Treatment of black liquor from the papermaking industry by acidification and reuse

Two different kinds of black liquor from the papermaking industry were treated by acidification and reuse. The experimental parameters and conditions were discussed in detail. The experimental results indicated that the treatment process mentioned in this article is an effective process for the treatment of black liquor from the papermaking industry. By the treatment, the solid materials in black liquor are transferred into two by-products and the other components are reused or evaporated. Thus, no wastewater except some condensation water would be discharged in pulping process and the problem of oollution of black liauor would be effectively solved.     

不同部位玉米秸秆对两种质地黑土CO2排放和微生物量的影响

秸秆还田后作物残体的分解是农田生态系统碳循环及养分周转平衡的一个至关重要环节.为了探索秸秆化学性质和土壤质地对黑土区土壤CO2排放和微生物量的影响,本文通过室内恒温培养实验研究了添加不同植株部位玉米秸秆(根、茎下部、茎顶部、叶)进入黑土区两种质地土壤(砂壤土和黏壤土)后的CO2排放、微生物量,并分析了它们与秸秆C/N、木质素含量的关系.结果表明,添加不同部位秸秆一致增加土壤CO2排放量,激发效应值介于216.53~335.17μmol·g-1,黏壤土大于砂壤土.激发效应值与木质素/N之间的线性回归关系明显好于激发效应与木质素含量、C/N、含氮量之间的线性关系.添加秸秆增加MBC和MBN含量,降低MBC/MBN,微生物群落氮固持的速率高于碳固持.添加秸秆后,砂壤土微生物量增加的幅度大于黏壤土,总溶解性氮含量小于黏壤土.结果说明,秸秆的木质素和氮含量均会对它的分解和CO2排放产生影响,木质素/N比木质素含量、C/N等更好地说明秸秆分解和CO2排放的差异;与黏壤土相比,在砂壤土中实施秸秆还田可以取得更好的土壤碳固存、微生物量和氮素保持效果.     

废旧硬质聚氨酯泡沫塑料的木质素改性及再生

采用含有二乙二醇(DEG)和乙醇胺(ETA)的双组分解交联剂降解废旧硬质聚氨酯泡沫塑料(PU硬泡),并利用降解得到的低聚物多元醇与木质素复合制备出性能增强的再生PU硬泡。通过对制备的再生PU硬泡的红外光谱、密度、吸水率、抗压强度、热稳定性、导热系数、热重曲线等进行分析测试,考察m(DEG)∶m(ETA)对再生PU硬泡性能的影响。实验结果表明:m(DEG)∶m(ETA)=1∶3时废旧PU硬泡的降解效果最好;木质素加入量为2.0%(w)时再生PU硬泡的密度低、抗压强度高、保温性能良好,达到国家标准《建筑绝热用硬质聚氨酯泡沫塑料》(GB/T 21558—2008)的品质要求。     

活性红M-3BE脱色真菌的筛选及脱色性能研究

从自然环境中分离到2株对染料活性红M-3BE具有明显脱色效果的真菌,经形态学和26S rDNA序列分析,将其鉴定为Fusarium oxysporum和Geosmithia viridis.采用初始浓度50 mg/L M-3BE的液体培养基同步脱色培养,F.oxysporum在24 h内对M-3BE的脱色率为96%,G.viridis在36 h内的脱色率为82%.对脱色酶系的检测结果表明,脱色过程中F.oxysporum能产生LiP和MnP,G.viridis则仅产生LiP.此外,F.oxysporu和G.viridis对另外7种染料的脱色率也可分别达到16%～100%和83.3%～100%.     

稻草制浆黑液生物＋混凝处理试验

通过对稻草制浆黑液厌氧、好氧、混凝处理组合工艺的试验研究,探索该工艺的可行性,考察了不同温度、不同有机负荷下,该类废水的生物处理效果以及后续混凝效果。结果表明：中温35℃是厌氧阶段最佳处理温度,好氧阶段不同负荷条件下,CODCr去除率基本相同;经厌氧－好氧处理,黑液CODCr和木质素去除率分别为80％和30％,色度去除不明显;混凝阶段CODCr和木质素去除率分别为70％和90％,色度去除率达90％以上,出水达到国家标准。     

改性蚁酸木质素的制备与应用

采用加拿大一枝黄花茎杆为原料提取蚁酸木质素,通过氧化或接枝复合的方法对蚁酸木质素进行改性,对改性产物进行了FTIR和SEM表征。实验结果表明：接枝复合改性产物中存在-CONH的接枝复合链,氧化改性产物基本保持了蚁酸木质素原来的吸收峰;采用接枝复合改性产物处理初始质量浓度为50 mg/L的亚甲基蓝废水,在废水pH 7、吸附时间4 h、改性产物加入量22 mg/mL的条件下,亚甲基蓝去除率为90.94%;采用氧化改性产物处理相同亚甲基蓝废水,在废水pH 10、吸附时间12 h、改性产物加入量22 mg/mL的条件下,亚甲基蓝去除率为81.93%。     

酸析法和碱析法处理草浆造纸黑液的效果对比

对比了酸析法和碱析法对碱法草浆造纸黑液中木质素的去除效果,并分析了聚合氯化铝(PAC)絮凝剂对酸析和碱析后木质素的絮凝效果。实验结果表明:酸析法和碱析法都能有效析出造纸黑液中的木质素,酸析法对色度的去除效果要优于碱析法;当造纸黑液pH为3时,COD去除率达到72.0%,色度去除率为97.7%;当造纸黑液pH为13时,COD去除率达到55.0%,色度去除率为22.3%;PAC对于酸析后木质素有较好的絮凝效果,当废水温度为55℃、PAC加入量为45mL/L时,COD去除率可以达到79.5%,色度去除率为98.5%;PAC絮凝剂对于碱析后的造纸黑液色度的去除效果较差。     

比值-导数光谱法快速测定香草醛

文章用比值—导数光谱法测定香草醛的含量。实验结果表明,香草醛木素溶液在pH≤7时香草醛在230 nm处有吸收,在pH>7时在248 nm处有吸收。根据不同pH值和不同浓度条件下香草醛木素溶液的比值-导数光谱,说明在230 nm处的光谱信号在pH≤7不受pH值影响,248 nm处的光谱信号在pH>7不受pH值影响。在230 nm和248 nm处的光谱信号对浓度的变化较为敏感,在此两处吸收值可用于香草醛的测定。     

Volatile metabolites from indoor molds grown on media containing wood constituents

Since volatile mold metabolites are used for the detection of mold growth in buildings, it was interesting to determine whether different indoor mold species show different affinity for the major components of wood, a common building material. Growth and volatile metabolites were studied when Aspergillus versicolor, Penicillium chrysogenum, and P. palitans were grown on laboratory substrates containing the major wood constituents cellulose, xylan and lignin. Microbial volatile organic compounds (MVOCs) were characterized by thermal desorption/gas chromatography/mass spectroscopy. Growth and volatile metabolites varied considerably and there appeared to be complementary substrate specificities for P. chrysogenum, and P. palitans grown on cellulose and xylan. The failure of A. versicolor to produce characteristic MVOCs when grown on media containing wood constituents suggests that systems using volatile metabolites to detect microbial growth in buildings may be fundamentally unreliable for the detection of this species.