Fractionation of Cu, Pb and Zn in certified reference soils SRM 2710 and SRM 2711 using the optimized BCR sequential extraction procedure

Sequential extraction of metals from solid media is a common analytical tool used in environmental and exploration geochemistry. A number of procedures exist, but without harmonization and standardization, meaningful comparisons are tenuous without baseline data. A newly developed, standardized sequential extraction procedure (optimized BCR) was applied to two contaminated certified reference soils from Montana, US (SRM 2710 and SRM 2711) for Cu, Pb and Zn. Four operationally defined fractions were isolated, acid extractable, reducible, oxidizable, and residual (by aqua regia). Fraction-specific concentrations, percentages and recoveries for Cu, Pb and Zn were used to explore differences between the optimized BCR procedure and three other sequential extraction schemes with published data for SRM 2710 and 2711 (i.e. Tessier scheme, Geological Survey of Canada scheme and the original BCR scheme). Results indicate significant differences between the four schemes, even for schemes that are closely associated (i.e. the original and optimized BCR schemes). Order-of-magnitude fraction-specific concentration differences were observed, especially for Pb in the reducible fraction. Differences between schemes are worrisome because trends varied between metals, between fractions and between reference soils. These data reinforce the need for increased adoption of standardized sequential extraction procedures and further examination of different solid media.     

The effect of heating temperature of thin film transistor-liquid crystal display (TFT-LCD) optical waste glass as a partial substitute partial for clay in eco-brick

In order to fulfill the current WEEE directives, the traditional approach to manage thin film transistor-liquid crystal display (TFT-LCD) waste glass is inadequate. It is a serious opportunity to achieve resource conservation, reduction, stabilization and safety of management of TFT-LCD in the near future. To assist in achieving these goals, this study investigated the sintering characteristics and material properties of TFT-LCD waste glass, which can be pulverized and ground and subsequently blended with clay, at various substitution levels (0–40%) and finally fired from 800 °C to 1000 °C to make eco-brick. The brick thus produced was analyzed to determine variations in weight losses on ignition, 24-h absorption, bulk density, shrinkage, compressive strength and microstructure changes. The results for specific gravity, water adsorption, and compressive strength revealed that bricks made from mixtures containing TFT-LCD waste glass met the general requirements for bricks. The advantages of less water absorption, less weight loss on ignition, and a gain in compressive strength in the clay-TFT-LCD waste glass bricks should encourage the use of TFT-LCD waste glass as a brick additive.     

Transboundary air pollution balance in the new integrated European environment

Ten out of the 12 new EU members, used to belong to the so-called “former eastern block”, with a post WWII environmental policy radically different from the tendencies followed in Western Europe. The lack of conservation regulations has resulted in a rather harmful industrialization, regarding natural resources and environmental quality. While air pollution transfer is a phenomenon of transboundary level, there is a particular interest in examining the contribution of the new EU member states to the environmental pressure faced by the older member states and vice versa. The current study utilises the official data for almost 20 years published by the European Monitoring and Evaluation Program concerning the transboundary transfer of NO_x and SO₂ in order to analyse the situation and discuss the present and future environmental policy regarding air pollution.     

Past and future sustainability of water policies in Europe

The article contributes to a discussion on two global issues on water: water resources management, and water supply and sanitation. Focusing on Europe, it traces the legal roots of current systems in history: as a resource, water is considered as a common property, rather than a market good; while as a public service it is usually a commodity. Public water supply and sanitation technologies and engineering have developed under three main paradigms: quantitative and civil engineering; qualitative and chemical/sanitary engineering (both on the supply side); and the most recent one, environmental engineering and integrated management (on the demand side). The cost of public drinking water is due to rise sharply in view of the two‐fold financial challenge of replacing an ageing infrastructure and keeping up with ever‐rising environmental and sanitary quality standards. Who will pay? Government subsidies, or water users? The author suggests that apparent successes with privatisation may have relied heavily on hidden government subsidies and/or the healthy state of previously installed water infrastructure: past government subsidies are still felt for as long as the lifetime of the infrastructure. The article stresses the importance of public participation and decentralized local management of water and sanitation services. Informing and involving users in water management decisions is seen as an integral part of the ‘ethics’ side of the crucial three E's (economics, environment, ethics). The article strongly argues for municipal provision of water services, and hopes that lessons learnt and solutions found in the European experience may serve water services management efforts in other regions of the world.     

Differences and similarities of gas and dust explosions: A critical evaluation of the European ‘ATEX’ directives in relation to dusts

Explosive gas mixtures and explosive dust clouds, once existing, exhibit similar ignition and combustion features. However, there are two basic differences between dusts and gases which are of substantially greater significance in design of safety standards than these similarities. Firstly, the physics of generation and up-keeping of dust clouds and premixed gas/vapour clouds are substantially different. This means that in most situations where accidental explosive gas clouds may be produced quite readily, generation of explosive dust clouds would be highly unlikely. Secondly, contrary to premixed gas flame propagation, the propagation of flames in dust/air mixtures is not limited only to the flammable dust concentration range of dynamic clouds. The state of stagnant layers/deposits offers an additional discrete possibility of flame propagation.

The two European Directives 94/9/EC (1994) and 1999/92/EC (1999) primarily address gases/vapours, whereas the particular properties of dusts are not addressed adequately. Some recent IEC and European dust standards resulting from this deficiency are discussed, and the need for revising the two directives accordingly is emphasized.     

Hazard property classification of waste according to the recent propositions of the EC using different methods

Hazard classification of waste is a necessity, but the hazard properties (named “H” and soon “HP”) are still not all defined in a practical and operational manner at EU level. Following discussion of subsequent draft proposals from the Commission there is still no final decision. Methods to implement the proposals have recently been proposed: tests methods for physical risks, test batteries for aquatic and terrestrial ecotoxicity, an analytical package for exhaustive determination of organic substances and mineral elements, surrogate methods for the speciation of mineral elements in mineral substances in waste, and calculation methods for human toxicity and ecotoxicity with M factors.In this paper the different proposed methods have been applied to a large assortment of solid and liquid wastes (>1 0 0).Data for 45 wastes – documented with extensive chemical analysis and flammability test – were assessed in terms of the different HP criteria and results were compared to LoW for lack of an independent classification. For most waste streams the classification matches with the designation provided in the LoW. This indicates that the criteria used by LoW are similar to the HP limit values.This data set showed HP 14 ‘Ecotoxic chronic’ is the most discriminating HP. All wastes classified as acute ecotoxic are also chronic ecotoxic and the assessment of acute ecotoxicity separately is therefore not needed. The high number of HP 14 classified wastes is due to the very low limit values when stringent M factors are applied to total concentrations (worst case method). With M factor set to 1 the classification method is not sufficiently discriminating between hazardous and non-hazardous materials. The second most frequent hazard is HP 7 ‘Carcinogenic’. The third most frequent hazard is HP 10 ‘Toxic for reproduction’ and the fourth most frequent hazard is HP 4 “Irritant – skin irritation and eye damage”. In a stepwise approach, it seems relevant to assess HP 14 first, then, if the waste is not classified as hazardous, to assess subsequently HP 7, HP 10 and HP 4, and then if still not classified as hazardous, to assess the remaining properties.The elements triggering the HP 14 classification in order of importance are Zn, Cu, Pb, Cr, Cd and Hg. Progress in the speciation of Zn and Cu is essential for HP 14. Organics were quantified by the proposed method (AFNOR XP X30-489) and need no speciation. Organics can contribute significantly to intrinsic toxicity in many waste materials, but they are only of minor importance for the assessment of HP 14 as the metal concentrations are the main HP 14 classifiers. Organic compounds are however responsible for other toxicological characteristics (hormone disturbance, genotoxicity, reprotoxicity…) and shall be taken into account when the waste is not HP 14 classified.     

Reorienting Systematic Conservation Assessment for Effective Conservation Planning

Abstract: Systematic conservation assessment (an information‐gathering and prioritization process used to select the spatial foci of conservation initiatives) is often considered vital to conservation‐planning efforts, yet published assessments have rarely resulted in conservation action. Conservation assessments may lead more directly to effective conservation action if they are reoriented to inform conservation decisions. Toward this goal, we evaluated the relative priority for conservation of 7 sites proposed for the first forest reserves in the Union of the Comoros, an area with high levels of endemism and rapidly changing land uses in the western Indian Ocean. Through the analysis of 30 indicator variables measured at forest sites and nearby villages, we assessed 3 prioritization criteria at each site: conservation value, threat to loss of biological diversity from human activity, and feasibility of reserve establishment. Our results indicated 2 sites, Yiméré and Hassera‐Ndrengé, were priorities for conservation action. Our approach also informed the development of an implementation strategy and enabled an evaluation of previously unexplored relations among prioritization criteria. Our experience suggests that steps taken to ensure the closer involvement of practitioners, include a broader range of social data, encourage stakeholder participation, and consider the feasibility of conservation action can improve the relevance of assessments for conservation planning, strengthen the scientific basis for conservation decisions, and result in a more realistic evaluation of conservation alternatives.     

跨流域环境污染联合处置机制初探——以苏鲁边界环保联席治污为例

随着经济的发展,流域水环境污染已成为制约区域经济和社会发展的关键性因素,流域跨界污染对上下游城市的水资源配置、社会稳定、经济可持续性等都提出严峻挑战。苏鲁边界九县（市）创造性地开展区域环境保护联席会议联防联治机制,为解决跨流域污染问题探索出了一条新路。     

Protection of ash (Fraxinus excelsior) trees from ozone injury by ethylenediurea (EDU): roles of biochemical changes and decreased stomatal conductance in enhancement of growth

Treatments with ethylenediurea (EDU) protect plants from ozone foliar injury, but the processes underlying this protection are poorly understood. Adult ash trees (Fraxinus excelsior), with or without foliar ozone symptoms in previous years, were treated with EDU at 450ppm by gravitational trunk infusion in May-September 2005 (32.5ppmh AOT40). At 30-day intervals, shoot growth, gas exchange, chlorophyll a fluorescence, and water potential were determined. In September, several biochemical parameters were measured. The protective influence of EDU was supported by enhancement in the number of leaflets. EDU did not contribute its nitrogen to leaf tissue as a fertiliser, as determined from lack of difference in foliar N between treatments. Both biochemical (increase in ascorbate-peroxidase and ascorbic acid, and decrease in apoplastic hydrogen peroxide) and biophysical (decrease in stomatal conductance) processes regulated EDU action. As total ascorbic acid increased only in the asymptomatic trees, its role in alleviating O(3) effects on leaf growth and visible injury is controversial.     

Types of Ectomycorrhiza as Pollution Stress Indicators: Case Studies in Slovenia

Mycorrhiza is the main spatial and temporal linkage between different constituents in a forest ecosystem. The functional compatibility and stress tolerance of ectomycorrhizal types is species specific, and therefore the information on the ectomycorrhizal community structure can add to the understanding of processes in forest ecosystems and can also be applied as tools for bioindication of pollution stress in forest soils. We have studied the effects of pollution (N and S) on trees and forest soils by: (1) quantification of ECM types diversity as in situ indicators in forest stands, (2) determination and quantification of pollution-sensitive or -insensitive ECM types as passive monitors, (3) root growth and development of ECM on nonmycorrhizal spruce seedlings, planted at the studied sites (active monitors), and (4) ECM infection (a bioassay based on mycorrhizal inoculum potential) of seedlings in an experimental set-up as ex situ testers. ECM species richness for Norway spruce trees (Picea abies) showed higher values in unpolluted sites than in polluted ones, while the differences were not significant for European beech trees (Fagus sylvatica). As pollution-sensitive or -insensitive ECM species in spruce forests, we suggest Hydnum rufescens (sensitive) and Paxillus involutus (unsensitive). Mycorrhizal potential in Norway spruce seedlings as a bioassay for soil N and S pollution was effective, and is suggested as an additional, standardized and widely comparable system in bioindication of soil pollution.