol/L时,材料的封装效果是最好的。材料能够对硫离子实现响应释放,且对应的临界浓度为0.1 mmol/L。     

Modeling photocatalytic destruction of the organic contaminants in continuous stir flow reactor

Thin-film technique is becoming an industry standard for the preparation of TiO₂-based photocatalyst for organic destruction. The catalyst provides several advantages over the conventional powder TiO₂ in the treatment of wastewater and groundwater. In this study, a continuous stir flow reactor model is developed capable of describing the photocatalytic process. The model incorporates the following fundamental mechanisms: adsorption, diffusion, liquid-film transfer, UV attenuation, and photocatalytic reaction. All of the simulation results indicate that there exists a highly nonlinear relation between each of these parameters and the destruction rate. Various incident light intensities also are incorporated to simulate the energy efficiency. The simulations illustrate that the photocatalytic model can be used to elucidate the effect of process variables. It is also possible to “custom-design” a catalyst for the treatment of a particular waste stream.     

塑料和橡胶类废物的热物理与焚烧特性研究的进展

随着社会和科技的发展，塑料和橡胶废弃量与日俱增，已成为城市垃圾的重要组成，由于这类废弃的聚合物给环境带来了污染问题，怎样合理地处理和利用已经成为一项重要的研究课题，本文对塑料和橡胶类的废物的理化性质，热值，焚烧特性，污染特性进行了论述，并根据它们的热物理及焚烧特性提出了进一步优化废物焚烧炉，完善低污染，低腐蚀，低粘结的废弃物的焚烧工艺的一些设想。     

水解-好氧系统处理生活污水的特性研究

采用新型 Yakult填料和中心导流式曝气方式 ,设计制作了新型生活污水净化装置 ,试验表明 ,停留时间 16 h左右 ,CODCr去除率 >80 % ,BOD5去除率 >90 % ,SS去除率 >85 % ,NH3 - N去除率 >87% ,出水水质达到国家一级排放标准     

The effect of heating temperature of thin film transistor-liquid crystal display (TFT-LCD) optical waste glass as a partial substitute partial for clay in eco-brick

In order to fulfill the current WEEE directives, the traditional approach to manage thin film transistor-liquid crystal display (TFT-LCD) waste glass is inadequate. It is a serious opportunity to achieve resource conservation, reduction, stabilization and safety of management of TFT-LCD in the near future. To assist in achieving these goals, this study investigated the sintering characteristics and material properties of TFT-LCD waste glass, which can be pulverized and ground and subsequently blended with clay, at various substitution levels (0–40%) and finally fired from 800 °C to 1000 °C to make eco-brick. The brick thus produced was analyzed to determine variations in weight losses on ignition, 24-h absorption, bulk density, shrinkage, compressive strength and microstructure changes. The results for specific gravity, water adsorption, and compressive strength revealed that bricks made from mixtures containing TFT-LCD waste glass met the general requirements for bricks. The advantages of less water absorption, less weight loss on ignition, and a gain in compressive strength in the clay-TFT-LCD waste glass bricks should encourage the use of TFT-LCD waste glass as a brick additive.     

铁蓝—活性炭生物膜法处理彩色胶片水洗废水的研究

定影漂白废话水用铁蓝法预处理，结果表明，以硫酸亚铁为沉淀剂，投加量为铁氰化物理论值的１．３倍，ＣＮ去除率为９８％，反应生成的普鲁士蓝纯度较高，可供综合利用，铁蓝法除ＣＮ后的出水与显影冲洗废水混合，再经生炭生物膜法处理，ＣＯＤｃｒ去除率为８０％；     

塑料薄膜用无滴消雾剂的研制

本文介绍了塑料薄膜用无滴消雾剂的配方、制备方法和使用情况。     

一种序批式生物膜反应器及其氧传递系数测定

介绍了一种序批式生物膜反应器 ,并求出了在给定的工艺条件下的氧传递系数。结果表明 :本反应器有较强的氧传递能力 ,能满足微生物的新陈代谢和降解有机污染物的需要