城市固体废物填埋场防护层天然材料研究

提出用石灰和粉煤灰对常用的粘土 +蒙脱土的衬里进行改性。对石灰配比为 0 %、0 4 %、1%、2 %、6 %、10 %的6种复合衬里、“三明治”结构的复合衬里 ,以及粉煤灰比例为 15 % ,2 5 % ,35 % ,5 0 %的 4种复合衬里 ,从渗透系数、衰减能力的角度进行了系列测试 ,得出了石灰配比为 10 %的复合土Ⅰ衬里和“三明治”结构复合土衬里性能良好、成本低、值得推广     

土工膜渗漏定位方法研究

对偶极子法电极形状和外形尺寸以及其他影响定位的因素进行了深入研究.结果表明:偶极子的检测电压与偶极子的外形尺寸关系不大.偶极子检测电压最大值出现在偶极子中心与漏洞的距离等于偶极子间距的1/2处,并且偶极子的间距越大,检测电压越高.偶极子下沿距离HDPE膜越近,检测电压变化越明显.在多漏洞的情况下,当偶极子的间距小于漏洞间距时,2个漏洞都能被检测出来;当2个漏洞间距小于偶极子间距时,将可能漏检1个漏洞.膜上供电电极的位置对漏洞定位有一定的影响,在测量时应尽可能将供电电极远离测量区.      

Recycling of an industrial sludge and marine clay as light-weight aggregates

The geographical limitations of Singapore, its restricted natural resources and voluminous municipal and industrial waste streams, make environmental management a major challenge for the island state. In an attempt to find ways to reduce importation of raw materials and the waste sent to landfill, light weight aggregates were produced from marine clay and a CaF(2)-rich semiconductor industry sludge. Aggregates were produced in a bench-scale rotary kiln with three clay/sludge loadings (90/10, 70/30 and 50/50%). All three mixtures showed good bloating behavior during firing and the ceramic pellets (1-1.5cm diameter) had densities well below that required for light-weight aggregates. In the initial tests, the pore sizes of the aggregates were in general too large resulting in high water absorption. Comparisons between the composition of the two waste products and the aggregates showed a significant loss of fluorine (40-60%) during processing; a problem which may require flue gas treatment. Leach testing showed that the formed aggregates would not pose a human or environmental hazard in terms of fluorine mobilization.     

白泥复合衬层防渗稳定性的研究

为考察白泥复合防渗衬层的防渗稳定性和对污染物的阻滞去除能力,利用自制击实渗透仪对白泥和亚粘土防渗衬层进行了对比研究. 结果表明:白泥/亚粘土“夹层结构"复合衬层能保持低于国家防渗规范(10－7 cm/s)的防渗性,并对渗滤液中的重金属,COD_Cr和NH₄＋-N具有较强的阻滞去除能力,可以与常用的亚粘土防渗衬层相媲美,不过其淋滤出水ρ(Cl－)高,因此其长期防渗稳定性需进一步研究;60%白泥+40%亚粘土“混合式"复合衬层和白泥防渗衬层在渗滤液渗透作用下,其防渗性能不好,渗透系数超过国家防渗规范要求,因此不宜用于填埋场防渗.      

基于物联网的麦积山石窟环境监测系统应用分析

简述了麦积山彩色泥塑佛像及壁画文物保护与管理监测,以及物联网技术构建文物保护微环境监测系统。针对麦积山石窟环境监测现状和存在的问题,分析了基于物联网应用的监测和传感技术在石窟实施全覆盖、实时监控的方式,以及其优势和可行性。     

Organochlorine pesticides in soil under irrigated cotton farming systems in Vertisols of the Namoi Valley, north-western New South Wales, Australia

Organochlorine pesticides (OCPs) such as DDT and DDE have been detected in the surface 0.2 m of Vertisols in the lower Namoi Valley of north western New South Wales, Australia even though they have not been applied to crops since 1982. However, their presence in the deeper soil horizons has not been investigated. The objective of this study was to determine if OCPs were present to a depth of 1.2 m in Vertisols under irrigated cotton farming systems in the lower Namoi Valley of New South Wales. Soil was sampled from the 0-1.2 m depths in three sites, viz. the Australian Cotton Research Institute, ACRI, near Narrabri (149°36′E, 30°12′S), and two cotton farms near Wee Waa (149°27′E, 30°13′S) and Merah North (149°18′E, 30°12′S) in northern New South Wales, Australia. The OCPs detected and their metabolites were α-endosulfan, β-endosulfan, endosulfan sulphate, DDD, DDE, DDT and endrin. The metabolite DDE, a breakdown product of DDT, was the most persistent OCP in all depths analysed. Endosulfan sulphate was the second most persistent followed by endrin > α-endosulfan > β-endosulfan > DDT and DDD. DDT was sprayed extensively in the lower Namoi Valley up to the early 1980s and may explain the persistence of DDE in the majority of soil samples. Dicofol and Dieldrin, two OCPs previously undocumented in Vertisols were also detected. The movement of OCPs into the subsoil of Vertisols may occur when irrigation or rain transports soil colloids and organic matter via preferential flow systems into the deeper layers of a soil profile. Persistence of OCPs was closely correlated to soil organic carbon concentrations. The persistence in soil of OCP’s applied to cotton crops grown more than two decades ago suggests that they could enter the food chain. Their presence at depths of 1.2 m suggests that they could move into groundwater that may eventually be used for domestic and stock consumption.     

Sorption of tylosin on clay minerals

The equilibrium sorption of tylosin (TYL) on kaolinite and montmorillonite was measured at different solution pH using batch reactor systems. The results showed that all the sorption isotherms were nonlinear and that the nonlinearity decreased as the solution pH increased for a given clay. At a specific aqueous concentration, the single-point sorption distribution coefficient (K_D) of TYL decreased rapidly as the solution pH increased. A speciation-dependent sorption model that accounted for the contributions of the cationic and neutral forms of TYL fit the data well, suggesting that the sorption may be dominated by both ion exchange and hydrophobic interactions. The isotherm data also fit well to a dual mode model that quantifies the contributions of a site-limiting Langmuir component (ion exchange) and a non-specific linear partitioning component (hydrophobic interactions). X-ray diffraction analyses revealed that the interlayers of montmorillonite were expanded due to the uptake of TYL. TYL molecules likely form a monolayer surface coverage.     

Potential of acid activated clays in the clarification of menhaden stickwater

Abstract

The primary objective of this investigation was to determine the feasibility of using acid activated clays to clarify menhaden stickwater effluent. Experiments, such as physical and chemical properties determinations, effect of changes in pH and temperature and coagulation, and coagulation followed by clay treatment were also performed to study the separation of solids in stickwater.

Analysis of the stickwater showed that it contained 4.5% crude protein, 1.4% crude fat, 6.5% total solids, 1.13% ash and 93.1% water. At a wavelength of 575 um, the sample absorbed all the light and the percent transmittance was zero. When diluted 1:100 the percent transmittance was 0.39 at the same wavelength. Measured at 25°C the sample had a viscosity of 9.0 centipoises.

The results showed that the precipitation of fat increased with increasing temperatures, while the reverse was true for protein. A pH of 4.0 gave the maximum clarification at all temperatures employed. The viscosity decreased at pH values above and below the original pH of the sample.

Among the four different acid activated clays used in this study (trade names Supact‐150, Impact‐150, Impact‐12 and Impact‐1OORR), Impact‐150 was the most effective in protein and fat precipitation, and the degree of separation of these components increased by treating stickwater with a coagulant (aluminum sulfate) prior to treatment with acid activated clay.     

Woody plant roots fail to penetrate a clay-lined landfill: Managment implications

In many locations, regulatory agencies do not permit tree planting above landfills that are sealed with a capping clay, because roots might penetrate the clay barrier and expose landfill contents to leaching. We find, however, no empirical or theoretical basis for this restriction, and instead hypothesize that plant roots of any kind are incapable of penetrating the dense clays used to seal landfills. As a test, we excavated 30 trees and shrubs, of 12 species, growing over a clay-lined municipal sanitary landfill on Staten Island, New York. The landfill had been closed for seven years, and featured a very shallow (10 to 30-cm) soil layer over a 45-cm layer of compacted grey marl (Woodbury series) clay. The test plants had invaded naturally from nearby forests. All plants examined—including trees as tall as 6 m—had extremely shallow root plates, with deformed tap roots that grew entirely above and parallel to the clay layer. Only occasional stubby feeder roots were found in the top 1 cm of clay, and in clay cracks at depths to 6 cm, indicating that the primary impediment to root growth was physical, although both clay and the overlying soil were highly acidic. These results, if confirmed by experimental research should lead to increased options for the end use of many closed sanitary landfills.     

Reusability of sewage sludge in clay bricks

Bricks produced from sewage sludge in different compositions were investigated. Results of the tests indicated that the sludge proportion is a key factor in determining the brick quality. Increasing the sludge content results in a decrease in brick shrinkage, bulk density, and compressive strength. Brick weight loss on ignition was mainly due to the contribution of the contained organic matter from the sludge being burnt off during the firing process, as well as inorganic substances found in both clay and sludge. The physical, mechanical, and chemical properties of the bricks that were supplemented with various proportions of dried sludge from 10 to 40wt% and generally complied with the General Specification for Brick as per the Malaysian Standard MS 7.6:1972, which dictates the requirements for clay bricks used in walling in general. A standard leaching test method also showed that the leaching of metals from the bricks is very low.