UASB启动运行特征及互营丙酸氧化菌定量分析

为揭示升流式厌氧污泥床（UASB）反应器启动运行效能与互营丙酸降解菌群数量之间的关系,以稀释的玉米淀粉生产废水为底物,考察了UASB启动期的运行特征,并采用实时荧光定量PCR技术（qPCR）分析了互营丙酸降解菌群（丙酸氧化菌和产甲烷菌）的演替规律.结果表明,在进水COD 2000mg/L和水力停留时间（HRT）24h条件下,经过38d的连续运行,COD去除率达到了91.9%.当HRT分阶段缩短至8h时,比产甲烷速率达到了315LCH₄/（kg COD·d）,且形成了沉降性能良好的颗粒污泥.qPCR检测结果表明,至少有5种已鉴定的丙酸氧化菌存在于UASB反应器中.Pelotomaculum propionicum为接种污泥中的主要丙酸氧化菌,约占检测到丙酸氧化菌总数的45.7%.它的数量随着HRT缩短不断减少.而Syntrophobacter sulfatireducens和S.wolinii的数量随着HRT缩短不断增加,并在启动完成时达到最大值,分别为1.3×10³,5.5×10³个16S rRNA基因拷贝数/ng DNA,演替成为成熟颗粒污泥中的优势丙酸氧化菌群.Methanobacterium和Methanosarcina为接种污泥中的主要氢营养型产甲烷菌和乙酸营养型产甲烷菌,其数量随着HRT的缩短而逐渐减少,而Methanospirillum和Methanosaeta的数量随HRT的缩短逐渐增加,成为成熟颗粒污泥中的优势产甲烷菌群.     

氨基淀粉絮凝剂合成工艺

以玉米淀粉为原料，以环氧氯丙烷(ECH)作交联剂，合成高交联淀粉(CS)；以HC1O4作引发剂，以ECH作醚化剂，合成中间产物3-氯-2-羟基丙烯基交联淀粉(CHCS)，在碱性条件下再与乙二胺反应，得到对重金属离子具有螯合能力的氨基淀粉(CAS)。最佳醚化条件：CS含水质量分数为7．0％，ECH与CS的摩尔比为2．5：1，HC104与CS的摩尔比为0．03：1，反应时间为8h，反应温度为95℃。以该法制得的CAS对废水中铜离子的去除能力为78．5mg／g。     

Water vapor permeability of biodegradable polymers

The water vapor transmission rates (WVTR) of several biodegradable polymers were evaluated to determine their suitability as water-resistant coatings and to understand WVTR better in terms of polymer structure. Values of WVTR at 25‡C ranged from 13 to 2900 g/m² /day and increased in the order PHBV PLA (cryst.) PLA (amorph.) PCL Bionolle BAK 1095 CAP CA. Values of WVTR were positively correlated with higher polymer solubility parameters, lower crystallinities, and higher free volumes. Although the WVTR of biodegradable polymers are much higher than those of good barrier materials such as low-density polyethylene, they are sufficient for short-term (hours to days) protection of polysaccharide-based materials against water. Product names are necessary to report factually on available data; however, the USDA neither guarantees nor warrants the standard of the product, and the use of the name by the USDA implies no approval of the product to the exclusion of others that may also be suitable.     

Pressure- volume- temperature relationships of soy protein isolate/starch plastic

The use of pressure-volume-temperature (PVT) studies in processing of a biodegradable plastic composition made from soy protein isolate and corn starch is described. The ability of PVT measurements to predict the combined effects of pressure, volume, and temperature effects is demonstrated. The results show that the PVT relations of the plastic can be predicted by using a regression analysis similar to the Tait equations of state. A change in slope of the PVT curves was observed at around 80‡C, which is ascribed to the glass-transition process of the plastic. Evidence of onset of thermal degradation of the plastic was observed at ca. 160‡C under 0 to 200 MPa isobaric pressure. This thermal degradation precluded determination of the crystal melting point of the plastic.     

Polymeric Complexes from Casein and Starch Phosphate: Characteristics and Enzyme Susceptibility

Novel biodegradable materials were prepared from potato starch enriched in phosphato moieties (DS 0.018 and 0.033) and casein in defatted milk. The components were blended in proportions providing starch: casein ratios of 2:1, 1:1, and 1:2 and were then precipitated with hydrochloric acid. Aqueous solubility, water-binding capacity, infrared spectra, and thermal analysis (thermogravimetry[7] and differential thermogravimetry of the precipitates revealed that they were not simple physical mixtures of the components. The components interacted with one another electrostatically with involvement of the phosphate groups of starch and the peptide bond of casein, as documented by infrared spectra. Because of insolubility in 7 M aqueous urea solution, they might also be considered as complexes in which the components were chemically bound.     

无机-有机复合絮凝剂PST处理印染废水效果研究

以模拟印染废水和实际印染废水为实验对象,检验了一种新合成有机-无机复合絮凝剂(PST)的絮凝效果。结果表明,PST具有良好的絮凝性能。在受试条件下,絮凝效果与絮凝剂投加量、染料浓度有较大相关性。废水的pH值应用范围较宽;搅拌时间对COD去除率和脱色率没有显著影响。采用PST处理广东省高明市某印染厂的印染废水后,COD去除率为75.16%,脱色率为76.18%,处理效果良好,处理成本明显低于目前市场上普遍使用的聚铝等絮凝剂。     

经济型阳离子淀粉絮凝剂的制备及其对印染废水的处理效果

采用玉米淀粉为原料、氯化缩水甘油三甲基铵（GTA）作阳离子化试剂、水-乙醇混合液作分散剂、NaOH作碱催化剂,制备了经济型阳离子淀粉絮凝剂（简称经济型阳离子淀粉）。实验结果表明：在淀粉加入量110g、GTA加入量30g、NaOH加入量1．6g、分散剂中m（水）：m（乙醇）=1：1、m（分散剂）：m（淀粉）=0．50：1、反应温度80℃、反应时间2．5h的条件下,可制得取代度（DS）为0．31的经济型阳离子淀粉;用该经济型阳离子淀粉与聚丙烯酰胺（PAM）联用处理印染废水,当经济型阳离子淀粉加入量为140mg／L、PAM加入量为4mg/L、废水pH为8时,印染废水的色度去除率和COD去除率分别达92％和82％。该方法絮凝效果好,药剂费用低,产生的污泥少。     

新型材料淀粉微球对Cu2＋、Cr3＋和Pb2＋的吸附机理研究

以可溶性淀粉为原料,在反相悬浮体系中合成N,N′-亚甲基双丙烯酰胺交联淀粉微球为载体,研究了新型吸附材料淀粉微球（cross-linked starch microsphere,CSMs）对Mn＋（Cu2＋、Cr3＋、Pb2＋）的静态吸附行为。利用扫描电镜、X射线衍射仪和红外光谱仪对微球及其吸附产物进行表征,分析讨论了3种金属原子结构,研究了吸附机理。结果表明：308K时,Cu2＋、Pb2＋和Cr3＋的饱和吸附量分别是2.43、0.30和0.27 mmol/g,CSMs对Cu2＋离子吸附能力最强,并且其通过物理吸附、配位吸附方式吸附Mn＋,并得出引起微球吸附能力大小可能与金属离子电荷、离子半径和外层电子排布的差异因素有关。     

有机化纳米粘土基絮凝吸附材料对马铃薯淀粉加工废水的资源化处理

采用物理化学提纯方法制备了有机化纳米粘土基絮凝吸附材料,经过以聚乙二醇2000(PEG-2000)、十六烷基三甲基溴化氨(CTAB)、四丁基氢氧化铵(TBAOH,质量分数25％)和溴化四苯基磷(TPPB)4种表面活性剂对絮凝吸附材料进行有机化修饰,并将其应用于马铃薯淀粉加工废水的资源化处理.实验结果表明,有机化纳米粘土...     

产朊假丝酵母处理马铃薯淀粉废水

研究了pH、接种量、无机盐(通过加入磷酸二氢钾进行无机盐补充)及DO等对产朊假丝酵母处理马铃薯淀粉废水的影响.结果表明.在pH为5.0、产朊假丝酵母接种量为10%(体积分数)、磷酸二氢钾(质量分散为0.1%)加入量为0.5 g/L、废水不灭菌的条件下,废水处理效果和产朊假丝酵母生长最佳.且当废水COD为5 074 mg/L时,COD去除率达到74.86%,同时可获得2.23g/L的单细胞蛋白.产朊假丝酵母处理马铃薯淀粉废水的最佳条件的实验研究对实现马铃薯淀粉废水资源化利用提供了理论参考.