The Thermal Discharges From Nuclear Power Plants in Taiwan

The increasing use of sea water for industrial cooling presents a real threat to the ecological environment in the ocean. in Taiwan where many electric power plants along the coast take sea water for cooling, people are concerned seriously about nuclear power plants. There are three nuclear power plants in Taiwan. Each plant has two units for generating power. the first two are located along the northern coast of Taiwan. the third is located in Kenting National Park along the coast of southernmost Taiwan. the plants take sea water for cooling, and discharge their heated effluents to the ocean surface from the coast. the thermal effluents have variable effects on the ecological environment near the plants. Fishermen living near the power plants complain that the heated water affects the inshore fishery catch. in addition, the thermal water from the second plant is easily accumulated near the coastal zone to influence the nearby swimming area in the summer-time. the thermal water from the third plant bleaches or kills some corals in shallow water near the outlet, and this conflicts with the interests of Kenting National Park.     

Effects of SO2 and H2O on low-temperature NO conversion over F-V2O5-WO3/TiO2 catalysts

F-V_2 O_5-WO3/Ti02 catalysts were prepared by the impregnation method.As the content of F ions increased from 0.00 to 0.35 wt.%,the NO conversion of F-V_2 O_5-WO_3/TiO_2 catalysts initially increased and then decreased.The 0.2 F-V_2 O_5-WO_3/TiO_2 catalyst(0.2 wt.% F ion)exhibited the best denitration(De-NOx) performance,with more than 95% NO conversion in the temperature range 160-360℃,and 99.0% N2 selectivity between 110 and 280℃.The addition of an appropriate amount of F ions eroded the surface morphology of the catalyst and reduced its grain size,thus enhancing the NO conversion at low temperature as well as the sulfur and water resistance of the V_2 O_5-WO3/Ti02 catalyst.After selective catalytic reduction(SCR) reaction in a gas flow containing SO_2 and H_2 O,the number of NH3 adsorption sites,active component content,specific surface area and pore volume decreased to different degrees.Ammonium sulfate species deposited on the catalyst surface,which blocked part of the active sites and reduced the NO conversion performance of the catalyst.On-line thermal regeneration could not completely recover the catalyst activity,although it prolonged the cumulative life of the catalyst.In addition,a mechanism for the effects of S02 and H_2 O on catalyst NO conversion was proposed.     

石英灯辐射加热条件下低密度碳/酚醛复合材料高温响应及分析

目的研究低密度碳/酚醛复合材料在不同地面加热实验测试响应的差异性,指导材料在实际应用环境下的高温响应分析。方法对低密度碳/酚醛复合材料开展了热流为400 kW/m~2的单侧石英灯辐射加热实验,利用热电偶测温系统测量试件在加热过程中不同位置的温度时间历程,并对试件的烧蚀形貌和微观结构进行观测。同时与热流为464k W/m~2的氧乙炔加热陶瓷板辐射加热实验结果进行对比分析,并且采用有限元方法对材料的传热传质多场耦合计算进行分析。结果对于石英灯辐射加热,在测量点升温到接近200℃时,温度响应拐点都依次出现。由于加热的辐射热源不同,在不同的辐射波段下,多孔材料吸收和发射的热量不同,短时间内氧乙炔加热陶瓷板辐射加热使材料内部升温速率比石英灯辐射加热实验的要快,但长时间加热时现象刚好相反。结论进行传热传质多场耦合计算材料高温响应时,合理确定材料宏观性能随温度的变化至关重要。     

纤维增强气凝胶复合材料高温结构转变及热稳定性研究

目的研究高温受热条件下纳米复合隔热材料的结构转变特征及热稳定性。方法采用扫描电镜、X射线衍射仪、红外光谱仪及热重仪等检测方法。结果纤维增强气凝胶材料从室温到650℃存在连续的质量损失,从室温到放热前,质量损失为1.66%;365℃开始出现放热,温度升至398℃时达到峰值,整个放热过程对应质量损失约为1.3%;从435℃放热结束开始到650℃的质量损失为1.46%。经过400℃热处理后,试样比表面积从268m~2/g增加到437m~2/g;当试样热处理温度达到600℃时,试样的比表面积明显随之降低至198m~2/g。结论 SiO_2气凝胶复合材料以无定形结构为主,存在少量的二氧化钛晶体。在400℃左右,SiO_2气凝胶结构中硅甲基Si—CH_3发生氧化,产生明显的放热峰,之后硅羟基Si—OH之间发生缩聚反应,使600℃热处理后气凝胶中Si—O—Si网络骨架强度有所提高。未处理的纤维增强气凝胶材料试样上气凝胶纳米颗粒构成的块体较为良好地包裹在玻璃纤维表面,而经过600℃的高温热处理1 h后,块体气凝胶脱离了光滑的纤维表面,气凝胶纳米粒子发生收缩,致使材料比表面积下降。     

包装箱用碳纤维增强复合材料贮存寿命研究

目的研究碳纤维增强复合材料贮存条件下的性能变化趋势和寿命评估。方法对碳纤维增强复合材料开展四个不同温度条件下的热氧老化试验,按试验周期定期取样开展冲击性能测试,对试验数据采用寿命预估方法进行处理,对材料性能进行预估。结果通过数据计算分别得到我国热带海洋、干热沙漠等典型气候条件下的碳纤维增强复合材料贮存寿命分别为17.21~35.89年。结论碳纤维增强复合材料具有较好的贮存性能,在较为严酷的热带海洋气候和给定的失效判据条件下,寿命预计为17.21年。试验和数据处理方法可以较好地预计材料的性能变化趋势和开展寿命评估。     

Estimation of the Thermal Sensitivity of a Dwelling to Variations in Architectural and Behavioural Parameters

The provision of energy for households is a major contributor to greenhouse gas emissions in the domestic sector. There is significant scope for energy savings and thus emission reduction in this sector. This paper constructs a bridge between thermal analysis and environmental assessment in the occupancy stage of the dwelling life cycle, approaching both methods as being on a common system Environment–Dwelling–Inhabitant. The importance of the local level in the thermal analysis and assessment of either a dwelling or an inhabitant's behaviour is demonstrated. It is shown that the researcher can choose between natural experiment, computer experiment and mathematical modelling to analyze the system. Such a choice is discussed for two particular methods of thermal analysis. Thermal Nomograms are the result of mathematical modelling, and the Energy Score Sheet is the result of a computer experiment in energy rating. Despite being developed for the purpose of thermal analysis, these methods can also be utilized for environmental assessment at the local level. The discussion centres on Australian conditions where the majority of the population resides in a relatively benign climate wherein behavioural alterations have significant potential for energy savings and environmental impact. The purpose of the paper is to emphasise benefits apart from energy minimisation to promote the use of energy efficient housing strategies.     

温度、盐度、铜、氨对对虾仔虾(Penaues orientalis K)和光滑河兰蛤(Potamocorbula laevis)的影响

在室内模拟条件下,进行了热冲击及其与盐度、铜、氨联合对对虾仔虾和光滑河兰蛤的急性影响研究。结果表明,两种动物的起始致死温度(TL₅₀)和最高临界温度(CTM)随驯化温度的升高而增大;随盐度的降低,仔虾的耐高温能力明显降低,而兰蛤对盐度变化反应不明显;高温明显提高铜、氨对仔虾的毒性。也提高铜对兰蛤的毒性,但降低氨对兰蛤的毒性影响。仔虾对高温、低盐、铜离子及非离子氨反应敏感。     

常温酸性腐蚀对热障涂层性能的影响

采用酸性盐雾腐蚀试验对物理气相沉积法制备的热障涂层进行了常温腐蚀,研究了常温酸性盐雾腐蚀对热障涂层的微观形貌以及高温性能的影响.试验结果表明：常温酸性腐蚀使热障涂层表面变得粗糙不平,产生了较大的裂纹.经过150次高温循环氧化后,顶层氧化锆晶粒排列疏松,裂纹进一步扩展,中间层--粘结层氧化速度加快,生成了疏松的TGO层.TGO的体积膨胀效应使得陶瓷/粘结层界面结合力降低,缩短了涂层的使用寿命.     

输气场站工艺安全风险分析

针对输气场站HAZOP风险评估出的天然气泄漏风险进行工艺安全量化分析,通过天然气泄漏喷射火模拟,对天然气泄漏风险进行量化,为输气场站的安全管理提供有效的技术支持。通过量化,分析出对天然气泄漏喷射火造成后果大小的影响因素,提高了HAZOP风险分析的准确性和科学性,对输气场站的风险管理具有参考意义。     

基于GIS的海洋环境质量评价图编制

本文介绍了采用地理信息系统技术制作海洋环境质量评价图的基本内容，重点阐述了图件的表现形式、编制过程和具体的操作方法，为海洋环境质量评价图的制作提供了一种新的方法。