Toxicological Assessment of Wastewater and Runoff from the Baikal Pulp and Paper Mill

Russian Journal of Ecology -     

含纤维素废水生物水解的应用研究

提取植物或动物纤维所产生的高浓有机废水，含短小纤维、木质素、纤维素、半纤维素、蜡质、果胶及其分解产物(糖、脂肪酸、醇等)，较难生物处理，属含纤维素废水。试验研究和生产应用表明，生物水解对含纤维素废水中高分子有机物，可予分解并提高度水可生化性：在常温、PH约9．5时，水解池污泥浓度达6．5～16．0g/L，容积负荷达2．9kgCOD／m^3．d，COD去除率为24—36％，VFA提高3．9—5．1倍，BOD／COD提高12～16％。分析认为：中温、酸性，纤维素、木素含量低时，水解效果应更好。     

Analysis of the hydrocyclone stock cleaning process for wasted fibre in a paper mill

The main objective of this project was to evaluate the possibility of reducing the quantity of fibre wasted at one of many hydrocyclone (centrifugal) cleaning processes in a paper mill. It was found that the application of elutriation water to both the tertiary and quaternary cleaners was essential to minimise the fibre discharged to the sewer, and the pressure of this elutriation water had a dramatic effect of reducing the fibre wastage. Accordingly, it has been shown that 150–160 kPa as the optimum pressure range to apply elutriation water to minimise the product grade fibre wasted whilst sending undesired shive fibre to the sewer. Also, monitoring of the press uhle box wastewater revealed that the paper mill has the potential to make substantial cost savings by reducing the waste stream. Further investigation is necessary to determine the types of fibre that are being wasted, and the viability of a screen to recycle the wasted fibre to the process. However, these fibres may be unsuitable to reuse in the process and alternative uses must be found.     

造纸行业的清洁生产示范

文章概述了我国造纸行业清洁生产示范项目审计的成果，从环境、经济及清洁生产方案类型等角度对企业推行清洁生产进行了初步分析，提出了存在的主要问题，并就进一步推动造纸行业的清洁生产提出了建议。     

利用造纸黑液回收电镀废液中铬的研究

本文报道了利用造纸黑液回收电镀废液中铬的方法，阐明了造纸黑液中所含有还原性物质与Ｃｒ＾６＋的反应机理；讨论了进行反应的最佳条件以及采用这一方法对废液的治理效果。     

Design of a representative and cost-effective sampling programs for industrial wastewater with examples from bleached kraft pulp and paper mills

The diagram constructed for selection of sampling methods indicates that, for a systematic error, E ≤ 13%, grab sampling (GS) may be used to characterize effluents with variation coefficient of flow ≤ 120% and of contaminant concentrations ≤ 10%. For the whole studied range of variation coefficient of contaminant concentrations (2–82%), time-proportional compositing (TC) method may be applied with E ≤ 10% for effluents characterized by variation coefficients in flow < 90%. The more complicated flow-proportional compositing (FC) method is required only for effluents with larger variation coefficients or to produce more precise results. The diagram constructed for selection of sampling frequencies indicates that sequential sampling at intervals of approximately 60 min may be applied with E ≤ 10% for effluents characterized by variation coefficients ≤ 30%. Practical application of the diagrams, constructed using normal series, was checked against monitoring data from two pulp and paper mills in Vietnam. The two diagrams provided results on sampling methods and frequencies in good agreement with those obtained from actual monitoring data with percentages of agreement cases of 80 and 75%, respectively. The approach was applied in design of a monitoring program at the Bai Bang integrated pulp and paper mill in Vietnam.     

A decision framework for possible remediation of contaminated sediments in the River Kymijoki, Finland

Background, aim, and scope  The paper describes the spatial contamination of the River Kymijoki, South-Eastern Finland, and the coastal region of the Gulf of Finland with PCDD/Fs and mercury. The findings of ecotoxicologial and human health studies are also reported, including environmental and human risk assessments. Sediments from the River Kymijoki, draining into the Gulf of Finland, have been heavily polluted by the pulp and paper industry and by chemical industries. A wood preservative, known as Ky-5, was manufactured in the upper reaches of the river between 1940 and 1984 causing severe pollution of river sediments with polychlorinated dibenzo-p-dioxins (PCDD) and dibenzofurans (PCDF). Moreover, the sediments have been polluted with mercury (Hg) from chlor-alkali production and the use of Hg as a slimicide in pulp and paper manufacturing. Materials and methods  An extensive sediment survey was conducted as well as sediment transport modeling, toxicity screening of sediment invertebrates, and a survey of contaminant bioaccumulation in invertebrates and fish. Studies on human exposure to PCDD/Fs and the possible effects on hypermineralization of teeth as well as an epidemiological study to reveal increased cancer risk were also conducted. An assessment of the ecological and human health risks with a null hypothesis (no remediation) was undertaken. Results  The sediment survey revealed severe contamination of river and coastal sediments with PCDD/Fs and Hg. The total volume of contaminated sediments was estimated to reach 5 × 10⁶ m³ and hot spots with extremely high concentrations (max 292,000 ng g⁻¹ or 1,060 ng I-TEQ g⁻¹ d.w.) were located immediately downstream from the pollution source (approximately 90,000 m³). Sediment contamination was accompanied by changes in benthic assemblages, but direct effects were masked by many factors. The fish showed only slightly elevated PCDD/F levels in muscle, but orders of magnitude higher in the liver compared with reference freshwater sites and the Baltic Sea. The concentrations in human fat did not reveal high human exposure in the Kymijoki area in general and was lower than in sea fishermen. The relative risk for total cancer among farmers was marginally higher (RR = 1.13) among those living close to the river, compared with farmers living further away, and the possibility of increased cancer risk cannot be ruled out. A conservative risk assessment revealed that the present probability of exceeding the WHO upper exposure limit of 4 pg WHO-TEQ kg⁻¹ d⁻¹ for PCDD/Fs and DL-PCBs was 6%. The probability of exceeding the WHO limit value of 0.23 μg kg⁻¹ d⁻¹ for methyl mercury was estimated to be notably higher at 62%. Based on these studies and the estimated risks connected with different remediation techniques a general remediation plan with cost benefit analysis was generated for several sub-regions in the river. Dredging, on-site treatment, and a close disposal of the most contaminated sediments (90,000 m³) was suggested as the first phase of the remediation. The decision regarding the start of remediation will be made during autumn 2008. Conclusions  The sediments in the River Kymijoki are heavily polluted with PCDD/Fs and mercury from earlier chlorophenol, chlor-alkali, and pulp and paper manufacturing. A continuous transport of contaminants is taking place to the Gulf of Finland in the Baltic Sea. The highly increased PCDD/F and Hg levels in river sediments pose an ecotoxicological risk to benthic fauna, to fish-eating predators and probably to human health. The risks posed by mercury exceed those from PCDD/Fs and need to be evaluated for (former) chlor-alkali sites and other mercury releasing industries as one basis for remediation decision making. Recommendations and perspectives  The studies form the basis of a risk management strategy and a plan for possible remediation of contaminated sediments currently under consideration in the Southeast Finland Regional Environment Centre. It is recommended that a detailed restoration plan for the most seriously contaminated areas should be undertaken. Based on current knowledge, the restoration of the whole river is not feasible, considering the current risk caused by the contaminated sediment in the river and the costs of an extensive restoration project. The experiences gained in the present case should be utilized in the evaluation of PCDD/F- and mercury-contaminated sites in other countries. The case demonstrates that the historic reservoirs are of contemporary relevance and should be addressed, e.g., in the national implementation plans of the Stockholm Convention. Electronic supplementary material  The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Impact of government regulations on pollution performance of pulp and paper firms

A comparative study of water pollution emissions of pulp and paper companies for the period 1978–1983 indicates a reduction in emissions for most firms. This improvement in pollution performance is attributed to the federal government's water pollution policy. Although there is an overall decline in water pollution, some firms have actually increased their emissions. Furthermore, there is still a wide disparity in each company's performance, although the differences are narrowing.     

The use of a sequential leaching procedure for assessing the heavy metal leachability in lime waste from the lime kiln at a caustizicing process of a pulp mill

A five-stage sequential leaching procedure was used to fractionate 13 heavy metals (Cd, Cu, Pb, Cr, Zn, Fe, Mn, Al, Ni, Co, As, V, Ba) and sulphur (S) in lime waste from the lime kiln at the causticizing plant of Stora Enso Oyj Veitsiluoto Pulp Mills at Kemi, Northern Finland, into the following fractions: (1) water-soluble fraction (H₂O), (2) exchangeable fraction (CH₃COOH), (3) easily reduced fraction (HONH₃Cl), (4) oxidizable fraction (H₂O₂ + CH₃COONH₄), and (5) residual fraction (HF + HNO₃ + HCl). Although metals were leachable in all fractions, the highest concentrations for most of the metals were observed in the residual fraction (stage 5). It was also notable that the total heavy metal concentrations in lime waste did not exceed the maximal allowable heavy metal concentrations for soil conditioner agents set by the ministry of the Agricultural and Forestry in Finland. The heavy metals concentrations in lime waste were also lower than the maximal allowable heavy metals concentrations of the European Union Directive 86/278/EEC on the protection of environment, and in particular of the soil, when sewage sludge is used in agriculture. The Ca concentration (420 g kg⁻¹; d.w.) was about 262 times higher than the typical value of 1.6 g kg⁻¹ (d.w.) in arable land in Central Finland. However, the concentration Mg (0.2 g kg⁻¹; d.w.) in lime waste was equal to the Mg concentration in arable land in the Central Finland. The lime waste has strongly alkaline pH (12.8) and a neutralizing value (i.e. liming effect) of 47.9% expressed as Ca equivalents (d.w.). This indicates lime waste to be a potential soil conditioner and improvement as well as a pH buffer.     

Acid dissolution methods for heavy metals determination in pine needles

Microwave digestion procedures using HNO₃, HNO₃+H₂O₂, HNO₃+HClO₄, HF mixtures and dry ashing with HF were investigated for heavy metals analysis by either inductively coupled plasma-optical emission spectroscopy (ICP-OES) or ICP-mass spectrometry (ICP-MS) in pine needles. The HF digestion procedures gave about 1.5 times higher values than a mixture of HNO₃+H₂O₂ alone. For Ti determination in needles, the HF procedure using dry ashing is thus recommended. The mean concentrations amounted to 900 mg/kg for Fe and 21.8 mg/kg for Ti in needles collected at an area polluted by a stainless steel works. Those concentrations were 10.6 and 4.3 times higher than in needles collected at an area nearby a pulp mill complex (84.5 mg/kg Fe and 5.0 mg/kg Ti).