模糊综合评价法在钢铁企业安全投资合理性评价中的应用

为了对钢铁企业安全投资进行模糊综合评价,建立了钢铁企业安全投资的评价体系,确定各因素的权重。得出模糊综合评价矩阵,可对各因素进行评价分析;得出某钢铁企业安全投资现状分数为83.9分,等级为较好,需着重加强安全培训、劳保品、工业卫生等人因素方面的投资;在环境方面的投资较合理。     

Spatial cost efficiency in waste paper handling: the case of corrugated board in Sweden

This paper analyzes the spatial cost efficiency of the Swedish legislation regarding waste disposal handling. We focus on the case of corrugated board and recognize that the different counties in Sweden possess different economic prerequisites in terms of waste paper recovery and utilization potential. We employ data for six corrugated board mills and 20 counties and a non-linear programming model to identify the least cost strategy for reaching the politically specified recycling target of a 65% recovery rate for corrugated board. That is, the total costs of recovering a minimum of 65% in each county are calculated and compared with the case when the country as a whole recovers 65% of all old corrugated board is collected but there exist no uniform target for each county. The conclusion is that from an efficiency point of view the recovery efforts should be concentrated to the highly populated and urbanized counties, and not be uniformly divided throughout the country. In the base case, the results suggest that the cost efficient county-specific recovery rates should range from 51 to 72%.     

Acceleration of floc-water separation and floc reduction with magnetic nanoparticles during demulsification of complex waste cutting emulsions

Waste cutting emulsions are difficult to treat efficiently owing to their complex composition and stable emulsified structure. As an important treatment method for emulsions, chemical demulsification is faced with challenges such as low flocs–water separation rates and high sludge production. Hence, in this study, Fe₃O₄ magnetic nanoparticles (MNPs) were used to enhance chemical demulsification performance for treating waste cutting emulsions under a magnetic field. The addition of MNPs significantly decreased the time required to attain sludge–water separation and sludge compression equilibrium, from 210 to 20 min. In addition, the volume percentage of sludge produced at the equilibrium state was reduced from 45% to 10%. This excellent flocculation–separation performance was stable over a pH range of 3–11. The magnetization of the flocculants and oil droplets to form a flocculant–MNP–oil droplet composite, and the magnetic transfer of the composite were two key processes that enhanced the separation of cutting emulsions. Specifically, the interactions among MNPs, flocculants, and oil droplets were important in the magnetization process, which was controlled by the structures and properties of the three components. Under the magnetic field, the magnetized flocculant–MNP–oil droplet composites were considerably accelerated and separated from water, and the sludge was simultaneously compressed. Thus, this study expands the applicability of magnetic separation techniques in the treatment of complex waste cutting emulsions.     

京津冀地区钢铁行业协同减排成本-效益分析

京津冀地区是我国钢铁行业布局最集中的区域,也是大气污染治理的重点区域之一.分析京津冀地区钢铁行业各类治污手段中长期减排的成本-效益,对于选择最经济有效的减排路径、加快推动该地区大气环境质量达标意义重大.基于能源环境、环境分布、人群健康效益评价等模块构建多模型耦合方法,以2015年为基准年,以每5 a为时间节点,设计了京津冀地区钢铁行业规模-结构、规模-技术、规模-末端治理、综合减排4种协同减排情景,计算各情景下2015—2030年京津冀地区钢铁行业主要污染物(SO₂、NO_x、PM₁₀、PM_2.5、CO₂)的减排成本与效益,比较获取治污减排的最优路径方案.结果表明:①基于减排成本计算,规模-末端治理减排情景成本最低,分别为规模-结构、规模-技术减排情景投入的15.18%、23.94%;综合减排情景下治污减排潜力最大,但综合成本最高.②基于环境税效益评价方法、人群健康效益评价方法计算显示,人群健康效益评价方法计算的减排效益高于环境税效益评价方法,表明污染减排的潜在人群健康效益更高;基于两种减排效益方法,4种协同减排情景中综合减排效益分别为10.78×108、76.14×108元,高于规模-结构、规模-技术、规模-末端治理减排情景效益.③基于环境税效益评价方法,4种协同减排情景的效益-成本比表现为规模-末端治理减排情景(0.46) >规模-技术减排情景(0.24) >综合减排情景(0.15) >规模-结构减排情景(0.10);基于人群健康效益评价方法4种协同减排情景的效益-成本比依次为规模-末端治理减排情景(8.35) >综合减排情景(1.07) >规模-结构减排情景(0.57) >规模-技术减排情景(0.65),表明规模-末端治理减排情景的减排路径最优.研究显示,京津冀地区钢铁行业应基于环境质量底线目标要求,综合考虑减排潜力、减排成本与收益,以规模-末端治理为主要途径,选取协同减排的最优路径.      

低温等离子体协同催化降解废气污染物的研究进展

阐述了低温等离子体协同催化工艺流程与反应机理,探讨了反应温度、废气进口组分、废气中水蒸气含量、气体流速、气溶胶等因素对降解效果的影响。分析认为:一段式低温等离子体协同催化可改变低温等离子体特征及催化剂催化特性,但尚未解决尾气臭氧逃逸、副产物产生及放电稳定性等问题;两段式低温等离子体协同催化可提高污染物分子降解效率并减少尾气臭氧逃逸,但未能有效利用等离子体的能量,气体中的水蒸气、粉尘及反应过程中产生的气溶胶均能影响后置催化剂的催化性能;两段式低温等离子体协同催化已具备工程应用条件,还需配套高效预处理单元以降低废气中水蒸气、粉尘等对催化剂的影响。     

海水中阴极极化对X80钢应力腐蚀及氢脆敏感性的影响

目的研究不同p H值海水中阴极极化对X80管线钢应力腐蚀及氢脆的抑制作用。方法采用慢应变速率拉伸试验、电化学测试、微观组织观察等分析方法。结果 X80钢在天然海水中的析氢电位约为-940m V(vs.SCE,下同),海水p H为3.5时析氢电位发生正移。其应力腐蚀敏感性与极化电位有很大关系,随着极化电位负移,X80钢的氢脆敏感性增加。天然海水中当极化电位负于-950 m V时,断口出现准解理断裂特征形貌。在-1050 m V极化电位下,钢材进入氢脆断裂区发生脆性断裂。海水p H为3.5时,-900 m V钢材有发生氢脆的危险。结论与天然海水相比,X80钢在p H为3.5的酸性海水中具有较高的应力腐蚀敏感性,两种海水介质中X80钢的应力腐蚀敏感性均随极化电位负移而增加。     

7B04铝合金和30CrMnSiA钢短期腐蚀的电化学行为研究

目的研究7B04铝合金和30CrMnSiA合金钢试样的电化学性能。方法采用电化学实验、扫描电子显微镜(SEM)、腐蚀坑深度测试分别对7B04铝合金和30CrMnSiA合金钢试样在是否经过天然海水浸泡的情况下进行测试分析,得到微观腐蚀形貌和腐蚀坑深度以及试样表面不带锈和带锈时的电化学性能。结果随着Na Cl浓度增大,7B04铝合金和30CrMnSiA钢的自腐蚀电流变大,两者之间存在明显的电位差,接触后会发生电偶腐蚀。电偶电流与阴阳极面积比和Na Cl浓度有关,阴阳极面积比增大或Na Cl浓度升高均会导致电偶效应增强。经过海水短期浸泡后,7B04铝合金表面的锈层不仅没有起到抑制腐蚀的作用,反而使自腐蚀加重,但电偶效应确实有所减弱。结论沿海设备在使用过程中应竭力避免铝合金在锈层下工作。     

硫酸盐还原菌对EH40焊接钢海水腐蚀的影响

目的研究无菌和SRB体系中EH40钢焊接接头的母材区、热影响区和焊缝区腐蚀差异。方法利用金相显微镜观察、失重法、电化学测试、扫描电镜和X射线光电子能谱仪等分析手段。结果焊缝区微观组织由块状铁素体(BLF)和魏氏组织(W)组成;热影响区可再分为粗晶区(CGHAZ)和细晶区(FGHAZ)两个区;母材区主要由BLF、AF和少量珠光体组成。在无菌对照体系中,焊缝区腐蚀速率为0.0026 mm/a,混合区次之,为0.0023 mm/a,母材区最小,为0.0019 mm/a。含SRB体系中,各区的腐蚀速率为:焊缝区(0.0037 mm/a)混合区(0.0034 mm/a)母材区(0.0030 mm/a)。热影响区腐蚀产物形貌粗大,点蚀孔也较大。结论焊缝区比母材区容易腐蚀,由此易造成小阳极大阴极加速腐蚀,热影响区容易发生点蚀。SRB能促进三个区域试样腐蚀加速。     

Distribution of airborne particles from multi-emission source

The purpose of this work was to study the distribution of airborne particles in the surroundings of an iron and steel factory in southern Finland. Several sources of particulate emissions are lying side by side, causing heavy dust loading to the environment. This complicated multi-pollutant situation was studied mainly by SEM/EDX methodology.Particles accumulated on Scots pine bark were identified andquantitatively measured according to their element content,size and shape. As a result, distribution maps of particulateelements were drawn and the amount of different particle typesalong the study lines was plotted. Particulate emissions fromthe industrial or energy production processes were not themain dust source. Most emissions were produced from theclinker crusher. Numerous stockpiles of the industrial wastesand raw materials also gave rise to particulate emissions as aresult of wind erosion. It was concluded that SEM/EDXmethodology is a useful tool for studying the distribution ofparticulate pollutants.     

消泡剂硅油I在工业废水氨氮测定中的应用

对色泽较深，含杂质量较高的废水加硅油I以抑制测定中蒸馏产生的泡沫．结果表明，在250ml水样中加硅油IO．10～1．25ml，即可收到理想效果．硅油I性质稳定，不随水蒸汽蒸出，对测定无干扰．