Spatial cost efficiency in waste paper handling: the case of corrugated board in Sweden

This paper analyzes the spatial cost efficiency of the Swedish legislation regarding waste disposal handling. We focus on the case of corrugated board and recognize that the different counties in Sweden possess different economic prerequisites in terms of waste paper recovery and utilization potential. We employ data for six corrugated board mills and 20 counties and a non-linear programming model to identify the least cost strategy for reaching the politically specified recycling target of a 65% recovery rate for corrugated board. That is, the total costs of recovering a minimum of 65% in each county are calculated and compared with the case when the country as a whole recovers 65% of all old corrugated board is collected but there exist no uniform target for each county. The conclusion is that from an efficiency point of view the recovery efforts should be concentrated to the highly populated and urbanized counties, and not be uniformly divided throughout the country. In the base case, the results suggest that the cost efficient county-specific recovery rates should range from 51 to 72%.     

焚烧飞灰重金属含量及浸出长期变化规律研究

通过对24个飞灰样品的重金属全量消解和高精度X射线荧光光谱法（HDXRF）快速检测结果进行线性回归分析,发现HDXRF法可较准确测定飞灰中Cu、Pb、Zn、Ni和Cd含量（线性回归决定系数R²³0.90）.采用HDXRF法对某焚烧厂飞灰重金属含量6个月快速检测及浸出毒性测定数据统计分析发现：飞灰重金属月均含量较稳定（变异系数CV<0.14）但日均含量波动较大（CV>2.54）;飞灰中Pb、Cu和Zn含量呈正相关（相关系数r>0.78）;金属浸出浓度受浸出液终点pH值影响显著,超标频率依次为Pb（68.9%）、Cd（66.1%）、Ni（24.0%）、Cu（14.2%）和Zn（1.6%）.短期飞灰金属含量和浸出毒性数据受焚烧工况,烟气处理工况和垃圾组分等多种因素共同影响,不具有代表性.为评估垃圾分类源头削减重金属效果,建议采用快速检测方法对焚烧飞灰重金属含量进行长期监测.     

Acceleration of floc-water separation and floc reduction with magnetic nanoparticles during demulsification of complex waste cutting emulsions

Waste cutting emulsions are difficult to treat efficiently owing to their complex composition and stable emulsified structure. As an important treatment method for emulsions, chemical demulsification is faced with challenges such as low flocs–water separation rates and high sludge production. Hence, in this study, Fe₃O₄ magnetic nanoparticles (MNPs) were used to enhance chemical demulsification performance for treating waste cutting emulsions under a magnetic field. The addition of MNPs significantly decreased the time required to attain sludge–water separation and sludge compression equilibrium, from 210 to 20 min. In addition, the volume percentage of sludge produced at the equilibrium state was reduced from 45% to 10%. This excellent flocculation–separation performance was stable over a pH range of 3–11. The magnetization of the flocculants and oil droplets to form a flocculant–MNP–oil droplet composite, and the magnetic transfer of the composite were two key processes that enhanced the separation of cutting emulsions. Specifically, the interactions among MNPs, flocculants, and oil droplets were important in the magnetization process, which was controlled by the structures and properties of the three components. Under the magnetic field, the magnetized flocculant–MNP–oil droplet composites were considerably accelerated and separated from water, and the sludge was simultaneously compressed. Thus, this study expands the applicability of magnetic separation techniques in the treatment of complex waste cutting emulsions.     

某垃圾焚烧厂投产前后周边土壤二英类化合物的分布

为研究垃圾焚烧厂运行对周边土壤二英类化合物（PCDD/Fs）含量的影响,采集了珠三角地区某垃圾焚烧厂投产前和投产后周边土壤样品,分析研究了该垃圾焚烧厂运行对周边土壤中PCDD/Fs含量和组分的变化.结果表明:①2012年（投产前）珠三角地区某垃圾焚烧厂周边土壤PCDD/Fs含量较低,范围为163~591 ng/kg（毒性当量范围为0.198~0.863 ng I-TEQ/kg,I-TEQ为国际毒性当量因子折算的毒性当量值）;2017—2019年（投产后）周边土壤PCDD/Fs含量范围为151~1.75×103 ng/kg（毒性当量范围为0.812~3.88 ng I-TEQ/kg）,与其他研究相比处于较低的水平.②投产后,距该垃圾焚烧厂较近（1.5 km）的采样点（S1）土壤PCDD/Fs含量逐年增长,在较远（5.2 km）但人口较密集的采样点（S3）土壤PCDD/Fs含量整体较高,但呈逐年下降趋势.③投产后,土壤中的17种PCDD/Fs单体组分中,毒性当量贡献率最高的单体为八氯二苯并二英（OCDD）和2,3,4,7,8-五氯二苯并呋喃（2,3,4,7,8-PeCDF）,二者毒性当量贡献率范围为15.7%~45.4%.④在同一采样点土壤PCDD/Fs单体组分年间差异不明显,但同一年份不同采样点差异明显.研究显示,目前该垃圾焚烧厂周边土壤PCDD/Fs含量较低,但仍需要长期监测其可能带来的风险.      

低温等离子体协同催化降解废气污染物的研究进展

阐述了低温等离子体协同催化工艺流程与反应机理,探讨了反应温度、废气进口组分、废气中水蒸气含量、气体流速、气溶胶等因素对降解效果的影响。分析认为:一段式低温等离子体协同催化可改变低温等离子体特征及催化剂催化特性,但尚未解决尾气臭氧逃逸、副产物产生及放电稳定性等问题;两段式低温等离子体协同催化可提高污染物分子降解效率并减少尾气臭氧逃逸,但未能有效利用等离子体的能量,气体中的水蒸气、粉尘及反应过程中产生的气溶胶均能影响后置催化剂的催化性能;两段式低温等离子体协同催化已具备工程应用条件,还需配套高效预处理单元以降低废气中水蒸气、粉尘等对催化剂的影响。     

消泡剂硅油I在工业废水氨氮测定中的应用

对色泽较深，含杂质量较高的废水加硅油I以抑制测定中蒸馏产生的泡沫．结果表明，在250ml水样中加硅油IO．10～1．25ml，即可收到理想效果．硅油I性质稳定，不随水蒸汽蒸出，对测定无干扰．     

泰州市环境空气中挥发性有机物分布特征

于2018年4—9月对泰州市环境空气中挥发性有机物(VOCs)组分开展现场观测,结合观测数据分析该市大气中VOCs的时空分布特征。结果表明:观测期间泰州市环境空气中VOCs平均摩尔比为45.1 nmol/mol,其中含氧挥发性有机物占比为57.8%;受周边排放源和地理位置影响,下风向点位的VOCs测定值高于其他点位;VOCs月均最高值出现在6月,与臭氧月均最高值出现时间一致,7—9月气团出现老化,导致臭氧生成能力减弱;观测期间VOCs中甲苯/苯(T/B)比值范围为0.201 9～5.130 3,且大部分T/B比值2,说明溶剂、油气和液化石油气挥发等排放源对泰州市环境空气中VOCs的影响较为显著。     

小型废电池填埋焚烧处置的健康风险分析

对废电池采取填埋、焚烧处置所引起的健康风险进行了分析，采用3种模型，分别研究了废电池随城市固体废物一起完全填埋处置，一起完全焚烧处置，一起部分填埋处置和部分焚烧处理时，可能引起的健康风险，由分析可知，镉镍电池焚烧过程将引起不可接受的致癌风险，填埋废电池也会引起重金属非致癌风险，提出在现阶段没有单独收集分类管理的条件下，对于小型废电池应采取填埋焚烧联合处置的办法，但应避免镉镍电池的焚烧，在建立了收集体系后，应该分类进行资源化和无害化管理。     

我国电子废弃物收集体系构想

解决中国电子废弃物问题,一是控制电子废弃物进入非正式循环利用者手中;二是把非正式循环利用系统纳入良好的电子废弃物管理系统,使之成为更有效和对环境友好的系统.因此,如何把千家万户废弃的电子废弃物有效收集起来,是关系到电子废弃物管理和循环利用的重要环节.在我国建立良好的电子废弃物收集体系,应以市场经济和目前我国“城乡二元经济“为基础,建立具有收集主体多元化、收集方式多样化,收集途径多渠道等特点的电子废弃物收集体系.     

离子色谱法在石化工业废水分析中的应用

用IC-6离子色谱分析仪，研究石化工业废水中阴离子的测定技术，并首次建立炼油、化肥外排废水中F^-、Cl^-、NO2^-、PO4^3-、NO3^-、SO4^2-等阴离子含量测定的岗位。以含0．0054mol／L碳酸氢钠和0．0050mol／L碳酸钠为淋洗液，在电流70mA、流速1．5mL／min、泵压0～42MPa的条件下，测得各阴离子的相关系数均大于0．995、相对标准偏差（RSD）〈5．00％、加标回收率为95％～116％。