EDTA增强Cr(VI)共存时Burkholderia cepacia降解孔雀绿的效率

重金属共存严重抑制了微生物降解染料的效率,本研究拟采用EDTA螯合Cr提高Burkholderia cepacia C09G降解复合污染中孔雀绿的效率.实验结果表明,0.1 mmol·L~(-1)孔雀绿单独存在条件下,24 h的生物降解率达到96.2%;然而,在0.5 mmol·L~(-1)Cr(VI)共存条件下,60 h的降解率仅为6.7%.当加入0.5 mmol·L~(-1)EDTA螯合剂后,60 h时孔雀绿的降解率提高到18.8%.当EDTA浓度为0.5 mmol·L~(-1)时,最佳螯合Cr(VI)的浓度为0.7 mmol·L~(-1),此时,60 h后孔雀绿的降解率达到35.3%,对Cr(VI)的吸附率为24.6%.此外,通过EDS、SEM、XPS分析证明,EDTA可以减小Cr(VI)的毒性,Burkholderia cepacia C09G可将吸附的Cr(VI)还原为Cr(III).     

FeⅡ(EDTA)络合协同RDB去除NO废气效能及过程分析

为进一步提高一氧化氮(NO)的去除效率,在新型生物转鼓反应器(rotating drum biofilter,RDB)中,以FeⅡ(EDTA)络合协同RDB生物转鼓的耦合技术强化难水溶性NO的气液传质速率,提高生物还原效能为目标进行了研究.结果表明,适量FeⅡ(EDTA)被添加到RDB底部营养液后,能迅速吸收气相中的NO并生成FeⅡ(EDTA)-NO络合物,进而可通过反硝化实现同步脱氮和络合剂再生.在转速0.5 r.min-1、空床停留时间(EBRT)57.7 s、温度30℃、pH 7～8的实验条件下,RDB的净化效能随络合剂的投加而显著改善;FeⅡ(EDTA)质量浓度从0增至500 mg.L-1后,NO去除率从61.1%提高到97.6%,去除负荷从16.2 g.(m3.h)-1上升到26.7 g.(m3.h)-1.分析了FeⅡ(EDTA)络合协同净化NO的反应过程,建立了NO净化效率与FeⅡ(EDTA)添加浓度的关联方程,可较好地拟合实验数据.     

EDTA对Pb、Cd及Pb-Cd处理下茼蒿中叶绿素的影响

通过盆栽模拟试验研究了Pb、Cd及Pb-Cd复合污染土壤添加EDTA(乙二胺四乙酸)对茼蒿中叶绿素的影响.结果表明,高浓度的EDTA对茼蒿中叶绿素的含量影响大,致使叶绿素结构破坏、叶片失绿,甚至叶片全部枯萎.在Pb处理的土壤中,EDTA的添加水平为2.5 mmol/kg时,茼蒿中叶绿素a、叶绿素b、叶绿素a+b的含量比...     

污染土壤中重金属的超声波强化EDTA洗脱及形态变化

以EDTA为洗脱剂,对重金属污染土壤进行超声波强化洗脱正交实验,并用Tessier连续提取法研究了洗脱前后Cd、Cu、Pb、Zn的形态变化.结果表明,在EDTA浓度20 mmol·L-1、固液比1∶20、超声波作用时间16 min、超声波功率54%、洗脱次数4次的条件下,对4种重金属洗脱率最大,分别为:Cd 83.6%、Cu 58.8%、Pb 98.0%、Zn 43.0%.在实验所设浓度范围内,随着EDTA浓度的升高,重金属洗脱率均有降低.形态分析结果显示,超声波强化EDTA洗脱能显著降低土壤重金属的残渣态含量.除土壤中Zn残渣态去除率只有5.7%以外,超声波强化EDTA洗脱对土壤中Cd、Cu、Pb的残渣态去除率都很高,分别为81.6%、62.3%、93.8%.     

EDTA优化纳米Pd/Fe对2,4-D的催化脱氯研究

采用EDTA优化纳米Pd/Fe催化脱氯水中2,4-二氯苯氧乙酸(2,4-D),并考察了EDTA投加浓度、pH、钯化率、温度等因素对2,4-D还原的影响.结果表明,EDTA的加入络合了纳米Pd/Fe在催化脱氯过程中生成的铁离子,抑制纳米Pd/Fe颗粒表面钝化层的形成,提高了体系的反应活性.适宜的EDTA浓度、低pH、高钯化率、低温等有利于2,4-D的还原脱氯.当EDTA浓度为25.0 mmol·L-1,纳米铁含量为1.0 g·L-1,初始pH=4.3、钯化率为0.5%,温度为25.0℃,搅拌速率为200 r·min~(-1)时,反应50 min,10.0 mg·L-1的2,4-D去除率及苯氧乙酸(PA)生成率均达到100%.     

Kinetic extractions to assess mobilization of Zn, Pb, Cu, and Cd in a metal-contaminated soil: EDTA vs. citrate

Kinetic EDTA and citrate extractions were used to mimic metal mobilization in a soil contaminated by metallurgical fallout. Modeling of metal removal rates vs. time distinguished two metal pools: readily labile (QM1) and less labile (QM2). In citrate extractions, total extractability (QM1+QM2) of Zn and Cd was proportionally higher than for Pb and Cu. Proportions of Pb and Cu extracted with EDTA were three times higher than when using citrate. We observed similar QM1/QM2 ratios for Zn and Cu regardless of the extractant, suggesting comparable binding energies to soil constituents. However, for Pb and Cd, more heterogeneous binding energies were hypothesized to explain different kinetic extraction behaviors. Proportions of citrate-labile metals were found consistent with their short-term, in-situ mobility assessed in the studied soil, i.e., metal amount released in the soil solution or extracted by cultivated plants. Kinetic EDTA extractions were hypothesized to be more predictive for long-term metal migration with depth.     

Selection of appropriate organic additives for enhancing Zn and Cd phytoextraction by hyperaccumulators

Chelant-enhanced phytoextraction is one of the most promising technologies to remove heavy metals from soil. The key of the technology is to choose suitable additives in combination with a suitable plant. In the present study, laboratory batch experiment of metal solubilization, cress seeds germination were undertaken to investigate the metal-mobilizing capability and the phytotoxicity of organic additives, including ethylene diamine triacetic acid （EDTA）, citric acid, acetic acid, oxalic acid, glutamine and monosodium glutamate waste liquid （MGWL） from food industry. Experiments in pots were carried out to study the effects of the additives on Zn and Cd phytoextraction. Furthermore, a leaching experiment with lysimeter was performed to evaluate the environmental risks of additive-induced leaching to underground water. The results showed that EDTA had a strong mobilizing ability for Zn and Cd, followed by mixed reagent （MR） and MGWL. MGWL and acetic acid at 5 mmol equivalent per liter resulted in seed germination index less than 2%. Experiments in pots verified the phytotoxicity of acetic acid and MGWL. Addition of the mixed reagent at 6--10 mmol/kg significantly increased Zn phytoextraction by Thlaspi caerulescens. The same for EDTA and the mixed reagent at 10 mmol/kg by Sedum dfredii. But only mixed reagents could significantly increase Cd phytoextraction by the studied hyperaccumulators. This suggested that the strong chelant was not always the good agent to enhance phytoextraction. S. alfredii combined with 2--10 mmol/kg soil MR was preferred for phytoremediation of Cd/Zn contaminated soils in southern China, this could result in high phytoextraction of Cd/Zn and reduce the leaching risk to underground water than EDTA assisted phytoextration.     

EDTA滴定法测定高锰水体总硬度的干扰和消除

测定水质总硬度最常用的是EDTA 滴定法,该法易受到多种因素的影响,而锰是重要影响因素之一。分析了锰对EDTA滴定法的影响,对比了两种掩蔽剂对不同浓度锰的掩蔽效果和对检测结果的影响。对实验结果进行了总结分析,为EDTA滴定法测定高锰水体总硬度过程中不同掩蔽剂的选择提供一定的依据。     

Development of a hybrid microbial fuel cell (MFC) and fuel cell (FC) system for improved cathodic efficiency and sustainability: the M2FC reactor

In an effort to improve the efficiency and sustainability of microbial fuel cell (MFC) technology, a novel MFC reactor, the M2FC, was constructed by combining a ferric-based MFC with a ferrous-based fuel cell (FC). In this M2FC reactor, ferric ion, the catholyte in the MFC component, is regenerated by the FC system with the generation of additional electricity. When the MFC component was operated separately, the electricity generation was maintained for only 98 h due to the depletion of ferric ion in the catholyte. In combination with the fuel cell, however, the production of power was sustained because ferric ion was continually replenished from ferrous ion in the FC component. Moreover, the regeneration process of ferric ion by the FC produced additional energy. The M2FC reactor yielded a power density of up to 2 W m⁻² (or time-averaged value of approximately 650 mW m⁻²), density up to 20 times (or approximately six times based on time-averaged value) higher than the corresponding MFC system.     

Comparison of EDTA-enhanced phytoextraction and phytostabilisation strategies with Lolium perenne on a heavy metal contaminated soil

Phytoremediation is a promising and cost-effective strategy to manage heavy metal polluted sites. In this experiment, we compared simultaneously phytoextraction and phytostabilisation techniques on a Cd and Zn contaminated soil, through monitoring of plant accumulation and leaching. Lolium perenne plants were cultivated for 2 months under controlled environmental conditions in a 27.6 dm³-pot experiment allowing the collect of leachates. The heavy metal phytoextraction was promoted by adding Na-EDTA (0.5 g kg⁻¹ of soil) in watering solution. Phytostabilisation was assessed by mixing soil with steel shots (1%) before L. perenne sowing. Presence of plants exacerbated heavy metal leaching, by improving soil hydraulic conductivity. Use of EDTA for phytoextraction led to higher concentration of heavy metal in shoots. However, this higher heavy metal extraction was insufficient to satisfactory reduce the heavy metal content in soil, and led to important heavy metal leaching induced by EDTA. On the other hand, addition of steel shots efficiently decreased both Cd and Zn mobility, according to 0.01 M CaCl₂ extraction, and leaching. However, improvement of growth conditions by steel shots led to higher heavy metal mass in shoot tissues. Therefore, soil heavy metal mobility and plant metal uptake are not systematically positively correlated.