Spatial cost efficiency in waste paper handling: the case of corrugated board in Sweden

This paper analyzes the spatial cost efficiency of the Swedish legislation regarding waste disposal handling. We focus on the case of corrugated board and recognize that the different counties in Sweden possess different economic prerequisites in terms of waste paper recovery and utilization potential. We employ data for six corrugated board mills and 20 counties and a non-linear programming model to identify the least cost strategy for reaching the politically specified recycling target of a 65% recovery rate for corrugated board. That is, the total costs of recovering a minimum of 65% in each county are calculated and compared with the case when the country as a whole recovers 65% of all old corrugated board is collected but there exist no uniform target for each county. The conclusion is that from an efficiency point of view the recovery efforts should be concentrated to the highly populated and urbanized counties, and not be uniformly divided throughout the country. In the base case, the results suggest that the cost efficient county-specific recovery rates should range from 51 to 72%.     

星形线电除尘器内EHD流动与粒子行为数值模拟

为了研究星形线电除尘器内电流体动力学（EHD）流动与荷电粒子运动行为及两者间相互作用,构建了线板式电除尘器（ESP）内关于EHD和带电粒子运动学的耦合数值模型.该模型采用有限体积法离散求解电场方程和空间电荷方程,在拉格朗日法下建立带电粒子运动方程,并与FLUENT湍流模型进行耦合.利用这一模型,对3种电场风速下星形线电除尘器内流动形态与粒子运动行为进行了细致模拟,并分析了二次流动对气流、粒子浓度分布的影响.结果表明,星形线电除尘通道内二次流动对流动形态和粒子浓度分布存在显著作用.随电场风速的降低,这一作用将越明显.EHD流动对细小荷电粒子运动的影响更为显著.二次流动产生涡旋并作用于主流来影响粒子运动行为.收尘板面的涡旋挤压粒子流远离壁面向流动中心运动,放电极下游的涡旋则促进粒子流向收尘板壁面靠近.此外,由于捕集通道中强二次流的存在,Deutsch计算式对除尘效率、特别是对于亚微米粒子捕集效率的计算并不准确.     

Optimal Timing to Adopt an Environmental Policy in a Strategic Framework

In this paper, the problem of optimal timing, when to adopt an environmental policy in a strategic framework is considered. Using real options theory and some basic tools of game theory, we show that, under certain assumptions, a country behaving strategically should wait longer before adopting such a policy than if it behaves unstrategically or within a larger entity. Such a postponed decision is sub-optimal as regards to the environment protection.     

住宅小区中水回用工程实例

为使某住宅小区居民生活污水达到中水回用的要求，采用曝气生物滤池一过滤工艺进行处理，并介绍了相关工艺参数：运行结果表明，采用该工艺出水水质全部达到《城市污水再生利用景现环境用水水质》中观赏性景观环境用水标准。该工艺可以作为住宅小区中水回用的一种选择方案。     

Complex behaviour of trivalent rare earth elements by humic acids

ＣｏｍｐｌｅｘｂｅｈａｖｉｏｕｒｏｆｔｒｉｖａｌｅｎｔｒａｒｅｅａｒｔｈｅｌｅｍｅｎｔｓｂｙｈｕｍｉｃａｃｉｄｓＧｅｎｇＡｎｃｈａｏＲｅｓｅａｒｃｈＩｎｓｔｉｔｕｔｅｏｆＥｎｖｉｒｏｎｍｅｎｔａｌＥｎｇｉｎｅｅｒｉｎｇ，ＦｕｓｈｕｎＰｅｔｒｏｌｅ...     

The effect of the introduction of prenatal diagnosis on the reproductive history of women at increased risk from neural tube defects

The reproductive history of 45 couples at increased risk for neural tube defect (NTD) who came for genetic counselling in 1970 and 1971 were compared with a similar number counselled in 1975 and 1976, when prenatal diagnostic tests were freely offered. They were subsequently interviewed in their homes and had their reproductive history recorded to the end of 1973 and 1978 respectively. Nearly all had a previous child with an NTD and none of the women were pregnant at the time of counselling. The effect of prenatal diagnosis was to speed somewhat the decision about further pregnancies, but the number of couples deciding on no further children and on having further pregnancies were almost identical in the two groups. The average number of pregnancies was 2·8 per family, with only 1·2 surviving children. The pregnancy outcomes are discussed as are the reasons for not attempting further pregnancies in both groups, which included very high risk of recurrence, a surviving spina bifida child, inability to accept the tests or its implications. Ninety per cent of the second group had tests. Their reactions to the tests were favourable but all complained of the waiting time between amniocentesis and obtaining the results. They all would have tests again in any future pregnancy. The reason for women not having prenatal diagnostic tests included inability to accept termination. It is concluded that couples in South Wales decide either to have no more children or to have further pregnancies regardless of tests. but tests speed a decision and enable the women to enjoy the pregnancy after obtaining the results, and that an NTD greatly reduces the number of children per family. A termination for an NTD is much more acceptable to most than an NTD at term. The reasons for this are discussed.     

基于资源最优化回收的再制造工程

从对寿命末端产品的处理选择分析出发，建立了末端产品回收梯级模型，提出基于最优化产品末端回收选择的再制造工程回收的附加值最大，环境污染最小，综合效益最高，并分析了再制造在产品全寿命周期各阶段所发挥的重要作用。     

废旧锂离子电池回收利用的研究现状

目前废旧锂离子电池的回收利用，重点是电极材料中有价金属的回收，主要是应用酸浸和溶剂萃取相联合的湿法冶金技术，其次将电化学技术用于浸出液中金属的沉积和对失效电极材料的直接修复也有相关的研究报导。根据锂离子电池的发展和未来的环境要求，今后的回收利用将朝综合处理和多元化处理技术的方向发展。     

Famine forecasting; Prices and peasant behaviour in Northern Ethiopia

This paper, completed in January 1984, begins by briefly outlining the contrasting views of price behaviour during the last Ethiopian famine (1972–1974) put forward by Seaman and Holt (1980) and Sen (1981). A hypothesis is developed to account for peasant behaviour and price responses under developing famine conditions. This is then tested with data recently made available. The paper concludes by summarizing the findings and their implications for famine forecasting, and argues that famine conditions in Northern Ethiopia are likely to worsen during 1984.     

The economics of tire remanufacturing

The world market for tires is described to identify the current material flow from raw materials to tires and the used tire disposal problem. Then, I describe the value-adding operations in the tire production process and in the tire retreading process. Once retreading is identified as the only recovery alternative that maximizes tire utilization, I explain why heat generation is the only recovery alternative, when retreading is not technically feasible. The economic values of heat generation in electric plants and in cement kilns are discussed. The paper culminates with the case of retreading, the tire remanufacturing process and the recommendation of a simple decision rule for selecting the number of times a tire should be retreaded to maximize its utilization.