城市旅游区暴雨径流污染过程中的不透水面效应

选取武汉市动物园4种典型的不透水面暴雨径流污染特征进行了系统的研究,以期为旅游区面源污染危害评价和治理提供基本的依据.结果表明,动物园4种不透水面初期径流污染物浓度很高,COD最大值达1140 mg/L,下垫面类型及地表累积污染物是影响径流水质的主要因素.通过无量纲累积曲线的分析,表明旅游区不透水面径流初期冲刷严重,该曲线还为面源治理提供了重要的工程参数.     

北京城市典型下垫面降雨径流污染初始冲刷效应分析

城市硬化地表的迅速增加使得降雨径流量增加,屋面和路面等下垫面上污染物的大量累积并随径流进入城市排水系统,对城市水环境造成威胁.为了解径流污染过程和给径流污染控制提供科学依据,于2004～2006年选取典型屋面和路面对径流污染过程进行了监测和分析,计算了两种径流的次降雨平均浓度(EMC)水平,发现两类径流的COD和TN污染较为严重;屋面径流的化学需氧量(COD)、总氮(TN)分别超标(地表水环境质量标准GB 3838-2002 V类)3.64和4.80倍;路面径流的COD、TN分别超标3.73和1.07倍.利用M(V)曲线,判断径流量同径流污染负荷的关系,发现屋面径流污染物总悬浮颗粒物(TSS)、COD、TN和总磷(TP)发生了不同程度的初始冲刷现象;路面初始冲刷现象主要表现为TSS和TP,总体上初始冲刷效应不明显.汇水面性质、降雨强度、污染物累积状况等都是影响屋面和路面径流污染物排放特征的重要影响因素.     

Photocatalytic remediation of γ-hexachlorocyclohexane contaminated soils using TiO2 and montmorillonite composite photocatalyst

TiO2 and montmorillonite composite photocatalysts were prepared and applied in degrading γ-hexachlorocyclohexane(γ-HCH)in soils.After being spiked with γ-HCH,soil samples loaded with the composite photocatalysts were exposed to UV-light irradiation.The results indicated that the photocatalytic activities of the composite photocatalysts varied with the content of TiO2 in the order of 10%＜70%＜50%＜30%.Moreover,the photocatalytic activity of the composite photocatalysts with TiO2 content 30% was higher than that of the pure P25 with the same mass of TiO2.The strong adsorption capacity of the composite photocatalysts and quantum size effect may contribute to its increased photocatalytic activities.In addition,effect of dosage of composite photocatalysts and soil pH on γ-HCH photodegradation was investigated. Pentachlorocyclohexene,trichlorocyclohexene,and dichlorobenzene were detected as photodegradation intermediates,which were gradually degraded with tlle phOtOdegradation evolution.     

山地城市典型硬化下垫面暴雨径流初期冲刷研究

为了解山地城市典型硬化下垫面暴雨径流初期冲刷效应,对山城重庆的8场暴雨进行了径流全过程监测,并与平原城市作了对比分析.结果表明:TSS(总悬浮物)、COD和TP来自城市交通干道的贡献较混凝土屋面大,而TN、NH3-N两者相当;对于重金属,除Cd外,城市交通干道重金属的EMC(Event Mean Concentration)值均高于混凝土屋面.城市交通干道,初期40%的暴雨径流携带了53%±16%TSS,66%±10%COD,59%±2%TN,58%±2%NH3-N,51%±5%TP;而混凝土屋面,初期40%的暴雨径流携带了64%±20%TSS,66%±17%COD,55%±14%TN,52%±14%NH3-N,56%±3%TP,建议两类硬化下垫面至少以初期40%的暴雨径流作为控制量.与平原城市相比,山地城市交通干道初期40%的暴雨径流携带污染负荷TSS与COD的比例比平原城市分别高出16%和22%,初期冲刷效应更加明显.     

Estimation of Land Use Specific Runoff and Pollutant Concentration for Tapi River Basin in India

Non-point source (NPS) pollution is the result of various land use practices such as agriculture, sites of construction and waste disposal, urban development and so on. The control of NPS pollution is possible by regular monitoring and assessment on watershed basis to educate people for implementing well-known structural and non-structural measures. Recent trend is to use GIS based modelling tool for assessment of rainfall-runoff and non-point loading. The approach requires generation and analysis of basin wide data on various features of land and estimates of Event Mean Concentrations (EMCs) of pollutants in the runoff. In the present paper, basin wide data in different districts of Tapi basin has been analysed for land use distribution; fertilizer application; low, medium and high-density habitation; and annual rainfall. Coefficients of runoff have been estimated considering pervious and impervious area for different land use types, and compared with the reported values for Indian conditions. The estimated mean annual runoff flow indicated that two districts Jalgaon and Dhule contribute maximum runoff to the Tapi River. Estimates of EMCs for BOD and nutrients (N and P) in the runoff from various districts are useful in GIS-based modelling study for NPS pollution assessment.     

模拟可见光下土壤表面石油的光化学降解研究

在模拟可见光照射下,分析了土壤中的初始含油量、土壤类型和土壤pH值对石油在土壤表面光降解过程的影响,并利用紫外-可见分光光度法(UV-Vis)、气相色谱-氢火焰离子化检测器(GC-FID)和傅立叶红外光谱(FTIR)等方法对石油在光降解过程中的演变规律进行研究.结果表明,石油在土壤表面上的光化学降解行为符合准一级反应动力学,实验测得石油的光解速率常数为0.002 6～0.017 2 h^-1,半衰期为40～267 h.GC-FID分析结果表明,在光降解50 h后,石油的饱和烃组分中高碳数的烷烃相对含量降低,低碳数的烷烃相对含量提高;芳香烃组分的大部分色谱峰有明显地降低或消失.红外光谱分析发现,光照60 h后土壤萃取液中可能产生了羰基类化合物,说明石油在光降解过程中逐渐发生氧化.     

Non-UV based germicidal activity of metal-doped TiO2 coating on solid surfaces

A stain-based screening method was developed to screen different catalyst coatings for their germicidal activity. A Baclight dead/live bacteria viability kit （invitrogen, molecular probes） was used for staining the cell. The screening was carried out following a standard procedure. This included loading cell suspension to solid surface and maintaining contact for 30 min, then staining with a mixture containing dyes. The stained cells were observed using an epifluorescent microscope and photographed with a CCD camera under UV. Metal-doped TiO2 coatings on AI plates were prepared and tested for non-UV germicidal activity without using UV. It was tested using model microorganisms such as Bakers Yeast （Saccharomyces cerevisiae）, Bacillus subtilis, Pseudomonas putida, and Escherichia coli. On the basis of the germicidal activity of catalyst and the degree of damage caused to the cells, the stained cells may appear green （viable）, green with red or yellow nuclei and yellow （compromised） or red （nonviable）. According to their stained color, cells were counted to calculate the percentage of dead, live, and compromised cells. Compromised cells are cells that grow very slowly after reculturing indicating a degree of reversible cell damage. Screening the germicidal activity using this staining method is accurate and efficient, and requires less time than the culture-based method. A modification to the procedure for measuring germicidal activity of rough surfaces or fibrous coatings was developed. Both TiO2 and metal-doped TiO2 （Ag, Pt, Au, Cu） possess non-UV based germicidal activity. The germicidal activity of TiO2 was found to be related with its wetting property and can be improved by UV irradiation before testing. It is not greatly affected by contact time, indicating a fast acting germicidal activity.     

Temporal Trends in the Spatial Distribution of Impervious Cover Relative to Stream Location

Use of impervious cover is transitioning from an indicator of surface water condition to one that also guides and informs watershed planning and management, including Clean Water Act (33 U.S.C. §1251 et seq.) reporting. Whether it is for understanding surface water condition or planning and management, impervious cover is most commonly expressed as summary measurement (e.g., percentage watershed in impervious cover). We use the National Land Cover Database to estimate impervious cover in the vicinity of surface waters for three time periods (2001, 2006, 2011). We also compare impervious cover in the vicinity of surface waters to watershed summary estimates of impervious cover for classifying the spatial pattern of impervious cover. Between 2001 and 2011, surface water shorelines (streams and water bodies) in the vicinity of impervious cover increased nearly 10,000 km. Across all time periods, approximately 27% of the watersheds in the continental United States had proximally distributed impervious cover, i.e., the percentage of impervious cover in the vicinity of surface waters was higher than its watershed summary expression. We discuss how impervious cover spatial pattern can be used to inform watershed planning and management, including reporting under the Clean Water Act.     

Regional impervious surface estimation: an urban heat island application

This paper describes a GIS-based estimation method that can be used to forecast future amounts of impervious surface as a mitigation measure for urban heat island effect in a metropolitan region. The method is unique because it employs a regression model that links the existing amount of impervious surface to population and employment at the census tract level. This approach provides a means to forecast future amounts of impervious surface based on projected population and employment. The method also includes a detailed analysis of high-resolution aerial photography to divide impervious surfaces into different categories. Subdividing impervious surfaces is necessary to evaluate potential urban heat island mitigation policies for different types of impervious surface. The analysis here shows that the impervious surface in the metropolitan Atlanta region will increase to 2638 km2 2. “The Albedo is defined as the hemispherical reflectivity averaged over the solar spectrum. A perfect reflector has a = 1, and a perfect absorber has a = 0” (Pomerantz et al. 1999 Pomerantz, M. 1999. Reflective surfaces for cooler buildings and cities. Philosophical magazine B, 79: 1457–1476. [Taylor & Francis Online], [Web of Science ®] [Google Scholar], p. 1458). View all notes in 2030, an increase of 45% from 2000. The most common type of impervious surface is dark-coloured pavement. Within this study area, the analyses showed that two-thirds of impervious surfaces are dark. Replacing dark pavement with light pavement materials, therefore, represents an important opportunity to mitigate the urban heat island effect in the Atlanta region.     

Low-impact development for impervious surface connectivity mitigation: assessment of directly connected impervious areas (DCIAs)

Urbanization increases directly connected impervious area (DCIA), the impervious area that is hydraulically connected to downstream drainage by closed pipelines. Although the benefits of low-impact development (LID) have been examined in other studies, its effect on alleviating DCIA levels has seldom been assessed. This study measured the DCIA of urban watersheds in Houston, TX, USA. Five land-use types were categorized and the contribution of LID facilities to reducing DCIA in each type was estimated by using Sutherland's equations. The results showed (1) DCIA in commercial areas was greater than that in residential areas, especially for big-box retailers; (2) the percentage of DCIA reduction by LID varied by land-use type; and (3) optimal combinations of LID application could maximize the effectiveness of DCIA reduction. The results contribute to prioritizing land-use type for implementing LID practices and providing local governments with a useful measure to estimate runoff volume.